scholarly journals Circulation and physical processes within the San Gabriel River Estuary during summer 2005

2007 ◽  
Author(s):  
Kurt J. Rosenberger ◽  
Jingping Xu ◽  
Eric D. Stein ◽  
Marlene A. Noble ◽  
Anne L. Gartner
Keyword(s):  
River Estuary ◽  
Physical Processes ◽  
San Gabriel River

scholarly journals THE M2 AND M4 TIDES IN THE PARÁ RIVER ESTUARY

2017 ◽  
Vol 45 (1) ◽  
Author(s):  
Yuri Onça PRESTES ◽  
Alex Costa SILVA ◽  
Marcelo ROLLNIC ◽  
Renan Peixoto ROSÁRIO
Keyword(s):  
River Discharge ◽  
River Estuary ◽  
Tidal Wave ◽  
Tidal Asymmetry ◽  
Tidal Amplitude ◽  
Physical Processes ◽  
Left Margin ◽  
The Right ◽  
Lateral Variations ◽  
Different Sources

The Pará River estuary is a complex and special system in amazon continental shelf, with micro and mesoscale physical processes generated by forces of different sources (e.g., astronomical tides and river discharge). In this study, the main semidiurnal (M2) and the overtide (M4) components were analyzed by quantifying distortions degrees and identifying tidal asymmetries in the Pará River estuary. Two submersible tidal gauges were moored to measure the water level. One on the right margin (point #RG) and another on the left margin (#LF) recorded measurements 6 months (from September 2014 to March 2015). Furthermore, we used harmonic charts from Marine Studies Foundation (FEMAR, Fundação de Estudos do Mar). Lateral variations were also identified between #RG and #LF points from the amplitude and phase cotidal charts, with about 10 minutes delay and variation of 2 cm in tidal amplitude. We verified that the tidal wave enters in system by the right margin (#RF). The results show distortion degrees higher than 10% and positive asymmetry of the tidal wave in the Pará River, and the tidal attenuation in the estuary may be greater than 400 km upstream along the drainage basin.Keywords: Tidal distortion, Tidal asymmetry, Tidal components, Lateral variations.

scholarly journals Investigation of Morphological Changes in the Tamsui River Estuary Using an Integrated Coastal and Estuarine Processes Model

Water ◽  
2020 ◽  
Vol 12 (4) ◽  
pp. 1084 ◽  
Author(s):  
Tung-Chou Hsieh ◽  
Yan Ding ◽  
Keh-Chia Yeh ◽  
Ren-Kai Jhong
Keyword(s):  
Sandy Beach ◽  
Morphological Changes ◽  
River Estuary ◽  
River Mouth ◽  
Physical Processes ◽  
Complex Flow ◽  
Monsoon Period ◽  
Estuarine Processes ◽  
Sediment Flushing ◽  
The Impact

This study is to investigate morphological changes in the Tamsui River Estuary in Taiwan driven by multiple physical processes, such as river flows, tides, waves, and storm surges, and then to study the impacts of sediment flushing operated at the Shihmen reservoir upstream on the river estuary. An integrated coastal and estuarine processes model (CCHE2D-Coast) (Center for Computational Hydroscience and Engineering Two-Dimensional-Coast) was validated by simulating these physical processes in the estuary driven by three historical typhoons in 2008. The site-specifically validated model was then applied to simulate morphological changes in the estuary in response to reservoir sediment flush scenarios from the upstream. For the impact assessment of sediment flushing, a synthetic hydrological event was designed by including a historical typhoon and a typical monsoon. It was found that during the typhoon, the sediments will be mostly deposited in the estuarine river reach of Tamsui and the Wazihwei sandy beach. During the monsoon period, most of the sediments tend to be deposited in the second fishing port of Tamsui, the northern breakwater, and the estuary, while the Wazihwei sandy beach in the river mouth would be scoured by backflow. Simulations of the complex flow fields and morphological changes will facilitate the best practice of sediment management in the coastal and estuarine regions.

Models of Thermodynamic Properties of Prominences

1979 ◽  
Vol 44 ◽  
pp. 349-355
Author(s):  
R.W. Milkey
Keyword(s):  
Thermodynamic Properties ◽  
Mass Transport ◽  
Emission Spectrum ◽  
Thermodynamic Parameters ◽  
Working Group ◽  
Physical Processes ◽  
Theoretical Concepts ◽  
Group 3 ◽  
Observational Techniques

The focus of discussion in Working Group 3 was on the Thermodynamic Properties as determined spectroscopically, including the observational techniques and the theoretical modeling of physical processes responsible for the emission spectrum. Recent advances in observational techniques and theoretical concepts make this discussion particularly timely. It is wise to remember that the determination of thermodynamic parameters is not an end in itself and that these are interesting chiefly for what they can tell us about the energetics and mass transport in prominences.

