scholarly journals Investigating the Performance of Viscoelastic Dampers (VED) Under Nearfield Earthquakes with Directivity Feature

2018 ◽  
Vol 14 (1) ◽  
pp. 21-27 ◽  
Author(s):  
Ali Vatanshenas ◽  
Mohammad Sadegh Rohanimanesh ◽  
Ehsan Mohammadiha
Keyword(s):  
Short Distance ◽  
Near Field ◽  
Time History ◽  
Steel Structure ◽  
Nonlinear Time History Analysis ◽  
Acceleration Response ◽  
Viscoelastic Dampers ◽  
Acceleration Time History ◽  
History Analysis ◽  
Nonlinear Time History

AbstractOne of the most important factors that make structures vulnerable to earthquakes is the short distance between structures and epicenter. Near-field earthquakes have special properties, such as increasing acceleration applied to the structure, which distinguishes them from far-field earthquakes. Therefore, the absorption of input energy for structures located near the faults is very important. Hence, by rotating the earthquake acceleration time history and comparing the resulting spectral acceleration response, the angle which applies the greatest force to the structure on the earthquake directivity side is obtained, and then the performance of a steel structure with viscoelastic dampers (VED) under near-field earthquakes with directivity feature is investigated. After analyzing the structure using nonlinear time history analysis, it was observed that the directivity phenomenon leads to significant increase in the force applied to the structure, but the viscoelastic dampers showed an acceptable performance in both states of with and without directivity.

scholarly journals Performance of an Existing Reinforced Concrete Building Designed in Accordance to Older Indonesian Seismic Code: A Case Study for a Hotel in Kupang, Indonesia

2018 ◽  
Vol 20 (1) ◽  
pp. 35
Author(s):  
Pamuda Pudjisuryadi ◽  
Benjamin Lumantarna ◽  
Ryan Setiawan ◽  
Christian Handoko
Keyword(s):  
Plastic Hinge ◽  
Time History ◽  
Nonlinear Time History Analysis ◽  
Seismic Load ◽  
Ground Acceleration ◽  
Seismic Code ◽  
Damage Level ◽  
History Analysis ◽  
Nonlinear Time History ◽  
Seismic Hazard Map

The recent seismic code SNI 1726-2012 is significantly different compared to the older code SNI 1726-2002. The seismic hazard map was significantly changed and the level of maximum considered earthquake was significantly increased. Therefore, buildings designed according to outdated code may not resist the higher demand required by newer code. In this study, seismic performance of Hotel X in Kupang, Indonesia which was designed based on SNI-1726-2002 is investigated. The structure was analyzed using Nonlinear Time History Analysis. The seismic load used was a spectrum consistent ground acceleration generated from El-Centro 18 May 1940 North-South component in accordance to SNI 1726-2012. The results show that Hotel X can resist maximum considered earthquake required by SNI 1726-2012. The maximum drift ratio is 0.81% which is lower than the limit set by FEMA 356-2000 (2%). Plastic hinge damage level is also lower than the allowance in ACMC 2001.

Investigation of Damages in RC Frames Under Near Field Earthquakes Using a Damage Index

2016 ◽  
Vol 16 (02) ◽  
pp. 1450094 ◽  
Author(s):  
Seyed Morteza Zinati Yazdi ◽  
Mohammad Taghi Kazemi
Keyword(s):  
Near Field ◽  
Damage Index ◽  
Time History ◽  
General Rule ◽  
Nonlinear Time History Analysis ◽  
Far Field ◽  
Moment Frames ◽  
Moment Frame ◽  
Rc Frames ◽  
Nonlinear Time History

Heavy damages on structures caused by near field earthquakes in recent years has brought serious attention to this problem. An examination of previous records has shown significant differences for near field earthquakes, including a large energy pulse, unlike far field earthquakes. But as a general rule, the effects of near field earthquakes have been ignored in most building codes. The purpose of this paper is to investigate the effect of near field earthquakes on reinforced concrete (RC) moment frames. To achieve this goal, the Erduran damage index, an efficient way to calculate damage, was employed to analyze two 4- and 8-story RC moment frame buildings. The buildings with moderate and high ductility were designed by the strength criteria. Seven pairs of near field and far field earthquakes were scaled and used for dynamic nonlinear time history analysis. Using Erduran’s beam and column damage index, respectively, based on rotation and drift, the results from both near and far field earthquakes were compared. Moreover, for better assessment, 4-story buildings were evaluated from the performance based viewpoint of design. We observe from the results that most of the components of the structures under near field earthquakes sustained severe damages and in some cases even component failure. Components of the structures under near field earthquakes suffered from 30% more of damage, on average, than that under far field earthquakes.

