scholarly journals EFFECT OF PARTIAL REPLACEMENT OF CEMENT WITH RICE HUSK ASH AND CELLULOSE INDUSTRIAL RESIDUE ON COMPRESSIVE STRENGTH OF CONCRETE

2019 ◽  
pp. 1-9
Keyword(s):  
Compressive Strength ◽  
Portland Cement ◽  
Rice Husk ◽  
Ordinary Portland Cement ◽  
Rice Husk Ash ◽  
Setting Time ◽  
Research Work ◽  
Partial Replacement ◽  
Control Test ◽  
Industrial Residue

In this research work, the effect of rice husk ash on concrete produced with cellulose industrial residue was studied. A mix proportion of 1:1.8:3.7 with water cement ratio of 0.47 were used. The percentage replacement of Ordinary Portland Cement (OPC) with cellulose industrial residue and rice husk ash used were 0%, 5%, 10%, 20% 30% and 40%. Concrete cubes of 150mm x 150mm x 150mm of Ordinary Portland Cement/Cellulose Industrial Residue and Ordinary Portland Cement/Cellulose Industrial Residue/Rice Ash were cast and cured at 3,7,28,60 and 90 days respectively. At the end of each hydration period, the concrete cubes were crushed and their compressive strength were determined. The result of compressive strength of 5-40% replacement of cement with cellulose industrial residue ranges from 13.02-32.81 N/mm2 as against 25.60-42.08N/mm2 for the control test. The result of the compressive strength of 5-40% replacement of cement with Cellulose Industrial Residue and Rice Husk Ash ranges from 13.17-36.30N/mm2 as against 25.60-42.08N/mm2 for the control test. The result of the initial and final setting time of Ordinary Portland Cement/Cellulose Industrial Residue and Cement/Cellulose Industrial Residue/Rice Husk Ash for 5-40% replacement of cement ranges from 61-118mins, 58-110mins and 620 – 836mins, 598 – 799mins respectively as against 52mins and 590mins for the control test. The main conclusion of this study is that the incorporation rice husk ash into cellulose industrial residue increase the strength of concrete produced. The objective of this study is to assess the strength of concrete produced when two pozzolanic materials were used to replace cement in producing concrete.

Experimental study on concrete with rice husk ash under sulphuric ACID solutions

2018 ◽  
Vol 7 (4.5) ◽  
pp. 522
Author(s):  
R. Ramya Swetha ◽  
Dr. G.Venkata Ramana ◽  
K. Anusha Hadassa
Keyword(s):  
Experimental Study ◽  
Compressive Strength ◽  
Portland Cement ◽  
Sulphuric Acid ◽  
Rice Husk ◽  
Industrial Waste ◽  
Ordinary Portland Cement ◽  
Rice Husk Ash ◽  
Acid Solutions ◽  
Iron And Calcium

This investigation shows the results on aggressive sulphuric acid on the concrete combined with rice husk ash (RH) when partially replaced for ordinary Portland cement. The husk ash, which mainly contains aluminum ion, silica, iron and calcium oxides, is an industrial waste and poses disposal problems. In this study, the effect of various concentrations (1%, 3%, 5%) of sulphuric acid (H2SO4) on Concrete replaced with various percentages (0%,5%,10%,15% and 20% by weight of cement) of RH is evaluated in-terms of residual compressive strength. The loss of compressive strengths of concrete immersed in various H2SO4 solutions for 7 days 28 days and 60 days indicates that at upto 10% replacement increase in strength was observed after which strengths were decreasing. This increase in strength is attributed to pozzolanic activity of RH.  

scholarly journals Effect of Rice Husk Ash (RHA) and Slag as Partial Replacement of Cement on Reinforced Concrete Slabs

2021 ◽  
pp. 34-40
Author(s):  
Mohamed Nabil ◽  
Ashraf Essa ◽  
Magdy Mahmoud ◽  
Mohamed Rabah
Keyword(s):  
Compressive Strength ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Setting Time ◽  
Partial Replacement ◽  
Reinforced Concrete Slabs ◽  
Time Flow ◽  
Increasing Demand ◽  
Relationship Of ◽  
Compressive Tests

