scholarly journals Study of Wind Loads and Wind Speed Amplifications on High-Rise Building with Opening by Numerical Simulation and Wind Tunnel Test

2020 ◽  
Vol 2020 ◽  
pp. 1-24
Author(s):  
Fu-Bin Chen ◽  
Xiao-Lu Wang ◽  
Yun Zhao ◽  
Yuan-Bo Li ◽  
Qiu-Sheng Li ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Wind Speed ◽  
Wind Tunnel ◽  
Wind Pressure ◽  
Wind Loads ◽  
Structural Safety ◽  
Pressure Coefficients ◽  
High Rise ◽  
High Rise Building ◽  
The Mean

High-rise buildings are very sensitive to wind excitations, and wind-induced responses have always been the key factors for structural design. Facade openings have often been used as aerodynamic measures for wind-resistant design of high-rise buildings to meet the requirement of structural safety and comfort. Obvious wind speed amplifications can also be observed inside the openings. Therefore, implementing wind turbines in the openings is of great importance for the utilization of abundant wind energy resources in high-rise buildings and the development of green buildings. Based on numerical simulation and wind tunnel testing, the wind loads and wind speed amplifications on high-rise buildings with openings are investigated in detail. The three-dimensional numerical simulation for wind effects on high-rise building with openings was firstly carried out on FLUENT 15.0 platform by SST k − ε model. The mean wind pressure coefficients and the wind flow characteristics were obtained. The wind speed amplifications at the opening were analyzed, and the distribution law of wind speed in the openings is presented. Meanwhile, a series of wind tunnel tests were conducted to assess the mean and fluctuating wind pressure coefficients in high-rise building models with various opening rates. The variation of wind pressure distribution at typical measuring layers with wind direction was analyzed. Finally, the wind speed amplifications in the openings were studied and verified by the numerical simulation results.

Effects of Geometrical Factors on Wind Pressure Characteristics of Cylindrical Roofs with Wind Tunnel Tests

2013 ◽  
Vol 351-352 ◽  
pp. 284-289 ◽  
Author(s):  
Bo Chen ◽  
Qing Shan Yang
Keyword(s):  
Wind Tunnel ◽  
Probability Distributions ◽  
Wind Pressure ◽  
Wind Tunnel Tests ◽  
Pressure Coefficients ◽  
High Rise ◽  
Mean Pressure ◽  
The Mean ◽  
Geometrical Factors ◽  
Pressure Characteristics

With wind tunnel tests, simultaneous pressure measurements are made on 4 cylindrical roof models with different rise-span ratios and roof inclinations. Effects of these geometrical factors on wind pressure characteristics of the roofs are investigated, including mean pressure coefficients, RMS pressure coefficients, skewness, kurtosis, and probability distributions of wind pressure. Results show that the mean vertical wind force coefficient of high rise-span ratio roof is larger than that of the low rise-span ration roof; the mean pressure coefficient distribution of the low rise-span ratio roof is similar to that of RMS pressure coefficients and the skewness (or the kurtosis); the vortex center line occurs at the windward edge for the low rise-span ratio roof with inclination 0°, which occurs at the roof apex for the high rise-span ratio roof. The roof inclination has more effects on the low rise-span ratio roof, the vortex moves from the windward edge to the apex for the roof with inclination 7.2°when the wind flows from the low eave to the high eave. The distribution of the skewness is strongly correlative to that of the kurtosis. The probability distributions of the roof edges and corners deviate obviously from the Guass distribution. If this point is ignored, the peak suction pressure will be underestimated.

scholarly journals Probability Characteristics, Area Reduction, and Wind Directionality Effects of Extreme Pressure Coefficients of High-Rise Buildings

2021 ◽  
Vol 11 (15) ◽  
pp. 7121
Author(s):  
Shouke Li ◽  
Feipeng Xiao ◽  
Yunfeng Zou ◽  
Shouying Li ◽  
Shucheng Yang ◽  
...  
Keyword(s):  
Probability Distribution ◽  
Pressure Coefficient ◽  
Wind Pressure ◽  
Extreme Pressure ◽  
Distribution Law ◽  
Distribution Fitting ◽  
Pressure Coefficients ◽  
High Rise ◽  
Area Reduction ◽  
The Mean

