The Controlling Synthesis and Photocatalytic Activity of Carbon Nanotubes Loaded with CdS Composites under Simulated Sunlight

2011 ◽  
Vol 396-398 ◽  
pp. 768-771
Author(s):  
Huan Ying Li ◽  
Shu Li Bai ◽  
Yu Jiang Guan ◽  
Zi Bo Wang

The CdS/CNTs nanocomposites were prepared by a simple heating refluxing method, and the scattering of CdS on CNTs surface was controlled by a dropping way. The samples were characterized by X-ray diffraction (XRD), Transmission electron microscopy (TEM) and ultraviolet-visible diffuse reflectance spectroscope (UV-Vis) .The photocatalytic activity of the samples was tested in the degradation of Methylene blue dye wasterwater under simulated sunlight with 500w short arc xenon lamp. The results showed that the photocatalytic activity of CdS/CNTs composites was enhanced by controlling CdS scatter on CNTs surface, and the forbidden band width was appropriate lowered when CNTs was added, and the scatter of CdS on CNTs surface was uniform and the photocata-lytic activity was the highest when the mass ration of CdS with CNTs was 4:1.The CdS composites have good stability and potential industrial application.

2014 ◽  
Vol 898 ◽  
pp. 23-26
Author(s):  
Jing Li ◽  
Wei Sun ◽  
Wei Min Dai ◽  
Yong Cai Zhang

TiO2/SnS2 nanocomposite was synthesized via hydrothermal treatment of tin (IV) chloride pentahydrate, thioacetamide and TiO2 nanotubes in deionized water at 150 °C for 3 h. The structure, composition and optical property of the as-synthesized nanocomposite were characterized by X-ray diffraction, energy dispersive X-ray spectroscopy, transmission electron microscopy and UV-vis diffuse reflectance spectra, and its photocatalytic property was tested in the reduction of aqueous Cr6+ under visible-light (λ > 420 nm) irradiation. It was observed that TiO2 nanotubes exhibited no photocatalytic activity, whereas TiO2/SnS2 nanocomposite exhibited photocatalytic activity in the reduction of aqueous Cr6+ under visible-light (λ > 420 nm) irradiation.


RSC Advances ◽  
2015 ◽  
Vol 5 (54) ◽  
pp. 43473-43479 ◽  
Author(s):  
Yanli Xu ◽  
Mengmeng Lv ◽  
Hanbiao Yang ◽  
Qi Chen ◽  
Xueting Liu ◽  
...  

The BiVO4/MIL-101 composite and pure materials were characterized by X-ray diffraction, transmission electron microscopy, thermogravimetric analysis, UV-vis diffuse reflectance absorption spectra and photoluminescence emission spectra.


2018 ◽  
Vol 20 (4) ◽  
pp. 66-74
Author(s):  
Mohamadreza Massoudinejad ◽  
Ali Paseban ◽  
Ahmadreza Yazdanbakhsh ◽  
Mohammad Reza Nabid

Abstract An N,S-codoped TiO2/Montmorillonite nanocomposite, as a photocatalyst, was synthesized in the sol-gel method and used for the degradation of ciprofloxacin (Cip) in an aqueous solution. N,S-codoped TiO2/Montmorillonte was characterized by powder X-ray diffraction (XRD), UV-Vis diffuse reflectance spectroscopy (DRS), field emission scanning electron microscopy (FESEM), transmission electron microscope (TEM), and X-ray fluorescence (XRF) analyzes. A central composite design (CCD) was used to optimize the variables for the removal of Cip by the N,S-codoped TiO2/Montmorillonite. A maximum decomposition of 92% of Cip was achieved in optimum conditions. The band gap value for the nanocomposite was 2.77 eV. Moreover, with the use of nanocomposite in the four consecutive runs, the final removal efficiency was 66%. The results show that the N,S-codoped TiO2/ Montmorillonite under simulated sunlight irradiation can be applied as an effective photocatalyst for the removal of Cip from aqueous solutions.


2020 ◽  
Vol 20 (5) ◽  
pp. 3047-3052 ◽  
Author(s):  
Zhen-Zhao Pei ◽  
Pei Wang ◽  
Chao-Yang Li ◽  
Xiao-Liang Li ◽  
Yong-Wu He ◽  
...  

The g-C3N4/BiPO4 composites have been successfully synthesized via a one-pot hydrothermal process, which can be used to degrade the organic dyes (rhodamine B and methylene blue) under simulated sunlight irradiation. X-ray diffraction (XRD), scanning electron microscope (SEM), UV-Vis diffuse reflectance spectra and Fourier transform infrared (FTIR) spectroscopy have been employed to characterize the samples. The g-C3N4/BiPO4 composites exhibited higher photocatalytic activity than pure BiPO4. And the optimum photocatalyst shows the outstanding photocatalytic activity, which exhibited 99.0% and 86.6% decolorization rate of RhB and MB, respectively.


2010 ◽  
Vol 19 (5) ◽  
pp. 096369351001900
Author(s):  
Lingling Wang ◽  
Miaoling Huang ◽  
Xiaolan Xie

12-tungstophosphoric acid (H3PW12O40) and Zinc oxide (ZnO) particles were encapsulated into mordenite by salt melting procedure. The material was characterized by X-ray diffraction (XRD), Ultraviolet-visible diffuse reflectance spectra (UV-Vis-DRS), High Resolution Transmission Electron Microscopy (HRTEM), Energy Dispersive Spectrometer (EDS), and Brunauer, Emmett and Teller surface area (BET). The characterization of ZnO/H3PW12O40-supported mordenite composite (ZnO/PW12/mordenite) clearly shows that some of ZnO and H3PW12O40 particles were encapsulated within the cavities and frameworks of mordenite, which effectively increases the photocatalytic activity on degradation of methyl orange. The ZnO/PW12/mordenite composite showed 1.7-fold increase amplitude of the photodegradation rate versus that of ZnO-supported mordenite composite (ZnO/mordenite) without H3PW12O40.


