Comparison of Endolymph Cross-Sectional Area Measured Histologically with that Measured in Vivo with an Ionic Volume Marker

1995 ◽  
Vol 104 (11) ◽  
pp. 886-894 ◽  
Author(s):  
Alec N. Salt ◽  
John E. Demott ◽  
Robert S. Kimura
Keyword(s):  
Injection Site ◽  
Cross Sectional Area ◽  
Endolymphatic Sac ◽  
Sectional Area ◽  
Cross Sectional ◽  
Constant Rate ◽  
Two Measures ◽  
The Cross ◽  
Ionic Volume

In order to establish how endolymph volume is regulated, it is essential to be able to measure endolymph volume or cross-sectional area in vivo. We have developed methods to accomplish this by injecting the volume marker ion hexafluoroarsenate (AsF6) into endolymph by iontophoresis. For an injection at a constant rate, the endolymph concentration is inversely dependent on the cross-sectional area of the scala into which injection occurred. Marker concentrations were monitored by inserting ion-selective microelectrodes into endolymph near the injection site. In a previous study we quantified the degree of hydrops in animals following ablation of the endolymphatic sac. In the present study we validated the technique by comparing the endolymphatic cross-sectional area measured in vivo with AsF6 with that measured by established histologic procedures. The correlation between the two measures was good, with a coefficient of .903, although the area measured histologically was a little lower than that measured in vivo.

scholarly journals A method for measuring the cross sectional area of the anterior portion of the optic nerve in vivo using a fast 3D MRI sequence

2010 ◽  
Vol 31 (6) ◽  
pp. 1486-1491 ◽  
Author(s):  
Marios C. Yiannakas ◽  
Claudia A.M. Wheeler-Kingshott ◽  
Alaine M. Berry ◽  
Karyn Chappell ◽  
Andrew Henderson ◽  
...  
Keyword(s):  
Optic Nerve ◽  
Cross Sectional Area ◽  
Sectional Area ◽  
3D Mri ◽  
Anterior Portion ◽  
Cross Sectional ◽  
The Cross

scholarly journals Rectus Femoris Mimicking Ultrasound Phantom for Muscle Mass Assessment: Design, Research, and Training Application

2021 ◽  
Vol 10 (12) ◽  
pp. 2721
Author(s):  
Nobuto Nakanishi ◽  
Shigeaki Inoue ◽  
Rie Tsutsumi ◽  
Yusuke Akimoto ◽  
Yuko Ono ◽  
...  
Keyword(s):  
Measurement Accuracy ◽  
Rectus Femoris ◽  
Cross Sectional Area ◽  
Sectional Area ◽  
Cross Sectional ◽  
Phantom Model ◽  
Ultrasound Measurements ◽  
Ultrasound Phantom

Ultrasound has become widely used as a means to measure the rectus femoris muscle in the acute and chronic phases of critical illness. Despite its noninvasiveness and accessibility, its accuracy highly depends on the skills of the technician. However, few ultrasound phantoms for the confirmation of its accuracy or to improve technical skills exist. In this study, the authors created a novel phantom model and used it for investigating the accuracy of measurements and for training. Study 1 investigated how various conditions affect ultrasound measurements such as thickness, cross-sectional area, and echogenicity. Study 2 investigated if the phantom can be used for the training of various health care providers in vitro and in vivo. Study 1 showed that thickness, cross-sectional area, and echogenicity were affected by probe compression strength, probe angle, phantom compression, and varying equipment. Study 2 in vitro showed that using the phantom for training improved the accuracy of the measurements taken within the phantom, and Study 2 in vivo showed the phantom training had a short-term effect on improving the measurement accuracy in a human volunteer. The new ultrasound phantom model revealed that various conditions affected ultrasound measurements, and phantom training improved the measurement accuracy.

scholarly journals Atrophy patterns in isolated subscapularis lesions

2021 ◽  
Vol 22 (1) ◽  
Author(s):  
Gernot Seppel ◽  
Andreas Voss ◽  
Daniel J. H. Henderson ◽  
Simone Waldt ◽  
Bernhard Haller ◽  
...  
Keyword(s):  
Muscle Atrophy ◽  
Area Ratio ◽  
Cross Sectional Area ◽  
Control Group ◽  
Sectional Area ◽  
Cross Sectional ◽  
Subscapularis Muscle ◽  
Mri Scans ◽  
The Mean ◽  
The Cross