Wind tunnel tests are carried out for the Commonwealth Advisory Aeronautical Research Council (CAARC) high-rise building with a scale of 1:400 in exposure categories D. The distribution law of extreme pressure coefficients under different conditions is studied. Probability distribution fitting is performed on the measured area-averaged extreme pressure coefficients. The general extreme value (GEV) distribution is preferred for probability distribution fitting of extreme pressure coefficients. From the comparison between the area-averaged coefficients and the value from GB50009-2012, it is indicated that the wind load coefficients from GB50009-2012 may be non-conservative for the CAARC building. The area reduction effect on the extreme wind pressure is smaller than that on the mean wind pressure from the code. The recommended formula of the area reduction factor for the extreme pressure coefficient is proposed in this study. It is found that the mean and the coefficient of variation (COV) for the directionality factors are 0.85 and 0.04, respectively, when the orientation of the building is given. If the uniform distribution is given for the building’s orientation, the mean value of the directionality factors is 0.88, which is close to the directionality factor of 0.90 given in the Chinese specifications.

scholarly journals Wind tunnel tests of aerodynamic interference of the high-rise building and its nearest city surroundings

2013 ◽  
Vol 12 (2) ◽  
pp. 079-086
Author(s):  
Grzegorz Bosak
Keyword(s):  
Wind Tunnel ◽  
Building Design ◽  
Wind Pressure ◽  
Horizontal Wind ◽  
Wind Tunnel Tests ◽  
Wind Action ◽  
Building Model ◽  
High Rise ◽  
High Rise Building ◽  
Aerodynamic Interference

The paper summarizes the results of wind tunnel tests of the influence of aerodynamic interference on wind action of a high-rise building design in Warsaw. Measurements were accomplished in Wind Engineering Laboratory of Cracow University of Technology. Wind pressures on external surfaces of the building model were acquired in two different situations. Firstly, only the building model was placed in the tunnel working section, secondly, the building model with the nearest surroundings was taken under consideration. A study of the character of wind action differences caused by the nearest surroundings of the building was the main aim of the paper. Wind pressure coefficients on the external building surfaces and the difference of horizontal wind action on full scale were compared.

WIND PRESSURE DISTRIBUTION ON LOW-RISE BUILDINGS WITH CYLINDRICAL ROOFS

2015 ◽  
Vol 2 (1) ◽  
Author(s):  
Astha Verma ◽  
Ashok Kumar Ahuja
Keyword(s):  
Boundary Layer ◽  
Experimental Study ◽  
Wind Tunnel ◽  
Pressure Distribution ◽  
Open Circuit ◽  
Wind Pressure ◽  
Wind Loads ◽  
Wind Loading ◽  
Pressure Coefficients ◽  
Available Information

Wind is one of the important loads to be considered while designing the roofs of low-rise buildings. The structural designers refer to relevant code of practices of various countries dealing with wind loads while designing building roofs. However, available information regarding wind pressure coefficients on cylindrical roofs is limited to single span only. Information about wind pressure coefficients on multi-span cylindrical roofs is not available in standards on wind loads. Present paper describes the details of the experimental study carried out on the models of low-rise buildings with multi-span cylindrical roofs in an open circuit boundary layer wind tunnel. Wind pressure values are measured at many pressure points made on roof surface of the rigid models under varying wind incidence angles. Two cases namely, single-span and two-span are considered. The experimental results are presented in the form of contours of mean wind pressure coefficients. Results presented in the paper are of great use for the structural designers while designing buildings with cylindrical roofs. These values can also be used by the experts responsible for revising wind loading codes from time to time.

Wind Load Characteristics of Tall Building with Atrium

2013 ◽  
Vol 639-640 ◽  
pp. 515-522
Author(s):  
Yong Gui Li ◽  
Q.S. Li
Keyword(s):  
Wind Tunnel ◽  
Critical Role ◽  
Pressure Coefficient ◽  
Tall Building ◽  
Wind Pressure ◽  
Wind Loads ◽  
Design Guideline ◽  
Pressure Coefficients ◽  
Opening Ratio ◽  
Wind Pressures

