scholarly journals Struvite Crystallisation and the Effect of Co2+ Ions

Minerals ◽  
2019 ◽  
Vol 9 (9) ◽  
pp. 503
Author(s):  
Jörn Hövelmann ◽  
Tomasz M. Stawski ◽  
Helen M. Freeman ◽  
Rogier Besselink ◽  
Sathish Mayanna ◽  
...  
Keyword(s):  
Colour Change ◽  
Ex Situ ◽  
Crystal Formation ◽  
Time Resolved ◽  
Recovery Method ◽  
Pure System ◽  
X Ray Scattering ◽  
Transmission Electron ◽  
Phosphate Phase ◽  
Co Concentrations

The controlled crystallisation of struvite (MgNH4PO4∙6H2O) is a viable means for the recovery and recycling of phosphorus (P) from municipal and industrial wastewaters. However, an efficient implementation of this recovery method in water treatment systems requires a fundamental understanding of struvite crystallisation mechanisms, including the behavior and effect of metal contaminants during struvite precipitation. Here, we studied the crystallisation pathways of struvite from aqueous solutions using a combination of ex situ and in situ time-resolved synthesis and characterization techniques, including synchrotron-based small- and wide-angle X-ray scattering (SAXS/WAXS) and cryogenic transmission electron microscopy (cryo-TEM). Struvite syntheses were performed both in the pure Mg-NH4-PO4 system as well as in the presence of cobalt (Co), which, among other metals, is typically present in waste streams targeted for P-recovery. Our results show that in the pure system and at Co concentrations < 0.5 mM, struvite crystals nucleate and grow directly from solution, much in accordance with the classical notion of crystal formation. In contrast, at Co concentrations ≥ 1 mM, crystallisation was preceded by the transient formation of an amorphous nanoparticulate phosphate phase. Depending on the aqueous Co/P ratio, this amorphous precursor was found to transform into either (i) Co-bearing struvite (at Co/P < 0.3) or (ii) cobalt phosphate octahydrate (at Co/P > 0.3). These amorphous-to-crystalline transformations were accompanied by a marked colour change from blue to pink, indicating a change in Co2+ coordination in the formed solid from tetrahedral to octahedral. Our findings have implications for the recovery of nutrients and metals during struvite crystallisation and contribute to the ongoing general discussion about the mechanisms of crystal formation.

Ex SituTransmission Electron Microscopy: A Fixed-Bed Reactor Approach

2005 ◽  
Vol 12 (2) ◽  
pp. 135-144 ◽  
Author(s):  
Chris E. Kliewer ◽  
Gabor Kiss ◽  
Gregory J. DeMartin
Keyword(s):  
Electron Microscopy ◽  
Heterogeneous Catalysts ◽  
Fixed Bed ◽  
Fixed Bed Reactor ◽  
Ex Situ ◽  
Process Conditions ◽  
Actual Process ◽  
Time Resolved ◽  
Transmission Electron ◽  
Intermediate Size

A fixed-bed reactor has been designed and constructed for ex situ transmission electron microscopy (TEM) studies of heterogeneous catalysts. Theex situfacility exposes a fully prepared TEM sample on a grid to actual process conditions (e.g., temperature, pressure, gas composition, etc.) by placing the grid at the exit section of a conventional fixed-bed reactor. A unique reactor design allows grid transfer into the electron microscope and back into the reactor again under a controlled (inert) environment, thus allowing time-resolved monitoring of catalyst morphology changes under realistic, well-controlled conditions. This facility stands completely independent of the TEM. Thus, no special TEM modifications are required and long-termex situstudies do not impact microscope utilization. The utility of the facility is demonstratedviathe oxidation of intermediate size (∼20–∼80 nm) supported copper particles.

Microtubule nucleation sequence studied by time-resolved x-ray scattering and electron microscopy

1983 ◽  
Vol 41 ◽  
pp. 766-767
Author(s):  
Eva-Maria Mandelkow ◽  
Eckhard Mandelkow ◽  
Joan Bordas
Keyword(s):  
Electron Microscopy ◽  
Dynamic Equilibrium ◽  
Time Resolved ◽  
X Ray ◽  
Additional Information ◽  
X Ray Scattering ◽  
Low Concentrations ◽  
Microtubule Growth ◽  
Ray Patterns ◽  
Ray Scattering

When a solution of microtubule protein is changed from non-polymerising to polymerising conditions (e.g. by temperature jump or mixing with GTP) there is a series of structural transitions preceding microtubule growth. These have been detected by time-resolved X-ray scattering using synchrotron radiation, and they may be classified into pre-nucleation and nucleation events. X-ray patterns are good indicators for the average behavior of the particles in solution, but they are difficult to interpret unless additional information on their structure is available. We therefore studied the assembly process by electron microscopy under conditions approaching those of the X-ray experiment. There are two difficulties in the EM approach: One is that the particles important for assembly are usually small and not very regular and therefore tend to be overlooked. Secondly EM specimens require low concentrations which favor disassembly of the particles one wants to observe since there is a dynamic equilibrium between polymers and subunits.

