scholarly journals Радиопоглощающие и радиоэкранирующие характеристики феррит-полимерных композитов Mn-Zn феррит/П (ТФЭ-ВДФ)

2022 ◽  
Vol 92 (3) ◽  
pp. 462
Author(s):  
И.М. Исаев ◽  
В.Г. Костишин ◽  
Р.И. Шакирязнов ◽  
А.Р. Каюмова ◽  
В.К. Олицкий ◽  
...  

The article discusses the electromagnetic absorbing and shielding properties of ferrite-polymer composites of the composition Mn-Zn ferrite/fluoroplast-42, obtained by pressing a mixture of powders with heating. The measurement of the complex magnetic and dielectric permittivity spectra, as well as the reflection coefficient spectra was carried out in the frequency range 0.1 - 7 GHz. Using the obtained spectra, a comprehensive analysis of the absorbing characteristics of the composites was carried out, and the factors responsible for the absorption were determined. Fitting of the composites magnetic permeability spectra show that the process of natural ferromagnetic resonance prevails over the resonance of domain walls, and a decrease in the concentration of ferrite inclusions leads to a significant shift in the frequency of natural ferromagnetic resonance to high frequencies. It was found that for composites with a thickness of 5 - 10 mm, compositions with a mass fraction of ferrite ≤ 0.4 show radio-absorbing properties, while compositions with a fraction of ≥ 0.6 show shielding properties.

Resistance measurements made on iron strips of thicknesses ranging from 7.1 to 92-9pm over the frequency range 15 kc/s to 30 Mc/s are presented together with supplementary measurements of the permeability and loss angle on rings cut from the same strip. Both strips and rings had been subjected to the same thorough anneal. A special specimen geometry (Bishop 1962) was employed to ensure current uniformity across the strip width at all frequencies. These measurements were designed for comparison with the predictions of the classical uniform permeability theory and the domain eddy current theories developed in the preceding paper. The measured losses are found to be much higher at low frequencies and somewhat lower at high frequencies than those calculated by the classical theory, especially with the thinner specimens. In this respect these observations agree in broad outline with the predictions of the simplest domain theory (which assumes identical equally spaced domain walls normal to the current flow) but the transition from square law to square-root law dependence of the losses on frequency is found to take place over a much wider frequency range than either theory predicts. The breadth of this transition is however satisfactorily interpreted in terms of a more refined domain theory which takes into account the very wide spread of domain wall restoring forces which is to be expected in the light of contemporary knowledge of the domain structure of iron.


2019 ◽  
Vol 30 ◽  
pp. 07006
Author(s):  
Kirill V. Dorozhkin ◽  
Grigorii E. Kuleshov ◽  
Alexander V. Badin ◽  
Maxim O. Gering ◽  
Kseniya V. Simonova

The results of the study of the electromagnetic response of the hexagonal ferrite composite BaFe12O19 in the frequency range 34–250 GHz at room temperature are presented. At a frequency of 46.5 GHz a region of natural ferromagnetic resonance was found. The possibility of creating a selective EHF absorber based on the developed material is shown.


2009 ◽  
Vol 152-153 ◽  
pp. 333-336 ◽  
Author(s):  
Andrei V. Ivanov ◽  
V.Yu. Galkin ◽  
V.A. Ivanov ◽  
D.A. Petrov ◽  
Konstantin N. Rozanov ◽  
...  

Microwave permeability of glass-coated ferromagnetic amorphous microwire exhibiting a weak negative magnetostriction has been studied. The diameter of the microwire was about 20 m and the diameter of the metal core was about 12 m. The microwire was wound to comprise a 7/3 washer-shaped composite sample with the volume fraction of magnetic constituent of about 10%. The permeability of the composite sample was measured in a coaxial line in the frequency range from 0.1 to 10 GHz. The composite was found to exhibit a negative permeability within the frequency range from approximately 0.7 to 1.5 GHz, with the permeability being as low as −0.4. Therefore, microwire-based composites, particularly, crossed arrays of microwires may be employed to develop metamaterials for microwave applications. In the composite, the negative microwave permeability is due to the natural ferromagnetic resonance and the negative microwave permittivity is due to the inherent inductance of the wire. Such metamaterials are advantageous in simple design, isotropic in-plane performance, and possible tunability of performance by external magnetic bias. However, for a feasible metamaterial fabricated from microwire arrays, the wires have to exhibit higher magnitude of the ferromagnetic resonance, higher quality factor, and higher resonance frequency.


