Experimental Study on Dynamic Compaction-Plastics Drain Board Method in Backfill Subgrade Reinforcement

2011 ◽  
Vol 474-476 ◽  
pp. 2032-2036
Author(s):  
Yong Ma ◽  
Mao Tian Luan ◽  
Zhong Chang Wang

Plastics drain board method is one of the most effective ways of reducing excess pore water pressure during the process of dynamic compaction in soft soil subgrade reinforcement. Based on field test in neritic backfilled area of Jinzhou Port 207B berth, the pore water pressure, groundwater level, subgrade bearing capacity and time effect of deformation have been measured and analyzed. The application of dynamic compaction-PDB method makes a mighty advance of the dynamic compaction method, which provides a new way for soft soil treatment in coastal areas.

2020 ◽  
Vol 2020 ◽  
pp. 1-11
Author(s):  
Qizhi Hu ◽  
Qiang Zou ◽  
Zhigang Ding ◽  
Zhaodong Xu

The excavation unloading of deep foundation pits in soft soil areas often produces negative excess pore water pressure. The rebound deformation of soil on the excavation surface of the foundation pit can be predicted reliably through the accurate expression of relevant variation laws. In combination with the principle of effective stress and the general equation of unidirectional seepage consolidation, an equation for calculating the rebound deformation from the bottom in the process of foundation pit excavation unloading was obtained. Additionally, a triaxial unloading test was adopted to simulate the excavation unloading processes for actual foundation pit engineering. After studying the variation law of the excess pore water pressure generated by excavation unloading, it was found that the negative excess pore water pressure increased with increasing unloading rate, while the corresponding peak value decreased with increasing confining pressure. The equation for rebound calculation was verified through a comparison with relevant measured data from actual engineering. Therefore, it is considered that the equation can reliably describe the rebound deformation law of the base. This paper aims to guide the design and construction of deep foundation pits in soft soil areas.


2019 ◽  
Vol 2019 ◽  
pp. 1-9 ◽  
Author(s):  
Wei Huang ◽  
Kejun Wen ◽  
Dongsheng Li ◽  
Xiaojia Deng ◽  
Lin Li ◽  
...  

The unloading creep behavior of soft soil under lateral unloading stress path and excess pore water pressure is the core problem of time-dependent analysis of surrounding rock deformation under excavation of soft soil. The soft soil in Shenzhen, China, was selected in this study. The triaxial unloading creep tests of soft soil under different initial excess pore water pressures (0, 20, 40, and 60 kPa) were conducted with the K0 consolidation and lateral unloading stress paths. The results show that the unloading creep of soft soil was divided into three stages: attenuation creep, constant velocity creep, and accelerated creep. The duration of creep failure is approximately 5 to 30 mins. The unloading creep behavior of soft soil is significantly affected by the deviatoric stress and time. The nonlinearity of unloading creep of soft soil is gradually enhanced with the increase of the deviatoric stress and time. The initial excess pore water pressure has an obvious weakening effect on the unloading creep of soft soil. Under the same deviatoric stress, the unloading creep of soft soil is more significant with the increase of initial excess pore water pressure. Under undrained conditions, the excess pore water pressure generally decreases during the lateral unloading process and drops sharply at the moment of unloading creep damage. The pore water pressure coefficients during the unloading process were 0.73–1.16, 0.26–1.08, and 0.35–0.96, respectively, corresponding to the initial excess pore water pressures of 20, 40, and 60 kPa.


2011 ◽  
Vol 90-93 ◽  
pp. 2254-2257 ◽  
Author(s):  
Xiao Jing Li ◽  
Kai Yao ◽  
Shao Chun Zhu ◽  
Xiang Hong Pan

The changing rule of excess pore water pressure during dynamic compaction is important for construction. The following conclusions could be drawn by observing and analyzing the excess pore water pressure in test area. Under ramming strike energy of 2000kN•m, the best hit number during the 1~2 times is 8~9, the best hit number during the third time is 6~8. After compaction, the shallow excess pore water pressure is basically larger than the deep. The shallow excess pore water pressure needs more time to dissipate. The horizontal distance of the shallow excess pore water pressure is larger than that of the deep. During the dissipating process of the pore water pressure, we should pay attention to avoid vibration interference of load in the surface and prevent liquefaction of the powder soil. Under ramming strike energy of 2000kN•m, the biggest influence depth of dynamic compaction is 8~9m, the effective reinforcement depth is 6~8m. The conclusions can provide the theoretical basis for dynamic compaction construction.