Direct Displacement Procedure for Performance-Based Seismic Design of Mid-Rise Wood-Framed Structures

2009 ◽  
Vol 25 (3) ◽  
pp. 583-605 ◽  
Author(s):  
Wei Chiang Pang ◽  
David V. Rosowsky
Keyword(s):  
Seismic Design ◽  
Response Spectrum ◽  
Design Procedure ◽  
Time History ◽  
Time History Analysis ◽  
Nonlinear Time History Analysis ◽  
Framed Structures ◽  
History Analysis ◽  
Performance Based Seismic Design ◽  
Nonlinear Time History

This paper presents a direct displacement design (DDD) procedure that can be used for seismic design of multistory wood-framed structures. The proposed procedure is applicable to any pure shear deforming system. The design procedure is a promising design tool for performance-based seismic design since it allows consideration of multiple performance objectives (e.g., damage limitation, safety requirements) without requiring the engineer to perform a complex finite element or nonlinear time-history analysis of the complete structure. A simple procedure based on normalized modal analysis is used to convert the code-specified acceleration response spectrum into a set of interstory drift spectra. These spectra can be used to determine the minimum stiffness required for each floor based on the drift limit requirements. Specific shear walls can then be directly selected from a database of backbone curves. The procedure is illustrated on the design of two three-story ATC-63 archetype buildings, and the results are validated using nonlinear time-history analysis.

An open-source framework for regional earthquake loss estimation using the city-scale nonlinear time history analysis

2020 ◽  
Vol 36 (2) ◽  
pp. 806-831 ◽  
Author(s):  
Xinzheng Lu ◽  
Frank McKenna ◽  
Qingle Cheng ◽  
Zhen Xu ◽  
Xiang Zeng ◽  
...  
Keyword(s):  
Open Source ◽  
Time History ◽  
Seismic Damage ◽  
Scientific Workflow ◽  
Time History Analysis ◽  
Nonlinear Time History Analysis ◽  
History Analysis ◽  
Loss Prediction ◽  
Nonlinear Time History ◽  
Damage Simulation

Regional seismic damage simulation of buildings provides decision-makers with important information for earthquake disaster prevention and mitigation. Utilizing nonlinear time history analysis using multiple-degree-of-freedom (MDOF) models for buildings, and the next-generation performance-based earthquake engineering, an open-source general-purpose scientific workflow for seismic damage simulation and loss prediction of urban buildings (referred to as SimCenter Workflow) is presented in this study. To introduce the SimCenter Workflow process in detail and demonstrate its advantages, a seismic damage simulation and loss prediction for 1.8 million buildings in the San Francisco Bay Area were performed using the SimCenter Workflow. The open nature and modularization of the SimCenter Workflow facilitate its extensibility and make it practical for researchers to apply to seismic damage simulations in other regions.

The Longitudinal Seismic Analysis of Single-Story and Single-Span Gabled Frame Structures

2015 ◽  
Vol 744-746 ◽  
pp. 335-339
Author(s):  
Hong Dong Ran ◽  
Le Chen ◽  
Yun Mei Ma
Keyword(s):  
Seismic Analysis ◽  
Time History ◽  
Steel Structure ◽  
National Standard ◽  
Nonlinear Time History Analysis ◽  
Frame Structures ◽  
Seismic Action ◽  
Light Weight ◽  
Standard Design ◽  
Nonlinear Time History

Four single-story single-span Gabled Frame Structures (GFSs) which included in China national Standard Design Drawing of Light-weight Steel Structure with Gabled Frame (02SG518-1) were studied and their longitudinal seismic performances were evaluated through extensive nonlinear time-history analysis using eight ground motions representing the Frequent Earthquake, DBE and the MCE hazard levels, the load-bearing performances, deformation capacities and the curves of displacement were studied. The analysis results showed that the longitudinal seismic action of all GFSs considered in this study is very little, the displacement at the top of the column can satisfy the demands of the Technical Specificationfor Steel Structure of Light-weight Building with Gabled Frames even in MCE. The GFSs designed followed the Specificaiton have the excellent longitudinal seismic performance.