2007 ◽  
Vol 22 (13) ◽  
pp. 2361-2381 ◽  
Author(s):  
CHRISTIAN CORDA

Recently, with an enlightening treatment, Baskaran and Grishchuk have shown the presence and importance of the so-called "magnetic" components of gravitational waves (GW's), which have to be taken into account in the context of the total response functions of interferometers for GW's propagating from arbitrary directions. In this paper the analysis of the response functions for the magnetic components is generalized in its full frequency dependence, while in the work of Baskaran and Grishchuk the response functions were computed only in the approximation of wavelength much larger than the linear dimensions of the interferometer. It is also shown that the response functions to the magnetic components grow at high frequencies, differently from the values of the response functions to the well-known ordinary components that decrease at high frequencies. Thus the magnetic components could in principle become the dominant part of the signal at high frequencies. This is important for a potential detection of the signal at high frequencies and confirms that the magnetic contributions must be taken into account in the data analysis. More, the fact that the response functions of the magnetic components grow at high frequencies shows that, in principle, the frequency-range of Earth-based interferometers could extend to frequencies over 10000 Hz.


2021 ◽  
Vol 5 ◽  
pp. 39-46
Author(s):  
V. V. Karanskij ◽  
◽  
S. V. Smirnov ◽  
A. S. Klimov ◽  
E. V. Savruk ◽  
...  

Increasing the reliability requirements for electromagnetic compatibility of electronic equipment requires the creation of protective coatings that absorb electromagnetic radiation or the development of new radio-absorbing materials. In the frequency range up to 1 GHz, radio-absorbing materials based on Ni – Zn ferrites are of the greatest interest. The absorption of electromagnetic radiation by ferrites occurs due to resonant phenomena at the level of domains and atoms. Improving the performance of ferrites is possible by modifying their surface properties. In this paper, gradient structures for electromagnetic radiation protection products are obtained by treating the surface of Ni – Zn ferrite samples with a low-energy electron beam. To generate the electron beam, a unique development was used — a forevacuum plasma electronic source that allows forming and transporting a beam with a power density of up to 105 W/cm2 under conditions of high pressure and high gas release. As a result of processing, gradient structures were found on the surface of ferrites. A theoretical analysis and experimental study of the obtained structures “non – magnetic conductor – ferrite”, characterized by an increased attenuation coefficient and a reduced reflection coefficient of electromagnetic radiation in the frequency range from 0.5 to 2.5 GHz. The possibility of obtaining near-surface layers depleted in zinc with increased electrical conductivity and reduced magnetic permeability is shown.


