The oligomeric state of spectrin in the rat erythrocyte membrane skeleton

1990 ◽  
Vol 68 (6) ◽  
pp. 936-943 ◽  
Author(s):  
Ross A. Avery ◽  
William J. Bettger
Keyword(s):  
Molecular Weight ◽  
Ionic Strength ◽  
High Molecular Weight ◽  
Erythrocyte Membrane ◽  
Human Erythrocyte ◽  
Protein A ◽  
Membrane Skeleton ◽  
Oligomeric State ◽  
High Molecular Weight Complex ◽  
Low Ionic Strength

The oligomeric state of spectrin in the erythrocyte membrane skeleton of the rat was investigated following extraction in a low ionic strength buffer for 24 and 96 h. All analyses were quantitively compared with preparations from human erythrocyte membranes. After nondenaturing agarose–polyacrylamide gel electrophoresis, the human samples revealed their characteristic spectrin oligomer pattern; there were high molecular weight complexes near the origin of the gel, followed by several high order oligomers, tetramers, and dimers. The pattern in the rat membrane skeleton also included tetramers and a high molecular weight complex band, but had only one oligomer and no dimers. With time the high molecular weight complex diminished and oligomers accumulated in both the rat and human, while dimers accumulated only in the human and tetramers accumulated only in the rat. Tetramers decreased with time in the human. Extraction of spectrin increased with time and was greater from rat than the human red cell membrane at both time points. The percentage of spectrin and actin in the low ionic strength extract was similar between species, as analyzed by SDS–polyacrylamide electrophoresis, staining, and densitometry. Proteins 4.1 and 4.9 were present in greater percentages in the human. The only temporal effect on monomeric protein composition was an increase of protein A in the rat. There was no species difference in protein A percentage at 24 h, but at 96 h the rat was greater than the human. The results suggest that there are significant differences in the structural arrangement of the rat and human erythrocyte membrane skeleton.Key words: spectrin, erythrocyte, membrane, cytoskeleton.

scholarly journals Role of the reticulum in the stability and shape of the isolated human erythrocyte membrane

1982 ◽  
Vol 92 (3) ◽  
pp. 714-721 ◽  
Author(s):  
Y Lange ◽  
RA Hadesman ◽  
TL Steck
Keyword(s):  
Ionic Strength ◽  
Erythrocyte Membrane ◽  
Human Erythrocyte ◽  
Time Course ◽  
Isotonic Saline ◽  
Human Erythrocyte Membrane ◽  
Wide Range ◽  
Cell Stability ◽  
Mechanically Stabilized ◽  
Low Ionic Strength

In order to examine the widely held hypothesis that the reticulum of proteins which covers the cytoplamsic surface of the human erythrocyte membrane controls cell stability and shape, we have assessed some of its properties. The reticulum, freed of the bilayer by extraction with Triton X-100, was found to be mechanically stable at physiological ionic strength but physically unstable at low ionic strength. The reticulum broke down after a characteristic lag period which decreased 500-fold between 0 degrees and 37 degrees C. The release of polypeptide band 4.1 from the reticulum preceded that of spectrin and actin, suggesting that band 4.1 might stabilize the ensemble but is not essential to its integrity. The time-course of breakdown was similar for ghosts, the reticulum inside of ghosts, and the isolated reticulum. However, at very low ionic strength, the reticulum was less stable within the ghost than when free; at higher ionic strength, the reverse was true. Over a wide range of conditions the membrane broke down to vesicles just as the reticulum disintegrated, presumably because the bilayer was mechanically stabilized by this network. The volume of both ghosts and naked reticula varied inversely and reversibly with ionic strength. The volume of the naked reticulum varied far more widely than the ghost, suggesting that its deformation was normally limited by the less extensible bilayer. The contour of the isolated reticulum was discoid and often dimpled or indented, as visualized in the fluorescence microscope after labeling of the ghosts with fluoroscein isothiocyanate. Reticula derived from ghosts which had lost the ability to crenate in isotonic saline were shriveled, even though the bilayer was smooth and expanded. Conversly, ghosts crenated by dinitrophenol yielded smooth, expanded reticula. We conclude that the reticulum is a durable, flexible, and elastic network which assumes and stabilizes the contour of the membrane but is not responsible for its crenation.

scholarly journals Production and characterisation of a marine Halomonas surface-active exopolymer

2019 ◽  
Vol 104 (3) ◽  
pp. 1063-1076
Author(s):  
Tony Gutierrez ◽  
Gordon Morris ◽  
Dave Ellis ◽  
Barbara Mulloy ◽  
Michael D. Aitken
Keyword(s):  
Molecular Weight ◽  
Ionic Strength ◽  
High Molecular Weight ◽  
Positive Influence ◽  
Contaminated Sites ◽  
Crude Oils ◽  
Magnetic Resonance Spectroscopic Analysis ◽  
Surface Active ◽  
Low Ionic Strength ◽  
Pure Hydrocarbon

