SEISMIC HAZARD ASSESSMENT OF SCHOOL BUILDINGS IN PENINSULAR MALAYSIA

2015 ◽  
Vol 2 (3) ◽  
Author(s):  
K.T. Tan ◽  
H. Abdul Razak
Keyword(s):  
Fragility Curves ◽  
Response Spectrum ◽  
Ground Motions ◽  
Active Faults ◽  
Plate Boundary ◽  
Peninsular Malaysia ◽  
Soil Conditions ◽  
Soil Parameters ◽  
School Buildings ◽  
Damage State

Peninsular Malaysia is located on the southern edge of the Eurasian Plate. However, it is close to a seismically active plate boundary, the inter-plate boundary between the Indo-Australian and Eurasian Plates. Occasionally, tremors can be felt throughout the region even when active faults are located several hundred kilometers away. Lessons learnt from past events, active earthquakes located far from the existing building can cause potential damage. Thus, fragility curves become an essential tool to estimate probability of building damage caused by seismic ground motions. In this study, the response of low-rise and mid-rise RC school buildings located in various soil conditions within Peninsular Malaysia under earthquake excitation was investigated by performing dynamic response spectrum analysis. These buildings were analysed using DIANA 9.3 structural analysis program and subjected to a range of low to high seismic ground motions to determine the performance damage state of each type of building. All structural elements were modeled using solid brick finite-element. Correspondingly, the fragility curves were developed using the log-normal distribution for structural response. The effects of various soil conditions on the response of the buildings were also investigated. The results indicated that the effect of soil parameters had a significant effect on the outcome of the fragility curves. However, the risk of these existing school buildings at a location in the northern part of Peninsular Malaysia showed the highest probability of exceeding each damage state. On the contrary, the risk of the existing school buildings at a location in the central part of Peninsular Malaysia was the lowest. Keywords: Interaction, fragility curves, soil-structure

scholarly journals Developed approach to determine the seismic vulnerability of reinforced concrete structures

2018 ◽  
Vol 149 ◽  
pp. 02078
Author(s):  
Serraye Mahmoud ◽  
Amri Salima
Keyword(s):  
Seismic Vulnerability ◽  
Fragility Curves ◽  
Response Spectrum ◽  
Response Spectra ◽  
Seismic Intensity ◽  
Point Of View ◽  
Damage State ◽  
Capacity Curves ◽  
Performance Point ◽  
Materials Used

Several evaluation methods of the seismic vulnerability have been developed around the world. Which are very use ful from humanitarian and socioeconomic point of view. Generally these methods use knowledge obtained from previous earthquakes and they are basing on seismic intensity scales and on buildings direct observation. But the macroseismic intensity expresses the consequences of the seism, and not its physical characteristics of the structures. Contrary to this type of methods, an approach based on a nonlinear analysis (Push-Over method) is proposed in this work. It consists in modeling the excitation of the earthquake by a response spectrum and building's behavior by capacity curves. These capacity curves are obtained from numerical modeling performed by Opensees software. The superposition of the two curves, response spectra and capacity curve, makes it possible to determine the performance point and consequently to deduce the state of expected damage. To estimate the probability of damage of a building at a given level of solicitation (defined by Sd), we excites a group of buildings characterized by different parameters related to the geometry of the building and those are related to the materials used (concrete, steel) by seismic solicitation (Response spectrum - RPA 99). The performance point for each building is determined by a procedure defined in FEMA 440. We classifies the buildings according to the position of performance point on their curve which defines a damage state of ds (Mild, Moderate, Important or Ruin) according to the damage levels of Risk-UE. A statistical analysis is then made for each class to build the fragility curves.

scholarly journals Evaluation of Seismic Vulnerability of Hospitals in the Tehran Metropolitan Area

Buildings ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 54
Author(s):  
Setareh Ghaychi Afrouz ◽  
Alireza Farzampour ◽  
Zahra Hejazi ◽  
Masoud Mojarab
Keyword(s):  
Metropolitan Area ◽  
Structural Damage ◽  
Seismic Vulnerability ◽  
Fragility Curves ◽  
Health Care Systems ◽  
Ground Motions ◽  
Active Faults ◽  
The United States ◽  
Damage And Failure ◽  
Proactive Management

