Experimental evidence of the correlation between possible precursors of earthquakes in near-surface quasistatic electric fields and in the ionosphere

2010 ◽  
Vol 50 (7) ◽  
pp. 920-926 ◽  
Author(s):  
L. P. Korsunova ◽  
Yu. M. Mikhailov ◽  
V. V. Khegai ◽  
L. N. Leshchenko ◽  
S. E. Smirnov ◽  
...  
2019 ◽  
Vol 41 (1) ◽  
pp. 5-45 ◽  
Author(s):  
Graham J. Hill

Abstract The polar regions are host to fundamental unresolved challenges in Earth studies. The nature of these regions necessitates the use of geophysics to address these issues, with electromagnetic and, in particular, magnetotelluric studies finding favour and being applied over a number of different scales. The unique geography and climatic conditions of the polar regions means collecting magnetotelluric data at high latitudes, which presents challenges not typically encountered and may result in significant measurement errors. (1) The very high contact resistance between electrodes and the surficial snow and ice cover (commonly MΩ) can interfere with the electric field measurement. This is overcome by using custom-designed amplifiers placed at the active electrodes to buffer their high impedance contacts. (2) The proximity to the geomagnetic poles requires verification of the fundamental assumption in magnetotellurics that the magnetic source field is a vertically propagating, horizontally polarised plane wave. Behaviour of the polar electro-jet must be assessed to identify increased activity (high energy periods) that create strong current systems and may generate non-planar contributions. (3) The generation of ‘blizstatic’, localised random electric fields caused by the spin drift of moving charged snow and ice particles that produce significant noise in the electric fields during periods of strong winds. At wind speeds above ~ 10 m s−1, the effect of the distortion created by the moving snow is broad-band. Station occupation times need to be of sufficient length to ensure data are collected when wind speed is low. (4) Working on glaciated terrain introduces additional safety challenges, e.g., weather, crevasse hazards, etc. Inclusion of a mountaineer in the team, both during the site location planning and onsite operations, allows these hazards to be properly managed. Examples spanning studies covering development and application of novel electromagnetic approaches for the polar regions as well as results from studies addressing a variety of differing geologic questions are presented. Electromagnetic studies focusing on near-surface hydrologic systems, glacial and ice sheet dynamics, as well as large-scale volcanic and tectonic problems are discussed providing an overview of the use of electromagnetic methods to investigate fundamental questions in solid earth studies that have both been completed and are currently ongoing in polar regions.


Geophysics ◽  
1991 ◽  
Vol 56 (12) ◽  
pp. 2102-2106 ◽  
Author(s):  
Catherine deGroot‐Hedlin

A common problem in magnetotelluric (MT) sounding is the presence of static shifts in the data, i.e., a vertical shifting of the log‐apparent‐resistivity versus period curves relative to regional values (Jones, 1988; Jiracek, 1990; Berdichevsky et al., 1989). These static shifts are due to the presence of small‐scale, shallow conductivity anomalies near the measurement site. Electric charge builds up on near‐surface anomalies that are small in comparison to the skin depth of the electromagnetic (EM) fields. The charge buildup produces a perturbation of the measured electric fields from their regional values that persists to arbitrarily low frequencies. Incorrect removal of these local distortions leads to incorrect interpretation of the deeper targets of investigation.


Author(s):  
Usama Ebead ◽  
Hossameldin El-Sherif

Fibre reinforced cementitious matrix (FRCM) systems are mostly externally bonded (EB) for the strengthening of reinforced concrete (RC) and masonry structures. In this paper, the relatively new concept of near-surface embedded (NSE) FRCM, has been introduced for the flexural strengthening of beams. The process of the application of NSE-FRCM strengthening technique involves the removal of the concrete layer at beam soffit, being the most deteriorated in actual practices. Experimental evidence of the flexural strengthening efficacy of this technique is provided here. Eight RC beams were prepared and tested under four-point loading with the consideration of two test parameters: (a) FRCM material (polyparaphenylene benzobisoxazole (PBO)/carbon/ glass); and (b) the reinforcement ratio (0.5% representing flexure-deficient beams and 1.28% representing typical under-reinforced beams). The strengthening led to gains in ultimate loads that ranged between 31.4% and 84.3%.


2007 ◽  
Vol 40 (3) ◽  
pp. 505-512 ◽  
Author(s):  
D. Walker ◽  
P. A. Thomas ◽  
P. Pernot-Rejmánková ◽  
J. Baruchel

Recent work on the non-linear optical single-crystal rubidium titanyl arsenate (RbTiOAsO4, RTA) has shown that it exhibits behaviour consistent with a ferroelectric semiconductor under large applied electric fields, with the development of a non-uniform field in the near-surface region. To confirm aspects of the proposed model, the behaviour of 001 slices of initially single-domain RTA, patterned with periodic Ag electrodes of spacing 38 µm, as for periodic poling in non-linear optics, were investigated using synchrotron X-ray section topography with the electric field appliedin situwhile under X-ray illumination at the ID19 topography beamline of the ESRF, Grenoble. The results of white-beam section topography as both a function of crystal to film distance, and under DC voltage are reported, confirming that there is a bending of the planes in the near-surface region. The strain in the near-surface region was examined directly using high-resolution monochromatic X-ray section topography. This revealed an extensive strain of 3 (±1) × 10−4at 1 kV, indicating that the electrostrictive coefficient, γ3333, in RTA is positive in sign.


