The photoreceptors and visual pigments in the retina of a boid snake, the ball python (Python regius)

1999 ◽  
Vol 202 (14) ◽  
pp. 1931-1938 ◽  
Author(s):  
A.J. Sillman ◽  
J.K. Carver ◽  
E.R. Loew

The photoreceptors and visual pigments of Python regius were studied using microspectrophotometry and scanning electron microscopy. The retina contains rods and cones, with rods constituting at least 90 % of the photoreceptor population. The rods are of a single type with long, narrow outer segments and are tightly packed. The wavelength of maximum absorbance (λ max) of the visual pigment in the rods is in the region of 494 nm. Two distinct types of cone are present. The most common cone, with a stout but stubby outer segment, contains a visual pigment with λ max at approximately 551 nm. A relatively rare cone, with a long, slender outer segment, contains an ultraviolet-sensitive visual pigment with λ max at approximately 360 nm. All the visual pigments have chromophores based on vitamin A1. The results are discussed in relation to the behavior of P. regius.

1974 ◽  
Vol 187 (1089) ◽  
pp. 461-478 ◽  

The association between cone outer segments and pigment epithelial cells in the tapetal region of the cat’s retina was studied by both transmission and scanning electron microscopy. Although the cone outer segments do not reach the perikaryal surface of the pigment epithelium they are still closely associated with the apical processes of the pigment epithelium. These processes are leaf-like in shape and ensheath the cone outer segments in a unique way. Each sheath is formed usually by four processes. The base of each process is a broad cytoplasmic sheet which wraps in a spiral of one and a half to two turns in the space above the outer segment’s tip. The processes of each sheath wrap concentrically in this space and form a tunnel whose wall is at least six laminae thick. Where the outer segment is inserted into the sheath, the thickness of the sheath diminishes to three or four laminae. This is because each process gradually narrows in width and, therefore, makes fewer turns. Since the processes continue to narrow as they extend along the outer segment the completeness of ensheathment gradually diminishes from the tip to the base of the outer segment. The processes finally narrow to pointed tips and some processes of each sheath reach the base of the outer segment.


2007 ◽  
Vol 85 (4) ◽  
pp. 584-587 ◽  
Author(s):  
A.J. Sillman ◽  
E.K. Ong ◽  
E.R. Loew

Lake sturgeon ( Acipenser fulvescens Rafinesque, 1817) photoreceptors were studied with scanning electron microscopy and microspectrophotometry. The retina contains both rods and cones, with cones estimated composing about 30% of the photoreceptor population. Only large single cones were identified and they are similar to those found in other species of the order Acipenseriformes. The rods are large, with long, broad outer segments, and are similar to the dominant rod found in other sturgeons and the North American paddlefish ( Polyodon spathula (Walbaum, 1792)). Mean (SD) rod packing density at 22 624 ± 3 509 rods/mm2 is low compared with those of other animals that function primarily in dim light. The visual pigment of the rods has a mean (SD) peak absorbance (λmax) at 541 ± 2 nm. Three different cone populations were identified: a long wavelength sensitive cone containing a visual pigment with λmax at 619 ± 3 nm; middle wavelength sensitive cone with λmax at 538 ± 1 nm; and short wavelength sensitive cone with λmax at 448 ± 1 nm. All the visual pigments are based on the vitamin A2 chromophore.


2009 ◽  
Vol 26 (3) ◽  
pp. 267-274 ◽  
Author(s):  
TOMOKI ISAYAMA ◽  
S.L. McCABE ENGLAND ◽  
R.K. CROUCH ◽  
A.L. ZIMMERMAN ◽  
C.L. MAKINO