The increasing demand and consumption of cement have necessitated the use of slag, fly ash, rice husk ash (RHA), and so forth as a supplement of cement in concrete construction. The aim of the study is to develop a replacement of the cement with rice husk ash and slag combined with chemical activator. NaOH, Ca(OH)2, and KOH were used in varying weights and molar concentrations. Partial replacement of cement was tested for its consistency, setting time, flow, compressive strength, and fire. The consistency and setting time of the Partial Z-Cement (Zero cement) paste increase with increasing RHA content. The replacement of cement mortar achieves a compressive strength of 22–25MPa at  28 days with 5% NaOH or at 2.5or non used activator molar concentrations. The tested slabs were made of concrete and reinforced with bars with 10 mm diameter having and compressive strength evaluated from the compressive tests. The analysis of the slab deflection behavior has been presented after fire of samples. The results show the different character of the load-deflection relationship of a replacement of the cement with rice husk ash and slag reinforced slabs compared to traditionally reinforced slabs.  

scholarly journals Incorporation of Rice Husk Ash as Partial Replacement of Cement in M40 Grade Concrete

2021 ◽  
Vol 9 (9) ◽  
pp. 1444-1447
Author(s):  
Musaib Bashir Dar
Keyword(s):  
Compressive Strength ◽  
Construction Industry ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Cement Mortar ◽  
Cement Content ◽  
Research Work ◽  
Industrial Wastes ◽  
Partial Replacement ◽  
Alternative Materials

Abstract: In this developing era concrete and cement mortar are widely used by the construction industry, with this development. Large number of industrial wastes are generated and if these wastes are not properly used it will create severe problems, keeping the environment in mind, concrete engineers are trying to find some alternative materials which will not only replaces the cement content but also improves strength of concrete. As we also know that during the manufacturing of cement large amount of Co2 is released into the environment, but if we use such material that will replace the quantity of cement content therefore indirectly, we are contributing towards the prevention of our planet from global warming and other pollutions. Also, in this research work the Rice Husk Ash is used. the rice husk ash obtained from the rice processing units, by adding this product with concrete, not only replaces the cement content but also increases the strength of concrete like compressive strength etc. The Rice husk ash was incorporated with concrete with varying percentages of 2.5% ,5% ,7.5%, & 10%. the proper codal precautions were followed during the manufacture of concrete cubes of 150x150x150mm. it was concluded that the strength of concrete increased by incorporated the rice husk ash. Keywords: Concrete, RHA, Compressive strength, Industrial wastes, Cement etc

scholarly journals Utilization of Sugarcane Bagasse Ash from Power Co-generation Boilers as a Supplementary Cementitious Material

2021 ◽  
Vol 2 (2) ◽  
Author(s):  
Safiki Ainomugisha ◽  
Bisaso Edwin ◽  
Bazairwe Annet
Keyword(s):  
Compressive Strength ◽  
Portland Cement ◽  
Sugarcane Bagasse ◽  
Low Income ◽  
Ordinary Portland Cement ◽  
Construction Material ◽  
Sustainable Construction ◽  
Partial Replacement ◽  
Hardened Concrete ◽  
Sugarcane Bagasse Ash

