Combination of Au Dielectrophoresis Chip and Optical Tweezers for Cell Culture

2015 ◽  
Vol 656-657 ◽  
pp. 549-553
Author(s):  
Kyohei Nishimoto ◽  
Kozo Taguchi

Dielectrophoresis (DEP) force will arise when an inhomogeneous AC electric field with sinusoidal wave is applied to microelectrodes. By using DEP, we could distinguish between viable and non-viable cells by their movement through a non-uniform electric field. In this paper, we propose a yeast cell separation system, which utilizes an Au DEP chip and an optical tweezers. The Au DEP chip is planar quadrupole microelectrodes, which were fabricated by Au thin-film and a box cutter. This fabrication method is low cost and simpler than previous existing methods. The tip of the optical tweezers was fabricated by dynamic chemical etching in a mixture of hydrogen fluoride and toluene. The optical tweezers has the feature of high manipulation performance. That does not require objective lens for focusing light because the tip of optical tweezers has conical shape. By using both the Au DEP chip and optical tweezers, we could obtain three-dimensional manipulation of specific cells after viability separation.

2019 ◽  
Vol 881 ◽  
pp. 524-550 ◽  
Author(s):  
Antarip Poddar ◽  
Shubhadeep Mandal ◽  
Aditya Bandopadhyay ◽  
Suman Chakraborty

We investigate the effects of surfactant coating on a deformable viscous drop under the combined action of shear flow and a uniform electric field. Employing a comprehensive three-dimensional approach, we analyse the non-Newtonian shearing response of the bulk emulsion in the dilute suspension regime. Our results reveal that the location of the peak surfactant accumulation on the drop surface may get shifted from the plane of shear to a plane orthogonal to it, depending on the tilt angle of the applied electric field and strength of the electrical stresses relative to their hydrodynamic counterparts. The surfactant non-uniformity creates significant alterations in the flow perturbation around the drop, triggering modulations in the bulk shear viscosity. Overall, the shear-thinning or shear-thickening behaviour of the emulsion appears to be greatly influenced by the interplay of surface charge convection and Marangoni stresses. We show that the balance between electrical and hydrodynamic stresses renders a vanishing surface tension gradient on the drop surface for some specific shear rates, rendering negligible alterations in the bulk viscosity. This critical condition largely depends on the electrical permittivity and conductivity ratios of the two fluids and orientation of the applied electric field. Also, the physical mechanisms of charge convection and surface deformation play their roles in determining this critical shear rate. As a consequence, we obtain new discriminating factors, involving electrical property ratios and the electric field configuration, which govern the same. Consequently, the surfactant-induced enhancement or attenuation of the bulk emulsion viscosity depends on the electrical conductivity and permittivity ratios. The concerned description of the drop-level flow physics and its connection to the bulk rheology of a dilute emulsion may provide a fundamental understanding of a more complex emulsion system encountered in industrial practice.


Sensors ◽  
2020 ◽  
Vol 20 (17) ◽  
pp. 4916
Author(s):  
Xunmin Zhu ◽  
Nan Li ◽  
Jianyu Yang ◽  
Xingfan Chen ◽  
Huizhu Hu

As a kind of ultra-sensitive acceleration sensing platform, optical tweezers show a minimum measurable value inversely proportional to the square of the diameter of the levitated spherical particle. However, with increasing diameter, the coupling of the displacement measurement between the axes becomes noticeable. This paper analyzes the source of coupling in a forward-scattering far-field detection regime and proposes a novel method of suppression. We theoretically and experimentally demonstrated that when three variable irises are added into the detection optics without changing other parts of optical structures, the decoupling of triaxial displacement signals mixed with each other show significant improvement. A coupling detection ratio reduction of 49.1 dB and 22.9 dB was realized in radial and axial directions, respectively, which is principally in accord with the simulations. This low-cost and robust approach makes it possible to accurately measure three-dimensional mechanical quantities simultaneously and may be helpful to actively cool the particle motion in optical tweezers even to the quantum ground state in the future.


2017 ◽  
Vol 2017 ◽  
pp. 1-8
Author(s):  
Bo Tao

We are concerned with gravity-capillary waves propagating on the surface of a three-dimensional electrified liquid sheet under a uniform electric field parallel to the undisturbed free surface. For simplicity, we make an assumption that the permittivity of the fluid is much larger than that of the upper-layer gas; hence, this two-layer problem is reduced to be a one-layer problem. In this paper, we propose model equations in the shallow-water regime based on the analysis of the Dirichlet-Neumann operator. The modified Benney-Luke equation and Kadomtsev-Petviashvili equation will be derived, and the truly three-dimensional fully localized traveling waves, which are known as “lumps” in the literature, are numerically computed in the Benney-Luke equation.