Sampling and analysis of the air-water interface with SEM and EDS of microlayers

1989 ◽  
Vol 47 ◽  
pp. 1004-1005
Author(s):  
Randall W. Smith ◽  
John Dash
Keyword(s):  
Heavy Metals ◽  
Surface Microlayer ◽  
Surface Films ◽  
Water Interface ◽  
Physical Processes ◽  
Infrared Spectroscopic Analysis ◽  
Eds Analysis ◽  
Air Water Interface ◽  
Significant Area ◽  
Bulk Chemical

The structure of the air-water interface forms a boundary layer that involves biological ,chemical geological and physical processes in its formation. Freshwater and sea surface microlayers form at the air-water interface and include a diverse assemblage of organic matter, detritus, microorganisms, plankton and heavy metals. The sampling of microlayers and the examination of components is presently a significant area of study because of the input of anthropogenic materials and their accumulation at the air-water interface. The neustonic organisms present in this environment may be sensitive to the toxic components of these inputs. Hardy reports that over 20 different methods have been developed for sampling of microlayers, primarily for bulk chemical analysis. We report here the examination of microlayer films for the documentation of structure and composition.Baier and Gucinski reported the use of Langmuir-Blogett films obtained on germanium prisms for infrared spectroscopic analysis (IR-ATR) of components. The sampling of microlayers has been done by collecting fi1ms on glass plates and teflon drums, We found that microlayers could be collected on 11 mm glass cover slips by pulling a Langmuir-Blogett film from a surface microlayer. Comparative collections were made on methylcel1ulose filter pads. The films could be air-dried or preserved in Lugol's Iodine Several slicks or surface films were sampled in September, 1987 in Chesapeake Bay, Maryland and in August, 1988 in Sequim Bay, Washington, For glass coverslips the films were air-dried, mounted on SEM pegs, ringed with colloidal silver, and sputter coated with Au-Pd, The Langmuir-Blogett film technique maintained the structure of the microlayer intact for examination, SEM observation and EDS analysis were then used to determine organisms and relative concentrations of heavy metals, using a Link AN 10000 EDS system with an ISI SS40 SEM unit. Typical heavy microlayer films are shown in Figure 3.

Climate-associated trends and variability in ichthyoplankton phenology from the longest continuous larval fish time series on the east coast of the United States

2020 ◽  
Vol 650 ◽  
pp. 269-287
Author(s):  
WC Thaxton ◽  
JC Taylor ◽  
RG Asch
Keyword(s):  
United States ◽  
Environmental Variability ◽  
Larval Fish ◽  
Interspecific Interactions ◽  
River Estuary ◽  
Atlantic Multidecadal Oscillation ◽  
The United States ◽  
Larval Survival ◽  
Ecological Communities ◽  
Northerly Wind

As the effects of climate change become more pronounced, variation in the direction and magnitude of shifts in species occurrence in space and time may disrupt interspecific interactions in ecological communities. In this study, we examined how the fall and winter ichthyoplankton community in the Newport River Estuary located inshore of Pamlico Sound in the southeastern United States has responded to environmental variability over the last 27 yr. We relate the timing of estuarine ingress of 10 larval fish species to changes in sea surface temperature (SST), the Atlantic Multidecadal Oscillation, the North Atlantic Oscillation, wind strength and phenology, and tidal height. We also examined whether any species exhibited trends in ingress phenology over the last 3 decades. Species varied in the magnitude of their responses to all of the environmental variables studied, but most shared a common direction of change. SST and northerly wind strength had the largest impact on estuarine ingress phenology, with most species ingressing earlier during warm years and delaying ingress during years with strong northerly winds. As SST warms in the coming decades, the average date of ingress of some species (Atlantic croaker Micropogonias undulatus, summer flounder Paralichthys dentatus, pinfish Lagodon rhomboides) is projected to advance on the order of weeks to months, assuming temperatures do not exceed a threshold at which species can no longer respond through changes in phenology. These shifts in ingress could affect larval survival and growth since environmental conditions in the estuarine and pelagic nursery habitats of fishes also vary seasonally.

Distributed Modeling Of Building Systems Through Cyber-Physical Integration

2019 ◽  
pp. 12-17
Keyword(s):  
Data Structure ◽  
Operating Conditions ◽  
Physical Models ◽  
Distributed Model ◽  
Physical Processes ◽  
Distributed Modeling ◽  
Distributed Models ◽  
Operating Modes ◽  
Building Systems ◽  
Important Practical Application

This article describes the proposed approaches to creating distributed models that can, with given accuracy under given restrictions, replace classical physical models for construction objects. The ability to implement the proposed approaches is a consequence of the cyber-physical integration of building systems. The principles of forming the data structure of designed objects and distributed models, which make it possible to uniquely identify the elements and increase the level of detail of such a model, are presented. The data structure diagram of distributed modeling includes, among other things, the level of formation and transmission of signals about physical processes inside cyber-physical building systems. An enlarged algorithm for creating the structure of the distributed model which describes the process of developing a data structure, formalizing requirements for the parameters of a design object and its operating modes (including normal operating conditions and extreme conditions, including natural disasters) and selecting objects for a complete group that provides distributed modeling is presented. The article formulates the main approaches to the implementation of an important practical application of the cyber-physical integration of building systems - the possibility of forming distributed physical models of designed construction objects and the directions of further research are outlined.

Sign in / Sign up

Export Citation Format

Share Document