scholarly journals Stress Accumulation and Earthquake Activity on the Great Sumatran Fault, Indonesia

Author(s):  
Muhammad Taufiq Rafie ◽  
David P. Sahara ◽  
Phil R. Cummins ◽  
Wahyu Triyoso ◽  
Sri Widiyantoro

Abstract The seismically active Sumatra subduction zone has generated some of the largest earthquakes in the instrumental record, and both historical accounts and paleogeodetic coral studies indicate such activity has historical recorded megathrust earthquakes and transferred stress to the surrounding, including the Great Sumatran Fault (GSF). Therefore, evaluating the stress transfer from these large subduction earthquakes could delineate the highly stressed area as potential-earthquake region along the GSF. In this study, we investigated eight megathrust earthquakes from 1797 to 2010 and resolved the accumulated Coulomb stress changes onto the 18 segments along the GSF. Additionally, we also estimated the rate of tectonic stress on the GSF segments which experienced large earthquake using the case of: (1) no sliver movement and (2) with sliver movement. Based on the historical stress changes of large earthquakes and the increase in tectonic stress rate, we analysed the historical stress changes time evolution on the GSF. The Coulomb stress accumulation of megathrust earthquakes between 1797-1907 increase the stress changes mainly on the southern part of GSF which followed by four major events between 1890-1943. The estimation of tectonic stress rates using case (1) produces low rate and long recurrence intervals which implies that the megathrust earthquakes plays an important role in allowing the GSF earthquake to occur. When implementing the arc-parallel sliver movement of case (2) to the calculation, the tectonic stress rates is 9 to 58 times higher than case (1) of no sliver movement. The observed slip rate of 15-16 mm/yr at the GSF is consistent with the recurrence interval for full-segment rupture of 100-200 years obtained from case (2). This suggests that the GSF earthquake is more controlled by the rapid arc-parallel forearc sliver motion. Furthermore, the analysis of stress changes time evolution model shows that some segments such as Tripa (North and South), Angkola, Musi and Manna appear to be brought back in their seismic cycles since these segments have experienced full-segment rupture and likely locked, increasing their earthquake hazard potentials.

2018 ◽  
Vol 10 (12) ◽  
pp. 2048 ◽  
Author(s):  
Rumeng Guo ◽  
Yong Zheng ◽  
Wen Tian ◽  
Jianqiao Xu ◽  
Wenting Zhang

By combining the seismogenic environment, seismic recurrence periods of strong historical earthquakes, precise locations of small–moderate earthquakes, and Coulomb stress changes of moderate–strong earthquakes, we analyze the potential locking status of a seismically quiet segment of Xianshuihe fault between Daofu County and Kangding City (SDK). The interseismic surface velocities between 1999 and 2017 are obtained from updated global positioning system (GPS) observations in this region. After removing the post-seismic relaxation effect caused by the 2008 Mw 7.9 Wenchuan earthquake that occurred around the fault segment, the observed velocities reveal a pronounced symmetric slip pattern along the SDK trace. The far field slip rate is 7.8 ± 0.4 mm/a, and the fault SDK is confirmed to be in an interseismic silent phase. The optimal locking depth is estimated at 7 km, which is perfectly distributed on the upper edge of the relocated hypocenters. A moment deficit analysis shows cumulative seismic moment between 1955 and 2018, corresponding to an Mw 6.6 event. Finally, based on a viscoelastic deformation model, we find that moderate–strong earthquakes in the surrounding area increase the Coulomb stress level by up to 2 bars on the SDK, significantly enhancing the future seismic potential.