2020 ◽  
Vol 2020 ◽  
pp. 1-13
Author(s):  
Wei Huang ◽  
Kejun Wen ◽  
Xiaojia Deng ◽  
Junjie Li ◽  
Zhijian Jiang ◽  
...  

Presented in this paper is a study on the lateral unloading creep tests under different excess pore water pressures. The marine sedimentary soft soil in Shenzhen, China, was selected in this study. The results show that the excess pore water pressure plays a significant role in enhancing the unloading creep of soft soil. Higher excess pore water pressure brings more obvious creep deformation of soft soil and lower ultimate failure load. Meanwhile, the viscoelastic and the viscoplastic modulus of soft soil were found to exponentially decline with creep time. A modified merchant model and a combined model of the modified merchant model and plastic elements are used to simulate the viscoelastic and the viscoplastic deformation, respectively. Therefore, a lateral unloading creep model of soft soil is developed based on the modified merchant model. The accuracy and applicability of this model were verified through identifying the parameters in the model. Research results are of particular significance to the numerical simulation of underground space excavation in soft soil areas which considers the effects of excess pore water pressure.


2020 ◽  
Vol 57 (3) ◽  
pp. 377-390
Author(s):  
Dongli Zhu ◽  
Buddhima Indraratna ◽  
Harry Poulos ◽  
Cholachat Rujikiatkamjorn

Piles and prefabricated vertical drains (PVDs) are two well-established inclusions used by geotechnical practitioners when dealing with soft compressible foundations. Induced movements in highly compressible soil can adversely influence the pile response by inducing additional movements and stresses in the piles. Especially, undesirable soil–pile interaction often leads to the development of excess pore-water pressure during pile installation and negative skin friction caused by the settlement of compressible soil surrounding the piles. Additional drainage by PVDs prior to the installation of a pile could reduce excess pore-water pressure, lateral soil movement, and negative skin friction on the pile. In this paper, full-scale field testing on two trial embankments built on soft soil is reported and the relative behaviour of these two embankments is compared and discussed. Soft soil underneath both embankments was consolidated before one pile was installed at the centre of each embankment. The pore-water pressure, lateral soil movement, surface settlement, and associated strain at the pile shaft were recorded. The pile capacity was tested immediately and 3 h after pile installation. The monitoring and testing results indicated that preconsolidation with PVDs before piling can effectively reduce the excess pore-water pressure, lateral soil movement, and downdrag on the pile.


2013 ◽  
Vol 639-640 ◽  
pp. 630-638
Author(s):  
Hua Yang Lei ◽  
Qian Qian Lv

The dissipating of pore water pressure caused by pile sinking is one of the main factors resulting in time effect of ultimate bearing capacity of pile.The pore water pressure is monitored at each observing point during pile sinking and after that. With the pore pressure plan embedded in advance, by means of spot test in the process of pile sinking, under this geological conditions of the pile foundation by referring to the second phase project of the free port logistics processing zone in Dongjiang, Tianjin.The change law of the distribution and dissipation of excess pore water pressure with time, depth, radial distance and permeability coefficient of soil was also discussed. It’s found that the excess pore water pressure attenuates approximately linearly with the increase of the distance from the pile heart and the scope influenced is around 10d. As the numerical simulation accord with the test results effectively, promote the results then get the change rule of pile bearing capacity with time.The formula of pile bearing capacity about time effect in dredge fill was deduced for engineering reference.The effect of soil internal friction angle on the ultimate bearing capacity of pile was discussed. Numerical simulation shows that the ultimate bearing capacity of pipe pile increases over time and keeps stable after 20d.The ultimate limit bearing capacity is 1473kN with increase of 12.3%, the time when it reaches the stable state is in accord with the excess pore water pressure dissipation monitored at each observing point. The larger the internal frictional angle of soil becomes, the more the ultimate bearing capacity is. The angle exceeding 20°,the bearing capacity would not increase as internal frictional angle of soil increases.


