scholarly journals Analytical Solution of General Bagley-Torvik Equation

2015 ◽  
Vol 2015 ◽  
pp. 1-4 ◽  
Author(s):  
William Labecca ◽  
Osvaldo Guimarães ◽  
José Roberto C. Piqueira
Keyword(s):  
Numerical Methods ◽  
Analytical Solution ◽  
Laplace Transform ◽  
Analytical Solutions ◽  
Empirical Data ◽  
Fractional Derivatives ◽  
Initial Conditions ◽  
Polynomial Form ◽  
Inhomogeneous Term

Bagley-Torvik equation appears in viscoelasticity problems where fractional derivatives seem to play an important role concerning empirical data. There are several works treating this equation by using numerical methods and analytic formulations. However, the analytical solutions presented in the literature consider particular cases of boundary and initial conditions, with inhomogeneous term often expressed in polynomial form. Here, by using Laplace transform methodology, the general inhomogeneous case is solved without restrictions in boundary and initial conditions. The generalized Mittag-Leffler functions with three parameters are used and the solutions presented are expressed in terms of Wiman’s functions and their derivatives.

scholarly journals 2D Plane Strain Consolidation Process of Unsaturated Soil with Vertical Impeded Drainage Boundaries

Processes ◽  
2018 ◽  
Vol 7 (1) ◽  
pp. 5 ◽  
Author(s):  
Minghua Huang ◽  
Dun Li
Keyword(s):  
Analytical Solution ◽  
Laplace Transform ◽  
Plane Strain ◽  
Unsaturated Soil ◽  
Analytical Solutions ◽  
Soil Layer ◽  
Permeability Ratio ◽  
Consolidation Process ◽  
The Time Domain ◽  
Excess Pore Pressures

The consolidation process of soil stratum is a common issue in geotechnical engineering. In this paper, the two-dimensional (2D) plane strain consolidation process of unsaturated soil was studied by incorporating vertical impeded drainage boundaries. The eigenfunction expansion and Laplace transform techniques were adopted to transform the partial differential equations for both the air and water phases into two ordinary equations, which can be easily solved. Then, the semi-analytical solutions for the excess pore-pressures and the soil layer settlement were derived in the Laplace domain. The final results in the time domain could be computed by performing the numerical inversion of Laplace transform. Furthermore, two comparisons were presented to verify the accuracy of the proposed semi-analytical solutions. It was found that the semi-analytical solution agreed well with the finite difference solution and the previous analytical solution from the literature. Finally, the 2D plane strain consolidation process of unsaturated soil under different drainage efficiencies of the vertical boundaries was illustrated, and the influences of the air-water permeability ratio, the anisotropic permeability ratio and the spacing-depth ratio were investigated.

scholarly journals Optimal Perturbation Iteration Method for Solving Fractional Model of Damped Burgers’ Equation

Symmetry ◽  
2020 ◽  
Vol 12 (6) ◽  
pp. 958 ◽  
Author(s):  
Sinan Deniz ◽  
Ali Konuralp ◽  
Mnauel De la Sen
Keyword(s):  
Laplace Transform ◽  
Analytical Solutions ◽  
Differential Form ◽  
Fractional Derivatives ◽  
Burgers Equation ◽  
Optimal Perturbation ◽  
Fractional Differential ◽  
Fractional Type ◽  
Iteration Technique ◽  
Fractional Differential Form

The newly constructed optimal perturbation iteration procedure with Laplace transform is applied to obtain the new approximate semi-analytical solutions of the fractional type of damped Burgers’ equation. The classical damped Burgers’ equation is remodeled to fractional differential form via the Atangana–Baleanu fractional derivatives described with the help of the Mittag–Leffler function. To display the efficiency of the proposed optimal perturbation iteration technique, an extended example is deeply analyzed.

