Preparation of Nano-Particles of Metal Oxides via a Novel Solid-Liquid Mechanochemical Reaction Technology

2007 ◽  
Vol 26-28 ◽  
pp. 671-674 ◽  
Author(s):  
Ding Chen ◽  
Song Ni ◽  
Geng Li Chen ◽  
Zhen Hua Chen

Nano-particles of metal oxides Mn3O4, Cu2O, Fe3O4, the mixture of Zn(OH)2 and ZnO have been successfully prepared via a novel solid-liquid mechanochemical reaction technology. The metal powders are ground in water solutions using planetary ball mill. The solid-liquid reactions can occur on the surface of the powders and the reacted layer can be continuously peeled off during milling. The mean sizes of the as-prepared particles are approximately 20~100nm.The formation of nano-particles is attributed to the reactions between particles and solution as well as the repeated and quick peeling of the formed oxides on the surface of metal particles. Furthermore, the reaction rate and phase types of the products can be controlled by adjusting the pH value of the solution.

2005 ◽  
Vol 486-487 ◽  
pp. 530-533 ◽  
Author(s):  
Yamato Hayashi ◽  
Hirotsugu Takizawa ◽  
Yoshitaka Saijo ◽  
Tohru Sekino ◽  
Katsuaki Suganuma ◽  
...  

Applications of silver nano-sized metal particles were investigated for a new, ecologically friendly and economical liquid-solid (silver oxide-alcohol) system. Silver metal oxides as starting materials have merits in metal particles fabrication because these materials are decomposed only by heating in air. That is, noble metal oxide does not use thestrong reduction atmosphere. This reduction is ecologically clean because many noble metal oxides are not toxic, and because O2 is evolved during decomposition. We reduced silver metal oxides by ultrasound and fabricated silver nano metal nanoparticles at room temperature, and various applications were investigated. By choosing a suitable process and conditions, it is reasonable to expect that ultrasonic eco-fabrications can be extended to obtain various silver nano-particles containing materials.


2012 ◽  
Vol 445 ◽  
pp. 833-838
Author(s):  
J. Sargheini ◽  
Abolghasem Ataie ◽  
S.M. Salili ◽  
M. Johari ◽  
M. Hadad

This research was aimed to synthesize calcium carbonate nanoparticles from CaCl2, NaCl and Na2CO3 precursors by mechano-chemical route without any subsequent heat treatment of the as-milled powder. Effects of intensive milling duration and amount of NaCl as a diluting agent on the powder particle characteristics have been investigated. XRD results showed that CaCO3 nanoparticles were obtained after 30 minutes of continuous milling in the planetary ball mill regardless of the amount of NaCl. Further milling up to 10 hour resulted in peak broadening indicating the crystallite refinement. For the 10-hour milled sample in the presence of 3.5 mole% NaCl, the mean crystallite and particle sizes were 12 and 56 nm, respectively. Those values decreased slightly when the amount of NaCl increased from 3.5 to 10.3 mole%.


2014 ◽  
Vol 925 ◽  
pp. 359-363
Author(s):  
Ibraheem J. Ibraheem ◽  
Tareg A. Mandeel ◽  
A.D. Faisal ◽  
Y. Al-Douri

Two different vacuum thermal degradation processes of plastic wastes materials: Poly Propylene (PP) and Low Density Poly Ethylene (LDPE) were conducted with homemade thermal degradation setup. The two processes were used 1-bulk metal particles,2-metal oxides (Fe,Ni,Fe2O3,NiO) and 3-metal nanoparticles (Fe and Ni) as a catalysts supported on feldspar clay respectively. The experimental results for both processes shows the presence of different products like liquid, wax, gas, and carbon. Our characterization was focused on the liquid product. The produced liquid was characterized by Fourier transform infra-red (FTIR) and Gas chromatography (GC) The octane number, cetane number, flash point, fire point, aniline point and some physical properties were also measured. The results indicated that the process with metal nanoparticles catalyst produces liquid much better properties compared to the other materials results used metal particles catalyst.


Author(s):  
J. Liu ◽  
M. Pan ◽  
G. E. Spinnler

Small metal particles have peculiar chemical and physical properties as compared to bulk materials. They are especially important in catalysis since metal particles are common constituents of supported catalysts. The structural characterization of small particles is of primary importance for the understanding of structure-catalytic activity relationships. The shape and size of metal particles larger than approximately 5 nm in diameter can be determined by several imaging techniques. It is difficult, however, to deduce the shape of smaller metal particles. Coherent electron nanodiffraction (CEND) patterns from nano particles contain information about the particle size, shape, structure and defects etc. As part of an on-going program of STEM characterization of supported catalysts we report some preliminary results of CEND study of Ag nano particles, deposited in situ in a UHV STEM instrument, and compare the experimental results with full dynamical simulations in order to extract information about the shape of Ag nano particles.


