scholarly journals К 125-летию со дня рождения лауреата Нобелевской премии академика Николая Николаевича Семенова Архитектура мезы и эффективность InGaP/Ga(In)As/Ge солнечных элементов

2021 ◽  
Vol 91 (7) ◽  
pp. 1067
Author(s):  
В.С. Калиновский ◽  
Е.В. Контрош ◽  
Е.А. Гребенщикова ◽  
В.М. Андреев

It has been shown that the mesa architecture and achieved quality of the mesa sidewall of concentrator multijunction solar cells ensured increasing their efficiency up to 36.7% at the sunlight concentration before 100 (AMO; 0.136W/cm²). Creation of the mesa structure architecture with following separation of epitaxial plates of monolithic InGaP/GaAs/Ge nanoheterostructure into chips was carried out by single step chemical wet etching in the HBr:H2O2:H2O (8:1:100) through a photoresist mask to the depth of 12-18µm. Conditions of single step etching, which ensure formation of a smooth and even side surface of the InGaP/Ga(In)As/Ge nanoheterostructure mesa containing different in composition and thickness layers have been determined. Determination of the activation energy has shown that etching occurs in the diffusion region of the heterogeneous process. In raising etchant temperature from 2 to 36˚C, a change of the tilt angle in the Ge substrate region from 4.5 to 25 angular degrees is observed, what allows optimizing the amount of concentrator solar cells and their quality at final mechanical separation of the epitaxial plate into chips.

2020 ◽  
Vol 2020 ◽  
pp. 1-10
Author(s):  
Chris H. van de Stadt ◽  
Pilar Espinet Gonzalez ◽  
Harry A. Atwater ◽  
Rebecca Saive

We have developed a computationally efficient simulation model for the optimization of redirecting electrical front contacts for multijunction solar cells under concentration, and we present its validation by comparison with experimental literature results. The model allows for fast determination of the maximum achievable efficiency under a wide range of operating conditions and design parameters such as the contact finger redirecting capability, period and width of the fingers, the light concentration, and the metal and emitter sheet resistivity. At the example of a state-of-the-art four-junction concentrator solar cell, we apply our model to determine ideal operating conditions for front contacts with different light redirection capabilities. We find a 7% relative efficiency increase when enhancing the redirecting capabilities from 0% to 100%.


2018 ◽  
Vol 8 (1) ◽  
pp. 333-341
Author(s):  
Thomas Missbach ◽  
Simon Andreas Dengler ◽  
Gerald Siefer ◽  
Andreas W. Bett

2012 ◽  
Vol 46 (8) ◽  
pp. 1051-1058 ◽  
Author(s):  
M. A. Mintairov ◽  
V. V. Evstropov ◽  
N. A. Kalyuzhnyi ◽  
C. A. Mintairov ◽  
N. Kh. Timoshina ◽  
...  

Author(s):  
А.В. Малевская ◽  
Д.А. Малевский ◽  
П.В. Покровский ◽  
В.М. Андреев

Carried out were investigations of methods for passivating and protecting p-n junctions in points of their exit on the side mesa structure surface and for sealing hermetically multijunction solar cells based on the GaInP/GaAs/Ge heterostructure. Study of protecting coatings based on silicon nitride layers and on silicone by analyzing dark I-V characteristics of solar cells and by estimating the electroluminescence distribution has been performed.


1989 ◽  
Vol 149 ◽  
Author(s):  
P. Grunow ◽  
D. Herm ◽  
R. Könenkamp ◽  
U. Küppers ◽  
M. Kunst ◽  
...  

ABSTRACTSeveral stationary and transient techniques are used to characterize a large number of intrinsic a-Si:H films prepared in a narrow range of production conditions. Correlation between stationary photoconductivity, the activation energy of the dark conductivity and the long-time range decay of the transient photoconductivity and photoinduced absorption is observed. The applicability of a-Si:H films for solar cells in view of these properties is discussed.


2015 ◽  
Vol 24 (6) ◽  
pp. 760-773 ◽  
Author(s):  
Helmut Nesswetter ◽  
Norman R. Jost ◽  
Paolo Lugli ◽  
Andreas W. Bett ◽  
Claus G. Zimmermann

Sign in / Sign up

Export Citation Format

Share Document