scholarly journals Evaluating nitrite oxidizing organism survival under different nitrite concentrations

2020 ◽  
Author(s):  
Bing Liu ◽  
Yifan Li ◽  
Jinzhu Wu ◽  
Yuanyuan Shao ◽  
Feiyong Chen ◽  
...  
Keyword(s):  
Reaction Rate ◽  
Oxygen Demand ◽  
Dead Cell ◽  
Bacterial Survival ◽  
Decay Stage ◽  
Uptake Rates ◽  
Rate Calculation ◽  
Pre Treatment ◽  
Complete Cell ◽  
Treatment Procedures

Abstract The objective of this study is to explore the optimal pre-treatment procedures and statistics methods for live/dead bacterial staining using nitrite oxidizing organism (NOO) as the research aim. This staining method was developed and widely utilized to evaluate activated bacterial survival situation, because it is direct and convenience to count live and dead bacteria amount by colour distinguishes (green/red) from pictures taken by microscope. The living cell (green colour) percentage and initial bacterial chemical oxygen demand (COD) could be used for accurate reaction rate calculation at the beginning of tests. While according to the physiological principles, the detection target was limited as the organism has a complete cell shape, that was applicable for the initial phase for decay stage (live cell → particulate dead cell), but it is impossible to evaluate the decayed soluble COD from particulate dead cell during whole reaction. To model the decay stage scientifically, a two-step decay model was developed to cater to the live/dead bacterial staining analysis of biological nitrite oxidizer under inhibition condition of high nitrite concentrations at 35 °C. As results of optimal pre-treatment, a three level ultrasonic wave with 45 seconds was explored, as a reasonable observed picture number, 30 sets with 95% confident interval for datasets statistics was summarized. A set of nitrite oxidizer inhibition test (total CODs and oxygen uptake rates) under high nitrite concentrations was simulated using the above model and obtained experimental schemes. Additionally, the disintegration enhancement from particulate dead cell to soluble COD by nitrite was inspected and modelled on the basis of experimental datasets.

Alkali pre-treatment of Sorghum Moench for biogas production

2013 ◽  
Vol 67 (9) ◽  
Author(s):  
Karina Michalska ◽  
Stanisław Ledakowicz
Keyword(s):  
Anaerobic Digestion ◽  
Chemical Oxygen Demand ◽  
Volatile Fatty Acids ◽  
Biogas Production ◽  
Oxygen Demand ◽  
Total Phenolic ◽  
Methane Generation ◽  
Pre Treatment ◽  
Alkali Hydrolysis ◽  
Almost All

AbstractThis work studies the influence of the alkali pre-treatment of Sorghum Moench — a representative of energy crops used in biogas production. Solutions containing various concentrations of sodium hydroxide were used to achieve the highest degradation of lignocellulosic structures. The results obtained after chemical pre-treatment indicate that the use of NaOH leads to the removal of almost all lignin (over 99 % in the case of 5 mass % NaOH) from the biomass, which is a prerequisite for efficient anaerobic digestion. Several parameters, such as chemical oxygen demand, total organic carbon, total phenolic content, volatile fatty acids, and general nitrogen were determined in the hydrolysates thus obtained in order to define the most favourable conditions. The best results were obtained for the Sorghum treated with 5 mass % NaOH at 121°C for 30 min The hydrolysate thus achieved consisted of high total phenolic compounds concentration (ca. 4.7 g L−1) and chemical oxygen demand value (ca. 45 g L−1). Although single alkali hydrolysis causes total degradation of glucose, a combined chemical and enzymatic pre-treatment of Sorghum leads to the release of large amounts of this monosaccharide into the supernatant. This indicates that alkali pre-treatment does not lead to complete cellulose destruction. The high degradation of lignin structure in the first step of the pre-treatment rendered the remainder of the biomass available for enzymatic action. A comparison of the efficiency of biogas production from untreated Sorghum and Sorghum treated with the use of NaOH and enzymes shows that chemical hydrolysis improves the anaerobic digestion effectiveness and the combined pre-treatment could have great potential for methane generation.

scholarly journals Modelization of Nutrient Removal Processes at a Large WWTP Using a Modified ASM2d Model

2018 ◽  
Vol 15 (12) ◽  
pp. 2817 ◽  
Author(s):  
Jakub Drewnowski ◽  
Jacek Makinia ◽  
Lukasz Kopec ◽  
Francisco-Jesus Fernandez-Morales
Keyword(s):  
Nutrient Removal ◽  
Carbon Sources ◽  
Oxygen Demand ◽  
Full Scale ◽  
Biological Nutrient Removal ◽  
Organic Substrates ◽  
Modified Model ◽  
Rate Limiting Step ◽  
Uptake Rates ◽  
Rate Limiting

