scholarly journals Low-Temperature Chemical Vapor Deposition Growth of MoS2 Nanodots and Their Raman and Photoluminescence Profiles

2021 ◽  
Vol 3 ◽  
Author(s):  
Larionette P. L. Mawlong ◽  
Ravi K. Biroju ◽  
P. K. Giri

We report on the growth of an ordered array of MoS2 nanodots (lateral sizes in the range of ∼100–250 nm) by a thermal chemical vapor deposition (CVD) method directly onto SiO2 substrates at a relatively low substrate temperature (510–560°C). The temperature-dependent growth and evolution of MoS2 nanodots and the local environment of sulfur-induced structural defects and impurities were systematically investigated by field emission scanning electron microscopy, micro-Raman spectroscopy, and X-ray photoelectron spectroscopy (XPS) techniques. At the substrate temperature of 560°C, we observed mostly few-layer MoS2, and at 510°C, multilayer MoS2 growth, as confirmed from the Raman line shape analysis. With reduced substrate temperature, the density of MoS2 nanodots decreases, and layer thickness increases. Raman studies show characteristic Raman modes of the crystalline MoS2 layer, along with two new Raman modes centered at ∼346 and ∼361 cm−1, which are associated with MoO2 and MoO3 phases, respectively. Room temperature photoluminescence (PL) studies revealed strong visible PL from MoS2 layers, which is strongly blue-shifted from the bulk MoS2 flakes. The strong visible emission centered at ∼ 658 nm signifies a free excitonic transition in the direct gap of single-layer MoS2. Position-dependent PL profiles show excellent uniformity of the MoS2 layers for samples grown at 540 and 560°C. These results are significant for the low-temperature CVD growth of a few-layer MoS2 dots with direct bandgap photoluminescence on a flexible substrate.

2000 ◽  
Vol 611 ◽  
Author(s):  
Akira Izumi ◽  
Hidekazu Sato ◽  
Hideki Matsumura

ABSTRACTThis paper reports a procedure for low-temperature nitridation of silicon dioxide (SiO2) surfaces using species produced by catalytic decomposition of NH3 on heated tungsten in catalytic chemical vapor deposition (Cat-CVD) system. The surface of SiO2/Si(100) was nitrided at temperatures as low as 200°C. X-ray photoelectron spectroscopy measurements revealed that incorporated N atoms are bound to Si atoms and O atoms and located top-surface of SiO2.


2006 ◽  
Vol 527-529 ◽  
pp. 1079-1082 ◽  
Author(s):  
Shiro Hino ◽  
Tomohiro Hatayama ◽  
Naruhisa Miura ◽  
Tatsuo Ozeki ◽  
Eisuke Tokumitsu

Low temperature deposition of HfO2 films on 4H-SiC(0001) substrates by pulse introduced metalorganic chemical vapor deposition (MOCVD) using tetrakis-diethylamido-hafnium [Hf[N(C2H5)2]4, (TDEAH)] and H2O has been investigated. HfO2 films with relatively low leakage current density of 10-4 A/cm2 were obtained even at a deposition temperature as low as 190 °C. We demonstrate that the HfO2/SiC interface, where the HfO2 was deposited at 190 °C, has lower interface state density than a typical thermally-grown SiO2/SiC interface. It is also shown by X-ray photoelectron spectroscopy (XPS) that the HfO2/SiC structure fabricated at 190 °C has lower SiOx count than the HfO2/SiC structure fabricated at 400 °C.


1999 ◽  
Vol 14 (4) ◽  
pp. 1238-1245 ◽  
Author(s):  
A. Subekti ◽  
E. M. Goldys ◽  
Melissa J. Paterson ◽  
K. Drozdowicz-Tomsia ◽  
T. L. Tansley

Metalorganic chemical vapor deposition (MOCVD) GaSb growth using trimethylgallium and trimethylantimony as a function of substrate temperature and V/III ratio was examined. These parameters were found to have a significant effect on the growth rate and surface morphology of the GaSb films. A phase diagram is used to interpret the effect of these growth parameters on the GaSb film growth. The region of single-phase growth was found to be narrow, falling between 540 and 560 °C. The optimum growth conditions for the MOCVD growth of GaSb have been determined for a TMGa flow rate of 20 sccm and a carrier gas flow of 8 l/min. The optimum substrate temperature and V/III ratio were found to be 540 °C and 0.72, respectively. In these conditions the lowest hole concentration of 5 × 1016 cm-3 and the highest room temperature mobility of 500 cm2 V-1 s-1 were achieved, accompanied by a steep, well-resolved band edge at 0.72 eV.


Nanomaterials ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 3363
Author(s):  
Chi Zhang ◽  
Majiaqi Wu ◽  
Pengchang Wang ◽  
Maoliang Jian ◽  
Jianhua Zhang ◽  
...  

In this paper, the environmental stability of silicon nitride (SiNx) films deposited at 80 °C by plasma-enhanced chemical vapor deposition was studied systematically. X-ray photoelectron spectroscopy and Fourier transform infrared reflection were used to analyze the element content and atomic bond structure of the amorphous SiNx films. Variation of mechanical and optical properties were also evaluated. It is found that SiNx deposited at low temperature is easily oxidized, especially at elevated temperature and moisture. The hardness and elastic modulus did not change significantly with the increase of oxidation. The changes of the surface morphology, transmittance, and fracture extensibility are negligible. Finally, it is determined that SiNx films deposited at low-temperature with proper processing parameters are suitable for thin-film encapsulation of flexible devices.


ACS Nano ◽  
2012 ◽  
Vol 6 (3) ◽  
pp. 2471-2476 ◽  
Author(s):  
Bin Zhang ◽  
Wi Hyoung Lee ◽  
Richard Piner ◽  
Iskandar Kholmanov ◽  
Yaping Wu ◽  
...  

2020 ◽  
Vol 20 (12) ◽  
pp. 7698-7704
Author(s):  
K. Kavitha ◽  
Akanksha R. Urade ◽  
Gurjinder Kaur ◽  
Indranil Lahiri

A two-step, low-temperature thermal chemical vapor deposition (CVD) process, which uses camphor for synthesizing continuous graphene layer on Cu substrate is reported. The growth process was performed at lower temperature (800 °C) using camphor as the source of carbon. A threezone CVD system was used for controlled heating of precursor, in order to obtain uniform graphene layer. As-grown samples were characterized by X-ray diffraction (XRD), Raman spectroscopy and transmission electron microscopy (TEM). The results show the presence of 4–5 layers of graphene. As-grown graphene transferred onto a glass substrate through a polymer-free wet-etching process, demonstrated transmittance ~91% in visible spectra. This process of synthesizing large area, 4–5 layer graphene at reduced temperature represents an energy-efficient method of producing graphene for possible applications in opto-electronic industry.


Sign in / Sign up

Export Citation Format

Share Document