scholarly journals Intensification of Xylo-oligosaccharides Production by Hydrothermal Treatment of Brewer’s Spent Grains: Use of Extremely Low Acid Catalyst for Reduction of Degradation Products Associated With High Solids Loading

Author(s):  
Lukas J. Swart ◽  
Oscar Koku Kplorm Bedzo ◽  
Eugéne van Rensburg ◽  
Johann F. Görgens

Abstract Brewers’ spent grains (BSG) make up to 85% of a brewery’s solid waste, and is either sent to landfill or sold as cheap animal feed supplement. Xylo-oligosaccharides (XOS) obtained from BSG are antioxidants and prebiotics that can be used in food formulations as low-calorie sweeteners and texturisers. The effect of extremely low acid (ELA) catalysis in liquid hot water (LHW) hydrothermal treatment (HTT) was assessed using BSG with dry matter contents of 15% and 25%, achieved by dewatering using a screw press. Batch experiments at low acid loadings of 5, 12.5 and 20 mg/g dry mass and temperatures of 120, 150 and 170 °C significantly affected XOS yield at both levels of dry mass considered. Maximum XOS yields of 76.4% (16.6 g/l) and 65.5% (31.7 g/l) were achieved from raw BSG and screw pressed BSG respectively, both at 170 °C and using 5 mg acid/g dry mass, after 15 min and 5 min, respectively. These XOS yields were obtained with BSG containing up to 63% less water and temperatures more than 20 °C lower than that reported previously. The finding confirms that ELA dosing in LHW HTT allows lowering of the required temperature that can result in a reduction of degradation products, which is especially relevant under high solids conditions. This substantial XOS production intensification through higher solids loadings in HTT, not only achieved high product yield, but also provided benefits such as increased product concentrations and decreased process heat requirements.

2015 ◽  
Vol 2015 ◽  
pp. 1-13 ◽  
Author(s):  
Stuart Wilkinson ◽  
Katherine A. Smart ◽  
David J. Cook

For the production of bioethanol from lignocellulosic biomass, it is important to optimise the thermochemical pretreatment which is required to facilitate subsequent liberation of monomeric sugars. Here, we report optimisation of pretreatment conditions for brewers spent grains (BSG) with the main objectives of (1) working at commercially relevant high solids content, (2) minimising energy and chemical inputs, and (3) maximising downstream sugar yields. Studies indicated there to be a play-off between pretreatment solids content, the usage of an acid catalyst, and pretreatment temperature. For example, yields of 80–90% theoretical glucose could be obtained following pretreatment at 35% w/v solids and 200°C, or at 140–160°C with addition of 1% HCl. However, at very high solids loadings (40–50% w/v) temperatures of 180–200°C were necessary to attain comparable sugar yields, even with an acid catalyst. The feasibility of producing bioethanol from feedstocks generated using these protocols was demonstrated (but not optimised) at laboratory scale.


2016 ◽  
Vol 111 ◽  
pp. 387-402 ◽  
Author(s):  
Elin Svensson ◽  
Valeria Lundberg ◽  
Mikael Jansson ◽  
Charilaos Xiros ◽  
Thore Berntsson

2017 ◽  
Vol 60 (4) ◽  
pp. 1025-1033
Author(s):  
Alicia A. Modenbach ◽  
Sue E. Nokes ◽  
Michael D. Montross ◽  
Barbara L. Knutson

Abstract. High-solids lignocellulosic pretreatment using NaOH followed by high-solids enzymatic hydrolysis was evaluated for an on-farm biochemical conversion process. Increasing the solids loadings for these processes has the potential for increasing glucose concentrations and downstream ethanol production; however, sequential processing at high-solids loading similar to an on-farm cellulose conversion system has not been studied. This research quantified the effects of high-solids pretreatment with NaOH and subsequent high-solids enzymatic hydrolysis on cellulose conversion. As expected, conversion efficiency was reduced; however, the highest glucose concentration (40.2 g L-1), and therefore the highest potential ethanol concentration, resulted from the high-solids combined pretreatment and hydrolysis. Increasing the enzyme dosage improved cellulose conversion from 9.6% to 36.8% when high-solids loadings were used in both unit operations; however, increasing NaOH loading and pretreatment time did not increase the conversion efficiency. The enzyme-to-substrate ratio had a larger impact on cellulose conversion than the NaOH pretreatment conditions studied, resulting in recommendations for an on-farm bioconversion system. Keywords: Corn stover, Enzymatic hydrolysis, Enzyme loading, High solids, Low solids, Sodium hydroxide.


2001 ◽  
Vol 206-213 ◽  
pp. 75-78
Author(s):  
O. Lyckfeldt ◽  
Lisa Palmqvist ◽  
Frederic Poeydemenge

2018 ◽  
Vol 250 ◽  
pp. 273-280 ◽  
Author(s):  
Bárbara Ribeiro Alves Alencar ◽  
Emmanuel Damilano Dutra ◽  
Everardo Valadares de Sá Barretto Sampaio ◽  
Rômulo Simões Cezar Menezes ◽  
Marcos Antônio Morais

2018 ◽  
Vol 6 (6) ◽  
pp. 7859-7870 ◽  
Author(s):  
Ruyi Zhong ◽  
Yuhe Liao ◽  
Li Peng ◽  
Remus Ion Iacobescu ◽  
Yiannis Pontikes ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document