scholarly journals On the Eddy Current Losses in Metallic Towers

2020 ◽  
Vol 9 (1) ◽  
pp. 1-6 ◽  
Author(s):  
Ibrahim Mahariq ◽  
Svetlana Beryozkina ◽  
Huda Mohammed ◽  
Hamza Kurt

The existence of magnetic field around high-voltage overhead transmission lines or low-voltage distribution lines is a known fact and well-studied in the literature. However, the interaction of this magnetic field either with transmission or distribution towers has not been investigated. Noteworthy it is to remember that this field is time-varying with a frequency of 50 Hz or 60 Hz depending on the country. In this paper, we studied for the first time the eddy currents in towers which are made of metals. As the geometrical structures of towers are extremely complex to model, we provide a simple approach based on principles of electromagnetism in order to verify the existence of power loss in the form of eddy currents. The frequency-domain finite difference method is adapted in the current study for simulating the proposed model. The importance of such a study is the addition of a new type of power loss to the power network due to the fact that some towers are made of relatively conductive materials.©2020. CBIORE-IJRED. All rights reserved

Author(s):  
Andrew L Haynes ◽  
Clare E Parnell ◽  
Klaus Galsgaard ◽  
Eric R Priest

The heating of the solar corona is probably due to reconnection of the highly complex magnetic field that threads throughout its volume. We have run a numerical experiment of an elementary interaction between the magnetic field of two photospheric sources in an overlying field that represents a fundamental building block of the coronal heating process. The key to explaining where, how and how much energy is released during such an interaction is to calculate the resulting evolution of the magnetic skeleton. A skeleton is essentially the web of magnetic flux surfaces (called separatrix surfaces) that separate the coronal volume into topologically distinct parts. For the first time, the skeleton of the magnetic field in a three-dimensional numerical magnetohydrodynamic experiment is calculated and carefully analysed, as are the ways in which it bifurcates into different topologies. A change in topology normally changes the number of magnetic reconnection sites. In our experiment, the magnetic field evolves through a total of six distinct topologies. Initially, no magnetic flux joins the two sources. Then, a new type of bifurcation, called a global double-separator bifurcation , takes place. This bifurcation is probably one of the main ways in which new separators are created in the corona (separators are field lines at which three-dimensional reconnection takes place). This is the first of five bifurcations in which the skeleton becomes progressively more complex before simplifying. Surprisingly, for such a simple initial state, at the peak of complexity there are five separators and eight flux domains present.


2009 ◽  
Vol 416 ◽  
pp. 54-60
Author(s):  
Huan Wu Sun ◽  
Shi Chun Yang

The fluid magnetic abrasives (FMA) are a new type of precision finishing abrasives which are developed on the basis of the phase transition phenomenon caused by magnetic field. The rheological effect of FMA is the basis to achieve its finishing function, and has a great impact on the finishing capabilities and the final surface roughness. In order to get a better understanding of FMA finishing mechanism, the rheological effect models of FMA are deduced for the first time, the simulations and the experimental results are discussed as well in this paper.


2017 ◽  
Vol 68 (4) ◽  
pp. 698-700
Author(s):  
Katarzyna Bloch ◽  
Marcin Nabialek ◽  
Konrad Gruszka

In this paper were studied the influence of magnetic field frequency and induction on the total core power loss � which is divided into eddy current loss, hysteresis loss and anomally losses of the bulk amorphous alloy. The total core power loss of the investigated bulk amorphous alloy increases with magnetic field frequency and peak induction. It follows a power relation similar to what has been observed in classical ribbons. In the investigated alloy in addition to losses due to magnetic hysteresis and eddy currents, other additional losses are present. However additional losses, emerging simultaneously to the component associated with migration relaxations are very weakly dependent on the frequency and temperature.


