Research on the Dissolving Character of Active Si/Al in Fly Ash Activated by Alkali

2010 ◽  
Vol 150-151 ◽  
pp. 1790-1795
Author(s):  
Hui Li ◽  
Shi Shi ◽  
De Long Xu ◽  
Li Jun Zhuge ◽  
Le Le Zhang

This paper investigated the influence of activator concentration, reaction time and fineness of fly ash on the dissolving character of the active Si/Al in fly ash activated by alkali. The results indicated that with the increase of the NaOH solution concentration, the dissolving percentage of active Si/Al in the fly ash went up. The finer the fly ash particles were, the higher dissolving percentage of active Si/Al was obtained. Under strong basic (2M NaOH solution) and boiling condition, the reaction time of active Si/Al dissolving was short and less than 10 minutes. The content of vitreous phase contributed to the content of active components. Active Si existed in the state of Q0 unit which presented an isolated silicon-oxide tetrahedron in fly ash, and active Al exhibited as Al[OSi]3 and Al[OSi]4 units in 4 coordinate. As the fly ash was activated by alkali, smooth shell of fly ash was gradually corroded by NaOH solution, glass phase was dissolved and crystal phase was exposed to the outside.

1999 ◽  
Vol 14 (11) ◽  
pp. 4437-4442 ◽  
Author(s):  
Zhidong Yao ◽  
Chikashi Tamura ◽  
Motohide Matsuda ◽  
Michihiro Miyake

Tobermorite was synthesized successfully from waste incineration fly ash by hydrothermal treatment in the presence of sodium hydroxide solution. The tobermorite synthesis was examined as a function of reaction temperature, time, and NaOH concentration. The formation of tobermorite was identified in all of the fly ash treated with NaOH at 180 °C, followed by the minor generations of sodalite and cancrinite phases with increasing NaOH concentration and extending reaction time. The NaOH-treated fly ash revealed the uptake behaviors for Cs+ and NH4+, whereas the fly ash untreated with NaOH solution did not show that. The uptake amounts of resulting products were also determined: 0.40 mmol/g for Cs+ and 0.35 mmol/g for NH4+ in the fly ash treated with 2.0 M NaOH at 180 °C for 20 h.


2017 ◽  
Author(s):  
W. M. W. Ibrahim ◽  
K. Hussin ◽  
M. M. A. Abdullah ◽  
A. A. Kadir ◽  
L. M. Deraman

2012 ◽  
Vol 538-541 ◽  
pp. 2322-2328 ◽  
Author(s):  
Jing Zhong Kuang ◽  
Xiang Chuan Zhao ◽  
Fang Shi ◽  
Hai Ying Cao

Gepolymeric material is a new building material, which not only has the characteristics of organic polymer, ceramic and cement but also unique properties. The effects of four factors on the strength of fly ash and metakaolin based geopolymer were discussed with the orthogonal tests in this study, including fly ash content, NaOH solution concentration, solid-liquid ratio and the content of sodium silicate in the liquid phase. The results show that: content of fly ash 30%, NaOH solution concentration 12mol/L, solid-to-liquid ratio 4.5 and the content of sodium silicate in the liquid phase 65% is the best condition preparation of fly ash and metakaolin based geopolymer.


2018 ◽  
Vol 147 ◽  
pp. 01004 ◽  
Author(s):  
Herwani ◽  
Ivindra Pane ◽  
Iswandi Imran ◽  
Bambang Budiono

Geopolymer concrete is a new material made by activating the raw materials which contain many elements of silica and alumina. Compressive strength of geopolymer concrete produced was influenced by the concentration of the activator solution. This paper presents an experimental investigation into fly ash-based geopolymer concrete. Research objective was to investigate the effects of alkaline activator solution (AAS) molarity on compressive strength of geopolymer concrete. Variable of the test were a solution to sodium hydroxide was chosen as the activator solution. Concentration of sodium hydroxide solution used was 10 M, 12 M and 14 M with ambient curing. The specimen is made of concrete cylinder with diameter 10 cm and height 20 cm as many as 9 pieces each variable. Compressive strength tests is performed when the concrete is 7, 14, and 28 days old. Results of the test are indicated that the increasing of sodium hydroxide (NaOH) solution concentration leads to improve the compressive strength of geopolymer concrete. The optimal compressive strength of geopolymer concrete was achieved at a concentration of sodium hydroxide solution (NaOH) of 12 M. Geopolymer concretes compressive strength only achieves around 50-60% of the planned.


2021 ◽  
Vol 10 (1) ◽  
pp. 157-168
Author(s):  
Biwei Luo ◽  
Pengfei Li ◽  
Yan Li ◽  
Jun Ji ◽  
Dongsheng He ◽  
...  

Abstract The feasibility of industrial waste fly ash as an alternative fluxing agent for silica in carbothermal reduction of medium-low-grade phosphate ore was studied in this paper. With a series of single-factor experiments, the reduction rate of phosphate rock under different reaction temperature, reaction time, particle size, carbon excess coefficient, and silicon–calcium molar ratio was investigated with silica and fly ash as fluxing agents. Higher reduction rates were obtained with fly ash fluxing instead of silica. The optimal conditions were derived as: reaction temperature 1,300°C, reaction time 75 min, particle size 48–75 µm, carbon excess coefficient 1.2, and silicon–calcium molar ratio 1.2. The optimized process condition was verified with other two different phosphate rocks and it was proved universally. The apparent kinetics analyses demonstrated that the activation energy of fly ash fluxing is reduced by 31.57 kJ/mol as compared with that of silica. The mechanism of better fluxing effect by fly ash may be ascribed to the fact that the products formed within fly ash increase the amount of liquid phase in the reaction system and promote reduction reaction. Preliminary feasibility about the recycling of industrial waste fly ash in thermal phosphoric acid industry was elucidated in the paper.