The biodegradation of particulate substrates starts by a hydrolytic stage. Hydrolysis is a slow reaction and usually becomes the rate limiting step of the organic substrates biodegradation. The objective of this work was to evaluate a novel hydrolysis concept based on a modification of the activated sludge model (ASM2d) and to compare it with the original ASM2d model. The hydrolysis concept was developed in order to accurately predict the use of internal carbon sources in enhanced biological nutrient removal (BNR) processes at a full scale facility located in northern Poland. Both hydrolysis concepts were compared based on the accuracy of their predictions for the main processes taking place at a full-scale facility. From the comparison, it was observed that the modified ASM2d model presented similar predictions to those of the original ASM2d model on the behavior of chemical oxygen demand (COD), NH4-N, NO3-N, and PO4-P. However, the modified model proposed in this work yield better predictions of the oxygen uptake rate (OUR) (up to 5.6 and 5.7%) as well as in the phosphate release and uptake rates.

scholarly journals Bioelectricity production from tofu wastewater using microbial fuel cells with microalgae Spirulina sp as catholyte

2020 ◽  
Vol 202 ◽  
pp. 08007
Author(s):  
Wahyu Zuli Pratiwi ◽  
Hadiyanto Hadiyanto ◽  
Purwanto Purwanto ◽  
Muthi’ah Nur Fadlilah
Keyword(s):  
Wastewater Treatment ◽  
Fuel Cells ◽  
Microbial Fuel Cells ◽  
Organic Waste ◽  
Oxygen Demand ◽  
Salt Bridge ◽  
Cod Removal ◽  
Biofuel Production ◽  
Pre Treatment ◽  
Made In

Microalgae-Microbial Fuel Cells (MMFCs) are very popular to be used to treat organic waste. MMFCs can function as an energy-producing wastewater pre-treatment system. Wastewater can provide an adequate supply of nutrients, support the large capacity of biofuel production, and can be integrated with existing wastewater treatment infrastructure. The reduced content of Chemical Oxygen Demand (COD) is one way to measure the efficiency of wastewater treatment. MMFCs reactors are made in the form of two chambers (anode and cathode) both of which are connected by a salt bridge. Tofu wastewater as an anode and Spirulina sp as a cathode. To improve MFCs performance which is to obtain maximum COD removal and electricity generation, nutrient NaHCO3 as the nutrient carbon source for Spirulina sp was varied. The system running phase on 12 days. The results were Spirulina sp treated with MFCs technology has better growth than non-MFCs. The MMFC generated a maximum power density of 21.728 mW/cm2 and achieved 57.37% COD removal. These results showed that the combined process was effective in treating tofu wastewater.

SBR treatment of olive mill wastewaters: dilution or pre-treatment?

2012 ◽  
Vol 65 (9) ◽  
pp. 1684-1691 ◽  
Author(s):  
G. Farabegoli ◽  
A. Chiavola ◽  
E. Rolle
Keyword(s):  
Biological Process ◽  
Batch Reactor ◽  
Oxygen Demand ◽  
Adequate Treatment ◽  
Olive Mill Wastewaters ◽  
Other Substances ◽  
Removal Efficiencies ◽  
Pre Treatment ◽  
Olive Mill ◽  
Gac Adsorption

The olive-oil extraction industry is an economically important activity for many countries of the Mediterranean Sea area, with Spain, Greece and Italy being the major producers. This activity, however, may represent a serious environmental problem due to the discharge of highly polluted effluents, usually referred to as ‘olive mill wastewaters’ (OMWs). They are characterized by high values of chemical oxygen demand (COD) (80–300 g/L), lipids, total polyphenols (TPP), tannins and other substances difficult to degrade. An adequate treatment before discharging is therefore required to reduce the pollutant load. The aim of the present paper was to evaluate performances of a biological process in a sequencing batch reactor (SBR) fed with pre-treated OMWs. Pre-treatment consisted of a combined acid cracking (AC) and granular activated carbon (GAC) adsorption process. The efficiency of the system was compared with that of an identical SBR fed with the raw wastewater only diluted. Combined AC and GAC adsorption was chosen to be used prior to the following biological process due to its capability of providing high removal efficiencies of COD and TPP and also appreciable improvement of biodegradability. Comparing results obtained with different influents showed that best performances of the SBR were obtained by feeding it with raw diluted OMWs (dOMWs) and at the lowest dilution ratio (1:25): in this case, the removal efficiencies were 90 and 76%, as average, for COD and TPP, respectively. Feeding the SBR with either the pre-treated or the raw dOMWs at 1:50 gave very similar values of COD reduction (74%); however, an improvement of the TPP removal was observed in the former case.

