A Study on V-Shaped Microstrip Patch MIMO Antenna

Author(s):  
Charles MacWright Thomas ◽  
Huda A. Majid ◽  
Zuhairiah Zainal Abidin ◽  
Samsul Haimi Dahlan ◽  
Mohamad Kamal A. Rahim ◽  
...  

<p>A study on the V-shaped microstrip patch antenna for multiple-input multiple-output (MIMO) communication system based on the antenna orientation is performed. First the microstrip patch antenna operating at 2.45 GHz is calculated and simulated. Next, multiple element of antennas for MIMO system is simulated and discussed. V-shaped with 45 degree slanted inward and outward is studied. The antenna properties is analyzed and compact antenna design is determined based on the simulation results. The results shows the gap between antennas can be optimized to 1 mm while maintaining low mutual coupling. The gain of the MIMO antenna is 8.42 dBi. The simulated return losses, together with the radiation patterns, are presented and discussed.</p>

Author(s):  
M. F. Ismail ◽  
H. A. Majid ◽  
C. Macwright ◽  
M. N. A. H. Shaabani ◽  
M. S. Mohd ◽  
...  

A study on the compact array microstrip patch antenna for multiple-input multiple-output (MIMO) communication system based on the antenna arrangement is performed. The 2.45 GHz rectangular array are arranged in 45 degree slanted inward and outward for each other to reduce the mutual coupling effect between the patches. The antenna properties are analyzed and compact antenna design is determined based on the simulation results. The results show the antennas can very compact while maintaining low mutual coupling. The gain of the MIMO antenna is 11.3 dBi. The simulated and tested return losses, together with the radiation patterns, are presented and discussed.


2018 ◽  
Vol 2018 ◽  
pp. 1-13 ◽  
Author(s):  
Raghad Ghalib Saadallah Alsultan ◽  
Gölge Ögücü Yetkin

E-shaped multiple-input-multiple-output (MIMO) microstrip antenna systems operating in WLAN and WiMAX bands (between 5 and 7.5 GHz) are proposed with enhanced isolation features. The systems are comprised of two antennas that are placed parallel and orthogonal to each other, respectively. According to the simulation results, the operating frequency of the MIMO antenna system is 6.3 GHz, and mutual coupling is below −18 dB in a parallel arrangement, whereas they are 6.4 GHz and −25 dB, respectively, in the orthogonal arrangement. The 2 × 3 matrix of C-shaped resonator (CSR) is proposed and placed between the antenna elements over the substrate, to reduce the mutual coupling and enhance the isolation between the antennas. More than 30 dB isolation between the array elements is achieved at the resonant frequency for both of the configurations. The essential parameters of the MIMO array such as mutual coupling, surface current distribution, envelop correlation coefficient (ECC), diversity gain (DG), and the total efficiency have been simulated to verify the reliability and the validity of the MIMO system in both parallel and orthogonal configurations. The experimental results are also provided and compared for the mutual coupling with simulated results. An adequate match between the measured and simulated results is achieved.


2013 ◽  
Vol 6 (2) ◽  
pp. 173-180 ◽  
Author(s):  
Ahmed A. Ibrahim ◽  
Mahmoud A. Abdalla ◽  
Adel B. Abdel-Rahman ◽  
Hesham F. A. Hamed

A design of low mutual coupling between two microstrip patch antennas for multi input multi output antenna is presented. The two antenna elements operate at 5.8 GHz for wireless applications. The reduction of mutual coupling between the antenna elements is achieved by using a defected ground structure (DGS). The DGS is inserted between the microstrip patch antenna elements to limit the surface waves between them. The separation between the edges of the two elements has been achieved to be only 0.058λ0. The analysis of the correlation coefficient, diversity gain and total active reflection coefficient is presented to validate the performance of the multiple-input–multiple-output (MIMO) antenna. The isolation of the proposed MIMO antenna is 28 dB at 5.8 GHz and the envelope correlation equals 0.003. Owing to these good performances each antenna can operate almost independently. A good agreement is achieved between the simulated and the measured results.


2019 ◽  
Vol 8 (1) ◽  
pp. 75-81
Author(s):  
N. Al Shalaby ◽  
S. G. El-Sherbiny

In this paper, A multiple input Multiple Output (MIMO) antenna using two Square Dielectric Resonators (SDRs) is introduced. The mutual coupling between the two SDRAs is reduced using two different methods; the first method is based on splitting a spiral slot in the ground plane, then filling the slot with dielectric material, "E.=2.2". The second method is based on inserting a copper parasitic element, having the same shape of the splitted Spiral, between the two SDRAs.  The effect of replacing the copper parasitic element with Carbon nanotubes (CNTs) parasitic element "SOC12 doped long-MWCNT BP" is also studied. The antenna system is designed to operate at 6 GHz. The analysis and simulations are carried out using finite element method (FEM). The defected ground plane method gives a maximum isolation of l8dB at element spacing of 30mm (0.6λo), whereas the parasitic element method gives a maximum isolation of 42.5dB at the same element spacing.