Concrete has been the world’s most consumed construction material, with over 10 billion tons of concrete annually. This is mainly due to its excellent mechanical and durability properties plus high mouldability. However, one of its major constituents; Ordinary Portland Cement is reported to be expensive and unaffordable by most low-income earners. Its production contributes about 5%–8% of global CO2 greenhouse emissions. This is most likely to increase exponentially with the demand of Ordinary Portland Cement estimated to rise by 200%, reaching 6000 million tons/year by 2050.  Therefore, different countries are aiming at finding alternative sustainable construction materials that are more affordable and offer greener options reducing reliance on non-renewable sources. Therefore, this study aimed at assessing the possibility of utilizing sugarcane bagasse ash from co-generation in sugar factories as supplementary material in concrete. Physical and chemical properties of this sugarcane bagasse ash were obtained plus physical and mechanical properties of fresh and hardened concrete made with partial replacement of Ordinary Portland Cement. Cost-benefit analysis of concrete was also assessed. The study was carried using 63 concrete cubes of size 150cm3 with water absorption studied as per BS 1881-122; slump test to BS 1881-102; and compressive strength and density of concrete according to BS 1881-116. The cement binder was replaced with sugarcane bagasse ash 0%, 5%, 10%, 15%, 20%, 25% and 30% by proportion of weight. Results showed the bulk density of sugarcane bagasse ash at 474.33kg/m3, the specific gravity of 1.81, and 65% of bagasse ash has a particle size of less than 0.28mm. Chemically, sugarcane bagasse ash contained SiO2, Fe2O3, and Al2O3 at 63.59%, 3.39%, and 5.66% respectively. A 10% replacement of cement gave optimum compressive strength of 26.17MPa. This 10% replacement demonstrated a cost saving of 5.65% compared with conventional concrete. 

scholarly journals Development of a Zero-Cement Binder Using Slag, Fly Ash, and Rice Husk Ash with Chemical Activator

2015 ◽  
Vol 2015 ◽  
pp. 1-14 ◽  
Author(s):  
M. R. Karim ◽  
M. F. M. Zain ◽  
M. Jamil ◽  
F. C. Lai
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Setting Time ◽  
Time Flow ◽  
Alumina Gel ◽  
Cement Binder ◽  
Increasing Demand ◽  
Chemical Activator

The increasing demand and consumption of cement have necessitated the use of slag, fly ash, rice husk ash (RHA), and so forth as a supplement of cement in concrete construction. The aim of the study is to develop a zero-cement binder (Z-Cem) using slag, fly ash, and RHA combined with chemical activator. NaOH, Ca(OH)2, and KOH were used in varying weights and molar concentrations. Z-Cem was tested for its consistency, setting time, flow, compressive strength, XRD, SEM, and FTIR. The consistency and setting time of the Z-Cem paste increase with increasing RHA content. The Z-Cem mortar requires more superplasticizer to maintain a constant flow of110±5% compared with OPC. The compressive strength of the Z-Cem mortar is significantly influenced by the amounts, types, and molar concentration of the activators. The Z-Cem mortar achieves a compressive strength of 42–44 MPa at 28 days with 5% NaOH or at 2.5 molar concentrations. The FTIR results reveal that molecules in the Z-Cem mortar have a silica-hydrate (Si-H) bond with sodium or other inorganic metals (i.e., sodium/calcium-silica-hydrate-alumina gel). Therefore, Z-Cem could be developed using the aforementioned materials with the chemical activator.

Quaternary blended cement mortars containing wood ash, glass and slag powders

2021 ◽  
Author(s):  
Eethar Thanon Dawood ◽  
Marwa Saadi Mhmood
Keyword(s):  
Compressive Strength ◽  
Portland Cement ◽  
Ordinary Portland Cement ◽  
Glass Powder ◽  
Steel Slag ◽  
Wood Ash ◽  
Supplementary Cementitious Materials ◽  
Partial Replacement ◽  
Slag Powder ◽  
Steel Slag Powder

AbstractA quaternary supplementary cementitious materials as partial replacement of ordinary Portland cement decreases CO2 emission. This paper has investigated the properties of mortars made from different quaternary blends of wood ash, steel slag powder and glass powder with ordinary Portland cement at different replacement levels of 0, 24, 25, and 30% by weight of the binder. The blended mortar mixtures tested for flow, compressive strength and density. The results showed that the flow of mortars is decreased with the combined use of steel slag powder, glass powder, and wood ash compared with control mix. Compressive strength reduced with the combination of steel slag powder, glass powder and wood ash but this reduction effects is acceptable especially at 24% replacement contain super-plasticizer compared with the ecological benefit.

Sign in / Sign up

Export Citation Format

Share Document