scholarly journals Frost Heave due to Ice Lens Formation in Freezing Soils

1995 ◽  
Vol 26 (2) ◽  
pp. 125-146 ◽  
Author(s):  
D. Sheng ◽  
K. Axelsson ◽  
S. Knutsson
Keyword(s):  
Pore Water Pressure ◽  
Water Pressure ◽  
Frost Heave ◽  
Darcy Law ◽  
Unfrozen Water ◽  
Clapeyron Equation ◽  
Unfrozen Water Content ◽  
Steady State Heat ◽  
Ice Pressure ◽  
Lens Formation

A frost heave model which simulates formation of ice lenses is developed for saturated salt-free soils. Quasi-steady state heat and mass flow is considered. Special attention is paid to the transmitted zone, i.e. the frozen fringe. The permeability of the frozen fringe is assumed to vary exponentially as a function of temperature. The rates of water flow in the frozen fringe and in the unfrozen soil are assumed to be constant in space but vary with time. The pore water pressure in the frozen fringe is integrated from the Darcy law. The ice pressure in the frozen fringe is determined by the generalized Clapeyron equation. A new ice lens is assumed to form in the frozen fringe when and where the effective stress approaches zero. The neutral stress is determined as a simple function of the unfrozen water content and porosity. The model is implemented on an personal computer. The simulated heave amounts and heaving rates are compared with experimental data, which shows that the model generally gives reasonable estimation.

Field frost heave measurement and prediction during periods of seasonal frost

1990 ◽  
Vol 27 (3) ◽  
pp. 393-397 ◽  
Author(s):  
H. N. Hayhoe ◽  
D. Balchin
Keyword(s):  
Temperature Gradient ◽  
Displacement Transducer ◽  
Linear Displacement ◽  
Time Domain Reflectometry ◽  
Frost Heave ◽  
Unfrozen Water ◽  
Data Logger ◽  
Unfrozen Water Content ◽  
Frost Penetration ◽  
Displacement Transducers

Frost heave measurements were taken over two winter seasons on a clay loam soil located near Ottawa, Canada. Heaving was measured using linear displacement transducers attached to a metal frame that was anchored in the soil below the depth of frost penetration. The output of the displacement transducer was recorded hourly using a microcomputer-based data logger. The system functioned reliably and the observed data compared well with published measurements.Soil temperature was recorded simultaneously using thermocouples. Time-domain reflectometry was used to measure the unfrozen water content. The study shows that soil temperature measurements can be used to estimate the temperature gradient at the freezing front for determining the cumulative frost heave, as suggested by the Konrad–Morgenstern theory of ice segregation processes. Key words: frost heave, temperature, gradient, displacement transducer, segregational potential.

scholarly journals Application of the Generalized Clapeyron Equation to Freezing Point Depression and Unfrozen Water Content

2018 ◽  
Vol 54 (11) ◽  
pp. 9412-9431 ◽  
Author(s):  
Jiazuo Zhou ◽  
Changfu Wei ◽  
Yuanming Lai ◽  
Houzhen Wei ◽  
Huihui Tian
Keyword(s):  
Water Content ◽  
Freezing Point ◽  
Unfrozen Water ◽  
Freezing Point Depression ◽  
Clapeyron Equation ◽  
Unfrozen Water Content

Influence of overconsolidation on the freezing characteristics of a clayey silt

1989 ◽  
Vol 26 (1) ◽  
pp. 9-21 ◽  
Author(s):  
J.-M. Konrad
Keyword(s):  
Hydraulic Conductivity ◽  
Void Ratio ◽  
Moisture Transfer ◽  
Frozen Soil ◽  
Frost Heave ◽  
Unfrozen Water ◽  
Initial Void Ratio ◽  
Clayey Silt ◽  
Segregation Potential ◽  
Lens Formation

Laboratory freezing tests were performed on a saturated clayey silt at various overconsolidation ratios (OCR) to establish the relationship between initial void ratio and stress history, and the amount of moisture transfer during freezing. The frost heave tests were analysed in terms of the segregation potential as well as a function of the temperature of ice lens formation and the overall hydraulic conductivity of the frozen fringe. All other factors being the same, the segregation potential was found to increase with increasing values of OCR (decreasing initial void ratios). However, the combined effects of decreasing void ratio and increasing suction at the frost line, all other factors being identical in all freezing tests, resulted in decreasing segregation potentials. This trend was the result of a decrease in the temperature of ice lens formation and the concomitant decrease in overall hydraulic conductivity of the frozen fringe. A simple model showed that the capillary unfrozen water between clay particles increases when the particles pack closer together, as overconsolidation increases, allowing the migratory water to freeze within the frozen soil at a colder temperature. Key words: frost heave, clayey silt, overconsolidation, void ratio.

scholarly journals Application of the Segregation Potential Model to Freezing Soil in a Closed System

Water ◽  
2020 ◽  
Vol 12 (9) ◽  
pp. 2418
Author(s):  
Xiyan Zhang ◽  
Yu Sheng ◽  
Long Huang ◽  
Xubin Huang ◽  
Binbin He
Keyword(s):  
Pore Water ◽  
Closed System ◽  
Potential Model ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Freezing Temperature ◽  
Frost Heave ◽  
Freezing Front ◽  
Freezing Soil ◽  
Segregation Potential

