scholarly journals Multifractal properties of large bubble paths in a single bubble column

2011 ◽  
Vol 32 (1) ◽  
pp. 3-20 ◽  
Author(s):  
Romuald Mosdorf ◽  
Tomasz Wyszkowski ◽  
Kamil Dąbrowski

Multifractal properties of large bubble paths in a single bubble columnIn the paper the paths of bubbles emitted from the brass nozzle with inner diameter equal to 1.6 mm have been analyzed. The mean frequency of bubble departure was in the range from 2 to 65.1 Hz. Bubble paths have been recorded using a high speed camera. The image analysis technique has been used to obtain the bubble paths for different mean frequencies of bubble departures. The multifractal analysis (WTMM - wavelet transform modulus maxima methodology) has been used to investigate the properties of bubble paths. It has been shown that bubble paths are the multifractals and the influence of previously departing bubbles on bubble trajectory is significant for bubble departure frequencyfb> 30 Hz.

Meccanica ◽  
2019 ◽  
Vol 54 (14) ◽  
pp. 2119-2130 ◽  
Author(s):  
P. Dzienis ◽  
R. Mosdorf ◽  
T. Wyszkowski

Abstract The nonlinear dynamics of self-organising bubble departures from twin nozzles in engine oils was analysed. Air bubbles were generated from twin brass nozzles with an inner diameter equal to 1 mm. The flow of bubbles in bubble chains was recorded using high-speed camera. The time series of air pressure oscillations and signal from laser–phototransistor identifying the presence of bubbles over the nozzles outlet were recorded simultaneously. The self-organising bubble departures were observed and their stability was analysed. It was found that self-organising bubble departures become unstable because of successive (during subsequent bubble departures) decrease of the mean air pressure in one of the nozzle air supply system. It was shown that instability of self-organising bubble departures leads to equalization of pressures in both nozzles air supply systems which causes that simultaneous bubble departures appear. In the present experiment, this process was repeated in a cyclic and chaotic way. It was shown that stable self-organising bubble departures are accompanied by periodic air pressure oscillations in one of the nozzles and chaotic air pressure oscillations in the second one.


2013 ◽  
Vol 569-570 ◽  
pp. 1218-1225
Author(s):  
Andreas Tjirkallis ◽  
Andreas Kyprianou ◽  
George Vessiaris

A novel structural health monitoring system to detect damages in structures under varying operational and environmental conditions is presented in this paper. A noncontact, full-field measurement using a high speed camera offers a convenient and less expensive measurement procedure, enabling the measuring of responses in elevated temperatures and in conditions where contact sensors are unable to be used. In this paper, a combination of Decay lines of the Wavelet Transform Modulus Maxima (WTMM) and Holder Exponent (HE) are used to distinguish changes on the time response of a vibrating structure due to the operational and environmental variations to changes due to the presence of damage, thus minimising the possibility of false alarm. The proposed methodology is demonstrated using a 3-DOF system under conditions of varying and constant temperatures with the presence of damage, as well as using an experimental setup of a cantilever beam under intact and damaged conditions.


1980 ◽  
Vol 23 (3) ◽  
pp. 630-645 ◽  
Author(s):  
Gerald Zimmermann ◽  
J.A. Scott Kelso ◽  
Larry Lander

High speed cinefluorography was used to track articulatory movements preceding and following full-mouth tooth extraction and alveoloplasty in two subjects. Films also were made of a control subject on two separate days. The purpose of the study was to determine the effects of dramatically altering the structural dimensions of the oral cavity on the kinematic parameters of speech. The results showed that the experimental subjects performed differently pre and postoperatively though the changes were in different directions for the two subjects. Differences in both means and variabilities of kinematic parameters were larger between days for the experimental (operated) subjects than for the control subject. The results for the Control subject also showed significant differences in the mean values of kinematic variables between days though these day-to-day differences could not account for the effects found pre- and postoperatively. The results of the kinematic analysis, particularly the finding that transition time was most stable over the experimental conditions for the operated subjects, are used to speculate about the coordination of normal speech.


2009 ◽  
Vol 27 (1) ◽  
pp. 1-30 ◽  
Author(s):  
P. Prikryl ◽  
V. Rušin ◽  
M. Rybanský