Abstract Background While supraspinatus atrophy can be described according to the system of Zanetti or Thomazeau there is still a lack of characterization of isolated subscapularis muscle atrophy. The aim of this study was to describe patterns of muscle atrophy following repair of isolated subscapularis (SSC) tendon. Methods Forty-nine control shoulder MRI scans, without rotator cuff pathology, atrophy or fatty infiltration, were prospectively evaluated and subscapularis diameters as well as cross sectional areas (complete and upper half) were assessed in a standardized oblique sagittal plane. Calculation of the ratio between the upper half of the cross sectional area (CSA) and the total CSA was performed. Eleven MRI scans of patients with subscapularis atrophy following isolated subscapularis tendon tears were analysed and cross sectional area ratio (upper half /total) determined. To guarantee reliable measurement of the CSA and its ratio, bony landmarks were also defined. All parameters were statistically compared for inter-rater reliability, reproducibility and capacity to quantify subscapularis atrophy. Results The mean age in the control group was 49.7 years (± 15.0). The mean cross sectional area (CSA) was 2367.0 mm2 (± 741.4) for the complete subscapularis muscle and 1048.2 mm2 (± 313.3) for the upper half, giving a mean ratio of 0.446 (± 0.046). In the subscapularis repair group the mean age was 56.7 years (± 9.3). With a mean cross sectional area of 1554.7 mm2 (± 419.9) for the complete and of 422.9 mm2 (± 173.6) for the upper half of the subscapularis muscle, giving a mean CSA ratio of 0.269 (± 0.065) which was seen to be significantly lower than that of the control group (p < 0.05). Conclusion Analysis of typical atrophy patterns of the subscapularis muscle demonstrates that the CSA ratio represents a reliable and reproducible assessment tool in quantifying subscapularis atrophy. We propose the classification of subscapularis atrophy as Stage I (mild atrophy) in case of reduction of the cross sectional area ratio < 0.4, Stage II (moderate atrophy) in case of < 0.35 and Stage III (severe atrophy) if < 0.3.

The area of eye muscle of beef cattle carcasses

1963 ◽  
Vol 3 (10) ◽  
pp. 249
Author(s):  
RM Seebeck
Keyword(s):  
Beef Cattle ◽  
Cross Sectional Area ◽  
Carcass Weight ◽  
Sectional Area ◽  
Muscle Area ◽  
Cross Sectional ◽  
Eye Muscle ◽  
Angus Cattle ◽  
The Cross

Variations in the cross-sectional area of eye muscle of carcasses cut between the tenth and eleventh ribs were investigated, using 105 Hereford and 51 Angus steers aged 20 months. These cattle consisted of three groups, born in successive years. At constant carcass weight, statistically significant differences in eye muscle area were found between breeds and between years. Breed and year differences were also found in eye muscle area with width and depth of eye muscle constant, so that there are limitations to the estimation of eye muscle area from width and depth measurements. A nomograph is given for estimating eye muscle area from width and depth for Hereford and Angus cattle, when all animals are reared in the same year and environment. The use of eye muscle area as an indicator of weight of carcass muscle is discussed.

Comparison of the Cross Sectional Area, the Loss in Volume and the Mechanical Properties of LAE442 and MgCa0.8 as Resorbable Magnesium Alloy Implants after 12 Months Implantation Duration

2010 ◽  
Vol 638-642 ◽  
pp. 675-680 ◽  
Author(s):  
Martina Thomann ◽  
Nina von der Höh ◽  
Dirk Bormann ◽  
Dina Rittershaus ◽  
C. Krause ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Cross Sections ◽  
Degradation Process ◽  
Cross Sectional Area ◽  
Bending Test ◽  
Sectional Area ◽  
Cross Sectional ◽  
Initial Strength ◽  
Three Point Bending ◽  
The Cross