2018 ◽  
Vol 40 (1) ◽  
pp. 386
Author(s):  
A. Messini ◽  
E. E. Papadimitriou ◽  
V. G. Karakostas ◽  
I. Baskoutas

The occurrence of strong earthquakes (M>6.3) and the evolution of the stress field along the southwestern part of the Hellenic arc since 1959 are examined by the calculation of Coulomb stress changes. The study area is characterized by low angle thrust faults and high seismicity as being part of the subduction interface. Coulomb stress changes were calculated assuming that earthquakes can be modeled as static dislocations in an elastic half-space, considering the co-seismic slip during strong events and the slow tectonic stress build-up along major fault segments due to the movements of the tectonic plates. The ruptures are modeled taking into account the strike, dip, and rake appropriate to each event examined. It is evaluated whether the stress changes brought a given earthquake closer to, or farther away from, failure. It was found that the majority of the events (strong and smaller) are located in stress enhanced areas.


2020 ◽  
Author(s):  
Julius Jara-Muñoz ◽  
Daniel Melnick ◽  
Anne Socquet ◽  
Joaquin Cortés-Aranda ◽  
Dominik Brill ◽  
...  

Abstract In seismically-active regions, mapping capable faults and estimating their recurrence time is the first step to assess seismic hazards. Fault maps are commonly based on geologic and geomorphic features evident at the surface; however, mapping blind faults and estimating their seismic potential is challenging because on-fault diagnostic features are absent. Here, we study the Pichilemu Fault in coastal Chile, unknown until it generated a M7.0 earthquake in 2010. The lack of evident surface faulting suggests a partly-hidden blind fault. Using off-fault deformed marine terraces, we estimate a slip-rate of 0.42 ± 0.04 m/ka, which when integrated with deformation estimated from satellite geodesy during the 2010 earthquake suggests a 2.5 ± 0.25 ka recurrence time for M6.6-6.9 extensional earthquakes. We propose that extension is associated with stress changes during megathrust earthquakes and accommodated by sporadic slip during upper-plate earthquakes. Our results have implications for assessing the seismic potential of cryptic faults along seismically-active coasts.


Author(s):  
R. Alac Barut ◽  
J. Trinder ◽  
C. Rizos

On August 17<sup>th</sup> 1999, a M<sub>w</sub> 7.4 earthquake struck the city of Izmit in the north-west of Turkey. This event was one of the most devastating earthquakes of the twentieth century. The epicentre of the Izmit earthquake was on the North Anatolian Fault (NAF) which is one of the most active right-lateral strike-slip faults on earth. However, this earthquake offers an opportunity to study how strain is accommodated in an inter-segment region of a large strike slip fault. In order to determine the Izmit earthquake post-seismic effects, the authors modelled Coulomb stress changes of the aftershocks, as well as using the deformation measurement techniques of Interferometric Synthetic Aperture Radar (InSAR) and Global Navigation Satellite System (GNSS). The authors have shown that InSAR and GNSS observations over a time period of three months after the earthquake combined with Coulomb Stress Change Modelling can explain the fault zone expansion, as well as the deformation of the northern region of the NAF. It was also found that there is a strong agreement between the InSAR and GNSS results for the post-seismic phases of investigation, with differences less than 2mm, and the standard deviation of the differences is less than 1mm.


2014 ◽  
Vol 971-973 ◽  
pp. 2172-2175
Author(s):  
Dong Ning Lei ◽  
Jian Chao Wu ◽  
Yong Jian Cai

TheCoulomb stress changes are usually adopted to make analysis on faultinteractions and stress triggering. This paper mainly deals with Coulomb stresschange of mainshock and affect on aftershocks. We preliminarily conclude thatthe mainshock produce Coulomb stress change on aftershocks most behavingpositive and triggered them. By calculating it is obvious that more aftershocksfell into stress increasing area and triggering percentage is up to ninety ofmaximum and seventy-one of minimum.


2015 ◽  
Vol 173 (1) ◽  
pp. 49-72 ◽  
Author(s):  
K. M. Leptokaropoulos ◽  
E. E. Papadimitriou ◽  
B. Orlecka–Sikora ◽  
V. G. Karakostas

Sign in / Sign up

Export Citation Format

Share Document