2021 ◽  
Vol 2021 ◽  
pp. 1-12
Author(s):  
Enze Zhang ◽  
Jinghui Qiu

A four-port dual-band dual circularly polarized (CP) stack-up patch antenna is introduced for multiple-input-multiple-output (MIMO) RFID application. The proposed antenna adopts two FR 4 substrates and one Rogers Ro4350b substrates. Two pairs of isolated ports work at FCC UHF/MW-RFID bands (0.902–0.928 and 2.4–2.485 GHz) with port isolations of 20 dB and 25 dB, respectively. Four inverted-F radiating elements fed with a 90° phase-delay feeding network realize the CP radiation at the FCC UHF-RFID band (0.902–0.928 GHz). The corner-truncated square slot and patch are implemented to obtain CP modes at the MW-RFID band. The relative impedance bandwidths in the FCC UHF and MW band are 10.9% and 9.4%, respectively, with peak gains of 4.1 and 7.2 dBic. The antenna’s MIMO performance of envelope correlation coefficient (ECC) is lower than 0.01, and diversity gain (DG) is close to 10 dB. Thanks to the stack-up configuration, the dual-band RFID antenna realizes good antenna performance with a compact size of 0.6 × 0.6 × 0.07 λ3.


2018 ◽  
Vol 10 (8) ◽  
pp. 948-955 ◽  
Author(s):  
Ling Wu ◽  
Yingqing Xia ◽  
Xia Cao ◽  
Zhengtao Xu

AbstractA simple multiple-input-multiple-output (MIMO) antenna with quad-band-notched characteristics for ultra-wideband (UWB) system is proposed and tested in the article. Based on two similar radiators, the UWB-MIMO system only occupies 22 mm × 28 mm. By etching an inverted L-like meander slot, two inverted L-shaped slots, and adding a C-shaped stub beside the feeding line, four notched bands are realized (3.25–3.6, 5.05–5.48, 5.6–6, and 7.8–8.4 GHz) to suppress interference from WiMAX, lower WLAN, upper WLAN, and uplink of X-band satellite communication system. With a T-like stub extruding from the ground plane, port isolation is effectively improved. The results show that the antenna covers 3.1–10.6 GHz UWB frequency band except four rejected bands and has high isolation of better than −20 dB over most of the frequency band. Moreover, envelope correlation coefficient and good radiation patterns also prove that the introduced antenna is suitable for UWB applications.


Frequenz ◽  
2017 ◽  
Vol 71 (11-12) ◽  
Author(s):  
A. Raza ◽  
Muhammad U. Khan ◽  
Farooq A. Tahir

AbstractIn this paper, a two element frequency reconfigurable multiple-input-multiple-output (MIMO) antenna system is presented. The proposed antenna consists of miniaturized patch antenna elements, loaded with varactor diodes to achieve frequency reconfigurability. The antenna has bandwidth of 30 MHz and provides a smooth frequency sweep from 2.12 GHz to 2.4 GHz by varying the reverse bias voltage of varactor diode. The antenna is designed on an FR4 substrate and occupies a space of 50×100 × 0.8 mm


2016 ◽  
Vol 9 (5) ◽  
pp. 1147-1153 ◽  
Author(s):  
Ling Wu ◽  
Yingqing Xia

With quad-band-notched characteristic, a compact ultrawideband (UWB) multiple-input-multiple-output (MIMO) antenna is introduced in the paper. The UWB–MIMO system has two similar monopole elements and occupies 30 × 45 mm2. By inserting two L-shaped slots, CSRR and C-shaped stubs, four notched bands are achieved (3.25–3.9, 5.11–5.35, 5.5–6.06, and 7.18–7.88 GHz) to filter WiMAX, lower WLAN, upper WLAN, and X-band. Meanwhile, the isolation is obviously enhanced with three metal strips on the ground plane. Results indicate that the antenna covers UWB frequency band of 3.1 – 10.6 GHz except four rejected bands, isolation of better than −18 dB, envelope correlation coefficient of <0.02, and good radiation pattern, thus making it useful for UWB systems.


2017 ◽  
Vol 9 (8) ◽  
pp. 1763-1780 ◽  
Author(s):  
Leeladhar Malviya ◽  
Rajib Kumar Panigrahi ◽  
M. V. Kartikeyan

Multiple input multiple output (MIMO) antenna is at core of the presently available wireless technologies. The design of MIMO antennas over a limited space requires various approaches of mutual coupling reduction, otherwise gain, efficiency, diversity gain, and radiation patterns will be severely affected. Various techniques have been reported in literature to control this degrading factor and to improve the performance of the MIMO antennas. In this review paper, we have carried out an extensive thorough investigation of diversity and mutual coupling (correlation) reduction techniques in compact MIMO antennas.


Sign in / Sign up

Export Citation Format

Share Document