Current research focuses on magnesium based alloys in the course of searching a resorbable osteosynthetic material which provides sufficient mechanical properties besides a good biocompatibility. Previous studies reported on a favorable biocompatibility of the alloys LAE442 and MgCa0.8. The present study compared the degradation process of cylindrical LAE442 and MgCa0.8 implants after 12 months implantation duration. Therefore, 10 extruded implants (2.5 x 25 mm, cross sectional area 4.9 mm²) of both alloys were implanted into the medullary cavity of both tibiae of rabbits for 12 months. After euthanization, the right bone-implant-compound was scanned in a µ-computed tomograph (µCT80, ScancoMedical) and nine uniformly distributed cross-sections of each implant were used to determine the residual implants´ cross sectional area (Software AxioVisionRelease 4.5, Zeiss). Left implants were taken out of the bone carefully. After weighing, a three-point bending test was carried out. LAE442 implants degraded obviously slower and more homogeneously than MgCa0.8. The mean residual cross sectional area of LAE442 implants was 4.7 ± 0.07 mm². MgCa0.8 showed an area of only 2.18 ± 1.03 mm². In contrast, the loss in volume of LAE442 pins was more obvious. They lost 64 % of their initial weight. The volume of MgCa0.8 reduced clearly to 54.4 % which corresponds to the cross sectional area results. Three point bending tests revealed that LAE442 showed a loss in strength of 71.2 % while MgCa0.8 lost 85.6 % of its initial strength. All results indicated that LAE442 implants degraded slowly, probably due to the formation of a very obvious degradation layer. Degradation of MgCa0.8 implants was far advanced.

A method of in-vitro measurement of the cross-sectional area of soft tissues, using ultrasonography

2002 ◽  
Vol 7 (2) ◽  
pp. 247-251 ◽  
Author(s):  
Masahiko Noguchi ◽  
Toshiya Kitaura ◽  
Kazuya Ikoma ◽  
Yoshiaki Kusaka
Keyword(s):  
Soft Tissues ◽  
Cross Sectional Area ◽  
Sectional Area ◽  
Cross Sectional ◽  
The Cross

Intra- and inter-rater reliability for the measurement of the cross-sectional area of ankle tendons assessed by magnetic resonance imaging

2021 ◽  
pp. 028418512110032
Author(s):  
Henrique Mansur ◽  
Guilherme Estanislau ◽  
Marcos de Noronha ◽  
Rita de Cassia Marqueti ◽  
Emerson Fachin-Martins ◽  
...  
Keyword(s):  
Magnetic Resonance Imaging ◽  
Magnetic Resonance ◽  
Repeated Measures ◽  
Cross Sectional Area ◽  
Sectional Area ◽  
Resonance Imaging ◽  
Cross Sectional ◽  
Rater Reliability ◽  
The Cross ◽  
Very High

Background The cross-sectional area (CSA) records make an essential measurement for determining the mechanical properties of tendons, such as stress and strength. However, there is no consensus regarding the best method to record the CSA from different tendons. Purpose To determine intra- and inter-rater reliability for CSA measures from magnetic resonance imaging (MRI) of the following tendons: tibialis anterior; tibialis posterior; fibularis longus and brevis; and Achilles. Material and Methods We designed an observational study with repeated measures taken from a convenience sample of 20 participants diagnosed with acute or chronic ankle sprain. Two independent raters took three separate records from the CSA of ankle tendon images of each MRI slice. The intra-class correlation coefficient (ICC) and 95% limits of agreement (LoA) defined the quality (associations) and magnitude (differences), respectively, of intra- and inter-rater reliability on the measures plotted by the Bland–Altman method. Results Data showed very high intra- and inter-rater correlations for measures taken from all tendons analyzed (ICC 0.952–0.999). It also revealed an excellent agreement between raters (0.12%–2.3%), with bias no higher than 2 mm2 and LoA in the range of 4.4–7.9 mm2. The differences between repeated measures recorded from the thinnest tendons (fibularis longus and brevis) revealed the lowest bias and narrowest 95% LoA. Conclusion Reliability for the CSA of ankle tendons measured from MRI taken by independent rates was very high, with the smallest differences between raters observed when the thinnest tendon was analyzed.

Sign in / Sign up

Export Citation Format

Share Document