Organic Carbon and Nitrogen Removal in Attached-Growth Circulating Reactor (AGCR)

1990 ◽  
Vol 22 (3-4) ◽  
pp. 179-186 ◽  
Author(s):  
S. Karnchanawong ◽  
C. Polprasert
Keyword(s):  
Organic Carbon ◽  
Nitrogen Removal ◽  
Loading Rate ◽  
Oxygen Demand ◽  
Channel Length ◽  
Synthetic Wastewater ◽  
Attached Growth ◽  
Carbon And Nitrogen ◽  
Loading Rates ◽  
Air Diffusion

Experiments on attached-growth circulating reactor (AGCR) were conducted to investigate its efficiencies on organic carbon and nitrogen removal (through denitrification). A laboratory-scale AGCR, made of serpentine channel with a total length of 180.0 m, was fed with a synthetic wastewater at the chemical oxygen demand (COD) and total nitrogen (TN) loading rates of 3.56-10.16 and 0.30 - 0.91 g/(m2.d), respectively. The reactor effluent was recycled back to the influent feeding point and the dissolved oxygen (DO) concentrations along the channel length were controlled by means of air diffusion. It was found that the COD loading rate of 5 g/(m2. d) corresponding to the TN loading rate of 0.54 g/(m2.d) gave the optimal COD and TN removal rates of 4.8 and 0.43 g/(m2.d), respectively. The overall AGCR performance was limited by the nitrification efficiency at the high TN loading rates. The biofilm accumulation and thickness were found to be relatively high in the first-half portion of the channel length where carbon oxidation and denitrification were predominant. The second-half portion where nitrification mainly occurred had much less biofilm accumulation and thickness.

Modeling dynamics of organic carbon and nitrogen removal during aeration interruption in aerated horizontal flow treatment wetlands

2019 ◽  
Vol 80 (3) ◽  
pp. 597-606 ◽  
Author(s):  
Johannes Boog ◽  
Thomas Kalbacher ◽  
Jaime Nivala ◽  
Manfred van Afferden ◽  
Roland A. Müller
Keyword(s):  
Steady State ◽  
Organic Carbon ◽  
Dynamic Response ◽  
Nitrogen Removal ◽  
Oxygen Demand ◽  
Ammonia Nitrogen ◽  
Treatment Wetlands ◽  
Horizontal Flow ◽  
Simulation Accuracy ◽  
Carbon And Nitrogen

Abstract Despite recent developments in process-based modeling of treatment wetlands (TW), the dynamic response of horizontal flow (HF) aerated wetlands to interruptions of aeration has not yet been modeled. In this study, the dynamic response of organic carbon and nitrogen removal to interruptions of aeration in an HF aerated wetland was investigated using a recently-developed numerical process-based model. Model calibration and validation were achieved using previously obtained data from pilot-scale experiments. Setting initial concentrations for anaerobic bacteria to high values ( 35–70 mg L−1) and including ammonia sorption was important to simulate the treatment performance of the experimental wetland in transition phases when aeration was switched off and on again. Even though steady-state air flow rate impacted steady-state soluble chemical oxygen demand (CODs), ammonia nitrogen (NH4–N) and oxidized nitrogen (NOx–N) concentration length profiles, it did not substantially affect corresponding effluent concentrations during aeration interruption. When comparing simulated with experimental results, it is most likely that extending the model to include mass transfer through the biofilm will allow to better explain the underlying experiments and to increase simulation accuracy. This study provides insights into the dynamic behavior of HF aerated wetlands and discusses assumptions and limitations of the modeling approach.

Simultaneous carbon and nitrogen removal using a litre-scale upflow microbial fuel cell

2013 ◽  
Vol 69 (2) ◽  
pp. 293-297 ◽  
Author(s):  
Ling-ling Zhao ◽  
Tian-shun Song
Keyword(s):  
Fuel Cell ◽  
Microbial Fuel Cell ◽  
Nitrogen Removal ◽  
Microbial Fuel Cells ◽  
Oxygen Demand ◽  
Pilot Scale ◽  
Chicken Manure ◽  
Synthetic Wastewater ◽  
Nitrification Rate ◽  
Carbon And Nitrogen