Micromachines ◽  
2019 ◽  
Vol 10 (6) ◽  
pp. 423 ◽  
Author(s):  
Haoqing Zhang ◽  
Honglong Chang ◽  
Pavel Neuzil

Dielectric particles in a non-uniform electric field are subject to a force caused by a phenomenon called dielectrophoresis (DEP). DEP is a commonly used technique in microfluidics for particle or cell separation. In comparison with other separation methods, DEP has the unique advantage of being label-free, fast, and accurate. It has been widely applied in microfluidics for bio-molecular diagnostics and medical and polymer research. This review introduces the basic theory of DEP, its advantages compared with other separation methods, and its applications in recent years, in particular, focusing on the different electrode types integrated into microfluidic chips, fabrication techniques, and operation principles.


Author(s):  
Ye Yao ◽  
Kevin M. Beussman ◽  
Yechun Wang

A three-dimensional spectral boundary integral algorithm has been developed to investigate the dynamics of a neutrally buoyant and initially uncharged droplet in another immiscible fluid subjected to a steady electric field. Good agreement has been found by comparing with analytical solutions and experimental results for droplets in a uniform electric field. Benefit from the fully three-dimensional algorithm that we have developed, the droplet deformation and migration induced by the nonuniform electric field created by a point charge has been investigated. We computationally predict the deformation and migration of the droplet under the influence of physical properties of the system: resistivities, permittivities and viscosities, as well as the electric capillary number. The numerical scheme developed by this study and computational results provide foundation for the computational investigation of droplet motion in digital microfluidics.


1999 ◽  
Vol 384 ◽  
pp. 59-91 ◽  
Author(s):  
S. M. LEE ◽  
I. S. KANG

A three-dimensional analysis is performed to investigate the effects of an electric field on the steady deformation and small-amplitude oscillation of a bubble in dielectric liquid. To deal with a general class of electric fields, an electric field near the bubble is approximately represented by the sum of a uniform field and a linear field. Analytical results have been obtained for steady deformation and modification of oscillation frequency by using the domain perturbation method with the angular momentum operator approach.It has been found that, to the first order, the steady shape of a bubble in an arbitrary electric field can be represented by a linear combination of a finite number of spherical harmonics Yml, where 0[les ]l[les ]4 and [mid ]m[mid ][les ]l. For the oscillation about the deformed steady shape, the overall frequency modification from the value of free oscillation about a spherical shape is obtained by considering two contributions separately: (i) that due to the deformed steady shape (indirect effect), and (ii) that due to the direct effect of an electric field. Both the direct and indirect effects of an electric field split the (2l+1)-fold degenerate frequency of Yml modes, in the case of free oscillation about a spherical shape, into different frequencies that depend on m. However, when the average is taken over the (2l+1) values of m, the frequency splitting due to the indirect effect via the deformed steady shape preserves the average value, while the splitting due to the direct effect of an electric field does not.The oscillation characteristics of a bubble in a uniform electric field under the negligible compressibility assumption are compared with those of a conducting drop in a uniform electric field. For axisymmetric oscillation modes, deforming the steady shape into a prolate spheroid has the same effect of decreasing the oscillation frequency in both the drop and the bubble. However, the electric field has different effects on the oscillation about a spherical shape. The oscillation frequency increases with the increase of electric field in the case of a bubble, while it decreases in the case of a drop. This fundamental difference comes from the fact that the electric field outside the bubble exerts a suppressive surface force while the electric field outside the conducting drop exerts a pulling force on the surface.


2002 ◽  
Vol 16 (17n18) ◽  
pp. 2300-2306
Author(s):  
J. XU ◽  
X. DONG ◽  
Z. Y. CHEN ◽  
Y. G. JIANG ◽  
L. W. ZHOU

The dipole interaction between a pair of electrorheological (ER) particles under an external AC electric field was confirmed in a dynamic case using optical tweezers positioning and a system of high speed imaging and image processing. By measuring the interactions between two micron-sized ER particles with both central distance and structure forming time, the structure response time and the interaction strength were obtained for the particles under an AC electric field. The spacial resolution of the optical tweezers-high speed imaging-image processing system is 0.26μm. The sampling rate of the high-speed video recorder is up to 8000 frame/s with the corresponding time resolution being 0.125 ms.


Sign in / Sign up

Export Citation Format

Share Document