scholarly journals Characterization of Bio-Inspired Electro-Conductive Soy Protein Films

Polymers ◽  
2021 ◽  
Vol 13 (3) ◽  
pp. 416
Author(s):  
Pedro Guerrero ◽  
Tania Garrido ◽  
Itxaso Garcia-Orue ◽  
Edorta Santos-Vizcaino ◽  
Manoli Igartua ◽  
...  

Protein-based conductive materials are gaining attention as alternative components of electronic devices for value-added applications. In this regard, soy protein isolate (SPI) was processed by extrusion in order to obtain SPI pellets, subsequently molded into SPI films by hot pressing, resulting in homogeneous and transparent films, as shown by scanning electron microscopy and UV-vis spectroscopy analyses, respectively. During processing, SPI denatured and refolded through intermolecular interactions with glycerol, causing a major exposition of tryptophan residues and fluorescence emission, affecting charge distribution and electron transport properties. Regarding electrical conductivity, the value found (9.889 × 10−4 S/m) is characteristic of electrical semiconductors, such as silicon, and higher than that found for other natural polymers. Additionally, the behavior of the films in contact with water was analyzed, indicating a controlled swelling and a hydrolytic surface, which is of great relevance for cell adhesion and spreading. In fact, cytotoxicity studies showed that the developed SPI films were biocompatible, according to the guidelines for the biological evaluation of medical devices. Therefore, these SPI films are uniquely suited as bioelectronics because they conduct both ionic and electronic currents, which is not accessible for the traditional metallic conductors.

Polymers ◽  
2020 ◽  
Vol 12 (9) ◽  
pp. 2106
Author(s):  
Jone Uranga ◽  
Mª Goretti Llamas ◽  
Ziortza Agirrezabala ◽  
María Teresa Dueñas ◽  
Oier Etxebeste ◽  
...  

Two exopolysaccharide (EPS)-producing lactic acid bacteria (LAB) strains, Liquorilactobacillus (L.) sp CUPV281 and Liquorilactobacillus (L.) mali CUPV271, were isolated from Spanish apple must. Each of the strains produced a dextran, with different branching degrees, to be incorporated into soy protein isolate (SPI) film-forming formulations. Films were prepared by compression molding, a more rapid processing method than solution casting and, thus, with a greater potential for scaling-up production. Thermal analysis showed that SPI and EPS start the degradation process at temperatures above 190 °C, confirming that the compression temperature selected (120 °C) was well below the corresponding degradation temperatures. Resulting films were transparent and homogeneous, as shown by UV-Vis spectroscopy and SEM, indicating the good compatibility between SPI and EPS. Furthermore, FTIR analysis showed that the interactions between SPI and EPS were physical interactions, probably by hydrogen bonding among the polar groups of SPI and EPS. Regarding antifungal/fungistatic activity, LAB strains used in this study showed an inhibitory effect on germination of fungal spores.


Polymers ◽  
2021 ◽  
Vol 13 (11) ◽  
pp. 1807
Author(s):  
Estefanía Álvarez-Castillo ◽  
José Manuel Aguilar ◽  
Carlos Bengoechea ◽  
María Luisa López-Castejón ◽  
Antonio Guerrero

Composite materials based on proteins and carbohydrates normally offer improved water solubility, biodegradability, and biocompatibility, which make them attractive for a wide range of applications. Soy protein isolate (SPI) has shown superabsorbent properties that are useful in fields such as agriculture. Alginate salts (ALG) are linear anionic polysaccharides obtained at a low cost from brown algae, displaying a good enough biocompatibility to be considered for medical applications. As alginates are quite hydrophilic, the exchange of ions from guluronic acid present in its molecular structure with divalent cations, particularly Ca2+, may induce its gelation, which would inhibit its solubilization in water. Both biopolymers SPI and ALG were used to produce composites through injection moulding using glycerol (Gly) as a plasticizer. Different biopolymer/plasticizer ratios were employed, and the SPI/ALG ratio within the biopolymer fraction was also varied. Furthermore, composites were immersed in different CaCl2 solutions to inhibit the amount of soluble matter loss and to enhance the mechanical properties of the resulting porous matrices. The main goal of the present work was the development and characterization of green porous matrices with inhibited solubility thanks to the gelation of alginate.


Author(s):  
Ozan Tas ◽  
Ulku Ertugrul ◽  
Mecit Halil Oztop ◽  
Bekir Gokcen Mazı

e-Polymers ◽  
2021 ◽  
Vol 21 (1) ◽  
pp. 433-442
Author(s):  
Hua He ◽  
Rui-jing Jia ◽  
Kai-qiang Dong ◽  
Jia-wen Huang ◽  
Zhi-yong Qin

Abstract A novel biodegradable protein-based material (UMSPIE) that consists of natural polymer soy protein isolate (SPI), ultrasonic-modified montmorillonite (UMMT), and ethylene glycol diglycidyl ether (EGDE) was produced by solution casting. Fourier infrared spectroscopy (FTIR), X-ray diffraction (XRD), thermogravimetric analysis (TG), and scanning electron microscopy (SEM) were used to characterize the chemical structure and micro-morphologies of as-synthesized protein-based composite films. The results showed that the interlayer structure of MMT was destroyed by ultrasonic treatment, and the hydrogen bonding between SPI chains and the ultrasound-treated MMT plates was enhanced. The synergistic effect of UMMT and EGDE on SPI molecules made the network structure of the UMSPIE film denser. In addition, the mechanical and barrier properties of the as-synthesized films were explored. Compared with pure soy protein film, the tensile strength of the UMSPIE film has an increase of 266.82% (increasing from 4.4 to 16.14 MPa). From the above, the modified strategy of layered silicates filling combining crosslinking agents is considered as an effective method to improve the functional properties of bio-based polymer composites.


Sign in / Sign up

Export Citation Format

Share Document