ANALYTICAL SOLUTIONS TO BRAJINSKII'S EQUATIONS FOR NUCLEAR FUSION PLASMA BY USING ICF METHOD

2008 ◽  
Vol 17 (06) ◽  
pp. 1131-1139
Author(s):  
S. N. HOSSEINIMOTLAGH
Keyword(s):  
Laplace Transform ◽  
Analytical Solutions ◽  
Initial Conditions ◽  
Fusion Reaction ◽  
Main Tool ◽  
Fusion Plasma ◽  
Arbitrary Boundary ◽  
One Dimensional ◽  
Special Cases ◽  
Laplace Transform Technique

Brajinskii's equations are the fundamental relations governing the behavior of the plasma produced during a fusion reaction, especially ICF plasma. These equations contains six partial differentials coupled together. In this paper we have tried to give analytical solutions to these equations using a one-dimensional method. Laplace transform technique is the main tool to do that with an arbitrary boundary and initial conditions for some special cases.

scholarly journals Proposed Framework for Comparison of Continuous Probabilistic Genotyping Systems amongst Different Laboratories

2021 ◽  
Vol 1 (1) ◽  
pp. 33-45
Author(s):  
Dennis McNevin ◽  
Kirsty Wright ◽  
Mark Barash ◽  
Sara Gomes ◽  
Allan Jamieson ◽  
...  
Keyword(s):  
Numerical Methods ◽  
Analytical Solutions ◽  
Peak Height ◽  
Dna Profiling ◽  
Likelihood Ratios ◽  
Dna Mixtures ◽  
Individual Laboratory ◽  
Multiple Variables

Continuous probabilistic genotyping (PG) systems are becoming the default method for calculating likelihood ratios (LRs) for competing propositions about DNA mixtures. Calculation of the LR relies on numerical methods and simultaneous probabilistic simulations of multiple variables rather than on analytical solutions alone. Some also require modelling of individual laboratory processes that give rise to electropherogram artefacts and peak height variance. For these reasons, it has been argued that any LR produced by continuous PG is unique and cannot be compared with another. We challenge this assumption and demonstrate that there are a set of conditions defining specific DNA mixtures which can produce an aspirational LR and thereby provide a measure of reproducibility for DNA profiling systems incorporating PG. Such DNA mixtures could serve as the basis for inter-laboratory comparisons, even when different STR amplification kits are employed. We propose a procedure for an inter-laboratory comparison consistent with these conditions.

scholarly journals Quadrature Integration Techniques for Random Hyperbolic PDE Problems

Mathematics ◽  
2021 ◽  
Vol 9 (2) ◽  
pp. 160
Author(s):  
Rafael Company ◽  
Vera N. Egorova ◽  
Lucas Jódar
Keyword(s):  
Numerical Methods ◽  
Laplace Transform ◽  
Quadrature Rule ◽  
Inverse Laplace Transform ◽  
Process Time ◽  
Efficient Computation ◽  
Hyperbolic Pde ◽  
Numerical Convergence ◽  
Laplace Transform Technique ◽  
Integration Techniques

In this paper, we consider random hyperbolic partial differential equation (PDE) problems following the mean square approach and Laplace transform technique. Randomness requires not only the computation of the approximating stochastic processes, but also its statistical moments. Hence, appropriate numerical methods should allow for the efficient computation of the expectation and variance. Here, we analyse different numerical methods around the inverse Laplace transform and its evaluation by using several integration techniques, including midpoint quadrature rule, Gauss–Laguerre quadrature and its extensions, and the Talbot algorithm. Simulations, numerical convergence, and computational process time with experiments are shown.

Zur Lösung der BETHE-GOLDSTONE-Gleichung bei nicht-verschwindendem Gesamtimpuls I

1963 ◽  
Vol 18 (4) ◽  
pp. 531-538
Author(s):  
Dallas T. Hayes
Keyword(s):  
Approximate Solution ◽  
Analytical Solution ◽  
Nuclear Matter ◽  
Analytical Solutions ◽  
Projection Operator ◽  
Center Of Mass ◽  
Separable Potential ◽  
Localized Solutions ◽  
Non Local ◽  
Square Well

Localized solutions of the BETHE—GOLDSTONE equation for two nucleons in nuclear matter are examined as a function of the center-of-mass momentum (c. m. m.) of the two nucleons. The equation depends upon the c. m. m. as parameter due to the dependence upon the c. m. m. of the projection operator appearing in the equation. An analytical solution of the equation is obtained for a non-local but separable potential, whereby a numerical solution is also obtained. An approximate solution for small c. m. m. is calculated for a square-well potential. In the range of the approximation the two analytical solutions agree exactly.