The Tehran metropolitan area is extremely vulnerable to earthquakes due to the location of its active faults and its dense population. Assessing the probable damage of a high magnitude earthquake on buildings and facilities relies on a precise structural survey, which has an empirical basis depending on historic ground motions. The probability of damage and failure in discrete limits based on different ground motions is estimated by fragility curves. Using the most matching fragility curves for buildings in Tehran, the vulnerability of the hospitals in the capital, as one of the most critical structures in crisis management of disasters, was investigated in this study. Subsequently, the existing fragility curves, developed for Tehran and the other seismic prone countries such as Japan and the United States, were compared considering the typology of Tehran’s hospitals. Finally, the possible damages for each hospital were calculated based on the most conservative fragility curve and the most pessimistic scenario, which were used to evaluate the seismic vulnerability of hospitals and health care systems for different damage states. After zoning the damage of therapeutic areas of Tehran, it was observed that at least 2% to 10% damage occurred in all hospitals of Tehran, and none of the healthcare centers would remain structurally undamaged after a strong earthquake with the moment magnitude of 7 or more. In addition, the healthcare buildings could be prone to significant structural damage, especially in southern parts, which necessitates proactive management plans for Tehran metropolitan area.

scholarly journals Fragility and Vulnerability Analysis of an RC Building with the Application of Nonlinear Analysis

Buildings ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 390
Author(s):  
Radomir Folić ◽  
Miloš Čokić
Keyword(s):  
Comparative Analysis ◽  
Structural Damage ◽  
Fragility Curves ◽  
Response Spectrum ◽  
Damage Index ◽  
Fragility Analysis ◽  
Elastic Response ◽  
Damage State ◽  
Damage States ◽  
Rc Building

In this paper, the seismic response of a five-story reinforced concrete (RC) frame system building is analysed through fragility analysis. The structure is designed in accordance with structural Eurocodes EN1990, EN1991, EN1992 and EN1998, as a high-ductility (DCH) system. For the analysis of the response of a structural system to earthquake actions, the methods of nonlinear static (NSA) and nonlinear dynamic analyses (NDA) are applied and, based on the obtained results, fragility curves are constructed using statistical methods. A relationship between the intensity measure (IM) and engineering demand parameters (EDPs) is needed in order to estimate a fragility curve. Fragility functions represent a possibility for different states of damage to occur in a certain structural systems at the observed value of the specified IM. Ten accelerograms, used in NDA, are selected and scaled, according to EN1998 provisions, for the chosen elastic response spectrum and referent PGA. Obtained results are used for the statistical analysis and construction of fragility curves. Structural damage state threshold parameters are determined based on the Park and Ang modified damage index methodology and provisions given in FEMA, HAZUS, VISION 2000 and EN codes. Comparative analysis of the structural damage probability for the analysed RC building, calculated using different methodologies to determine damage states, is applied. The fragility analysis results showed the difference between the probabilities of the damage states to occur when different calculation methods are used. This reflects on the assessment of vulnerability curves as well. The obtained results, calculated using different methods, are analysed using comparative analysis.

scholarly journals Development of Fragility Curves for Piping and Slope Stability of River Levees

Water ◽  
2021 ◽  
Vol 13 (5) ◽  
pp. 738
Author(s):  
Nicola Rossi ◽  
Mario Bačić ◽  
Meho Saša Kovačević ◽  
Lovorka Librić
Keyword(s):  
Slope Stability ◽  
Fragility Curves ◽  
Safety Margin ◽  
Water Levels ◽  
Flood Event ◽  
Soil Parameters ◽  
Design Code ◽  
A Site ◽  
Insight Into

The design code Eurocode 7 relies on semi-probabilistic calculation procedures, through utilization of the soil parameters obtained by in situ and laboratory tests, or by the means of transformation models. To reach a prescribed safety margin, the inherent soil parameter variability is accounted for through the application of partial factors to either soil parameters directly or to the resistance. However, considering several sources of geotechnical uncertainty, including the inherent soil variability, measurement error and transformation uncertainty, full probabilistic analyses should be implemented to directly consider the site-specific variability. This paper presents the procedure of developing fragility curves for levee slope stability and piping as failure mechanisms that lead to larger breaches, where a direct influence of the flood event intensity on the probability of failure is calculated. A range of fragility curve sets is presented, considering the variability of levee material properties and varying durations of the flood event, thus providing crucial insight into the vulnerability of the levee exposed to rising water levels. The procedure is applied to the River Drava levee, a site which has shown a continuous trend of increased water levels in recent years.