Previous studies have shown that an accurate prediction of frost heaves largely depends on the pore water pressure and hydraulic conductivity of frozen fringes, which are difficult to determine. The segregation potential model can avoid this problem; however, the conventional segregation potential is considered to be approximately unchanged at a steady state and only valid in an open system without dehydration in the unfrozen zone. Based on Darcy’s law and the conventional segregation potential, the segregation potential was expressed as a function of the pore water pressure at the base of the ice lens, the pore water pressure at the freezing front, the freezing temperature, the segregation freezing temperature and the hydraulic conductivity of the frozen fringe. This expression indicates that the segregation potential under quasi-steady-state conditions is not a constant in a closed system, since the pore water pressure at the freezing front varies with the freezing time owing to the dehydration of the unfrozen zone, and that when the pore water pressure at the freezing front is equal to that at the base of the ice lens, the water migration and frost heave will be terminated. To analyze the possibility of applying the segregation potential model in a closed system, a series of one-sided frost heave tests under external pressure in a closed system were carried out in a laboratory, and the existing frost heaving test data from the literature were also analyzed. The results indicate that the calculated frost heave was close to the tested data, which shows the applicability of the model in a closed system. In addition, the results show the rationality of calculating the segregation potential from the frost heaving test by comparing the potential with that calculated from the numerical simulation results. This study attempted to extend the segregation potential model to freezing soil in a closed system and is significant to the study of frost heaves.

TIME TO THE END OF PRIMARY CONSOLIDATION (EOP) OF SOFT CLAYEY SOILS: CONCERNING THE EFFECT OF ATTERBERG’S LIMIT AND CYCLIC LOADING HISTORY

2019 ◽  
Vol 128 (2B) ◽  
pp. 29-41
Author(s):  
Trần Thanh Nhàn
Keyword(s):  
Cyclic Loading ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Clayey Soils ◽  
Loading History ◽  
Cyclic Shear ◽  
Wide Range ◽  
Primary Consolidation ◽  
Time Required

In order to observe the end of primary consolidation (EOP) of cohesive soils with and without subjecting to cyclic loading, reconstituted specimens of clayey soils at various Atterberg’s limits were used for oedometer test at different loading increments and undrained cyclic shear test followed by drainage with various cyclic shear directions and a wide range of shear strain amplitudes. The pore water pressure and settlement of the soils were measured with time and the time to EOP was then determined by different methods. It is shown from observed results that the time to EOP determined by 3-t method agrees well with the time required for full dissipation of the pore water pressure and being considerably larger than those determined by Log Time method. These observations were then further evaluated in connection with effects of the Atterberg’s limit and the cyclic loading history.

Conjectures, Hypotheses, and Theories of Drumlin Formation (In memory of Stanislaw Baranowski)

1981 ◽  
Vol 27 (97) ◽  
pp. 503-505 ◽  
Author(s):  
Ian J. Smalley
Keyword(s):  
Shear Strength ◽  
Pore Water ◽  
Stress Level ◽  
Critical Stress ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Glacial Till ◽  
Forming Process ◽  
Stress Levels

AbstractRecent investigations have shown that various factors may affect the shear strength of glacial till and that these factors may be involved in the drumlin-forming process. The presence of frozen till in the deforming zone, variation in pore-water pressure in the till, and the occurrence of random patches of dense stony-till texture have been considered. The occurrence of dense stony till may relate to the dilatancy hypothesis and can be considered a likely drumlin-forming factor within the region of critical stress levels. The up-glacier stress level now appears to be the more important, and to provide a sharper division between drumlin-forming and non-drumlin-forming conditions.

The temperature and pore water pressure in soil subjected to dynamic load

2018 ◽  
Vol 35 (2) ◽  
pp. 111
Author(s):  
Kun ZHANG ◽  
Ze ZHANG ◽  
Xiangyang SHI ◽  
Sihai LI ◽  
Donghui XIAO
Keyword(s):  
Pore Water ◽  
Dynamic Load ◽  
Pore Water Pressure ◽  
Water Pressure

Development of Experimental P-Y Curves from Centrifuge Tests for Piles Subjected to Static Loading and Liquefaction-Induced Lateral Spreading

2020 ◽  
Vol 14 (1) ◽  
Author(s):  
Milad Souri
Keyword(s):  
Static Loading ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Pressure Ratio ◽  
Lateral Spreading ◽  
American Petroleum Institute ◽  
Unique Contribution ◽  
Pile Groups ◽  
Centrifuge Tests ◽  
Centrifuge Models

The results of five centrifuge models were used to evaluate the response of pile-supported wharves subjected to inertial and liquefaction-induced lateral spreading loads. The centrifuge models contained pile groups that were embedded in rockfill dikes over layers of loose to dense sand and were shaken by a series of ground motions. The p-y curves were back-calculated for both dynamic and static loading from centrifuge data and were compared against commonly used American Petroleum Institute p-y relationships. It was found that liquefaction in loose sand resulted in a significant reduction in ultimate soil resistance. It was also found that incorporating p-multipliers that are proportional to the pore water pressure ratio in granular materials is adequate for estimating pile demands in pseudo-static analysis. The unique contribution of this study is that the piles in these tests were subjected to combined effects of inertial loads from the superstructure and kinematic loads from liquefaction-induced lateral spreading.

Sign in / Sign up

Export Citation Format

Share Document