Joint Resource Allocation and Interference Mitigation Techniques for Cooperative Wireless Networks

2012 ◽  
pp. 185-213
Author(s):  
Rodrigo C. de Lamare ◽  
Patrick Clarke
Keyword(s):  
Interference Mitigation ◽  
Interference Suppression ◽  
Amplify And Forward ◽  
Decode And Forward ◽  
Cross Layer Optimization ◽  
Mimo Networks ◽  
Cooperative Wireless Networks ◽  
Joint Resource Allocation ◽  
And Performance ◽  
Allocation Algorithms

This chapter presents joint interference suppression and power allocation algorithms for DS-CDMA and MIMO networks with multiple hops and amplify-and-forward and Decode-and-Forward (DF) protocols. A scheme for joint allocation of power levels across the relays and linear interference suppression is proposed. The authors also consider another strategy for joint interference suppression and relay selection that maximizes the diversity available in the system. Simulations show that the proposed cross-layer optimization algorithms obtain significant gains in capacity and performance over existing schemes.

scholarly journals Two-Way Relaying Cooperative Wireless Networks: Resource Allocation and Performance Analysis

2013 ◽  
Vol 59 (3) ◽  
pp. 229-235
Author(s):  
Muhammad Abrar ◽  
Xiang Gui ◽  
Amal Punchihewa
Keyword(s):  
Resource Allocation ◽  
Wireless Networks ◽  
Cost Effective ◽  
Proportional Fairness ◽  
Matlab Simulation ◽  
Cooperative Wireless Networks ◽  
And Performance ◽  
The Cost ◽  
Time Division ◽  
Allocation Algorithms

Abstract Relay-based cooperative wireless networks have been widely considered one of the cost-effective solutions to meet the demands in future wireless networks. In order to maximize the overall sum-rate while maintaining proportional fairness among users, we investigate different resource allocation algorithms in two-way relay networks with analog network coding (ANC) protocol and time division broadcast (TDBC) protocol. The algorithms investigated are different from traditional proportional fairness schemes in terms of fairness and computational complexity as we have applied Access Proportional Fairness (APF) and Minimum Rate Proportional Fairness (MRPF) along with load balancing at the relays. A MATLAB simulation has been performed and simulation results show the effectiveness of these algorithms.

Joint resource allocation and power control for radar interference mitigation in multi-UAV networks

2021 ◽  
Vol 64 (8) ◽  
Author(s):  
Xinyi Wang ◽  
Zesong Fei ◽  
Jingxuan Huang ◽  
J. Andrew Zhang ◽  
Jinhong Yuan
Keyword(s):  
Resource Allocation ◽  
Power Control ◽  
Interference Mitigation ◽  
Joint Resource Allocation ◽  
Multi Uav

On Performance of Combining Methods for Three-Node Relay Network

2012 ◽  
Vol 263-266 ◽  
pp. 1160-1164
Author(s):  
Wen Yuan Rao
Keyword(s):  
Relay Network ◽  
Estimation Accuracy ◽  
Diversity Order ◽  
Amplify And Forward ◽  
Decode And Forward ◽  
Channel Quality ◽  
Combining Methods ◽  
Better Than

We study the performance of the three-node relay network. Three combining methods for the Amplify-and-Forward (AF) protocol and the Decode-and-Forward (DF) protocol are compared. Simulations indicate that the AF protocol is better than DF under all these three combining methods. To combine the incoming signals the channel quality should be estimated as accuracy as possible, more estimation accuracy requires more resource. A very simple combining method can obtain the performance comparative with optimal combining methods approximately. At the same time, all three combining methods for both diversity protocols can achieve the maximum diversity order.

scholarly journals Evaluation of PLC Channel Capacity and ABER Performances for OFDM-Based Two-Hop Relaying Transmission

2017 ◽  
Vol 2017 ◽  
pp. 1-12 ◽  
Author(s):  
Sana Ezzine ◽  
Fatma Abdelkefi ◽  
Jean Pierre Cances ◽  
Vahid Meghdadi ◽  
Ammar Bouallégue
Keyword(s):  
Channel Capacity ◽  
Orthogonal Frequency Division Multiplexing ◽  
Low Cost ◽  
Relay Node ◽  
Destination Node ◽  
Direct Link ◽  
Amplify And Forward ◽  
Decode And Forward ◽  
Maximum Ratio Combining ◽  
The Impact

