scholarly journals Analysis of the impact of wind on fuel consumption and emissions of harmful exhaust gas compounds on the selected flight route

2019 ◽  
Vol 179 (4) ◽  
pp. 93-101
Author(s):  
Marta GALANT ◽  
Paula KURZAWSKA ◽  
Marta MACIEJEWSKA ◽  
Monika KARDACH

The article discusses the issue of the impact of wind force and direction on fuel consumption and the emission of harmful exhaust gases on the selected flight route. The focus was on percentage changes in fuel consumption and emissions of individual harmful exhaust gas compounds depending on the wind speed and the direction from which it interacts with the aircraft. The analysis was carried out for three different flight levels, in order to compare changes in fuel consumption and emissions also in terms of flight altitude, however the following article focuses only on one level – FL240.

2018 ◽  
Vol 173 (2) ◽  
pp. 55-60
Author(s):  
Małgorzata PAWLAK ◽  
Andrzej MAJKA ◽  
Michał KUŹNIAR ◽  
Jowita PAWLUCZY

Among the most important problems currently faced by air transport, we can distinguish the adverse impact of aircrafts on the natu-ral environment, as well as the rising costs of transport. One of the possibilities to improve this situation is better adjustment of aircraft characteristics to the performed transport tasks, taking into account all the requirements and limitations that exist in air traffic and the adverse impact of air transport on the natural environment. It is reflected in the research tasks conducted under the SESAR program. The aspiration to minimize the adverse impact of aircrafts on the environment is executed, among others, through determining such trajectories that are characterized by minimal fuel consumption or minimal emission of harmful substances in the engines exhausts. These goals are corresponding with the research conducted and described in the paper. The main aim of the work was to analyse the impact of wind speed and direction on the emission of harmful substances of a jet aircraft performing a flight on a given route. For research purposes, the route between two Polish cities Gdansk and Rzeszow was considered. The distance between the two airports was divided into sections for which wind direction and strength were determined (read from the windy.com website). Next, the aircraft per-formance was determined and the fuel consumption and the amount of harmful compounds (CO2, NOx, CO and HC), emitted in the en-gines exhausts were determined for the route from Gdansk to Rzeszow (under favourable wind conditions) and on the return route – from Rzeszow to Gdansk (under unfavourable wind conditions). For comparative purposes, emission of these substances for windless condi-tions was also determined. The results are presented in tables and depicted in the graph, as well as discussed in the conclusions of the paper.


2018 ◽  
Vol 122 (1258) ◽  
pp. 1967-1984 ◽  
Author(s):  
M. E. J. Stettler ◽  
G. S. Koudis ◽  
S. J. Hu ◽  
A. Majumdar ◽  
W. Y. Ochieng

ABSTRACTOptimisation of aircraft ground operations to reduce airport emissions can reduce resultant local air quality impacts. Single engine taxiing (SET), where only half of the installed number of engines are used for the majority of the taxi duration, offers the opportunity to reduce fuel consumption, and emissions of NOX, CO and HC. Using 3510 flight data records, this paper develops a model for SET operations and presents a case study of London Heathrow, where we show that SET is regularly implemented during taxi-in. The model predicts fuel consumption and pollutant emissions with greater accuracy than previous studies that used simplistic assumptions. Without SET during taxi-in, fuel consumption and pollutant emissions would increase by up to 50%. Reducing the time before SET is initiated to the 25th percentile of recorded values would reduce fuel consumption and pollutant emissions by 7–14%, respectively, relative to current operations. Future research should investigate the practicalities of reducing the time before SET initialisation so that additional benefits of reduced fuel loadings, which would decrease fuel consumption across the whole flight, can be achieved.


Author(s):  
Tessa Tielert ◽  
Moritz Killat ◽  
Hannes Hartenstein ◽  
Raphael Luz ◽  
Stefan Hausberger ◽  
...  