AbstractVision begins with photoisomerization of 11-cis retinal to the all-trans conformation within the chromophore-binding pocket of opsin, leading to activation of a biochemical cascade. Release of all-trans retinal from the binding pocket curtails but does not fully quench the ability of opsin to activate transducin. All-trans retinal and some other analogs, such as β-ionone, enhance opsin’s activity, presumably on binding the empty chromophore-binding pocket. By recording from isolated salamander photoreceptors and from patches of rod outer segment membrane, we now show that high concentrations of β-ionone suppressed circulating current in dark-adapted green-sensitive rods by inhibiting the cyclic nucleotide-gated channels. There were also decreases in circulating current and flash sensitivity, and accelerated flash response kinetics in dark-adapted blue-sensitive (BS) rods and cones, and in ultraviolet-sensitive cones, at concentrations too low to inhibit the channels. These effects persisted in BS rods even after incubation with 9-cis retinal to ensure complete regeneration of their visual pigment. After long exposures to high concentrations of β-ionone, recovery was incomplete unless 9-cis retinal was given, indicating that visual pigment had been bleached. Therefore, we propose that β-ionone activates and bleaches some types of visual pigments, mimicking the effects of light.


1994 ◽  
Vol 11 (2) ◽  
pp. 389-399 ◽  
Author(s):  
Jing Jin ◽  
Gregor J. Jones ◽  
M. Carter Cornwall

AbstractSingle isolated photoreceptors can be taken through a visual cycle of light adaptation by bleaching visual pigment, followed by dark adaptation when supplied with 11–cis retinal. Light adaptation after bleaching is manifested by faster response kinetics and a permanent reduction in sensitivity to light flashes, presumed to be due to the presence of bleached visual pigment. The recovery of flash sensitivity during dark adaptation is assumed to be due to regeneration of visual pigment to pre-bleach levels. In previous work, the outer segments of bleached, light-adapted cells were exposed to 11–cis retinal. In the present work, the cell bodies of bleached photoreceptors were exposed. We report a marked difference between rods and cones. Bleached cones recover sensitivity when their cell bodies are exposed to 11–cis retinal. Bleached rods do not. These results imply that retinal can move freely along the cone photoreceptor, but retinal either is not taken up by the rod cell body or retinal cannot move from the rod cell body to the rod outer segment. The free transfer of retinal along cone but not along rod photoreceptors could explain why, during dark adaptation in the retina, cones have access to a store of 11–cis retinal which is not available to rods. Additional experiments investigated the movement of retinal along bleached rod outer segments. The results indicate that retinal can move along the rod outer segment, but that this movement is slow, occurring at about the same rate as the regeneration of visual pigment.


Author(s):  
P.S. Porter ◽  
T. Aoyagi ◽  
R. Matta

Using standard techniques of scanning electron microscopy (SEM), over 1000 human hair defects have been studied. In several of the defects, the pathogenesis of the abnormality has been clarified using these techniques. It is the purpose of this paper to present several distinct morphologic abnormalities of hair and to discuss their pathogenesis as elucidated through techniques of scanning electron microscopy.


Author(s):  
P.J. Dailey

The structure of insect salivary glands has been extensively investigated during the past decade; however, none have attempted scanning electron microscopy (SEM) in ultrastructural examinations of these secretory organs. This study correlates fine structure by means of SEM cryofractography with that of thin-sectioned epoxy embedded material observed by means of transmission electron microscopy (TEM).Salivary glands of Gromphadorhina portentosa were excised and immediately submerged in cold (4°C) paraformaldehyde-glutaraldehyde fixative1 for 2 hr, washed and post-fixed in 1 per cent 0s04 in phosphosphate buffer (4°C for 2 hr). After ethanolic dehydration half of the samples were embedded in Epon 812 for TEM and half cryofractured and subsequently critical point dried for SEM. Dried specimens were mounted on aluminum stubs and coated with approximately 150 Å of gold in a cold sputtering apparatus.Figure 1 shows a cryofractured plane through a salivary acinus revealing topographical relief of secretory vesicles.