A 10 L upflow microbial fuel cell (UMFC) was constructed for simultaneous carbon and nitrogen removal. During the 6-month operation, the UMFC constantly removed carbon and nitrogen, and then generated electricity with synthetic wastewater as substrate. At 5.0 mg L−1 dissolved oxygen, 100 Ω external resistance, and pH 6.5, the maximum power density (Pmax) and nitrification rate for the UMFC was 19.5 mW m−2 and 17.9 mg·(L d)−1, respectively. In addition, Pmax in the UMFC with chicken manure wastewater as substrate was 16 mW m−2, and a high chemical oxygen demand (COD) removal efficiency of 94.1% in the UMFC was achieved at 50 mM phosphate-buffered saline. Almost all ammonia in the cathode effluent was effectively degraded after biological denitrification in the UMFC cathode. The results can help to further develop pilot-scale microbial fuel cells for simultaneous carbon and nitrogen removal.

scholarly journals Effects of hydraulic loading rate and aeration mode on nitrogen removal and nitrogen functional gene abundances in subsurface wastewater infiltration systems

2017 ◽  
Vol 76 (1) ◽  
pp. 210-218 ◽  
Author(s):  
Yafei Sun ◽  
Jing Pan ◽  
Shiyue Qi ◽  
Hexin Fei
Keyword(s):  
Nitrogen Removal ◽  
Loading Rate ◽  
Oxygen Demand ◽  
Functional Gene ◽  
Intermittent Aeration ◽  
Anaerobic Conditions ◽  
Loading Rates ◽  
Hydraulic Loading ◽  
Artificial Aeration ◽  
Operation Cost

Matrix dissolved oxygen, nitrogen removal and nitrogen functional gene abundances in two artificial aeration modes, continuous aeration (CA) and intermittent aeration (IA), in subsurface wastewater infiltration systems (SWISs) under different hydraulic loading rates (HLRs) were investigated. Aeration not only successfully created aerobic conditions at 50 cm depth, but also did not change anoxic or anaerobic conditions at 80 and 110 cm depths. Meanwhile, aeration significantly enhanced chemical oxygen demand, NH4+-N, and total nitrogen (TN) removal and the enrichment of nitrogen removal functional genes (amoA, nxrA, napA, narG, nirK and qnorB) compared to the non-aerated SWIS, especially for high HLRs. IA SWIS (79.7%–85.8%) had a better performance on TN removal compared with CA SWIS (73.8%–82.2%) when the HLRs ranged from 0.06 to 0.3 m3/(m2 d). Intermittent aeration is a sensible strategy to achieve high HLR, good nitrogen removal performance and comparatively low operation cost for SWISs.

Stabilization of Organic Carbon and Nitrogen in Consolidating Benthal Deposits

1985 ◽  
Vol 17 (6-7) ◽  
pp. 929-940 ◽  
Author(s):  
C. W. Bryant ◽  
L. G. Rich
Keyword(s):  
Organic Carbon ◽  
Model Verification ◽  
Volatile Acid ◽  
Free Energies ◽  
Organic Loading ◽  
Carbon And Nitrogen ◽  
Loading Rates ◽  
Degradation Reactions ◽  
The Individual ◽  
Organic Deposits

The objective of this research was to develop and validate a predictive model of the benthal stabilization of organic carbon and nitrogen in deposits of waste activated sludge solids formed at the bottom of an aerated water column, under conditions of continual deposition. A benthal model was developed from a one-dimensional, generalized transport equation and a set of first-order biological reactions. For model verification, depth profiles of the major interstitial carbon and nitrogen components were measured from a set of deposits formed in the laboratory at 20°C and a controlled loading rate. The observed sequence of volatile acid utilization in each benthal deposit was that which would be predicted by the Gibbs free energies of the individual degradation reactions and would be controlled by the reduction in interstitial hydrogen partial pressure with time. Biodegradable solids were solubilized rapidly during the first three weeks of benthal retention, but subsequent solubilization occurred much more slowly. The benthal simulation effectively predicted the dynamics of consolidating, organic deposits. Simulation of organic loading rates up to 250 g BVSS/(m2 day) indicated that the stabilization capacity of benthal deposits was far above the range of organic loading rates currently used in lagoon design.

scholarly journals The Concept of Wastes to Energy Using Sugary Wastes

2012 ◽  
Vol 9 ◽  
pp. 57-62
Author(s):  
Fiza Sarwar ◽  
Wajeeha Malik ◽  
Muhammad Salman Ahmed ◽  
Harja Shahid
Keyword(s):  
Volatile Fatty Acids ◽  
Loading Rate ◽  
Biogas Production ◽  
Oxygen Demand ◽  
Uasb Reactor ◽  
Organic Loading Rate ◽  
Anaerobic Sludge ◽  
Loading Rates ◽  
Sugar Mills ◽  
Anaerobic Sludge Blanket