2009 ◽  
Vol 9 (5) ◽  
pp. 1579-1595 ◽  
Author(s):  
C. Galy-Lacaux ◽  
D. Laouali ◽  
L. Descroix ◽  
N. Gobron ◽  
C. Liousse

Abstract. Long-term precipitation chemistry have been recorded in the rural area of Banizoumbou (Niger), representative of a semi-arid savanna ecosystem. A total of 305 rainfall samples ~90% of the total annual rainfall) were collected from June 1994 to September 2005. From ionic chromatography, pH major inorganic and organic ions were detected. Rainwater chemistry is controlled by soil/dust emissions associated with terrigeneous elements represented by SO42−, Ca2+, Carbonates, K+ and Mg2+. It is found that calcium and carbonates represent ~40% of the total ionic charge. The second highest contribution is nitrogenous, with annual Volume Weighed Mean (VWM) for NO3− and NH4+ concentrations of 11.6 and 18.1 μeq.l−1, respectively. This is the signature of ammonia sources from animals and NOx emissions from savannas soil-particles rain-induced. The mean annual NH3 and NO2 air concentration are of 6 ppbv and 2.6 ppbv, respectively. The annual VWM precipitation concentration of sodium and chloride are both of 8.7 μeq.l−1 which reflects the marine signature of monsoonal and humid air masses. The median pH value is of 6.05. Acidity is neutralized by mineral dust, mainly carbonates, and/or dissolved gases such NH3. High level of organic acidity with 8μeq.l−1 and 5.2 μeq.l−1 of formate and acetate were also found. The analysis of monthly Black Carbon emissions and Fraction of Absorbed Photosynthetically Active Radiation (FAPAR) values show that both biogenic emission from vegetation and biomass burning could explain the rainfall organic acidity content. The interannual variability of the VWM concentrations around the mean (1994–2005) is between ±5% and ±30% and mainly due to variations of sources strength and rainfall spatio-temporal distribution. From 1994 to 2005, the total mean wet deposition flux in the Sahelian region is of 60.1 mmol.m−2.yr−1 ±25%. Finally, Banizoumbou measurements are compared to other long-term measurements of precipitation chemistry in the wet savanna of Lamto (Côte d'Ivoire) and in the forested zone of Zoétélé (Cameroon). The total chemical loading presents a maximum in the dry savanna and a minimum in the forest (from 143.7, 100.2 to 86.6 μeq.l−1), associated with the gradient of terrigeneous sources. The wet deposition fluxes present an opposite trend, with 60.0 mmol.m−2.yr−1 in Banizoumbou, 108.6 mmol.m−2.yr−1 in Lamto and 162.9 mmol.m−2.yr−1 in Zoétélé, controlled by rainfall gradient along the ecosystems transect.


2001 ◽  
Vol 79 (12) ◽  
pp. 1864-1869 ◽  
Author(s):  
Mitsuru Matsumoto ◽  
Delanie Lamprecht ◽  
Michael R North ◽  
Thomas W Swaddle

Volumes of activation (ΔV‡el) are reported for electron transfer at a Pt electrode of Mn(CN-cyclo-C6H11)62+/+ in acetonitrile, acetone, methanol, and propylene carbonate, and of Fe(phen)33+/2+ in acetonitrile. In all cases, ΔV‡el is markedly positive, whereas for the homogeneous self-exchange reactions of these couples in the same solvents the corresponding parameter is known to be strongly negative. The rate constants for the electrode reactions correlate loosely with the mean reactant diffusion coefficients (i.e., with solvent fluidity) and the ΔV‡el values with the volumes of activation for diffusion (i.e., for viscous flow), consistent with solvent dynamical control of the electrode reaction rate in organic solvents. A detailed analysis of ΔV‡el values of the kind presented for a couple with an uncharged member (Zhou and Swaddle, Can. J. Chem. 79, 841 (2001)) fails, however, either because of ion-pairing effects with these more highly charged couples or because of breakdown of transition-state theory in predicting the contribution of the activational barrier. Attempts to measure ΔV‡el for the oxidation of the uncharged molecule ferrocene at various electrodes in acetonitrile were unsuccessful, although ΔV‡el was again seen to be clearly positive.Key words: electrode kinetics, volumes of activation, nonaqueous electron transfer, solvent dynamics.


2020 ◽  
Vol 25 (1) ◽  
pp. 52
Author(s):  
Alston Millan

Nutmeg oleoresin microcapsule is the solid, liquid, and gas coating technology of the nutmeg fruit.  The purpose of this study was to know how mace nutmeg oleoresin microcapsules could preserve the broiler chicken meat at room temperature during 4 days of observation. The experimental design used was a Completely Randomized Design (CRD) consisting of 5 treatments with mace concentration of nutmeg microcapsules oleoresin (0, 50, 100, 150, and 200) ppm. The variables observed were water content, pH value, total microbes, and organoleptic properties (color, aroma, and texture). The results showed that mace nutmeg oleoresin microcapsules did not affect (p> 0.05)  water content and sensory properties of broiler chicken meat, but had a significant effect (p <0.05) on the pH value and total microbe at the same day of room temperature storage. Panel organoleptic test results on the level of preference for meat color, aroma, and texture of chicken meat were in the range score of 3 (somewhat like) to 4 (somewhat dislike). The treatments of nutmeg oleoresin did not affect (p> 0.05) on color, the aroma, and the texture of broiler chicken meat. This research shows that marinating using oleoresin microcapsules has not been effective as a preservative to broiler chicken meat at room temperature. Keywords: chicken meat, mace nutmeg oleoresin microcapsules


Sign in / Sign up

Export Citation Format

Share Document