Author(s):  
Nakazo Watari ◽  
Yasuaki Hotta ◽  
Yoshio Mabuchi

It is very useful if we can observe the identical cell elements within the same sections by light microscopy (LM), transmission electron microscopy (TEM) and/or scanning electron microscopy (SEM) sequentially, because, the cell fine structure can not be indicated by LM, while the color is; on the other hand, the cell fine structure can be very easily observed by EM, although its color properties may not. However, there is one problem in that LM requires thick sections of over 1 μm, while EM needs very thin sections of under 100 nm. Recently, we have developed a new method to observe the same cell elements within the same plastic sections using both light and transmission (conventional or high-voltage) electron microscopes.In this paper, we have developed two new observation methods for the identical cell elements within the same sections, both plastic-embedded and paraffin-embedded, using light microscopy, transmission electron microscopy and/or scanning electron microscopy (Fig. 1).


Author(s):  
Ronald H. Bradley ◽  
R. S. Berk ◽  
L. D. Hazlett

The nude mouse is a hairless mutant (homozygous for the mutation nude, nu/nu), which is born lacking a thymus and possesses a severe defect in cellular immunity. Spontaneous unilateral cataractous lesions were noted (during ocular examination using a stereomicroscope at 40X) in 14 of a series of 60 animals (20%). This transmission and scanning microscopic study characterizes the morphology of this cataract and contrasts these data with normal nude mouse lens.All animals were sacrificed by an ether overdose. Eyes were enucleated and immersed in a mixed fixative (1% osmium tetroxide and 6% glutaraldehyde in Sorenson's phosphate buffer pH 7.4 at 0-4°C) for 3 hours, dehydrated in graded ethanols and embedded in Epon-Araldite for transmission microscopy. Specimens for scanning electron microscopy were fixed similarly, dehydrated in graded ethanols, then to graded changes of Freon 113 and ethanol to 100% Freon 113 and critically point dried in a Bomar critical point dryer using Freon 13 as the transition fluid.


Author(s):  
Jane A. Westfall ◽  
S. Yamataka ◽  
Paul D. Enos

Scanning electron microscopy (SEM) provides three dimensional details of external surface structures and supplements ultrastructural information provided by transmission electron microscopy (TEM). Animals composed of watery jellylike tissues such as hydras and other coelenterates have not been considered suitable for SEM studies because of the difficulty in preserving such organisms in a normal state. This study demonstrates 1) the successful use of SEM on such tissue, and 2) the unique arrangement of batteries of nematocysts within large epitheliomuscular cells on tentacles of Hydra littoralis.Whole specimens of Hydra were prepared for SEM (Figs. 1 and 2) by the fix, freeze-dry, coat technique of Small and Màrszalek. The specimens were fixed in osmium tetroxide and mercuric chloride, freeze-dried in vacuo on a prechilled 1 Kg brass block, and coated with gold-palladium. Tissues for TEM (Figs. 3 and 4) were fixed in glutaraldehyde followed by osmium tetroxide. Scanning micrographs were taken on a Cambridge Stereoscan Mark II A microscope at 10 KV and transmission micrographs were taken on an RCA EMU 3G microscope (Fig. 3) or on a Hitachi HU 11B microscope (Fig. 4).


Author(s):  
J.N. Ramsey ◽  
D.P. Cameron ◽  
F.W. Schneider

As computer components become smaller the analytical methods used to examine them and the material handling techniques must become more sensitive, and more sophisticated. We have used microbulldozing and microchiseling in conjunction with scanning electron microscopy, replica electron microscopy, and microprobe analysis for studying actual and potential problems with developmental and pilot line devices. Foreign matter, corrosion, etc, in specific locations are mechanically loosened from their substrates and removed by “extraction replication,” and examined in the appropriate instrument. The mechanical loosening is done in a controlled manner by using a microhardness tester—we use the attachment designed for our Reichert metallograph. The working tool is a pyramid shaped diamond (a Knoop indenter) which can be pushed into the specimen with a controlled pressure and in a specific location.


Sign in / Sign up

Export Citation Format

Share Document