scholarly journals S. K. Olenin. - To the pathology of the hymen. - (Archpriest Tambov. Med. General 1894, 1-12. Tambov, 1895. Page 109).

2020 ◽  
Vol 9 (9) ◽  
pp. 809
Author(s):  
N. Kakushkin

1st case. 20 years old, recently married. Coitus has never been successful. Besides fleshy, with a small hole, hymen in the usual place, sntm. 1-2 higher, in the vaginal cavity, there is a transverse septum with a hole that barely passes the end of the little finger. Lateral cuts of the outer septum were made and the posterior flap formed in this way was cut out; the wound was closed with knotty sutures. The ring is scattered on the narrowed place of the vagina. Systematic expansion of iodoforms. gauze. Convalescence.2nd case. 45 years old, nulliparous. Coitus was never accompanied by pain, but the patient almost constantly suppresses the secretion from the vagina. The hymen, thick, with a very small opening, is pressed into the vaginal cavity, thanks to 29 years of married life, but not torn. Haematocolpos. Two side cuts; the edges are cut and sewn.

Author(s):  
P. B. Basham ◽  
H. L. Tsai

The use of transmission electron microscopy (TEM) to support process development of advanced microelectronic devices is often challenged by a large amount of samples submitted from wafer fabrication areas and specific-spot analysis. Improving the TEM sample preparation techniques for a fast turnaround time is critical in order to provide a timely support for customers and improve the utilization of TEM. For the specific-area sample preparation, a technique which can be easily prepared with the least amount of effort is preferred. For these reasons, we have developed several techniques which have greatly facilitated the TEM sample preparation.For specific-area analysis, the use of a copper grid with a small hole is found to be very useful. With this small-hole grid technique, TEM sample preparation can be proceeded by well-established conventional methods. The sample is first polished to the area of interest, which is then carefully positioned inside the hole. This polished side is placed against the grid by epoxy Fig. 1 is an optical image of a TEM cross-section after dimpling to light transmission.


Author(s):  
Elisabeth van Houts

This book contains an analysis of the experience of married life by men and women in Christian medieval Europe c. 900–1300. The focus will be on the social and emotional life of the married couple rather than on the institutional history of marriage. The book consists of three parts: the first part (Getting Married) is devoted to the process of getting married and wedding celebrations, the second part (Married Life) discusses the married life of lay couples and clergy, their sexuality, and any remarriage, while the third part (Alternative Living) explores concubinage and polygyny as well as the single life in contrast to monogamous sexual unions. Four main themes are central to the book. First, the tension between patriarchal family strategies and the individual family member’s freedom of choice to marry and, if so, to what partner; second, the role played by the married priesthood in their quest to have individual agency and self-determination accepted in their own lives in the face of the growing imposition of clerical celibacy; third, the role played by women in helping society accept some degree of gender equality and self-determination to marry and in shaping the norms for married life incorporating these principles; fourth, the role played by emotion in the establishment of marriage and in married life at a time when sexual and spiritual love feature prominently in medieval literature.


Micromachines ◽  
2021 ◽  
Vol 12 (7) ◽  
pp. 828
Author(s):  
Zhaolong Li ◽  
Ye Dai

This paper presents a simulation and experimental study of the structure of small holes in GH4169 alloy electrolytic ally processed by tube electrodes with different characteristic power sources. It analyzes the multi-physical field coupling relationship of flow, temperature, and electric fields within the interstitial space. The results indicate that the tube electrode electrolytic processing of the GH4169 alloy small hole structure with a pulsed power supply has more uniform temperature and current density distribution within the gap, which is beneficial to the processing accuracy and smoothness of the small hole structure. Meanwhile, SEM was used to analyze the microscopic morphology of the electrode end surface during short-circuiting, and it was concluded that as the processing continued, the electrode end surface gradually produced a non-metallic oxide layer, which destroyed the electric field of the gap and affected the processing stability. The use of high-frequency positive and negative pulse power can effectively avoid the generation of a non-metallic oxide layer. Through the combination of simulation analysis and experimental verification, it is concluded that increasing electrolyte pressure in stages can effectively improve machining accuracy and stability. The interstitial current increases as the feed rate of the tool electrode increases, and the diameter of the machined small hole decreases as it increases.


