IRRIGATION SCHEDULE OF LONG-FRUIT CUCUMBERS AND HYDROAMELIORATIVE REQUIREMENTS FOR DRIP IRRIGATION IN PLASTIC GREENHOUSE

Author(s):  
Rumiana Kireva ◽  
Roumen Gadjev

The deficit of the irrigation water requires irrigation technologies with more efficient water use. For cucumbers, the most suitable is the drip irrigation technology. For establishing of the appropriate irrigation schedule of cucumbers under the soil and climate conditions in the village of Chelopechene, near Sofia city, the researchеs was conducted with drip irrigation technology, adopting varying irrigation schedules and hydraulic regimes - from fully meeting the daily crops water requirements cucumbers to reduced depths with 20% and 40%. It have been established irrigation schedule with adequate pressure flows in the water source, irrigation water productivity and yields of in plastic unheated greenhouses of the Sofia plant.

Agronomy ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 888 ◽  
Author(s):  
Christoph Studer ◽  
Simon Spoehel

Appropriate irrigation scheduling for efficient water use is often a challenge for small-scale farmers using drip irrigation. In a trial with 12 farmers in Sébaco, Nicaragua, two tools to facilitate irrigation scheduling were tested: the Water Chart (a table indicating required irrigation doses) and tensiometers. The study aimed at evaluating if and to what extent simple tools can reduce irrigation water use and improve water productivity in drip-irrigated vegetable (beetroot; Beta vulgaris L.) production compared with the farmers’ usual practice. Irrigation water use was substantially reduced (around 20%) when farmers irrigated according to the tools. However, farmers did not fully adhere to the tool guidance, probably because they feared that their crop would not get sufficient water. Thus they still over-irrigated their crop: between 38% and 88% more water than recommended was used during the treatment period, resulting in 91% to 139% higher water use than required over the entire growing cycle. Water productivity of beetroot production was, therefore, much lower (around 3 kg/m3) than what can be achieved under comparable conditions, although yields were decent. Differences in crop yield and water productivity among treatments were not significant. The simplified Water Chart was not sufficiently understandable to farmers (and technicians), whereas tensiometers were better perceived, although they do not provide any indication on how much water to apply. We conclude that innovations such as drip irrigation or improved irrigation scheduling have to be appropriately introduced, e.g., by taking sufficient time to co-produce a common understanding about the technologies and their possible usefulness, and by ensuring adequate follow-up support.


2020 ◽  
Vol 63 (3) ◽  
pp. 703-729 ◽  
Author(s):  
Steven R. Evett ◽  
Paul D. Colaizzi ◽  
Freddie R. Lamm ◽  
Susan A. O’Shaughnessy ◽  
Derek M. Heeren ◽  
...  

Highlights Irrigation is key to the productivity of Great Plains agriculture but is threatened by water scarcity. The irrigated area grew to >9 million ha since 1870, mostly since 1950, but is likely to decline. Changes in climate, water availability, irrigated area, and policy will affect productivity. Adaptation and innovation, hallmarks of Great Plains populations, will ensure future success. Abstract. Motivated by the need for sustainable water management and technology for next-generation crop production, the future of irrigation on the U.S. Great Plains was examined through the lenses of past changes in water supply, historical changes in irrigated area, and innovations in irrigation technology, management, and agronomy. We analyzed the history of irrigated agriculture through the 1900s to the present day. We focused particularly on the efficiency and water productivity of irrigation systems (application efficiency, crop water productivity, and irrigation water use productivity) as a connection between water resource management and agricultural production. Technology innovations have greatly increased the efficiency of water application, the productivity of water use, and the agricultural productivity of the Great Plains. We also examined the changes in water stored in the High Plains aquifer, which is the region’s principle supply for irrigation water. Relative to other states, the aquifer has been less impacted in Nebraska, despite large increases in irrigated area. Greatly increased irrigation efficiency has played a role in this, but so have regulations and the recharge to the aquifer from the Nebraska Sand Hills and from rivers crossing the state. The outlook for irrigation is less positive in western Kansas, eastern Colorado, and the Oklahoma and Texas Panhandles. The aquifer in these regions is recharged at rates much less than current pumping, and the aquifer is declining as a result. Improvements in irrigation technology and management plus changes in crops grown have made irrigation ever more efficient and allowed irrigation to continue. There is good reason to expect that future research and development efforts by federal and state researchers, extension specialists, and industry, often in concert, will continue to improve the efficiency and productivity of irrigated agriculture. Public policy changes will also play a role in regulating consumption and motivating on-farm efficiency improvements. Water supplies, while finite, will be stretched much further than projected by some who look only at past rates of consumption. Thus, irrigation will continue to be important economically for an extended period. Sustaining irrigation is crucial to sustained productivity of the Great Plains “bread basket” because on average irrigation doubles the efficiency with which water is turned into crop yields compared with what can be attained in this region with precipitation alone. Lessons learned from the Great Plains are relevant to irrigation in semi-arid and subhumid areas worldwide. Keywords: Center pivot, Crop water productivity, History, Sprinkler irrigation, Subsurface drip irrigation, Water use efficiency.