Powerline network is recognized as a favorable infrastructure for Smart Grid to transmit information in the network thanks to its broad coverage and low cost deployment. The existing works are trying to improve and adapt transmission techniques to reduce Powerline Communication (PLC) channel attenuation and exploit the limited bandwidth to support high data rate over long distances. Two-hop relaying BroadBand PLC (BB-PLC) system, in which Orthogonal Frequency Division Multiplexing (OFDM) is used, is considered in this paper. We derive and compare the PLC channel capacity and the end-to-end Average BER (ABER) for OFDM-based direct link (DL) BB-PLC system and for OFDM-based two-hop relaying BB-PLC system for Amplify and Forward (AF) and Decode and Forward (DF) protocols. We analyze the improvements when we consider the direct link in a cooperative communication when the relay node only transmits the correctly decoded signal. Maximum ratio combining is employed at the destination node to detect the transmitted signal. In addition, in this paper, we highlight the impact of the relay location on the channel capacity and ABER for AF and DF transmission protocols. Moreover, an efficient use of the direct link was also investigated in this paper.

scholarly journals A Coordinated Direct AF/DF Relay-Aided NOMA Framework for Low Outage

2021 ◽  
Author(s):  
Anand Jee ◽  
KAMAL AGRAWAL ◽  
Shankar Prakriya
Keyword(s):  
Energy Efficiency ◽  
Monte Carlo ◽  
Monte Carlo Simulations ◽  
Outage Probability ◽  
Closed Form ◽  
Power Allocation ◽  
Multiple Access ◽  
Performance Gain ◽  
Amplify And Forward ◽  
Decode And Forward

This paper investigates the performance of a framework for low-outage downlink non-orthogonal multiple access (NOMA) signalling using a coordinated direct and relay transmission (CDRT) scheme with direct links to both the near-user (NU) and the far-user (FU). Both amplify-and-forward (AF) and decode-and-forward (DF) relaying are considered. In this framework, NU and FU combine the signals from BS and R to attain good outage performance and harness a diversity of two without any need for feedback. For the NU, this serves as an incentive to participate in NOMA signalling. For both NU and FU, expressions for outage probability and throughput are derived in closed form. High-SNR approximations to the outage probability are also presented. We demonstrate that the choice of power allocation coefficient and target rate is crucial to maximize the NU performance while ensuring a desired FU performance. We demonstrate performance gain of the proposed scheme over selective decode-and-forward (SDF) CDRT-NOMA in terms of three metrics: outage probability, sum throughput and energy efficiency. Further, we demonstrate that by choosing the target rate intelligently, the proposed CDRT NOMA scheme ensures higher energy efficiency (EE) in comparison to its orthogonal multiple access counterpart. Monte Carlo simulations validate the derived expressions.

scholarly journals Performance Enhancement for Multihop Cognitive DF and AF Relaying Protocols under Joint Impact of Interference and Hardware Noises: NOMA for Primary Network and Best-Path Selection for Secondary Network

2021 ◽  
Vol 2021 ◽  
pp. 1-15
Author(s):  
Tran Trung Duy ◽  
Pham Thi Dan Ngoc ◽  
Phuong T. Tran
Keyword(s):  
Spectrum Sharing ◽  
Performance Enhancement ◽  
Path Selection ◽  
Secondary Source ◽  
Amplify And Forward ◽  
Decode And Forward ◽  
Transmit Power ◽  
Primary Network ◽  
Secondary Network ◽  
Relaying Protocols

In this paper, we propose and evaluate performance of multihop multipath underlay cognitive radio networks. In a primary network, an uplink nonorthogonal multiple access method is employed to allow primary transmitters to simultaneously transmit their data to a primary receiver. Using an underlay spectrum-sharing method, secondary source and secondary relays must adjust their transmit power to guarantee quality of service of the primary network. Under the limited transmit power, cochannel interference from the primary transmitters, and hardware noises caused by impairments, we propose best-path selection methods to improve the end-to-end performance for the secondary network. Moreover, both multihop decode-and-forward and amplify-and-forward relaying protocols are considered in this paper. We derive expressions of outage probability for the primary and secondary networks and propose an efficient method to calculate the transmit power of the secondary transmitters. Then, computer simulations employing the Monte-Carlo approach are realized to validate the derivations.

Sign in / Sign up

Export Citation Format

Share Document