Wind tunnel test of 1:500 rigid model of tall building with atrium was carried out. Based on the experimental results, characteristics of wind pressures on atrium facades and wind loads on the structure were investigated in detail. The results show that the formation of flow separation on the building top plays a critical role in the generation of wind pressures on the atrium facades. Meanwhile, wind pressure coefficient distributions on the atrium facades are found to be relatively uniform. Moreover, the horizontal and vertical correlations of pressure coefficient exhibit high at most locations on atrium facades. With the increasing of the opening ratio, the mean wind pressure coefficients first decreased and then stabilized, and the fluctuating wind pressure coefficients first decreased and then increased. A design guideline for the wind-resistant design of atrium facades was proposed, and the results predicted by the proposed guideline were in good agreement with those from the wind tunnel tests, indicating that the proposed guideline can be used in engineering applications. When the opening ratio is no more than 5.33%, the effect of the facade pressures within the atrium on the wind loads on the structure can be ignored. For such cases, the wind-resistant design for a tall building with atrium can refer to that of a similar shape tall building without atrium.

scholarly journals Wind Pressure Coefficients on Greenhouse Structures

Agriculture ◽  
2020 ◽  
Vol 10 (5) ◽  
pp. 149 ◽  
Author(s):  
Chrysanthos Maraveas
Keyword(s):  
Structural Engineering ◽  
Experimental Studies ◽  
Measurement Data ◽  
Wind Pressure ◽  
Wind Loads ◽  
Structural Safety ◽  
Strong Wind ◽  
Design Standards ◽  
Pressure Coefficients ◽  
Research Studies

Commercial production greenhouses are widely used to produce plants and crops. From the structural engineering viewpoint, among the loads that act on greenhouses, wind and snow loads are the major ones. This paper focuses on the former, particularly on wind pressure coefficients. Design and construction of greenhouses should consider wind loads in order to ensure seamless operation, overall stability, durability, and safety, even though human occupancy is limited. Classification and design of greenhouses is typically based on European standards, which cover a variety of geometries and conditions. Some recent research studies suggest, however, that greenhouse design standards should be revised to ensure structural safety of greenhouses subject to strong wind loads. Triggered by this recent outcomes, this paper reviews existing literature on the topic: (a) briefly presenting the state of the art methods for determining wind pressures on greenhouses; (b) comparing the EN 13031-1 pressure coefficients with those stemming from recent experimental studies on single-span pitched and arched roof greenhouses in South Korea; and (c) summarizing most recent comparative results for multi-span greenhouses. It concludes that these recent research studies are not enough to justify revision of EN 13031-1, and more measurement data and experimental or numerical studies are necessary to justify such a conclusion.

Analysis of Wind Impacts on the High-Rise Building "Iset Tower"

2013 ◽  
Vol 281 ◽  
pp. 639-644 ◽  
Author(s):  
V.N. Alekhin ◽  
A.A. Antipin ◽  
S.N. Gorodilov
Keyword(s):  
Numerical Simulation ◽  
Numerical Analysis ◽  
Qualitative Agreement ◽  
Numerical Results ◽  
Experimental Results ◽  
Wind Loads ◽  
Wind Effects ◽  
High Rise ◽  
High Rise Building

In the paper the wind loads on 52 flore building "Iset Tower" are investigated. Distribution of pressure to the building and velocities are presented. Performed calculations show qualitative agreement with experimental results. According to the results of numerical simulation of wind effects it can be concluded that both aerodynamic experiments and numerical analysis are needed in the design. If there is coincidence of experimental and numerical results then they can be used to calculate the skeleton of the building.

Wind Tunnel Test of Tall Buildings with Irregularities of Elevation

2014 ◽  
Vol 578-579 ◽  
pp. 1208-1211
Author(s):  
Jian Guo Zhang ◽  
Hui Min Zhuang
Keyword(s):  
Wind Tunnel ◽  
Wind Tunnel Test ◽  
Tall Buildings ◽  
Wind Pressure ◽  
High Rise ◽  
Pressure Distributions ◽  
Building Models ◽  
The Mean ◽  
Wind Pressures ◽  
Fluctuating Wind

In this paper, 2 high-rise building models with ladder and cascade irregularities of elevation were tested in a wind tunnel respectively to measure the mean and fluctuating wind pressure distributions. The mean and RMS (root-mean-square) coefficients of the drag, lift and torsion moment on the measuring layer were obtained from the wind pressures. In the direction which the buildings were positive in the wind, the variation of these above mentioned coefficients with height and the power spectrum densities of the fluctuating wind loads on sudden changed positions were analyzed in detail. Compared with the elevation regular tall building, the wind load characteristics of irregular ones were more complicated.

Sign in / Sign up

Export Citation Format

Share Document