2016 ◽  
Vol 30 (1) ◽  
pp. 47-55 ◽  
Author(s):  
Mahmoud M. Ibrahim ◽  
Ahmed A. El-Baroudy ◽  
Ahmed M. Taha

Abstract Field experiments was conducted to determine the best irrigation scheduling and the proper period for injecting fertilizers through drip irrigation water in a sandy soil to optimize maize yield and water productivity. Four irrigation levels (0.6, 0.8, 1.0 and 1.2) of the crop evapotranspiration and two fertigation periods (applying the recommended fertilizer dose in 60 and 80% of the irrigation time) were applied in a split-plot design, in addition to a control treatment which represented conventional irrigation and fertilization of maize in the studied area. The results showed that increasing the irrigation water amount and the fertilizer application period increased vegetative growth and yield. The highest grain yield and the lowest one were obtained under the treatment at 1.2 and of 0.6 crop evapotranspiration, respectively. The treatment at 0.8 crop evapotranspiration with fertilizer application in 80% of the irrigation time gave the highest water productivity (1.631 kg m−3) and saved 27% of the irrigation water compared to the control treatment. Therefore, this treatment is recommended to irrigate maize crops because of the water scarcity conditions of the studied area.


2020 ◽  
Vol 41 (03) ◽  
Author(s):  
Sachin Himmatrao Malve ◽  
Ashok Saini ◽  
Praveen Rao V

Water is one of the most essential natural resource, which is often costly and limiting input particularly in arid and Semi-arid. Since water is the life line for accruing desired yield levels, its time of application, method of application and quantity applied levels besides saving water. Further, there is a need for judicious use of water to reap the maximum benefit from this limiting resource. Off late, amongst irrigation methods, drip irrigation plays a vital role in economizing irrigation water, higher water use efficiency and enhancing crop yield in water scarce areas. Many research findings also confirm considerable saving in irrigation water through adoption of precise irrigation method like drip irrigation. The response of wheat to surface check basin and drip irrigation is reviewed.


Author(s):  
Rahel Deribe Bekele ◽  
Alisher Mirzabaev ◽  
Dawit Mekonnen

Using a household and plot-level survey conducted in 2016/17 in ten districts of Ethiopia, this study explores whether there is a difference in farmers’ adoption of sustainable land management (SLM) practices between their rainfed and irrigated plots. The paper also investigates the varying influence of different types of irrigation water management systems and associated irrigation technologies on the adoption of SLM practices in irrigated plots. Our findings show only a small difference in the average number of SLM practices between rainfed and irrigated plots, even though significant differences are observed between many of the practices applied individually among these plots. The econometric estimation shows that the role of the combined effect of irrigation water management system and irrigation technology on adoption of SLM practices is quite varied and very significant. The evidence highlights that farmers adopt more SLM practices in their plots with pump irrigation compared to those plots where gravity irrigation is applied. This finding implies that pump irrigation systems enhance complementarities with SLM practices. Furthermore, the results indicate that the type of irrigation water management and the technology applied could play an important role in restoring degraded lands and maintaining soil fertility, even when farmers’ adoption of irrigation were not explicitly triggered by concerns for soil health.


Water ◽  
2021 ◽  
Vol 14 (1) ◽  
pp. 7
Author(s):  
Musammat Shahinara Begum ◽  
Sujit Kumar Bala ◽  
AKM Saiful Islam

Urbanization and population growth have led to urban areas with a substantial concrete surface compared to adjacent rural areas, creating challenges regarding fresh food, water security, and the need for agricultural land. Climate change affects the rainfall pattern and ground water in urban areas, so the gradual growth of urban rooftop agriculture (URTA) is an increasing trend for the owners of residential buildings. URTA is increasing in the form of private initiatives, but without consideration of efficient water management techniques and application of other related inputs. URTA differs substantially from traditional agriculture in terms of sunshine, thermal regime, the moisture dynamics of a concrete roof top, etc. Considering these aspects of URTA, an effective, efficient, science-based and economically viable irrigation method is necessary to popularize this approach and consequently increase the productivity of crops. With this in mind, the drip irrigation method is considered for the cultivation and determination of water productivity for selected species of plants such as the Bottle Gourd, Tomato, Chili, and Brinjal in the URTA, which was also compared to the traditional irrigation approach. This is why groundwater and green (grey and rain) water were considered as the source of irrigation during the dry season, based on the daily crop evapotranspiration and moisture content of the plant growing medium. For this reason, ET0 of the selected crops was measured using the CROPWAT 8.0 model. The results of this study revealed that the optimum irrigation water requirement of any crop in URTA is around 54% access (ETc), and 46–64% of access irrigation water is used by the traditional method compared to the drip irrigation method. The study reported that with drip irrigation with potable water, the yield was increased by 21.43–22.40% and rain and grey-water also increased yield by 31.87–33.33% compared to container and traditional pipe irrigation. It was also found that the water qualities of mixed water (grey and rainwater) are in an acceptable range limit for irrigation. As a result, urban planners, city dwellers, and researchers can formulate appropriate plans to cultivate different species of plants through this water saving irrigation method using green water, and should explore the concept of water-smart URTA technologies as organic inventions embedded in these results.


