Epitaxial growth of semiconducting LaVO3 thin films

2000 ◽  
Vol 15 (1) ◽  
pp. 1-3 ◽  
Author(s):  
Woong Choi ◽  
Timothy Sands ◽  
Kwang-Young Kim
Keyword(s):  
Thin Films ◽  
Activation Barrier ◽  
Pulsed Laser ◽  
Laser Deposition ◽  
Epitaxial Thin Films ◽  
Conductivity Measurements ◽  
X Ray Diffraction ◽  
X Ray ◽  
Thermally Activated ◽  
Substrate Temperatures

Epitaxial thin films of LaVO3 were grown on (001) LaAlO3 substrates by pulsed laser deposition from a LaVO4 target in a vacuum ambient at substrate temperatures ≥500 °C. X-ray diffraction studies showed that epitaxial LaVO3 films consist of mixed domains of [110] and [001] orientations. Thermoprobe and four-probe conductivity measurements demonstrated the p-type semiconducting behavior of the epitaxial LaVO3 films. The temperature dependence of the conductivity is consistent with a thermally activated hopping mechanism with an activation barrier of 0.16 eV.

Structure and Conductivity of Iodine-Doped C60 Thin Films

1994 ◽  
Vol 359 ◽  
Author(s):  
Jun Chen ◽  
Haiyan Zhang ◽  
Baoqiong Chen ◽  
Shaoqi Peng ◽  
Ning Ke ◽  
...  
Keyword(s):  
Thin Films ◽  
Electrical Conductivity ◽  
Room Temperature ◽  
Conductivity Measurements ◽  
X Ray Diffraction ◽  
Temperature Conductivity ◽  
Room Temperature Conductivity ◽  
X Ray ◽  
Thermally Activated ◽  
Order Of Magnitude

ABSTRACTWe report here the results of our study on the properties of iodine-doped C60 thin films by IR and optical absorption, X-ray diffraction, and electrical conductivity measurements. The results show that there is no apparent structural change in the iodine-doped samples at room temperature in comparison with that of the undoped films. However, in the electrical conductivity measurements, an increase of more that one order of magnitude in the room temperature conductivity has been observed in the iodine-doped samples. In addition, while the conductivity of the undoped films shows thermally activated temperature dependence, the conductivity of the iodine-doped films was found to be constant over a fairly wide temperature range (from 20°C to 70°C) exhibiting a metallic feature.

Study of Raman Spectrum of Fe Doped CeO2 Thin Films Grown by Pulsed Laser Deposition

2010 ◽  
Vol 123-125 ◽  
pp. 375-378 ◽  
Author(s):  
Ram Prakash ◽  
Shalendra Kumar ◽  
Chan Gyu Lee ◽  
S.K. Sharma ◽  
Marcelo Knobel ◽  
...  
Keyword(s):  
Thin Films ◽  
Pulsed Laser Deposition ◽  
Single Phase ◽  
Pulsed Laser ◽  
Laser Deposition ◽  
Fe Doping ◽  
Full Width ◽  
Deposition Technique ◽  
X Ray Diffraction ◽  
X Ray

Ce1-xFexO2 (x=0, 0.01, 0.03 and 0.0 5) thin films were grown by pulsed laser deposition technique on Si and LaAlO3 (LAO) substrates. These films were deposited in vacuum and 200 mTorr oxygen partial pressure for both the substrates. These films were characterized by x-ray diffraction XRD and Raman spectroscopy measurements. XRD results reveal that these films are single phase. Raman results show F2g mode at ~466 cm-1 and defect peak at 489 cm-1 for film that deposited on LAO substrates, full width at half maximum (FWHM) is increasing with Fe doping for films deposited on both the substrates.

CRYSTALLINE SrTiO3 THIN FILMS ON SILICON BY PULSED LASER DEPOSITION

2005 ◽  
Vol 19 (01n03) ◽  
pp. 533-535
Author(s):  
J. H. HAO ◽  
J. GAO
Keyword(s):  
Thin Films ◽  
Pulsed Laser Deposition ◽  
Pulsed Laser ◽  
Laser Deposition ◽  
Perovskite Oxide ◽  
Deposition Technique ◽  
X Ray Diffraction ◽  
Rocking Curve ◽  
X Ray ◽  
Silicon Materials

We have developed a process to grow SrTiO 3 ( STO ) thin films showing single (110) orientation directly on Si by means of pulsed laser deposition technique. The growth of STO films directly on Si has been described. The crystallinity of the grown STO films was characterized by X-ray diffraction analysis of θ-2θ scan and rocking curve. Our results may be of interest for better understanding of the growth based on the perovskite oxide thin films on silicon materials.

Thermoelectric Properties of C-Axis-Oriented Ca3Co4O9+δ Films Grown on MgO-Buffered Si (100) by PLD Technique

2010 ◽  
Vol 29-32 ◽  
pp. 1913-1918
Author(s):  
Xia Zhang ◽  
Hong Chen ◽  
Qiu Hui Liao ◽  
Xia Li
Keyword(s):  
Thin Films ◽  
State Of The Art ◽  
Pulsed Laser ◽  
Buffer Layers ◽  
Laser Deposition ◽  
X Ray Diffraction ◽  
High Quality ◽  
X Ray ◽  
Current State ◽  
Good Crystallinity

High-quality c-axis-oriented Ca3Co4O9+δ thin films have been grown directly on Si (100) wafers with inserting MgO buffer layers by pulsed-laser deposition (PLD). X-ray diffraction and scan electron microscopy show good crystallinity of the Ca3Co4O9+δ films. The resistivity and Seebeck coefficient of the Ca3Co4O9+δ thin films on Si (100) substrates are 9.8 mΩcm and 189 μV/K at the temperature of 500K, respectively, comparable to the single-crystal samples. This advance demonstrates the possibility of integrating the cobaltate-based high thermoelectric materials with the current state-of-the-art silicon technology for thermoelectricity-on-a-chip applications.