Research on the Seismic Response Characteristic of a Curved Ramp Bridge

2011 ◽  
Vol 243-249 ◽  
pp. 3889-3892 ◽  
Author(s):  
Tian Li Wang ◽  
Qing Ning Li ◽  
Hai Jun Yin
Keyword(s):  
Seismic Response ◽  
Time History ◽  
Response Characteristic ◽  
Time History Analysis ◽  
Nonlinear Time History Analysis ◽  
Expansion Joints ◽  
History Analysis ◽  
Nonlinear Time History

In order to analyze seismic response of the curved ramp bridge, this paper selected a single curved ramp bridge in a multilevel junction system as its research object. Considering the piers, beams, bearings and expansion joints simulation, it respectively built the calculating models for a curved ramp bridge and a corresponding linear one. Using nonlinear time history analysis, the paper contrasts seismic response of the curved ramp bridge with that of the linear one in several different seismic inputs. Finally the seismic response characteristic of a curved ramp bridge is put forward.

Optimization Design of Large Span Cable-Stayed Bridge in High Seismic Risk Zone

2013 ◽  
Vol 353-356 ◽  
pp. 2015-2019
Author(s):  
Zhi Hua Xiong ◽  
Yun Cheng Feng ◽  
Song Lin Song ◽  
Jiang Bo Wang
Keyword(s):  
Optimization Design ◽  
Time History ◽  
Nonlinear Time History Analysis ◽  
Seismic Safety ◽  
Seismic Demands ◽  
Large Span ◽  
Cable Stayed Bridge ◽  
History Analysis ◽  
Ductile Steel ◽  
Nonlinear Time History

To ensure seismic safety of a large span cable-stayed bridge, two alternative pylon shapes and section types were studied. Nonlinear time history analysis was performed in the context. It is found that the A-shaped pylon is much stiffener than the H-shaped pylon in terms of deformation. The steel A-shaped pylon can significantly reduce the seismic demands of the key member including tower drift and moment. A ductile steel link between towers is proposed for the optimization of design in the paper. The A-shaped reinforced concrete tower with ductile steel link was proved to be a relatively balanced plan considering engineering, aesthetic and economic factors.

scholarly journals Investigation of PTMD System Affected by Parkfield Near-Field Earthquake

2017 ◽  
Vol 11 (4) ◽  
pp. 70 ◽  
Author(s):  
Ali Vatanshenas
Keyword(s):  
Near Field ◽  
Structural Response ◽  
Time History ◽  
Steel Structure ◽  
Roof Displacement ◽  
Base Shear ◽  
Maximum Acceleration ◽  
Existing Structures ◽  
History Analysis ◽  
Reduction Methods

Earthquake is considered as the main destructive and collapsing factor of structures in near-fault zones, so design new structures and retrofitting existing structures in order to decrease structural responses is an unavoidable matter. One of the structural response reduction methods is using of TMDs. In this paper, a two-dimensional 10-storey steel structure as three structural models without PTMD, with a PTMD at the highest level and ten PTMDs with different characteristics at all levels with the Modal-FNA time-history analysis method under acceleration records with directivity and without directivity of Parkfield 2004 earthquake at the angle of the maximum acceleration response in the first mode period of structure after rotating the acceleration records at the station with directivity and its corresponding angle at the station without directivity were compared to each other in terms of the roof displacement, the input energy and the base shear. It was observed that the structure behavior in the case of using only one PTMD is better, but in the case where ten PTMDs with relative smaller masses were used compared to the case where only one PTMD was used is also with roof displacement reduction.

Sign in / Sign up

Export Citation Format

Share Document