1999 ◽  
Vol 5 (2) ◽  
pp. 135-140
Author(s):  
Vytautas Stauskis

The paper deals with the differences between the energy created by four different pulsed sound sources, ie a sound gun, a start gun, a toy gun, and a hunting gun. A knowledge of the differences between the maximum energy and the minimum energy, or the signal-noise ratio, is necessary to correctly calculate the frequency dependence of reverberation time. It has been established by investigations that the maximum energy excited by the sound gun is within the frequency range of 250 to 2000 Hz. It decreases by about 28 dB at the low frequencies. The character of change in the energy created by the hunting gun differs from that of the sound gun. There is no change in the maximum energy within the frequency range of 63–100 Hz, whereas afterwards it increases with the increase in frequency but only to the limit of 2000 Hz. In the frequency range of 63–500 Hz, the energy excited by the hunting gun is lower by 15–30 dB than that of the sound gun. As frequency increases the difference is reduced and amounts to 5–10 dB. The maximum energy of the start gun is lower by 4–5 dB than that of the hunting gun in the frequency range of up to 1000 Hz, while afterwards the difference is insignificant. In the frequency range of 125–250 Hz, the maximum energy generated by the sound gun exceeds that generated by the hunting gun by 20 dB, that by the start gun by 25 dB, and that by the toy gun—by as much as 35 dB. The maximum energy emitted by it occupies a wide frequency range of 250 to 2000 Hz. Thus, the sound gun has an advantage over the other three sound sources from the point of view of maximum energy. Up until 500 Hz the character of change in the direct sound energy is similar for all types of sources. The maximum energy of direct sound is also created by the sound gun and it increases along with frequency, the maximum values being reached at 500 Hz and 1000 Hz. The maximum energy of the hunting gun in the frequency range of 125—500 Hz is lower by about 20 dB than that of the sound gun, while the maximum energy of the toy gun is lower by about 25 dB. The maximum of the direct sound energy generated by the hunting gun, the start gun and the toy gun is found at high frequencies, ie at 1000 Hz and 2000 Hz, while the sound gun generates the maximum energy at 500 Hz and 1000 Hz. Thus, the best results are obtained when the energy is emitted by the sound gun. When the sound field is generated by the sound gun, the difference between the maximum energy and the noise level is about 35 dB at 63 Hz, while the use of the hunting gun reduces the difference to about 20–22 dB. The start gun emits only small quantities of low frequencies and is not suitable for room's acoustical analysis at 63 Hz. At the frequency of 80 Hz, the difference between the maximum energy and the noise level makes up about 50 dB, when the sound field is generated by the sound gun, and about 27 dB, when it is generated by the hunting gun. When the start gun is used, the difference between the maximum signal and the noise level is as small as 20 dB, which is not sufficient to make a reverberation time analysis correctly. At the frequency of 100 Hz, the difference of about 55 dB between the maximum energy and the noise level is only achieved by the sound gun. The hunting gun, the start gun and the toy gun create the decrease of about 25 dB, which is not sufficient for the calculation of the reverberation time. At the frequency of 125 Hz, a sufficiently large difference in the sound field decay amounting to about 40 dB is created by the sound gun, the hunting gun and the start gun, though the character of the sound field curve decay of the latter is different from the former two. At 250 Hz, the sound gun produces a field decay difference of almost 60 dB, the hunting gun almost 50 dB, the start gun almost 40 dB, and the toy gun about 45 dB. At 500 Hz, the sound field decay is sufficient when any of the four sound sources is used. The energy difference created by the sound gun is as large as 70 dB, by the hunting gun 50 dB, by the start gun 52 dB, and by the toy gun 48 dB. Such energy differences are sufficient for the analysis of acoustic indicators. At the high frequencies of 1000 to 4000 Hz, all the four sound sources used, even the toy gun, produce a good difference of the sound field decay and in all cases it is possible to analyse the reverberation process at varied intervals of the sound level decay.


2019 ◽  
Vol 4 (4) ◽  
pp. 4-7
Author(s):  
Lubov V. Aizenshtadt ◽  
Tatyana Yu. Vladimirova ◽  
Alexandr V. Kurenkov ◽  
Anastasia M. Kashapova

Objectives - to study hearing thresholds at high frequencies in elderly and senile patients, taking into account the age norm and the presence of comorbid diseases. Material and methods. 111 patients aged from 50 to 97 years (mean age 70.5 ± 2.1) were examined, their age, auditory function, and concomitant diseases were also registered. Results. The measured average auditory thresholds at high frequencies, if compared to the age-related standards for auditory sensitivity, have revealed an underestimated hearing loss in 12.6% of patients. The presence of concomitant diseases has a significant impact on the development of chronic sensorineural hearing loss in each age group. Conclusion. Audiometry in an extended frequency range in elderly patients with concurrent diseases can improve the hearing examination algorithm.


Sign in / Sign up

Export Citation Format

Share Document