2020 ◽  
Vol 4 (Supplement_1) ◽  
Author(s):  
Rajiv Ark

Abstract Case report - Introduction In 2011 a gentleman in his 50s presented with nasal blockage and bloody discharge. He was diagnosed with sarcoidosis and after 9 years of failed strategies to control his disease, he developed dactylitis. X-ray of the hands showed severe arthropathy in the distal interphalangeal joints. This case demonstrates an uncommon extrapulmonary manifestation of sarcoidosis. Although most of his follow up was with a respiratory clinic, his main symptoms were not due to interstitial lung disease, highlighting the importance of a multidisciplinary approach. To reduce the need for steroids, several DMARDs were tried illustrating that there are limited treatment options. Case report - Case description This gentleman presented in June 2011 with left epiphora, bloody nasal discharge and fatigue. He had no family history of sarcoidosis and was of Caucasian ethnicity. He was referred by his GP to Ophthalmology and ENT. Septoplasty showed a 95% blockage at the lacrimal sac. A biopsy was performed, and histology showed a nasal sarcoid granuloma. He was referred to the respiratory team who requested a high-resolution CT scan showing sizeable lymph nodes. One inguinal node was biopsied confirming sarcoid granulomas before starting treatment. Calcium was briefly raised, and serum ACE was initially 123. He was started on 40mg of prednisolone for 6 weeks, which was tapered to 20/25mg on alternating days. There was a recurrence of his nasal discharge; steroids were increased again but he developed symptoms of muscle weakness from long term steroid use. He was referred to an interstitial lung disease clinic at a tertiary centre where he was investigated for cardiac sarcoidosis with MRI due to ventricular ectopics. Hydroxychloroquine was started to reduce the steroid use however he developed symptoms of tinnitus, so it was stopped. Methotrexate, Azathioprine and Leflunomide were all trialled to however they did not have any impact on controlling his disease. His Prednisolone was slowly reduced by 1mg a month. When he had recurrence of his symptoms, he was given IV methylprednisolone. Nine years after his first presentation he presented with stiffness of the right thumb base. This progressed to dactylitis and slight fixed flexion deformity of right index finger and left little finger. An x-ray of his hands showed disease in the distal interphalangeal joints bilaterally with severe changes in the left little finger. The effects of long-term steroids led him to request a letter to support early retirement. Case report - Discussion The main rationale for changing treatment options was to reduce the prednisolone dose. Steroids were the only treatment option that showed evidence of controlling his disease when the dose was between 25mg and 40mg a day. Each of the DMARDs that were trialled had a different side effect profile and did not show any evidence of suppressing disease as symptoms recurred. Dose changes later in treatment fluctuated, reflecting a balancing act between disease recurrence and side effects of long-term steroids. There are many extra pulmonary manifestations of sarcoidosis that were investigated in this case. The first being the nasal granuloma, which can occur in sarcoid patients with symptoms of epistaxis, crusting, congestion, and pain. There were granulomatous changes seen in the hila as well as other lymph nodes such as the inguinal region; inguinal lymphadenopathy can lead to pain in the groin area. In addition to this it was important to exclude uveitis with ophthalmology review as he had symptoms of epiphora. Uveitis can be diagnosed in ophthalmological assessment of sarcoid patients in the absence of ocular complaints. Cardiac sarcoidosis was excluded with an MRI at a specialist heart and lung centre due to ventricular ectopics. Cardiac sarcoidosis can lead to heart block, arrhythmias, and congestive cardiac failure. Finally, he developed sarcoid arthropathy, review of his radiological images over time showed extensive damage to the joints of the hand. This gentleman had poor outcomes due to limited treatment options for his disease. Being restricted to long term steroid as the mainstay of treatment led to early retirement due to fatigue and muscle weakness. Conversely, under dosing steroids led to recurrence in symptoms. His disease is still not controlled as shown by an evolving sarcoid arthropathy. Case report - Key learning points An illustration of sarcoid arthropathy is also shown in this case. Sarcoid arthropathy is an uncommon manifestation of the disease primarily affecting joints in the hands and feet. In this case the distal interphalangeal joints and proximal interphalangeal joints were affected. The first symptom of arthropathy was stiffness of the base of the right thumb in 2017, this could fit with an osteoarthritic picture and could be mistaken for it in undiagnosed sarcoidosis. The most severe disease was in the DIP of the left little finger, which is not commonly affected. An oligoarthritic pattern with involvement of the ankle is seen more often. This is also an unusual case of sarcoidosis as there was no family history of the disease and his ethnicity did not predispose him to the condition. He also had a few uncommon extra pulmonary manifestations of sarcoidosis. The importance of a multidisciplinary approach in managing sarcoidosis was demonstrated in this case. Most of his follow up was with a respiratory clinic. However, respiratory symptoms were not the main issue during the patient journey; early ENT and rheumatology input was significant in managing his disease. Although pulmonary lymph nodes were enlarged, they did not affect his lung function.


