Self-Organizing Map for Fingerprinting-Based Cooperative Localization in Dynamic Indoor Environments

2015 ◽  
Vol 03 (03) ◽  
pp. 171-183
Author(s):  
Wendong Xiao ◽  
Apostolia Papapostolou ◽  
Hakima Chaouchi ◽  
Ming Wei

Wireless Local Area Network (WLAN) fingerprinting methods based on 802.11 signal strength are becoming increasingly the dominating indoor positioning techniques, due to their independence from radio propagation models and cost-effectiveness in terms of hardware and deployment requirements. However, frequent environmental changes cause inconsistency between the fingerprints stored in the radio map and the current radio behavior, thus jeopardizing their accuracy. Re-calibration of the area for updating the radio map incurs considerable amount of time and manual effort. In this paper, we aim to overcome this limitation by adapting to the new radio characteristics through user cooperation and thus eliminating the need of re-calibration. To that end, we propose a cooperative learning algorithm, whereby users exchange their real-time signal measurements in order to refine their estimated locations. The refinement process relies on the neural network structure of self-organizing map (SOM) which is of special interest for localization due to the key property of its neurons in self-organizing in geographic structures based on their similarity to a high-dimensional input data. In our solution, each user is regarded as a neuron of its local SOM network and runs in distributed fashion a modified version of SOM learning algorithm by considering its signal relationship with its neighboring users. Performance evaluation results demonstrate accuracy improvement over both the baseline deterministic and probabilistic fingerprinting approaches, while keeping the communication and computational overheads low.

Sensors ◽  
2018 ◽  
Vol 18 (10) ◽  
pp. 3579 ◽  
Author(s):  
Yongliang Sun ◽  
Yu He ◽  
Weixiao Meng ◽  
Xinggan Zhang

In the last decade, fingerprinting localization using wireless local area network (WLAN) has been paid lots of attention. However, this method needs to establish a database called radio map in the off-line stage, which is a labor-intensive and time-consuming process. To save the radio map establishment cost and improve localization performance, in this paper, we first propose a Voronoi diagram and crowdsourcing-based radio map interpolation method. The interpolation method optimizes propagation model parameters for each Voronoi cell using the received signal strength (RSS) and location coordinates of crowdsourcing points and estimates the RSS samples of interpolation points with the optimized propagation model parameters to establish a new radio map. Then a general regression neural network (GRNN) is employed to fuse the new and original radio maps established through interpolation and manual operation, respectively, and also used as a fingerprinting localization algorithm to compute localization coordinates. The experimental results demonstrate that our proposed GRNN fingerprinting localization system with the fused radio map is able to considerably improve the localization performance.


Sensors ◽  
2020 ◽  
Vol 20 (10) ◽  
pp. 2818
Author(s):  
Ruolin Guo ◽  
Danyang Qin ◽  
Min Zhao ◽  
Xinxin Wang

The crowdsourcing-based wireless local area network (WLAN) indoor localization system has been widely promoted for the effective reduction of the workload from the offline phase data collection while constructing radio maps. Aiming at the problem of the diverse terminal devices and the inaccurate location annotation of the crowdsourced samples, which will result in the construction of the wrong radio map, an effective indoor radio map construction scheme (RMPAEC) is proposed based on position adjustment and equipment calibration. The RMPAEC consists of three main modules: terminal equipment calibration, pedestrian dead reckoning (PDR) estimated position adjustment, and fingerprint amendment. A position adjustment algorithm based on selective particle filtering is used by RMPAEC to reduce the cumulative error in PDR tracking. Moreover, an inter-device calibration algorithm is put forward based on receiver pattern analysis to obtain a device-independent grid fingerprint. The experimental results demonstrate that the proposed solution achieves higher localization accuracy than the peer schemes, and it possesses good effectiveness at the same time.


Electronics ◽  
2018 ◽  
Vol 7 (11) ◽  
pp. 290 ◽  
Author(s):  
Tomoki Murakami ◽  
Masahiko Miyazaki ◽  
Shigemi Ishida ◽  
Akira Fukuda

Sensing services for the detection of humans and animals by analyzing the environmental changes of wireless local area network (WLAN) signals have attracted attention in recent years. In object detection using WLAN signals, a widely known technique is the use of time changes in received signal strength indicators that are easily measured between WLAN devices. Utilizing channel response, including power and phase values per subcarrier on multiple input multiple output (MIMO), the orthogonal frequency division multiplexing transmission was researched as channel state information (CSI) to further improve detection accuracy. This paper describes a WLAN-based CSI monitoring system that efficiently acquires the CSI of multiple links in a target area where multiple CSI measuring stations are distributed. In the system, a novel CSI monitoring station captures wireless packets sent within the area and extracts CSI by analyzing the packets on the sounding protocol, specified by IEEE 802.11ac. The paper also describes the system configuration and shows that indoor experimental measurements confirmed the system’s feasibility.


Author(s):  
Chaithra. H. U ◽  
Vani H.R

Now a days in Wireless Local Area Networks (WLANs) used in different fields because its well-suited simulator and higher flexibility. The concept of WLAN  with  advanced 5th Generation technologies, related to a Internet-of-Thing (IOT). In this project, representing the Network Simulator (NS-2) used linked-level simulators for Wireless Local Area Networks and still utilized IEEE 802.11g/n/ac with advanced IEEE 802.11ah/af technology. Realization of the whole Wireless Local Area Networking linked-level simulators inspired by the recognized Vienna Long Term Evolution- simulators. As a outcome, this is achieved to link together that simulator to detailed performances of Wireless Local Area Networking with Long Term Evolution, operated in the similar RF bands. From the advanced 5th Generation support cellular networking, such explore is main because different coexistences scenario can arise linking wireless communicating system to the ISM and UHF bands.


Jurnal Teknik ◽  
2018 ◽  
Vol 7 (1) ◽  
Author(s):  
Heru Abrianto

Microstrip antenna which designed with dual feeding at 2.4 GHz and 5.8 GHz can meet WLAN (Wireless Local Area Network) application.Antenna fabrication use PCB FR4 double layer with thickness 1.6 mm and dielectric constant value 4.4. The length of patch antenna according to calculation 28.63 mm, but to get needed parameter length of patch should be optimized to 53 mm. After examination, this antenna has VSWR 1.212 at 2.42 GHz and 1.502 at 5.8 GHz, RL -13.94 dB at 2.42 GHz and -20.357 dB at 5.8 GHz, gain of antenna 6.16 dB at 2.42 GHz and 6.91 dB at 5.8 GHz, the radiation pattern is bidirectional. Keywords : microstrip antenna, wireless LAN, dual polarization, single feeding technique


2018 ◽  
Author(s):  
Kiramat

IEEE 802.11 is a set of media access control (MAC) and physical layer (PHY) specifications for implementing wireless local area network (WLAN) computer communications. Maintained by the Institute of Electrical and Electronics Engineers (IEEE) LAN/MAN Standards Committee (IEEE 802). This document highlights the main features of IEEE 802.11n variant such as MIMO, frame aggregation and beamforming along with the problems in this variant and their solutions


2020 ◽  
Vol 1550 ◽  
pp. 032078
Author(s):  
Kaigang Fan ◽  
Xin Chen ◽  
Biao Zhao ◽  
Jiale Wang ◽  
Wenbin Cui ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document