Growth of CaFeOX/LaFeO3 Superlattice on SrTiO3(100) Substrates

2011 ◽  
Vol 1292 ◽  
Author(s):  
Nobuyuki Iwata ◽  
Mark Huijben ◽  
Guus Rijnders ◽  
Hiroshi Yamamoto ◽  
Dave H. A. Blank
Keyword(s):  
Thin Films ◽  
Pulsed Laser Deposition ◽  
Pulsed Laser ◽  
Layer Growth ◽  
Laser Deposition ◽  
Growth Mode ◽  
Layer By Layer ◽  
X Ray Diffraction ◽  
Reciprocal Space Mapping ◽  
X Ray

ABSTRACTThe CaFeOX(CFO) and LaFeO3(LFO) thin films as well as superlattices were fabricated on SrTiO3(100) substrates by pulsed laser deposition (PLD) method. The tetragonal LFO film grew with layer-by-layer growth mode until approximately 40 layers. In the case of CFO, initial three layers showed layer-by-layer growth, and afterward the growth mode was transferred to two layers-by-two layers (TLTL) growth mode. The RHEED oscillation was observed until the end of the growth, approximately 50nm. Orthorhombic twin CaFeO2.5 (CFO2.5) structure was obtained. However, it is expected that the initial three CFO layers are CaFeO3 (CFO3) with the valence of Fe4+. The CFO and LFO superlattice showed a step-terraces surface, and the superlattice satellite peaks in a 2θ-θ and reciprocal space mapping (RSM) x-ray diffraction (XRD) measurements, indicating that the clear interfaces were fabricated.

High temperature x-ray diffraction studies of zirconia thin films prepared by reactive pulsed laser deposition

2011 ◽  
Vol 47 (4) ◽  
pp. 415-422 ◽  
Author(s):  
G. Balakrishnan ◽  
P. Kuppusami ◽  
S. Murugesan ◽  
E. Mohandas ◽  
D. Sastikumar
Keyword(s):  
Thin Films ◽  
High Temperature ◽  
Pulsed Laser Deposition ◽  
Pulsed Laser ◽  
Laser Deposition ◽  
X Ray Diffraction ◽  
X Ray

scholarly journals Lead potassium niobate thin films grown by Pulsed Laser Deposition

2016 ◽  
Vol vol1 (1) ◽  
Author(s):  
Billal Allouche ◽  
Yaovi Gagou ◽  
M. El Marssi
Keyword(s):  
Thin Films ◽  
Pulsed Laser Deposition ◽  
Pulsed Laser ◽  
Laser Deposition ◽  
Potassium Niobate ◽  
X Ray Diffraction ◽  
X Ray ◽  
Deposition Parameters ◽  
Out Of Plane

By pulsed laser deposition, lead potassium niobate Pb2KNb5O15 was grown on (001) oriented Gd3Ga5O12 substrate using a platinum buffer layer. The PKN thin films were characterized by X-Ray diffraction and Scanning Electron Microscopy (SEM). The dependence of their structural properties as a function of the deposition parameters was studied. It has been found that the out of plane orientation of PKN film depends on the oxygen pressure used during the growth. Indeed, PKN thin film is oriented [001] for low pressure and is oriented [530] for high pressure. For these two orientations, the crystalline quality of PKN film was determined using omega scans.

ZrC Thin Films Grown by Pulsed Laser Deposition

2003 ◽  
Vol 780 ◽  
Author(s):  
V. Craciun ◽  
D. Craciun ◽  
J. M. Howard ◽  
R. K. Singh
Keyword(s):  
Thin Films ◽  
Pulsed Laser Deposition ◽  
Photoelectron Spectroscopy ◽  
Pulsed Laser ◽  
Surface Region ◽  
Laser Deposition ◽  
X Ray Diffraction ◽  
X Ray ◽  
Si Substrates ◽  
Crystalline Films

AbstractZrC thin films were grown on Si substrates by the pulsed laser deposition (PLD) technique. X- ray photoelectron spectroscopy, x-ray diffraction and reflectivity, variable angle spectroscopic ellipsometry, and four point probe measurements were used to investigate the composition, density, thickness, surface morphology, optical and electrical properties of the grown structures. It has been found that crystalline films could be grown only by using fluences above 6 J/cm2 and substrate temperatures in excess of 500 °C. For a fluence of 10 J/cm2 and a substrate temperature of 700 °C, highly (100)-textured ZrC films exhibiting a cubic structure (a=0.469 nm) and a density of 6.7 g/cm3 were deposited. The use of a low-pressure atmosphere of C2H2 had a beneficial effect on crystallinity and stoichiometry of the films. All films contained high levels of oxygen contamination, especially in the surface region, because of the rather reactive nature of Zr atoms.

Sign in / Sign up

Export Citation Format

Share Document