2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
Chenghe Hua ◽  
Xiaoli Dong ◽  
Xiuying Wang ◽  
Mang Xue ◽  
Xiufang Zhang ◽  
...  

W-doped TiO2and W-La-codoped TiO2nanomaterials were successfully synthesized via the sol-gel method. The products were characterized by X-ray diffraction, UV-vis diffuse reflectance spectrophotometer, transmission electron microscopy, and X-ray photoelectron spectroscopy. The presence of W and La results in significant red shift of absorption edge for TiO2-based nanomaterials. The weight ratios of La and W in the composites play important roles in the absorption edge for TiO2-based nanomaterials. The photocatalytic activities of both W-doped TiO2and W-La-codoped TiO2photocatalysts for decolorization of methyl orange solution were evaluated under simulated sunlight irradiation. The results showed that both W-doped and W-La-codoped can effectively improve the photocatalytic behaviors of TiO2nanomaterials ascribed to the improved photoinduced charge carriers separation, enhanced light absorption, and large surface area. Furthermore, W-La-codoped TiO2exhibited higher photocatalytic activity than W-doped TiO2. Considering their high photocatalytic activity, the doped TiO2nanomaterials could be applied in wastewater treatment and environmental purification.


NANO ◽  
2016 ◽  
Vol 11 (10) ◽  
pp. 1650114 ◽  
Author(s):  
Dan Li ◽  
Jianwei Li ◽  
Caiqin Han ◽  
Xinsheng Zhao ◽  
Haipeng Chu ◽  
...  

Few-layered MoS2 nanostructures were successfully synthesized by a simple hydrothermal method without the addition of any catalysts or surfactants. Their morphology, structure and photocatalytic activity were characterized by X-ray diffraction, scanning electron microscopy, energy dispersive X-ray spectroscopy, transmission electron microscopy, electrochemical impedance spectra and UV-Vis absorption spectroscopy, respectively. These results show that the MoS2 nanostructures synthesized at 180[Formula: see text]C exhibit an optimal visible light photocatalytic activity (99%) in the degradation of Rhodamine B owing to the relatively easier adsorption of pollutants, higher visible light absorption and lower electron–hole pair recombination.


2014 ◽  
Vol 809-810 ◽  
pp. 890-894
Author(s):  
Dan Li ◽  
Lian Wei Shan ◽  
Gui Lin Wang ◽  
Li Min Dong ◽  
Wei Li ◽  
...  

Boron-BiVO4 samples were synthesized by sol-gel method. They were characterized by UV-vis diffuse reflectance spectroscopy, X-ray diffraction. Photocatalytic activity of the obtained BiVO4 samples was investigated through degrading methylene blue (MB). The results reveal that boron-BiVO4 catalysts have monoclinic scheelite structure. The BiVO4 and Co-BiVO4 photocatalysts were responsive to visible light. Co-BiVO4 photocatalyst showed higher photocatalytic activity than pure BiVO4, resulting in the significantly improved efficiency of degradation of MB.


2012 ◽  
Vol 2012 ◽  
pp. 1-12 ◽  
Author(s):  
Jiang Zhang ◽  
Zheng-Hong Huang ◽  
Yong Xu ◽  
Feiyu Kang

The iodine-doped Bi2WO6(I-BWO) photocatalyst was prepared via a hydrothermal method using potassium iodide as the source of iodine. The samples were characterized by X-ray diffraction (XRD), scanning electron microscope (SEM), transmission electron microscopy (TEM) and selected area electron diffraction (SAED), X-ray photoelectron spectroscopy (XPS), UV-vis diffuse reflectance spectroscopy (DRS), and photoluminescence (PL) spectroscopy. The photocatalytic activity of I-BWO for the degradation of rhodamine B (RhB) was higher than that of pure BWO and I2-BWO regardless of visible light (>420 nm) or ultraviolet light (<400 nm) irradiation. The results of DRS analysis showed that the I-BWO and I2-BWO catalysts had narrower band gaps. XPS analysis proved that the multivalent iodine species including I0and were coadsorbed on the defect surface of Bi2WO6in I-BWO. The enhanced PL intensity revealed that a large number of defects of oxygen vacancies were formed by the doping of iodine. The enhanced photocatalytic activity of I-BWO for degradation of RhB was caused by the synergetic effect of a small crystalline size, a narrow band gap, and plenty of oxygen vacancies.


2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
Beata Zielińska ◽  
Ewa Mijowska ◽  
Ryszard J. Kalenczuk

K-Ta mixed oxides photocatalysts have been prepared by impregnation followed by calcination. The influence of the reaction temperature (450°C–900°C) on the phase formation, crystal morphology, and photocatalytic activity in hydrogen generation of the produced materials was investigated. The detailed analysis has revealed that all products exhibit high crystallinity and irregular structure. Moreover, two different crystal structures of potassium tantalates such as KTaO3and K2Ta4O11were obtained. It was also found that the sample composed of KTaO3and traces of unreacted Ta2O5(annealed at 600°C) exhibits the highest activity in the reaction of photocatalytic hydrogen generation. The crystallographic phases, optical and vibronic properties were examined by X-ray diffraction (XRD) and diffuse reflectance (DR) UV-vis and resonance Raman spectroscopic methods, respectively. Morphology and chemical composition of the produced samples were studied using a high-resolution transmission electron microscope (HR-TEM) and an energy dispersive X-ray spectrometer (EDX) as its mode.


Sign in / Sign up

Export Citation Format

Share Document