2019 ◽  
Vol 97 (2.1) ◽  
pp. 385-404
Author(s):  
FAWZIA A. NAGM AL DEEN ◽  
MOHAMED Y. . El ANSARY ◽  
MONTASER A. AWAAD ◽  
WAEL M. SOLTAN

2019 ◽  
Vol 9 (1) ◽  
Author(s):  
H. S. Jat ◽  
P. C. Sharma ◽  
Ashim Datta ◽  
Madhu Choudhary ◽  
S. K. Kakraliya ◽  
...  

AbstractA study was conducted to design productive, profitable, irrigation water¸ nitrogen and energy use efficient intensive cereal systems (rice-wheat; RW and maize-wheat; MW) in North-West India. Bundling of conservation agriculture (CA) with sub-surface drip irrigation termed as CA+ were compared with CA alone and conventional tillage based and flood irrigated RW rotation (farmer’s practice; ScI). In contrast to conventional till RW rotation which consumed 1889 mm ha−1 irrigation water (2-yr mean), CA+ system saved 58.4 and 95.5% irrigation water in RW and MW rotations, respectively. CA+ practices saved 45.8 and 22.7% of irrigation water in rice and maize, respectively compared to CA with flood irrigation. On a system basis, CA+ practices saved 46.7 and 44.7% irrigation water under RW (ScV) and MW (ScVI) systems compared to their respective CA-based systems with flood irrigation (ScIII and ScIV). CA+ in RW system recorded 11.2% higher crop productivity and improved irrigation water productivity by 145% and profitability by 29.2% compared to farmers’ practice. Substitution of rice with maize (MW system; ScVI) recorded 19.7% higher productivity, saved 84.5% of irrigation water and increased net returns by 48.9% compared to farmer’s practice. CA+ RW and MW system improved energy productivity by 75 and 169% and partial factor productivity of N by 44.6 and 49.6%, respectively compared to ScI. The sub-surface drip irrigation system saved the fertilizer N by 20% under CA systems. CA+ in RW and MW systems recorded ~13 and 5% (2-yr mean) higher profitability with 80% subsidy on installing sub-surface drip irrigation system and similar profitability without subsidy scenario compared with their respective flood irrigated CA-based systems.


2020 ◽  
Vol 12 (17) ◽  
pp. 6779 ◽  
Author(s):  
Indranil Samui ◽  
Milan Skalicky ◽  
Sukamal Sarkar ◽  
Koushik Brahmachari ◽  
Sayan Sau ◽  
...  

In the coastal zone of the Ganges Delta, water shortages due to soil salinity limit the yield of dry season crops. To alleviate water shortage as a consequence of salinity stress in the coastal saline ecosystem, the effect of different water-saving (WS) and water-conserving options was assessed on growth, yield and water use of tomato; two field experiments were carried out at Gosaba, West Bengal, India in consecutive seasons during the winter of 2016–17 and 2017–18. The experiment was laid out in a randomized block design with five treatments viz., surface irrigation, surface irrigation + straw mulching, drip irrigation at 100% reference evapotranspiration (ET0), drip irrigation at 80% ET0, drip irrigation at 80% ET0 + straw mulching. Application of drip irrigation at 80% ET0 + straw mulching brought about significantly the highest fruit as well as the marketable yield of tomato (Solanum lycopersicum L.). The soil reaction (pH), post-harvest organic carbon, nitrogen, phosphorus and potassium (N, P and K) status and soil microbial population along with the biochemical quality parameters of tomato (juice pH, ascorbic acid, total soluble solids and sugar content of fruits) were significantly influenced by combined application of drip irrigation and straw mulching. Surface irrigation significantly increased the salinity level in surface and sub-surface soil layers while the least salinity development was observed in surface mulched plots receiving irrigation water through drip irrigation. The highest water productivity was also improved from drip irrigation at 80% ET0 + straw mulched plots irrespective of the year of experimentation. Such intervention also helped in reducing salinity stress for the tomato crop. Thus, straw mulching along with drip irrigation at 80% ET0 can be recommended as the most suitable irrigation option for tomato crop in the study area as well as coastal saline regions of South Asia. Finally, it can be concluded that the judicious application of irrigation water not only increased growth, yield and quality tomatoes but also minimized the negative impact of soil salinity on tomatoes grown in the coastal saline ecosystem of Ganges Delta.


Sign in / Sign up

Export Citation Format

Share Document