2019 ◽  
pp. 81-86
Author(s):  
Дмитро Вікторович Коновалов

There are many ways and methods to reduce exhaust gases emissions on modern ships. One of the most effective ways to reduce NOx and SOx emissions is to use of exhaust gas recirculation (EGR technology). The EGR system disadvantage is an increase in back pressure through additional pressure losses in the scrubber and heat ex-changer, which entails an engine fuel efficiency deterioration. Creating a reliable and efficient heat exchanger for cooling recirculation gases is a complex task due to deposits and pollution emitted by these gases. In the pre-sent work, the jet apparatus effectiveness named aerothermopressor is analyzed in the scheme with exhaust gases recirculation of the ship low-speed two-stroke engine. Aerothermopressor is a two-phase jet for contact disperse cooling, in which by increasing the heat from the gas stream the gas pressure and cooling are increased. The calculation of the characteristics of the engine was carried out, both in nominal, and in operating modes and in all possible range of partial loads. The installation of the aerothermopressor before the scrubber is pro-posed, which allows reducing engine thermal load. Increasing the pressure in the aerothermopressor by 0.2-0.4 ∙ 105 Pa (6-12 %) allows reducing the back pressure in the gas exhaust system and thus reducing the load on the exhaust gas recirculation fan and when the engine load is higher than 75% in the cold zone, the fan is not need-ed, which additionally allows to reduce the specific fuel consumption. The parameters of the exhaust gases that are going to be recirculated and the processes of their gas-dynamic cooling in the aerothermopressor are based on the developed technique and program using the thermodynamic and gas dynamics equations. The proposed scheme-design solution allows at a high environmental friendliness of the existing exhaust gas recirculation sys-tem to provide a certain reduction in specific fuel consumption. It was determined that the engine specific fuel consumption has been decreasing when the aerothermopressor is used to Dge = 2.5-3.0 g/(kW·h) (1.5-1.7%).


2019 ◽  
Vol 48 (3) ◽  
pp. 236-241
Author(s):  
Hang Cao ◽  
Máté Zöldy

The aim of this paper is to evaluate the impact of connected autonomous behavior in real vehicles on vehicle fuel consumption and emission reductions. Authors provide a preliminary theoretical summary to assess the driving conditions of autonomous vehicles in roundabout, which attempts exploring the impact of driving behavior patterns on fuel consumption and emissions, and including other key factors of autonomous vehicles to reduce fuel consumption and emissions. After summarizing, driving behavior, effective in-vehicle systems, both roundabout physical parameters and vehicle type are all play an important role in energy using. ZalaZONE’s roundabout is selected for preliminary test scenario establishment, which lays a design foundation for further in-depth testing.


2020 ◽  
Author(s):  
Ronny Badeke ◽  
Volker Matthias ◽  
David Grawe

Abstract. Estimating the impact of ship emissions on local air quality is a topic of high relevance, especially in large harbour cities. For chemistry transport modeling studies, the initial plume rise and dispersion play a crucial role for the distribution of pollutants into vertical model layers. This study aims at parameterizing the vertical downward dispersion in the near-field of a prototype cruise ship, depending on several meteorological and technical input parameters. By using the micro-scale transport and stream model MITRAS, a parameterization scheme was developed to calculate the downward dispersion, i.e. the fraction of emissions, which will be dispersed below stack height. This represents the local concentration in the vicinity of the ship. Cases with and without considering the obstacle effect of the ship have been compared. Wind speed and ship size were found to be the strongest factors influencing the downward dispersion, which can reach values up to 55 % at high wind speed and lateral wind. This compares to 31 % in the case where the obstacle effect was not considered and shows the importance of obstacle effects when assessing the ground-level pollution situation in ports.


2021 ◽  
Author(s):  
Patrycja Puzdrowska

The paper discusses the impact of changes in the compression ratio on the operating parameters of a diesel engine, e.g. on the temperature of exhaust gases. It presents the construction of the laboratory test stand, on which experimental measurements were realized. It is characterized how the actual changes of the compression ratio were introduced to the existing engine. The program of experimental investigations taking into account the available test stand and measurement possibilities was described. A statistical and qualitative analysis of the obtained measurement results was made. The use of F statistics of the Fisher-Snedecor distribution was proposed to assess the significance of the effect of compression ratio changes on the specific enthalpy of the exhaust gas stream. The specific enthalpy of exhaust gases was analysed for one cycle of diesel engine work, determined on the basis of the course of quickly varying temperature of exhaust gases. The results of these analyses are discussed and the utilitarian purpose of this type of evaluation in parametric diagnostics of piston engines is presented.


Sign in / Sign up

Export Citation Format

Share Document