Abstract: This study was designed using actual effluent from the sugary mills in an Up-flow Anaerobic Sludge Blanket (UASB) Reactor to evaluate treatability performance. The reactor was started-up in step-wise loading rates beginning from 0.05kg carbon oxygen demand (COD)/m3-day to 3.50kg-COD/m3-day. The hydraulic retention time (HRT) was slowly decreased from 96 hrs to eight hrs. It was observed that the removal efficiency of COD of more than 73% can be easily achieved at an HRT of more than 16 hours corresponding to an average organic loading rate (OLR) of 3.0kg-COD/m3-day, at neutral pH and constant temperature of 29°C. The average VFAs (volatile fatty acids) and biogas production was observed as 560mg/L and 1.6L/g-CODrem-d, respectively. The average methane composition was estimated as 62%. The results of this study suggest that the treatment of sugar mills effluent with the anaerobic technology seems to be more reliable, effective and economical.DOI: http://dx.doi.org/10.3126/hn.v9i0.7075 Hydro Nepal Vol.9 July 2011 57-62

scholarly journals Micro-pressure swirl reactor (MPSR) for efficient COD and nitrogen removal of high-concentration wastewater

2020 ◽  
Vol 82 (9) ◽  
pp. 1795-1807 ◽  
Author(s):  
Dejun Bian ◽  
Zebing Nie ◽  
Fan Wang ◽  
Shengshu Ai ◽  
Suiyi Zhu ◽  
...  
Keyword(s):  
Removal Efficiency ◽  
Nitrogen Removal ◽  
Lower Cost ◽  
Batch Reactor ◽  
Oxygen Demand ◽  
Swirl Flow ◽  
High Concentration ◽  
Internal Circulation ◽  
Carbon And Nitrogen ◽  
Pressure Swirl

Abstract A micro-pressure swirl reactor (MPSR) was developed for carbon and nitrogen removal of wastewater, in which dissolved oxygen (DO) gradient and internal circulation could be created by setting the aerators along one side of the reactor, and micro-pressure could be realized by sealing most of the top cap and increasing the outlet water level. In this study, velocity and DO distribution in the reactor was measured, removal performance treating high-concentration wastewater was investigated, and the main functional microorganisms were analyzed. The experiment results indicated that there was stable swirl flow and spatial DO gradient in MPSR. Operated in sequencing batch reactor mode, distinct biological environments spatially and temporally were created. Under the average influent condition of chemical oxygen demand (COD) concentration of 2,884 mg/L and total nitrogen (TN) of 184 mg/L, COD removal efficiency and removal loading was 98% and 1.8 kgCOD/(m3·d) respectively, and TN removal efficiency and removal loading reached up to 90% and 0.11 kgTN/(m3·d) respectively. With efficient utilization of DO and simpler configuration for simultaneous nitrification and denitrification, the MPSR has the potential of treating high-concentration wastewater at lower cost.

A membrane bioreactor for an innovative biological nitrogen removal process

2010 ◽  
Vol 61 (3) ◽  
pp. 671-676 ◽  
Author(s):  
W. Chen ◽  
F. Y. Sun ◽  
X. M. Wang ◽  
X. Y. Li
Keyword(s):  
Total Nitrogen ◽  
Nitrogen Removal ◽  
Membrane Bioreactor ◽  
Loading Rate ◽  
Nitrogen Loading ◽  
Synthetic Wastewater ◽  
Biological Nitrogen Removal ◽  
Laboratory System ◽  
Working Volume ◽  
Biological Nitrogen

A hybrid system has been developed for biological nitrogen removal through nitrification-denitrification. The system includes an aerobic tank and an anoxic tank with an intermediate sludge settler connected to a membrane bioreactor (MBR) with a submerged 0.4 μm hollow-fiber membrane module. The laboratory system has a total working volume of 6.5 L treating a glucose-based synthetic wastewater. The experimental results demonstrate that the new process is highly effective for simultaneous organic and nitrogen removal. During the stationary operation, a sludge SS (suspended solids) concentration of 6 g/L or higher can be maintained in the reactors. The system has a COD (chemical oxygen demand) loading rate of up to 2,100 mg/L-d and a total nitrogen loading rate of up to 170 mg N/L-d. More than 95% COD can be degraded, and the total nitrogen removal efficiency can be 90% or higher as the nitrogen is reduced from 100 to around 7.5 mg/L. A high quality effluent is produced with a SS of less than 1 mg/L. With the MBR, organic degradation, nitrogen removal and sludge-liquid separation can be well achieved within a short HRT of about 10 hr.

Sign in / Sign up

Export Citation Format

Share Document