AbstractDuring screening for novel emulsifiers and surfactants, a marine gammaproteobacterium, Halomonas sp. MCTG39a, was isolated and selected for its production of an extracellular emulsifying agent, P39a. This polymer was produced by the new isolate during growth in a modified Zobell’s 2216 medium amended with 1% glucose, and was extractable by cold ethanol precipitation. Chemical, chromatographic and nuclear magnetic resonance spectroscopic analysis confirmed P39a to be a high-molecular-weight (~ 261,000 g/mol) glycoprotein composed of carbohydrate (17.2%) and protein (36.4%). The polymer exhibited high emulsifying activities against a range of oil substrates that included straight-chain aliphatics, mono- and alkyl- aromatics and cycloparaffins. In general, higher emulsification values were measured under low (0.1 M PBS) compared to high (synthetic seawater) ionic strength conditions, indicating that low ionic strength is more favourable for emulsification by the P39a polymer. However, as observed with other bacterial emulsifying agents, the polymer emulsified some aromatic hydrocarbon species, as well as refined and crude oils, more effectively under high ionic strength conditions, which we posit could be due to steric adsorption to these substrates as may be conferred by the protein fraction of the polymer. Furthermore, the polymer effected a positive influence on the degradation of phenanthrene by other marine bacteria, such as the specialist PAH-degrader Polycyclovorans algicola. Collectively, based on the ability of this Halomonas high-molecular-weight glycoprotein to emulsify a range of pure hydrocarbon species, as well as refined and crude oils, it shows promise for the bioremediation of contaminated sites.

scholarly journals Enhanced reactive lysis of paroxysmal nocturnal hemoglobinuria erythrocytes. Studies on C9 binding and incorporation into high molecular weight complexes.

1986 ◽  
Vol 164 (4) ◽  
pp. 981-997 ◽  
Author(s):  
S I Rosenfeld ◽  
D E Jenkins ◽  
J P Leddy
Keyword(s):  
Molecular Weight ◽  
Ionic Strength ◽  
High Molecular Weight ◽  
Paroxysmal Nocturnal Hemoglobinuria ◽  
Specific Binding ◽  
Type Iii ◽  
Normal Human ◽  
Membrane Bound ◽  
Low Ionic Strength

As part of a broader analysis of the mechanism(s) by which the most sensitive (type III) paroxysmal nocturnal hemoglobinuria (PNH) erythrocytes are excessively sensitive to reactive lysis by isolated C5b6, C7, C8, and C9, we have compared type III PNH (PNH-III) and normal human E in respect to both total specific binding of 125I-C9 and the proportion of cell-bound C9 appearing in high molecular weight (HMW) complexes. In a previous report, we found that after exposure to purified C5b6 and 125I-C7, specific C7 binding and, by implication, EC5b-7 formation were equal for PNH-III E and normal E. In the present study, C8-dependent binding of 125I-C9 to PNH-III EC5b-7 and normal EC5b-7 was also similar, although lysis of the PNH-III E was up to five times greater; that is, PNH-III E required fewer bound C9 molecules to produce an effective lytic site than did normal E. To quantify radioactivity in monomeric and HMW forms of membrane-bound C9, lysed and unlysed E were subjected to low ionic strength buffers to convert all E to ghosts. These ghosts were solubilized in 0.1 or 2% SDS (without reduction) and electrophoresed on 2.4-11% polyacrylamide gradient gels followed by autoradiography and densitometric scanning. With 0.1% SDS, broad, heterodisperse zones of HMW C9 were recovered from both PNH and normal ghosts; the amounts of C9 incorporated into the HMW complexes were similar for PNH-III E and normal E. In selected experiments, 125I-C7 could be shown in these same HMW bands. When membranes were solubilized in 2% SDS, the overall proportion of HMW C9 complexes compared with dimer and monomer C9 was reduced on both PNH and normal membranes. In many, but not all experiments, more of the highest mol wt C9 complexes were detected from PNH-III E membranes solubilized in 2% SDS than from normal or PNH-II E membranes similarly treated. When antibody-sensitized E were lysed by purified C1-C9, PNH-III EA bound far more C9 than did normal EA, and both lysis and C9 incorporation into HMW complexes were markedly and proportionately increased over normal; however, lytic efficiency of 125I-C9 bound to PNH EA was equal to or less than that bound to normal EA.(ABSTRACT TRUNCATED AT 250 WORDS)

P4-129 Genetic study of APH-1 and PEN-2, components of presenilin high molecular weight complex

2004 ◽  
Vol 25 ◽  
pp. S512
Author(s):  
Toshitaka Kawarai ◽  
Antonio Orlacchio ◽  
Ekaterina Rogaeva ◽  
Susan Ling ◽  
Hiroshi Hasegawa ◽  
...  
Keyword(s):  
Molecular Weight ◽  
High Molecular Weight ◽  
Genetic Study ◽  
High Molecular Weight Complex
Sign in / Sign up

Export Citation Format

Share Document