Abstract. A sun-weather correlation, namely the link between solar magnetic sector boundary passage (SBP) by the Earth and upper-level tropospheric vorticity area index (VAI), that was found by Wilcox et al. (1974) and shown to be statistically significant by Hines and Halevy (1977) is revisited. A minimum in the VAI one day after SBP followed by an increase a few days later was observed. Using the ECMWF ERA-40 re-analysis dataset for the original period from 1963 to 1973 and extending it to 2002, we have verified what has become known as the "Wilcox effect" for the Northern as well as the Southern Hemisphere winters. The effect persists through years of high and low volcanic aerosol loading except for the Northern Hemisphere at 500 mb, when the VAI minimum is weak during the low aerosol years after 1973, particularly for sector boundaries associated with south-to-north reversals of the interplanetary magnetic field (IMF) BZ component. The "disappearance" of the Wilcox effect was found previously by Tinsley et al. (1994) who suggested that enhanced stratospheric volcanic aerosols and changes in air-earth current density are necessary conditions for the effect. The present results indicate that the Wilcox effect does not require high aerosol loading to be detected. The results are corroborated by a correlation with coronal holes where the fast solar wind originates. Ground-based measurements of the green coronal emission line (Fe XIV, 530.3 nm) are used in the superposed epoch analysis keyed by the times of sector boundary passage to show a one-to-one correspondence between the mean VAI variations and coronal holes. The VAI is modulated by high-speed solar wind streams with a delay of 1–2 days. The Fourier spectra of VAI time series show peaks at periods similar to those found in the solar corona and solar wind time series. In the modulation of VAI by solar wind the IMF BZ seems to control the phase of the Wilcox effect and the depth of the VAI minimum. The mean VAI response to SBP associated with the north-to-south reversal of BZ is leading by up to 2 days the mean VAI response to SBP associated with the south-to-north reversal of BZ. For the latter, less geoeffective events, the VAI minimum deepens (with the above exception of the Northern Hemisphere low-aerosol 500-mb VAI) and the VAI maximum is delayed. The phase shift between the mean VAI responses obtained for these two subsets of SBP events may explain the reduced amplitude of the overall Wilcox effect. In a companion paper, Prikryl et al. (2009) propose a new mechanism to explain the Wilcox effect, namely that solar-wind-generated auroral atmospheric gravity waves (AGWs) influence the growth of extratropical cyclones. It is also observed that severe extratropical storms, explosive cyclogenesis and significant sea level pressure deepenings of extratropical storms tend to occur within a few days of the arrival of high-speed solar wind. These observations are discussed in the context of the proposed AGW mechanism as well as the previously suggested atmospheric electrical current (AEC) model (Tinsley et al., 1994), which requires the presence of stratospheric aerosols for a significant (Wilcox) effect.


Fluids ◽  
2019 ◽  
Vol 4 (3) ◽  
pp. 162 ◽  
Author(s):  
Thorben Helmers ◽  
Philip Kemper ◽  
Jorg Thöming ◽  
Ulrich Mießner

Microscopic multiphase flows have gained broad interest due to their capability to transfer processes into new operational windows and achieving significant process intensification. However, the hydrodynamic behavior of Taylor droplets is not yet entirely understood. In this work, we introduce a model to determine the excess velocity of Taylor droplets in square microchannels. This velocity difference between the droplet and the total superficial velocity of the flow has a direct influence on the droplet residence time and is linked to the pressure drop. Since the droplet does not occupy the entire channel cross-section, it enables the continuous phase to bypass the droplet through the corners. A consideration of the continuity equation generally relates the excess velocity to the mean flow velocity. We base the quantification of the bypass flow on a correlation for the droplet cap deformation from its static shape. The cap deformation reveals the forces of the flowing liquids exerted onto the interface and allows estimating the local driving pressure gradient for the bypass flow. The characterizing parameters are identified as the bypass length, the wall film thickness, the viscosity ratio between both phases and the C a number. The proposed model is adapted with a stochastic, metaheuristic optimization approach based on genetic algorithms. In addition, our model was successfully verified with high-speed camera measurements and published empirical data.


Author(s):  
Patrícia Hennig Osmari ◽  
Francisco Thiago Sacramento Aragão ◽  
Leni Figueiredo Mathias Leite ◽  
Renata Antoun Simão ◽  
Laura Maria Goretti da Motta ◽  
...  

This study evaluated the effects of the commercial product, AR 5, and two alternative products, waste cooking oil and castor oil, in the rejuvenation process of two asphalt binders. The analyses were carried out on microscopic and macroscopic scales on virgin, aged, and rejuvenated binders. Tests in a dynamic shear rheometer were performed to characterize rheological properties of the binders. Then, an atomic force microscope was used to identify microstructural changes in the materials. A digital image analysis technique enabled the quantification of key variables such as area fraction and spatial and size distributions of the binder constituents. Finally, the following chemical tests were performed to identify changes in the chemical composition of the binders resulting from the aging and rejuvenation processes: SARA (which measures saturates, asphaltenes, resins, and aromatics), gel permeation chromatography, and nuclear magnetic resonance. The results obtained from the tests were further compared to identify correlations between the properties evaluated in different scales. The results demonstrated the efficiency and potential of the rejuvenators evaluated in this study. The results also highlighted the importance of the use of advanced techniques to characterize and understand the material aging and rejuvenation processes.


Sign in / Sign up

Export Citation Format

Share Document