Seismic response analysis of steel–concrete hybrid wind turbine tower

2021 ◽  
pp. 107754632110075
Author(s):  
Junling Chen ◽  
Jinwei Li ◽  
Dawei Wang ◽  
Youquan Feng
Keyword(s):  
Wind Turbine ◽  
Response Spectrum ◽  
Ground Motions ◽  
Time History ◽  
Seismic Action ◽  
Response Spectrum Method ◽  
Spectrum Method ◽  
Wind Turbine Tower ◽  
Ground Types ◽  
Nonlinear Time History

The steel–concrete hybrid wind turbine tower is characterized by the concrete tubular segment at the lower part and the traditional steel tubular segment at the upper part. Because of the great change of mass and stiffness along the height of the tower at the connection of steel segment and concrete segment, its dynamic responses under seismic ground motions are significantly different from those of the traditional steel tubular wind turbine tower. Two detailed finite element models of a full steel tubular tower and a steel–concrete hybrid tower for 2.0 MW wind turbine built in the same wind farm are, respectively, developed by using the finite element software ABAQUS. The response spectrum method is applied to analyze the seismic action effects of these two towers under three different ground types. Three groups of ground motions corresponding to three ground types are used to analyze the dynamic response of the steel–concrete hybrid tower by the nonlinear time history method. The numerical results show that the seismic action effect by the response spectrum method is lower than those by the nonlinear time history method. And then it can be concluded that the response spectrum method is not suitable for calculating the seismic action effects of the steel–concrete hybrid tower directly and the time history analyses should be a necessary supplement for its seismic design. The first three modes have obvious contributions on the dynamic response of the steel–concrete hybrid tower.

scholarly journals Simulation of response spectrum-compatible ground motions using wavelet-based multi-resolution analysis

2021 ◽  
pp. 002029402110130
Author(s):  
Guan Chen ◽  
Zhiren Zhu ◽  
Jun Hu
Keyword(s):  
Ground Motion ◽  
Response Spectrum ◽  
Ground Motions ◽  
Power Spectra ◽  
Simulation Method ◽  
Eurocode 8 ◽  
Effective Response ◽  
Multi Resolution Analysis ◽  
Resolution Analysis ◽  
Simulated Ground Motions

This study proposed a simple and effective response spectrum-compatible ground motions simulation method to mitigate the scarcity of ground motions on seismic hazard analysis base on wavelet-based multi-resolution analysis. The feasibility of the proposed method is illustrated with two recorded ground motions in El Mayor-Cucapah earthquake. The results show that the proposed method enriches the ground motions exponentially. The simulated ground motions agree well with the attenuation characteristics of seismic ground motion without modulating process. Moreover, the pseudo-acceleration response spectrum error between the recorded ground motion and the average of the simulated ground motions is 5.2%, which fulfills the requirement prescribed in Eurocode 8 for artificially simulated ground motions. Besides, the cumulative power spectra between the simulated and recorded ground motions agree well on both high- and low-frequency regions. Therefore, the proposed method offers a feasible alternative in enriching response spectrum-compatible ground motions, especially on the regions with insufficient ground motions.

A Suite of Alternative Ground-Motion Models (GMMs) for Israel

2021 ◽  
Author(s):  
Soumya Kanti Maiti ◽  
Gony Yagoda-Biran ◽  
Ronnie Kamai
Keyword(s):  
Seismic Hazard ◽  
Ground Motion ◽  
Empirical Data ◽  
Epistemic Uncertainty ◽  
Ground Motions ◽  
Plate Boundary ◽  
Strong Motion ◽  
Engineering Applications ◽  
Motion Models ◽  
Ground Motion Models

ABSTRACT Models for estimating earthquake ground motions are a key component in seismic hazard analysis. In data-rich regions, these models are mostly empirical, relying on the ever-increasing ground-motion databases. However, in areas in which strong-motion data are scarce, other approaches for ground-motion estimates are sought, including, but not limited to, the use of simulations to replace empirical data. In Israel, despite a clear seismic hazard posed by the active plate boundary on its eastern border, the instrumental record is sparse and poor, leading to the use of global models for hazard estimation in the building code and all other engineering applications. In this study, we develop a suite of alternative ground-motion models for Israel, based on an empirical database from Israel as well as on four data-calibrated synthetic databases. Two host models are used to constrain model behavior, such that the epistemic uncertainty is captured and characterized. Despite the lack of empirical data at large magnitudes and short distances, constraints based on the host models or on the physical grounds provided by simulations ensure these models are appropriate for engineering applications. The models presented herein are cast in terms of the Fourier amplitude spectra, which is a linear, physical representation of ground motions. The models are suitable for shallow crustal earthquakes; they include an estimate of the median and the aleatory variability, and are applicable in the magnitude range of 3–8 and distance range of 1–300 km.

Sign in / Sign up

Export Citation Format

Share Document