The high temperature stability of AC-16, AC-13, AC-20 under specimen thickness of 5cm and 6cm is studied through indoor asphalt mixture high rutting test, Through comparison and analysis about experimental data, it is found that the stability of AC-16, AC-13, AC-20 asphalt mixture at high- temperature decreases in turn. It is shown that thickness changes did not affect the change trend of the high temperature stability under gradation change, and the stability of AC-16 at high-temperature is the best, the AC-13 is second and the AC-20 is less.
During lignite pyrolysis process, there will produce large amounts of gas which is low calorific value, combustion difficult. This paper creatively put forward a program: high temperature and oxygen-containing flue gas of coal-fired mix combustion with low calorific value gas. Compared to mixing high calorific value fuel, the distinguishing feature of this program is ultra-low cost, and technically feasible. In this scheme, the stability of high-temperature and oxygen-containing flue gas is key technology. Through coal-fired experiments, we obtained generation rule of high-temperature and oxygen-containing flue gas, and summed up a diminishing marginal effect.
The strengthening effect at high temperature produced by a dispersed oxide phase in a metal matrix is seemingly dependent on at least two major contributors: oxide particle size and spatial distribution, and stability of the worked microstructure. These two are strongly interrelated. The stability of the microstructure is produced by polygonization of the worked structure forming low angle cell boundaries which become anchored by the dispersed oxide particles. The effect of the particles on strength is therefore twofold, in that they stabilize the worked microstructure and also hinder dislocation motion during loading.
A simulation apparatus for the experimental study of the methods of control of batch reactors is devised. In this apparatus, the production of heat by an exothermic reaction is replaced by electric heating controlled by a computer in a closed loop; the reactor is cooled with an external cooler whose dynamic properties can be varied while keeping the heat exchange area constant. The effect of the cooler geometry on its dynamic properties is investigated and the effect of the cooler inertia on the stability and safety of the on-off temperature control in the unstable pseudostationary state is examined.
A high-pressure experimental study on the effect of Cr3+ on the stability, phase relations and compositions of ilmenite in the Fe-Mg-Ti-Cr-Si-O system