Use of dairy reject and fermented Aleo sp. Leaf Gel mixture in the biological Pre-treatment of landfill leachate

2018 ◽  
Vol 13 (1) ◽  
pp. 219-228 ◽  
Author(s):  
Kasmi Mariam ◽  
Elleuch Lobna ◽  
Abidi Haifa ◽  
Cherni Yassmine ◽  
Hosni Cyrine ◽  
...  
Keyword(s):  
Saccharomyces Cerevisiae ◽  
Organic Matter ◽  
Size Effect ◽  
Landfill Leachate ◽  
Yeast Strain ◽  
Oxygen Demand ◽  
Treatment Efficiency ◽  
Chemical Oxygen Demand Removal ◽  
Pre Treatment ◽  
Aloe Gel

Abstract In this study the biotreatability of Jebel Chakir landfill leachate (Tunisia) using a mixture of dairy industry reject (bactofugate) and Aloe sp. leaf gel was evaluated. The effect of Aloe gel fermentation using Saccharomyces cerevisiae yeast strain was investigated against some selected bacterial and fungal strains. The inoculation size effect of the treatment mixtures (2, 6, 10 and 12%) in the treatment efficiency was also studied. The obtained results showed that when natural Aloe gel and bactofugate mixtures were used the recorded chemical oxygen demand removal rates exceeded 56% within 48 h of treatment. Whereas, the use of the fermented Aloe gel in the treatment mixtures has promoted the organic matter removal to reach 72%.

Effect of Ultrasonic Pretreatment for the Anaerobic Digestion of Sewage Sludge

2012 ◽  
Vol 531 ◽  
pp. 528-531 ◽  
Author(s):  
Na Wei
Keyword(s):  
Anaerobic Digestion ◽  
Sewage Sludge ◽  
Volatile Fatty Acids ◽  
Biogas Production ◽  
Oxygen Demand ◽  
High Concentration ◽  
Ultrasonic Pretreatment ◽  
Soluble Chemical Oxygen Demand ◽  
Pre Treatment ◽  
Settling Characteristics

Anaerobic digestion is an economic and environmentally friendly technology for treating the biomass material-sewage sludge, but has some limitations, such as the low efficient biogass production. In this paper ultrasound was proposed as pre-treatment for effective sludge anaerobic digestion. Sludge anaerobic digestion experiments with ultrasonic pretreatment was investigated. It can be seen that this treatment effectively leaded to the increase of soluble chemical oxygen demand(SCOD) and volatile fatty acids(VFA)concentration. High concentration of VFA leaded to a increase in biogas production. Besides, the SV of sludge was reduced and the settling characteristics of sludge was improved after ultrasonic pretreatment. It can be concluded that sludge anaerobic digestion with ultrasonic pretreatment is an effective method for biomass material transformation.

Sustainable wastewater management technology for tourism in Thailand: case and experimental studies

2019 ◽  
Vol 79 (10) ◽  
pp. 1977-1984
Author(s):  
W. Liamlaem ◽  
L. Benjawan ◽  
C. Polprasert
Keyword(s):  
Kinetic Constant ◽  
Experimental Studies ◽  
Oxygen Demand ◽  
Domestic Wastewater ◽  
Wastewater Management ◽  
Order Kinetic ◽  
First Order ◽  
Treated Effluent ◽  
Management Technology ◽  
Pre Treatment

Abstract Thailand has adopted the concept of eco-tourism as a protocol to protect environmental resources. One of the key factors in enabling the achievement of this goal is the improvement of the quality of effluent from those homestays and resorts which still lack efficient on-site wastewater treatment. This research utilized case studies of subsurface flow constructed wetlands (SFCWs), planted mainly with the Indian shot (Canna indica L.), which were designed to treat wastewaters at three resorts located in Amphawa District, Samut Songkram Province in central Thailand. The results showed that the treated effluent was of sufficient quality to meet the building effluent standards Type C, which require the concentrations of biological oxygen demand (BOD), total Kjeldahl nitrogen (TKN) and suspended solids (SS) to be less than 40, 40 and 50 mg/L, respectively. In addition, the first-order kinetic constants for the design and operation of SFCWs were determined. For treating wastewater containing organic substances, with no prior pre-treatment, the first-order kinetic constant of 0.24 1/d can be applied to predict effluent quality. For treating other types of domestic wastewater, a first-order kinetic constant in the range 0.40–0.45 1/d can be used when sizing and operating SFCWs. This research highlights the great potential of SFCWs as a sustainable wastewater management technology.

Sign in / Sign up

Export Citation Format

Share Document