Techniques for cryoultramicrotomy of propane jet frozen biological samples

1986 ◽  
Vol 44 ◽  
pp. 260-261
Author(s):  
B. Craig ◽  
L. Hawkey ◽  
A. LeFurgey
Keyword(s):  
Freeze Fracture ◽  
Freeze Substitution ◽  
Heart Cells ◽  
Crystal Formation ◽  
X Ray ◽  
Transmission Electron ◽  
Scanning Transmission ◽  
Chick Heart ◽  
Embryonic Chick Heart ◽  
A New Technique

Ultra-rapid freezing followed by cryoultramicrotomy is essential for the preservation of diffusible elements in situ within cells prior to scanning transmission electron microscopy and quantitative energy dispersive x-ray microanalysis. For cells or tissue fragments in suspension and for monolayer cell cultures, propane jet freezing provides cooling rates greater than 30,000°C/sec with regions up to 40μm in thickness free of significant ice crystal formation. While this method of freezing has frequently been applied prior to freeze fracture or freeze substitution, it has not been widely utilized prior to cryoultramicrotomy and subsequent x-ray microanalytical studies. This report describes methods devised in our laboratory for cryosectioning of propane jet frozen kidney proximal tubule suspensions and cultured embryonic chick heart cells, in particular a new technique for mounting frozen suspension specimens for sectioning. The techniques utilize the same specimen supports and sample holders as those used for freeze fracture and freeze substitution and should be generally applicable to any cell suspension or culture preparation.

Transmission Electron Microscopy of Epitaxial silicides grown by ultra high vacuum deposition

1989 ◽  
Vol 47 ◽  
pp. 462-463
Author(s):  
D. Loretto ◽  
J. M. Gibson ◽  
S. M. Yalisove
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Electron Diffraction ◽  
High Vacuum ◽  
High Energy ◽  
Energy Electron ◽  
Ultra High Vacuum ◽  
Ex Situ ◽  
Transmission Electron

The silicides CoSi2 and NiSi2 are both metallic with the fee flourite structure and lattice constants which are close to silicon (1.2% and 0.6% smaller at room temperature respectively) Consequently epitaxial cobalt and nickel disilicide can be grown on silicon. If these layers are formed by ultra high vacuum (UHV) deposition (also known as molecular beam epitaxy or MBE) their thickness can be controlled to within a few monolayers. Such ultrathin metal/silicon systems have many potential applications: for example electronic devices based on ballistic transport. They also provide a model system to study the properties of heterointerfaces. In this work we will discuss results obtained using in situ and ex situ transmission electron microscopy (TEM).In situ TEM is suited to the study of MBE growth for several reasons. It offers high spatial resolution and the ability to penetrate many monolayers of material. This is in contrast to the techniques which are usually employed for in situ measurements in MBE, for example low energy electron diffraction (LEED) and reflection high energy electron diffraction (RHEED), which are both sensitive to only a few monolayers at the surface.

Time-Resolved Cryo-Electron Microscopy of Oscillating Microtubules

1990 ◽  
Vol 48 (1) ◽  
pp. 502-503
Author(s):  
Eva-Maria Mandelkow ◽  
Ron Milligan
Keyword(s):  
Electron Microscopy ◽  
Dynamic Instability ◽  
Entire Solution ◽  
Reaction Scheme ◽  
Time Resolved ◽  
X Ray ◽  
X Ray Scattering ◽  
A Chain ◽  
Ray Scattering

Microtubules form part of the cytoskeleton of eukaryotic cells. They are hollow libers of about 25 nm diameter made up of 13 protofilaments, each of which consists of a chain of heterodimers of α-and β-tubulin. Microtubules can be assembled in vitro at 37°C in the presence of GTP which is hydrolyzed during the reaction, and they are disassembled at 4°C. In contrast to most other polymers microtubules show the behavior of “dynamic instability”, i.e. they can switch between phases of growth and phases of shrinkage, even at an overall steady state [1]. In certain conditions an entire solution can be synchronized, leading to autonomous oscillations in the degree of assembly which can be observed by X-ray scattering (Fig. 1), light scattering, or electron microscopy [2-5]. In addition such solutions are capable of generating spontaneous spatial patterns [6].In an earlier study we have analyzed the structure of microtubules and their cold-induced disassembly by cryo-EM [7]. One result was that disassembly takes place by loss of protofilament fragments (tubulin oligomers) which fray apart at the microtubule ends. We also looked at microtubule oscillations by time-resolved X-ray scattering and proposed a reaction scheme [4] which involves a cyclic interconversion of tubulin, microtubules, and oligomers (Fig. 2). The present study was undertaken to answer two questions: (a) What is the nature of the oscillations as seen by time-resolved cryo-EM? (b) Do microtubules disassemble by fraying protofilament fragments during oscillations at 37°C?