1999 ◽  
pp. 261-274
Author(s):  
Kusukatu YUASA ◽  
Shigeru SAKAIDA ◽  
Hiroshi KAWASE ◽  
Takeshi ISHIGURO ◽  
Hideki SHIMIZU ◽  
...  

2013 ◽  
Vol 448-453 ◽  
pp. 1256-1259
Author(s):  
Feng Tan ◽  
Tai Quan Zhou

The two-dimensional finite element model for subgrade consolidation settlement analysis within soft soil pile is developed using ABAQUS. The numerical simulation on a highway subgrade deformation is performed to study the variation of consolidation settlement and the excess pore water pressure distribution in the central location and the part under centerline of the embankment. The results show that settlement develops gradually with the increasing period of soil consolidation. The excess pore water pressure of deep subgrade soils under embankment centerline rise due to the increased load. After each soil layer was filled, the excess pore water pressure increased in the first and was stable later along with the increase of soil depth. After the embankment soil was filled completely, excess pore pressure dissipated with time developing until the completion of consolidation.


2011 ◽  
Vol 374-377 ◽  
pp. 436-439
Author(s):  
Kai Yao ◽  
Zhan Yong Yao ◽  
Xiu Guang Song ◽  
Qing Sen Shang

The Yellow River flood area mainly consisted of silt and silty clay. Water level observing holes and pore water pressure gauges were embedded in the test section. The observation results showed that: The pore water pressure of 3m and 5m grew slowly at the beginning. With the increase of ramming strike and the total ramming strike energy, the fourth hit pore water pressure mutated and then grew slowly. The pore water pressure of 7m and 9m grew slowly all the time. Because of the well point dewatering, the excess pore water pressure dissipated very soon. 70~75% of the excess pore water pressure of the first pass dissipated 3 hours after ramming strike, then the excess pore water pressure dissipated slowly. The excess pore water pressure of 3m and 5m grew significantly, so the effective reinforcing depth of dynamic compaction was 5m.


2021 ◽  
Vol 11 (16) ◽  
pp. 7612
Author(s):  
Yuan Lu ◽  
Jian Chen ◽  
Juehao Huang ◽  
Libo Feng ◽  
Song Yu ◽  
...  

Soft soil is often subjected to cyclic loading such as that imposed during storms, under traffic, or in an earthquake. Furthermore, the cyclic-loading-induced excess pore water pressure can be partially dissipated after cyclic loading. Thus, different reconsolidation processes should be considered. A series of static and dynamic triaxial tests were conducted on undisturbed soft soil to determine the post-cyclic mechanical behavior thereof, such as the variation of undrained shear strength, the development of excess pore water pressure, and the evolution of effective stress path. The effects of consolidated confining pressure, cyclic stress ratio, and degree of reconsolidation were analyzed. Results show that the trend of all stress–strain curves is similar under different conditions. The effect of the degree of reconsolidation is such that, with increasing the degree of reconsolidation, the shear strength is enhanced. Meanwhile, compared with undrained shear strength without cyclic loading, the shear strength after cyclic loading with full reconsolidation is increased. These factors also have a significant effect on the undrained shear strength: the greater both the confining pressure and cyclic stress ratio are, the higher the undrained shear strength. A positive excess pore water pressure is always observed during post-cyclic shearing process, irrespective of different factors. The S-shaped effective stress paths under different test conditions are observed and cross the critical state line. The microstructures of undisturbed soil and post-cyclic specimens with different degrees of reconsolidation were quantitatively investigated. Besides that, the degree of influence of different factors on the post-cyclic undrained strength was analyzed. Based on the test results, the undrained shear strength with cyclic load-history was well predicted by existing models.


Sign in / Sign up

Export Citation Format

Share Document