2009 ◽  
Vol 22 (12) ◽  
pp. 1073-1078 ◽  
Author(s):  
Ubolluk Rattanasak ◽  
Prinya Chindaprasirt
Keyword(s):  
Fly Ash ◽  

2012 ◽  
Vol 608-609 ◽  
pp. 1337-1341
Author(s):  
Hong Liang Chen ◽  
Ji Song Yang ◽  
Yan Wang ◽  
Hui Ying Li ◽  
Xin Xin Li ◽  
...  

Silicalite-1 membranes were successfully synthesized on α-Al2O3 tubes by in-situ hydrothermal synthesis after filling the tubes with water and glycerol mixtures, and all the membranes show high concentration performance towards ethanol/water mixtures after pretreating tubes with different NaOH solution. The results show that the flux enhances with the enhancement of NaOH solution concentration, but the separation selectivity decreases with the enhancement of NaOH solution concentration. After pretreating the α-Al2O3 tubes with different NaOH solution, the weight of all the α-Al2O3 tube decreases, but the Si/Al ratio increases, which shows that suitable pretreatment of α-Al2O3 is useful for improving the hydrophobicity of silicalite-1 membranes.


Materials ◽  
2021 ◽  
Vol 14 (23) ◽  
pp. 7109
Author(s):  
Wei Yang ◽  
Pinghua Zhu ◽  
Hui Liu ◽  
Xinjie Wang ◽  
Wei Ge ◽  
...  

Geopolymer binder is expected to be an optimum alternative to Portland cement due to its excellent engineering properties of high strength, acid corrosion resistance, low permeability, good chemical resistance, and excellent fire resistance. To study the sulfuric acid corrosion resistance of geopolymer concrete (GPC) with different binding materials and concentrations of sodium hydroxide solution (NaOH), metakaolin, high-calcium fly ash, and low-calcium fly ash were chosen as binding materials of GPC for the geopolymerization process. A mixture of sodium silicate solution (Na2SiO3) and NaOH solution with different concentrations (8 M and 12 M) was selected as the alkaline activator with a ratio (Na2SiO3/NaOH) of 1.5. GPC specimens were immersed in the sulfuric acid solution with the pH value of 1 for 6 days and then naturally dried for 1 day until 98 days. The macroscopic properties of GPC were characterized by visual appearance, compressive strength, mass loss, and neutralization depth. The materials were characterized by SEM, XRD, and FTIR. The results indicated that at the immersion time of 28 d, the compressive strength of two types of fly ash-based GPC increased to some extent due to the presence of gypsum, but this phenomenon was not observed in metakaolin-based GPC. After 98 d of immersion, the residual strength of fly ash based GPC was still higher, which reached more than 25 MPa, while the metakaolin-based GPC failed. Furthermore, due to the rigid 3D networks of aluminosilicate in fly ash-based GPC, the mass of all GPC decreased slightly during the immersion period, and then tended to be stable in the later period. On the contrary, in metakaolin-based GPC, the incomplete geopolymerization led to the compressive strength being too low to meet the application of practical engineering. In addition, the compressive strength of GPC activated by 12 M NaOH was higher than the GPC activated by 8 M NaOH, which is owing to the formation of gel depended on the concentration of alkali OH ion, low NaOH concentration weakened chemical reaction, and reduced compressive strength. Additionally, according to the testing results of neutralization depth, the neutralization depth of high-calcium fly ash-based GPC activated by 12 M NaOH suffered acid attack for 98 d was only 6.9 mm, which is the minimum value. Therefore, the best performance was observed in GPC prepared with high-calcium fly ash and 12 M NaOH solution, which is attributed to gypsum crystals that block the pores of the specimen and improve the microstructure of GPC, inhibiting further corrosion of sulfuric acid.


2021 ◽  
Vol 8 (1) ◽  
pp. 20218111
Author(s):  
V. A. Snegirev ◽  
V. M. Yurk

The study examines the technology of processing fly ash from Troitskaya power plant for the production of zeolite. The paper presents the results of laboratory studies evaluating the suitability of fly ash from Troitskaya power plant for the production of zeolites and the development of the zeolite production process. Fly ash contains a small amount of heavy metals that can complicate processing, but contains a large amount of silicon oxide. The technology consists of high-temperature alkaline activation of fly ash and hydrochemical synthesis. The resulting powder has a specific surface area of 89.7 m2/g, determined by the BET method, and an average pore diameter of 0.345 μm. The static exchange capacity was 220 mg/g.


2018 ◽  
Vol 266 ◽  
pp. 102-108 ◽  
Author(s):  
Piotr Kunecki ◽  
Rafał Panek ◽  
Anna Koteja ◽  
Wojciech Franus

Sign in / Sign up

Export Citation Format

Share Document