1947 ◽  
Vol 40 (12) ◽  
pp. 741-748
Author(s):  
P. Bauwens

The fact that standing wave phenomena exist along transmission lines and loops conducting high-frequency electrical energy is responsible for effects of which therapeutic use can be made. A. Power measurements are made possible because parallel transmission lines behave as power transformers of which the ratio varies with the length of these lines. In a generator designed by the G.E.C. the dimensions of the lines are such that after a preliminary estimation of the impedance of the load in the treatment field, the sensitivity of the meter can be adjusted so that the meter subsequently registers in watts the power absorbed in this load. B. When using cable electrodes, in practice, the presence of strong electric fields between the antinodal portions of the loop as well as strong oscillating magnetic fields around the nodal portion gives rise to two distinct phenomena (fig. 6). Search for currents resulting from the electric field on the one hand, and for eddy currents due to the magnetic field on the other, was carried out at St. Thomas's Hospital, in liquid phantoms by means of a probe (fig. 5 a) incorporating a small lamp capable of being rotated in every direction. Voltage measurements were recorded by matching its light intensity with that of a similar lamp in circuit with a variable resistance and a voltmeter (fig. 5 b). When a portion of a cable electrode was coiled around a cylindrical vessel containing an electrolyte, the effects due to the two conditions could be dissociated. The following observations were made (fig. 7): ( a) By using the nodal portions of the loop only, it was shown that only eddy currents are produced and that the lower the resistance of the electrolyte the more easily they are produced. They are strongest at the periphery and rapidly fall off away from it, as shown by the curves of the graph in fig. 8. ( b) By using only the antinodal portions of the loop, coiled around the same vessel, coaxial or longitudinal currents can be demonstrated. It is interesting to note that these exist both at the periphery and at the centre. ( c) When the whole cable is wound around the vessel, the concentration of the electrolyte becomes the factor determining the way in which the energy will be dissipated: (1) with tap-water, it is found that no eddy currents can be demonstrated whereas coaxial currents exist; (2) with strong saline solutions the converse holds good; (3) with electrolytes of intermediate concentration both types of currents can be shown to coexist at the periphery while at the centre only coaxial currents can be demonstrated. The fact that eddy currents and coaxial currents could be detected simultaneously and did not, as might be expected, give rise to a resultant, could only be explained by assuming that although eddy currents and coaxial currents coexisted as far as their effects on the pilot lamp were concerned, these two phenomena were not coincident as regards their phase relations. On examining the system more closely it became clear that the coaxial currents must be approximately 90 degrees out of phase with the eddy currents. By means of another type of probe (fig. 5 c) for surface work, consisting of two metallic buttons mounted on an insulating strip and bridged by a small lamp, P3, similar to the one used throughout the investigations, it was possible to show that the same conditions existed in the body. It could be demonstrated that both coaxial and eddy currents occurred and that the predominance of one or the other type was dictated by conditions related to impedance. In the thigh just above the knee-joint, in most cases both currents could be demonstrated. It could also be shown that when half the cable was wound clockwise and the other half anticlockwise, so as to cancel the magnetic field between the two halves, no eddy currents existed. C. Present therapeutic applications of high-frequency currents involve the continuous dissipation of electrical energy in the load under treatment. Under these conditions the only detectable effect to which therapeutic value may be ascribed is the rise in temperature which results from heat production. This rise in temperature sets a limit to the power which can be used without risk of burns. Consequently effects other than thermal ones which might manifest themselves under higher intensities remain undetected. It is not possible to predict what would happen if, instead of treating tissues by means of sustained high-frequency electrical energy, tissues were subjected to intermittent radio-frequency pulses of very high intensity separated by silent periods of sufficient length to allow for the dissipation of heat. Those who have some technical knowledge of such matters will readily recognize an application of “Radar” technique in this.


2012 ◽  
Vol 151 ◽  
pp. 41-46
Author(s):  
Hong Jun Zhang ◽  
Xian Feng Du ◽  
Bao Li

This paper analyzed the eddy characteristics of the coaxial cylindrical magnetic coupler by using the finite element method, and simulated the impact of eddy currents on magnetic field. These effects mainly reflected in: weakening the magnetic coupling of the magnetic field intensity, and reducing the magnetic coupling torque. In addition, this paper calculated eddy current power loss, and proposed specific programs to reduce the eddy current power loss.


Author(s):  
S.J. Krause ◽  
W.W. Adams

Over the past decade low voltage scanning electron microscopy (LVSEM) of polymers has evolved from an interesting curiosity to a powerful analytical technique. This development has been driven by improved instrumentation and in particular, reliable field emission gun (FEG) SEMs. The usefulness of LVSEM has also grown because of an improved theoretical and experimental understanding of sample-beam interactions and by advances in sample preparation and operating techniques. This paper will review progress in polymer LVSEM and present recent results and developments in the field.In the early 1980s a new generation of SEMs produced beam currents that were sufficient to allow imaging at low voltages from 5keV to 0.5 keV. Thus, for the first time, it became possible to routinely image uncoated polymers at voltages below their negative charging threshold, the "second crossover", E2 (Fig. 1). LVSEM also improved contrast and reduced beam damage in sputter metal coated polymers. Unfortunately, resolution was limited to a few tenths of a micron due to the low brightness and chromatic aberration of thermal electron emission sources.


2016 ◽  
Vol 2016 (4) ◽  
pp. 8-10 ◽  
Author(s):  
B.I. Kuznetsov ◽  
◽  
A.N. Turenko ◽  
T.B. Nikitina ◽  
A.V. Voloshko ◽  
...  

Author(s):  
N. B. Rubtsova ◽  
A. Y. Tokarskiy

The main problems of overhead and cable transmission lines with voltage >=110 kV electric and magnetic fields general public protection are presented. It is shown that it is necessary to develop regulatory requirements for these lines’ sanitary protection zones organization, taking into account the magnetic field component, because its possible health risk factor, up to carcinogenic.


2021 ◽  
pp. 232102222098516
Author(s):  
Dipankar Das

The paper puts forth a notion and derives a special type of production function where labour is an indivisible factor and is in the integer space. Thus, Newtonian calculus is not an appropriate method of deriving the marginal value because limit point does not exist. This shows that indivisibility determines the output elasticity. In the first part, the paper propounds a notion regarding how indivisibility determines curvature of the production function. In the second part, the paper incorporates the findings within a production function and derives a new type accordingly. Moreover, it formally derives the standard wage equation considering all the entitlements of labour, namely (a) normal wages, (b) interest and (c) rent of ability. So far, no such mathematical proof is there to support this wage composition. This paper, for the first time, derives this wage equation considering indivisibility of labour. JEL Classifications: J23, J24, J31, D24, C61, E24, L8


Sign in / Sign up

Export Citation Format

Share Document