1989 ◽  
Vol 38 (1) ◽  
pp. 277-280
Author(s):  
Tatsuya Ogata ◽  
Kosuke Hyakutake ◽  
Hiroshi Inoue ◽  
Masashi Sagara ◽  
Shyoji Nakao ◽  
...  

1975 ◽  
Vol 53 (6) ◽  
pp. 560-564 ◽  
Author(s):  
L. H. Huang

Triangularia backusii n. sp. was isolated from a soil sample collected in Ohio, U.S.A., and was subjected to alcohol treatment. Triangularia backusii is characterized by oval to pyriform perithecia, elongate-clavate asci, and obovoid ascospores with hyaline, gelatinous appendages. The ascospores are two-celled with a transverse septum; the upper cell is obovoid with a truncate base and brownish black to black and the lower cell is triangular and pale brown to brown. The conidial state is assignable to the genus Phialophora. The new species differs from other known Triangularia species in having the largest ascospores.


2011 ◽  
Vol 413 ◽  
pp. 520-523
Author(s):  
Cai Xia Luo

The Stress Distribution in the Connection of the Spherical Shell and the Opening Nozzle Is Very Complex. Sharp-Angled Transition and Round Transition Are Used Respectively in the Connection in the Light of the Spherical Shell with the Small Opening and the Large One. the Influence of the Two Connecting Forms on Stress Distribution Is Analyzed by Establishing Finite Element Model and Solving it. the Result Shows there Is Obvious Stress Concentration in the Connection. Round Transition Can Reduce the Maximum Stress in Comparison with Sharp-Angled Transition in both Cases of the Small Opening and the Large Opening, Mainly Reducing the Bending Stress and the Peak Stress, but Not the Membrane Stress. the Effect of Round Transition on Reducing Stress Was Not Significant. so Sharp-Angled Transition Should Be Adopted in the Connection when a Finite Element Model Is Built for Simplification in the Future.


2010 ◽  
Vol 13 (02) ◽  
pp. 75-82 ◽  
Author(s):  
Takako Chikenji ◽  
Hajime Toda ◽  
Chin Gyoku ◽  
Naoki Oikawa ◽  
Masaki Katayose ◽  
...  

The purpose of this study was to investigate the strengths of four intrinsic muscles of the hand of college baseball players. The strengths of four intrinsic muscle groups were measured by the Rotterdam Intrinsic Hand Myometer (RIHM) which has been developed to assess the abduction of the little finger and index finger, and palmar abduction and opposition of the thumb. The strengths of these four intrinsic muscle groups were compared between baseball players and inexperienced sports players. The abduction of the little finger and index finger, and the opposition of the thumb in both the dominant and nondominant hands of the baseball players were notably stronger than those of the inexperienced sports players. There was no statistical difference in the strength of the palmar abduction of the thumb between the two groups. The results suggest that the specific intrinsic muscles in both the dominant and nondominant hands might be strengthened by repeated baseball practices, such as a batting performance, which requires strain in both the dominant and nondominant hands repeatedly.


Sign in / Sign up

Export Citation Format

Share Document