Geophysics ◽  
2007 ◽  
Vol 72 (2) ◽  
pp. G9-G20 ◽  
Author(s):  
Seth S. Haines ◽  
Steven R. Pride ◽  
Simon L. Klemperer ◽  
Biondo Biondi

We have undertaken a series of controlled field experiments to develop seismoelectric experimental methods for near-surface applications and to improve our understanding of seismoelectric phenomena. In a set of off-line geometry surveys (source separated from the receiver line), we place seismic sources and electrode array receivers on opposite sides of a man-made target (two sand-filled trenches) to record separately two previously documented seismoelectric modes: (1) the electromagnetic interface response signal created at the target and (2) the coseismic electric fields located within a compressional seismic wave. With the seismic source point in the center of a linear electrode array, we identify the previously undocumented seismoelectric direct field, and the Lorentz field of the metal hammer plate moving in the earth’s magnetic field. We place the seismic source in the center of a circular array of electrodes (radial and circumferential orientations) to analyze the source-related direct and Lorentz fields and to establish that these fields can be understood in terms of simple analytical models. Using an off-line geometry, we create a multifold, 2D image of our trenches as dipping layers, and we also produce a complementary synthetic image through numerical modeling. These images demonstrate that off-line geometry (e.g., crosswell) surveys offer a particularly promising application of the seismoelectric method because they effectively separate the interface response signal from the (generally much stronger) coseismic and source-related fields.


2007 ◽  
Vol 34 (14) ◽  
Author(s):  
W. M. Farrell ◽  
T. J. Stubbs ◽  
R. R. Vondrak ◽  
G. T. Delory ◽  
J. S. Halekas
Keyword(s):  

2020 ◽  
Author(s):  
Liisa Juusola ◽  
Heikki Vanhamäki ◽  
Ari Viljanen ◽  
Maxim Smirnov

Abstract. Geomagnetically induced currents (GIC) are directly described by ground electric fields, but estimating them is time-consuming and requires knowledge of the ionospheric currents as well as the three-dimensional distribution of the electrical conductivity of the Earth. The time derivative of the horizontal component of the ground magnetic field (dH/dt) is closely related to the electric field via Faraday's law, and provides a convenient proxy for the GIC risk. However, forecasting dH/dt still remains a challenge. We use 25 years of 10 s data from the North European International Monitor for Auroral Geomagnetic Effects (IMAGE) magnetometer network to show that part of this problem stems from the fact that instead of the primary ionospheric currents, the measured dH/dt is dominated by the signature from the secondary induced telluric currents nearly at all IMAGE stations. The largest effects due to telluric currents occur at coastal sites close to highly-conducting ocean water and close to near-surface conductivity anomalies. The secondary magnetic field contribution to the total field is a few tens of percent, in accordance with earlier studies. Our results have been derived using IMAGE data and are thus only valid for the involved stations. However, it is likely that the main principle also applies to other areas. Consequently, it is recommended that the field separation into internal (telluric) and external (ionospheric and magnetospheric) parts is performed whenever feasible, i.e., a dense observation network is available.


2020 ◽  
Vol 38 (5) ◽  
pp. 983-998
Author(s):  
Liisa Juusola ◽  
Heikki Vanhamäki ◽  
Ari Viljanen ◽  
Maxim Smirnov

Abstract. Geomagnetically induced currents (GICs) are directly described by ground electric fields, but estimating them is time-consuming and requires knowledge of the ionospheric currents and the three-dimensional (3D) distribution of the electrical conductivity of the Earth. The time derivative of the horizontal component of the ground magnetic field (dH∕dt) is closely related to the electric field via Faraday's law and provides a convenient proxy for the GIC risk. However, forecasting dH∕dt still remains a challenge. We use 25 years of 10 s data from the northern European International Monitor for Auroral Geomagnetic Effects (IMAGE) magnetometer network to show that part of this problem stems from the fact that, instead of the primary ionospheric currents, the measured dH∕dt is dominated by the signature from the secondary induced telluric currents at nearly all IMAGE stations. The largest effects due to telluric currents occur at coastal sites close to high-conducting ocean water and close to near-surface conductivity anomalies. The secondary magnetic field contribution to the total field is a few tens of percent, in accordance with earlier studies. Our results have been derived using IMAGE data and are thus only valid for the stations involved. However, it is likely that the main principle also applies to other areas. Consequently, it is recommended that the field separation into internal (telluric) and external (ionospheric and magnetospheric) parts is performed whenever feasible (i.e., a dense observation network is available).


Author(s):  
Mattia Belotti ◽  
Xin Lyu ◽  
Longkun Xu ◽  
Peter Halat ◽  
Nadim Darwish ◽  
...  

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Gen Urabe ◽  
Takashi Sato ◽  
Gomaru Nakamura ◽  
Yoshihiro Kobashigawa ◽  
Hiroshi Morioka ◽  
...  

Abstract Numerous theoretical studies have been conducted on the effects of high-voltage electric fields on proteins, but few have produced experimental evidence. To acquire experimental data for the amyloid disassemble theory, we exposed transthyretin aggregates to 1 ns 1.26 MV/cm pulsed electric fields (PEFs) to promote transthyretin degradation. The process produced no changes in pH, and the resulting temperature increases were < 1 °C. We conclude that the physical effects of PEFs, rather than thermal or chemical effects, facilitate aggregate degradation.


Sign in / Sign up

Export Citation Format

Share Document