In situ Time-Resolved Small-Angle X-ray Scattering Reveals the Formation Kinetics of Polyelectrolyte Complex Micelles

2019 ◽  
Author(s):  
Hao Wu ◽  
Jeffrey Ting ◽  
Siqi Meng ◽  
Matthew Tirrell
Keyword(s):  
Small Angle ◽  
Self Assembly ◽  
Electrostatic Interactions ◽  
Polyelectrolyte Complex ◽  
Time Resolved ◽  
X Ray ◽  
X Ray Scattering ◽  
Kinetics Of ◽  
Ray Scattering

We have directly observed the <i>in situ</i> self-assembly kinetics of polyelectrolyte complex (PEC) micelles by synchrotron time-resolved small-angle X-ray scattering, equipped with a stopped-flow device that provides millisecond temporal resolution. This work has elucidated one general kinetic pathway for the process of PEC micelle formation, which provides useful physical insights for increasing our fundamental understanding of complexation and self-assembly dynamics driven by electrostatic interactions that occur on ultrafast timescales.

A Cross-Method Comparison of Sub-10 nm Nanoparticle Size Distribution

2019 ◽  
Author(s):  
Ye Yang ◽  
Suiyang Liao ◽  
Zhi Luo ◽  
Runzhang Qi ◽  
Niamh Mac Fhionnlaoich ◽  
...  
Keyword(s):  
Size Distribution ◽  
Analytical Ultracentrifugation ◽  
Statistical Significance ◽  
Method Comparison ◽  
Size Determination ◽  
Size Dependent ◽  
X Ray Scattering ◽  
Transmission Electron ◽  
Gold Nps ◽  
Reliable Representation

Accurate nanoparticle (NP) size determination is essential across research domains, with many functions in nanoscience and biomedical research being size-dependent. Although transmission electron microscopy (TEM) is capable of resolving a single NP down to the sub-nm scale, the reliable representation of entire populations is plagued by challenges in providing statistical significance, predominantly due to limited sample counts, suboptimal preparation procedures and operator bias during image acquisition and analysis. Meanwhile alternative techniques exist, but reliable implementation requires a detailed understanding of appendant limitations. Herein, conventional TEM is compared to the size determination of sub-10 nm gold NPs in solution by small-angle X-ray scattering and analytical ultracentrifugation. Form-free Monte Carlo fitting of scattering profiles offers access to a direct representation of the core size distribution while ultracentrifugation sedimentation velocity analysis provides information of the hydrodynamic size distribution. We report a comparison of these three methods in determining the size of quasi-monodisperse, polydisperse and bimodal gold nanoparticles of 2 – 7 nm and discuss advantages and limitations of each technique.

A New Method of Wafer Level Plan View TEM Sample Preparation by DualBeam

2008 ◽  
Author(s):  
Hyoung H. Kang ◽  
Michael A. Gribelyuk ◽  
Oliver D. Patterson ◽  
Steven B. Herschbein ◽  
Corey Senowitz
Keyword(s):  
Sample Preparation ◽  
Ex Situ ◽  
Wafer Level ◽  
Cross Sectional ◽  
Plan View ◽  
Manufacturing Line ◽  
Transmission Electron ◽  
Thin Lamella ◽  
Preparation Techniques

Abstract Cross-sectional style transmission electron microscopy (TEM) sample preparation techniques by DualBeam (SEM/FIB) systems are widely used in both laboratory and manufacturing lines with either in-situ or ex-situ lift out methods. By contrast, however, the plan view TEM sample has only been prepared in the laboratory environment, and only after breaking the wafer. This paper introduces a novel methodology for in-line, plan view TEM sample preparation at the 300mm wafer level that does not require breaking the wafer. It also presents the benefit of the technique on electrically short defects. The methodology of thin lamella TEM sample preparation for plan view work in two different tool configurations is also presented. The detailed procedure of thin lamella sample preparation is also described. In-line, full wafer plan view (S)TEM provides a quick turn around solution for defect analysis in the manufacturing line.

Sign in / Sign up

Export Citation Format

Share Document