scholarly journals Direct imaging of an inhomogeneous electric current distribution using the trajectory of magnetic half-skyrmions

2020 ◽  
Vol 6 (6) ◽  
pp. eaay1876 ◽  
Author(s):  
Senfu Zhang ◽  
Xichao Zhang ◽  
Junwei Zhang ◽  
Arnab Ganguly ◽  
Jing Xia ◽  
...  

The direct imaging of current density vector distributions in thin films has remained a daring challenge. Here, we report that an inhomogeneous current distribution can be mapped directly by the trajectories of magnetic half-skyrmions driven by an electrical current in Pt/Co/Ta trilayer, using polar magneto-optical Kerr microscopy. The half-skyrmion carries a topological charge of 0.5 due to the presence of Dzyaloshinskii-Moriya interaction, which leads to the half-skyrmion Hall effect. The Hall angle of half-skyrmions is independent of current density and can be reduced to as small as 4° by tuning the thickness of the Co layer. The Hall angle is so small that the elongation path of half-skyrmion approximately delineates the invisible current flow as demonstrated in both a continuous film and a curved track. Our work provides a practical technique to directly map inhomogeneous current distribution even in complex geometries for both fundamental research and industrial applications.

2010 ◽  
Vol 721 (1) ◽  
pp. L58-L61 ◽  
Author(s):  
K. G. Puschmann ◽  
B. Ruiz Cobo ◽  
V. Martínez Pillet

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Musa Ahmed ◽  
Ibnelwaleed A. Hussein ◽  
Abdulmujeeb T. Onawole ◽  
Mohammed A. Saad ◽  
Mazen Khaled

AbstractPyrite scale formation is a critical problem in the hydrocarbon production industry; it affects the flow of hydrocarbon within the reservoir and the surface facilities. Treatments with inorganic acids, such as HCl, results in generation toxic hydrogen sulfide, high corrosion rates, and low dissolving power. In this work, the dissolution of pyrite scale is enhanced by the introduction of electrical current to aid the chemical dissolution. The electrolytes used in this study are chemical formulations mainly composed of diethylenetriamine-pentaacetic acid–potassium (DTPAK5) with potassium carbonate; diethylenetriamine pentaacetic acid sodium-based (DTPANa5), and l-glutamic acid-N, N-diacetic acid (GLDA). DTPA and GLDA have shown some ability to dissolve iron sulfide without generating hydrogen sulfide. The effect of these chemical formulations, disc rotational rate and current density on the electro-assisted dissolution of pyrite are investigated using Galvanostatic experiments at room temperature. The total iron dissolved of pyrite using the electrochemical process is more than 400 times higher than the chemical dissolution using the same chelating agent-based formulation and under the same conditions. The dissolution rate increased by 12-folds with the increase of current density from 5 to 50 mA/cm2. Acid and neutral formulations had better dissolution capacities than basic ones. In addition, doubling the rotational rate did not yield a significant increase in electro-assisted pyrite scale dissolution. XPS analysis confirmed the electrochemical dissolution is mainly due to oxidation of Fe2+ on pyrite surface lattice to Fe3+. The results obtained in this study suggest that electro-assisted dissolution is a promising technique for scale removal.


2015 ◽  
Vol 2015 ◽  
pp. 1-10 ◽  
Author(s):  
The Huyen Nguyen ◽  
Tuan Anh Nguyen ◽  
Thien Vuong Nguyen ◽  
Van Khu Le ◽  
Thi Mai Thanh Dinh ◽  
...  

The electrical rehabilitation treatments of repair mortar were performed with tetrabutylammonium bromide salt (TBAB) at an electrical current density of 5 A/m2, using two electrolytes (0.1 M NaOH and 0.1 M Na3BO3solutions), and for two time periods (1 and 4 weeks), respectively. The average organic cation-based inhibitor’s concentration in cement mortars before and after this treatment was quantified using the UV-Vis spectroscopy. The experimental results reveal that the EICI treatment with 0.1 M Na3BO3was more effective in injecting the inhibitor and in improving the chloride penetration resistance and compressive strength of the mortar, relative to using 0.1 M NaOH as electrolyte. In this case, after the 4-week EICI treatment, [TBA+] contents were 2.3 % and 2.4% by mass of cement mortar for uncontaminated and salt-contaminated mortars, respectively. After the 4-week EICI treatment, the apparent diffusion coefficients of chloride anion in cement mortar were decreased by 40% from 1.52 × 10−10 m2/s. The EICI treatment was able to halt the chloride-induced corrosion of the steel rebar by promoting its passivation. The 2-week EICI treatment using sodium hydroxide and sodium borate solutions decreased the corrosion current density of the rebar by 77.8% and 78.5%, respectively, approximately two months after the treatment.


1986 ◽  
Vol 81 (1) ◽  
pp. 189-206 ◽  
Author(s):  
J. Bohrmann ◽  
A. Dorn ◽  
K. Sander ◽  
H. Gutzeit

We determined the extracellular electrical current pattern around Drosophila follicles at different developmental stages (7–14) with a vibrating probe. At most stages a characteristic pattern can be recognized: current leaves near the oocyte end of the follicle and enters at the nurse cells. Only at late vitellogenic stages was an inward-directed current located at the posterior pole of many follicles. Most striking was the observed heterogeneity both in current pattern and in current density between follicles of the same stage. Different media (changed osmolarity or pH, addition of cytoskeletal inhibitors or juvenile hormone) were tested for their effects on extrafollicular currents. The current density was consistently influenced by the osmolarity of the medium but not by the other parameters tested. Denuded nurse cells (follicular epithelium locally stripped off) show current influx, while an accidentally denuded oocyte produced no current. Our results show that individual follicles may be electrophysiologically different, though their uniform differentiation during vitellogenesis does not reflect such heterogeneity.


2005 ◽  
Vol 86 (23) ◽  
pp. 234101 ◽  
Author(s):  
Roberto S. Aga ◽  
Xiang Wang ◽  
Jonathan Dizon ◽  
Jesse Noffsinger ◽  
Judy Z. Wu

2002 ◽  
Vol 67 (4) ◽  
pp. 273-278 ◽  
Author(s):  
Konstantin Popov ◽  
S.M. Pesic ◽  
Predrag Zivkovic

Anew method for the determination of the ability of an electrolyte to distribute uniformly current density in an electrochemical cell is proposed. It is based on the comparison of the current in cells in which the electrode edges touch the cell side walls with the current in cells with different electrode edge ? cell side wall distances. The effects of cell geometry process parameters and current density are discussed and illustrated using the results presented in the previous papers from this series.


Sign in / Sign up

Export Citation Format

Share Document