scholarly journals Numerical methods for solving the multi-term time-fractional wave-diffusion equation

2013 ◽  
Vol 16 (1) ◽  
Author(s):  
Fawang Liu ◽  
Mark Meerschaert ◽  
Robert McGough ◽  
Pinghui Zhuang ◽  
Qingxia Liu
Keyword(s):  
Numerical Methods ◽  
Theoretical Analysis ◽  
Diffusion Equation ◽  
Fractional Derivatives ◽  
Fractional Laplacian ◽  
Numerical Results ◽  
Diffusion Equations ◽  
Time Space ◽  
Methods And Techniques ◽  
Wave Diffusion

AbstractIn this paper, the multi-term time-fractional wave-diffusion equations are considered. The multi-term time fractional derivatives are defined in the Caputo sense, whose orders belong to the intervals [0,1], [1,2), [0,2), [0,3), [2,3) and [2,4), respectively. Some computationally effective numerical methods are proposed for simulating the multi-term time-fractional wave-diffusion equations. The numerical results demonstrate the effectiveness of theoretical analysis. These methods and techniques can also be extended to other kinds of the multi-term fractional time-space models with fractional Laplacian.

A Numerical Scheme for a Class of Parametric Problem of Fractional Variational Calculus

2012 ◽  
Vol 7 (2) ◽  
Author(s):  
Om P. Agrawal ◽  
M. Mehedi Hasan ◽  
X. W. Tangpong
Keyword(s):  
Analytical Solutions ◽  
Numerical Scheme ◽  
Fractional Derivatives ◽  
Optimization Problems ◽  
Practical Interest ◽  
Variational Calculus ◽  
Functional Minimization ◽  
Orthogonal Functions ◽  
Order Problem ◽  
Parametric Problem

Fractional derivatives (FDs) or derivatives of arbitrary order have been used in many applications, and it is envisioned that in the future they will appear in many functional minimization problems of practical interest. Since fractional derivatives have such properties as being non-local, it can be extremely challenging to find analytical solutions for fractional parametric optimization problems, and in many cases, analytical solutions may not exist. Therefore, it is of great importance to develop numerical methods for such problems. This paper presents a numerical scheme for a linear functional minimization problem that involves FD terms. The FD is defined in terms of the Riemann-Liouville definition; however, the scheme will also apply to Caputo derivatives, as well as other definitions of fractional derivatives. In this scheme, the spatial domain is discretized into several subdomains and 2-node one-dimensional linear elements are adopted to approximate the solution and its fractional derivative at point within the domain. The fractional optimization problem is converted to an eigenvalue problem, the solution of which leads to fractional orthogonal functions. Convergence study of the number of elements and error analysis of the results ensure that the algorithm yields stable results. Various fractional orders of derivative are considered, and as the order approaches the integer value of 1, the solution recovers the analytical result for the corresponding integer order problem.

scholarly journals Dynamic Analytical Solution of a Piezoelectric Stack Utilized in an Actuator and a Generator

2018 ◽  
Vol 8 (10) ◽  
pp. 1779 ◽  
Author(s):  
Xinnan Liu ◽  
Jianjun Wang ◽  
Weijie Li
Keyword(s):  
Analytical Solution ◽  
Dynamic Characteristics ◽  
Analytical Solutions ◽  
External Load ◽  
Piezoelectric Actuators ◽  
Displacement Method ◽  
Proposed Model ◽  
Special Cases ◽  
Piezoelectric Stacks ◽  
Comprehensive Manner

This paper presents the dynamic analytical solution of a piezoelectric stack utilized in an actuator and a generator based on the linear piezo-elasticity theory. The solutions for two different kinds of piezoelectric stacks under external load were obtained using the displacement method. The effects of load frequency and load amplitude on the dynamic characteristics of the stacks were discussed. The analytical solutions were validated using the available experimental results in special cases. The proposed model is able not only to predict the output properties of the devices, but also to reflect the inner electrical and mechanical components, which is helpful for designing piezoelectric actuators and generators in a comprehensive manner.

Sign in / Sign up

Export Citation Format

Share Document