scholarly journals Mixing at the extratropical tropopause as characterized by collocated airborne H<sub>2</sub>O and O<sub>3</sub> lidar observations

2021 ◽  
Vol 21 (6) ◽  
pp. 5217-5234
Author(s):  
Andreas Schäfler ◽  
Andreas Fix ◽  
Martin Wirth

Abstract. The composition of the extratropical transition layer (ExTL), which is the transition zone between the stratosphere and the troposphere in the midlatitudes, largely depends on dynamical processes fostering the exchange of air masses. The Wave-driven ISentropic Exchange (WISE) field campaign in 2017 aimed for a better characterization of the ExTL in relation to the dynamic situation. This study investigates the potential of the first-ever collocated airborne lidar observations of ozone (O3) and water vapor (H2O) across the tropopause to depict the complex trace gas distributions and mixing in the ExTL. A case study of a perpendicular jet stream crossing with a coinciding strongly sloping tropopause is presented that was observed during a research flight over the North Atlantic on 1 October 2017. The collocated and range-resolved lidar data that are applied to established tracer–tracer (T–T) space diagnostics prove to be suitable to identify the ExTL and to reveal distinct mixing regimes that enabled a subdivision of mixed and tropospheric air. A back projection of this information to geometrical space shows remarkably coherent structures of these air mass classes along the cross section. This represents the first almost complete observation-based two-dimensional (2D) illustration of the shape and composition of the ExTL and a confirmation of established conceptual models. The trace gas distributions that represent typical H2O and O3 values for the season reveal tropospheric transport pathways from the tropics and extratropics that have influenced the ExTL. Although the combined view of T–T and geometrical space does not inform about the process, location and time of the mixing event, it gives insight into the formation and interpretation of mixing lines. A mixing factor diagnostic and a consideration of data subsets show that recent quasi-instantaneous isentropic mixing processes impacted the ExTL above and below the jet stream which is a confirmation of the well-established concept of turbulence-induced mixing in strong wind shear regions. At the level of maximum winds reduced mixing is reflected in jumps in T–T space that occurred over small horizontal distances along the cross section. For a better understanding of the dynamical and chemical discontinuities at the tropopause, the lidar data are illustrated in isentropic coordinates. The strongest gradients of H2O and O3 are found to be better represented by a potential vorticity-gradient-based tropopause compared to traditional dynamical tropopause definitions using constant potential vorticity values. The presented 2D lidar data are considered to be of relevance for the investigation of further meteorological situations leading to mixing across the tropopause and for future validation of chemistry and numerical weather prediction models.

2020 ◽  
Author(s):  
Andreas Schäfler ◽  
Andreas Fix ◽  
Martin Wirth

Abstract. The composition of the extratropical transition layer (ExTL), which is the transition zone between the stratosphere and the troposphere in the mid-latitudes, largely depends on dynamical processes fostering the exchange of air masses. Here we follow the need to better characterize the ExTL in relation to the dynamic situation using the first-ever collocated airborne lidar observations of ozone (O3) and water vapour (H2O) across the tropopause. The potential of such lidar profile data, required for a novel, two-dimensional depiction of the complex trace gas distributions and mixing along cross-sections, is illustrated for a perpendicular jet stream crossing during a research flight over the North Atlantic conducted on 1 October 2017 in the framework of the Wave-driven Isentropic Exchange (WISE) field campaign. The analysis of the ExTL shape and composition uses a combined view of the lidar data in geometrical and tracer-tracer (T-T) space, which was so far not possible from existing observations. For this particular case study, which is considered to be representative for the climatological distribution, the T-T depiction allows to identify distinct mixing regimes that suggest mixing of air masses with differing origin: we find clearly separated mixing of stratospheric air with moist extratropical air as well as with dry tropical air in the surrounding of the extratropical jet stream. This separation is indicative for differing transport pathways in the troposphere which need to be further elaborated using Lagrangian diagnostics. The O3 and H2O distributions confirm strongest mixing above and below the maximum jet stream winds, while it is suppressed in-between. The interrelation of chemical and dynamical discontinuities is investigated and strongest isentropic trace gas gradients are found to be better correlated with maximum isentropic PV gradients than with classical dynamical tropopause definitions. Although the methods neither allow conclusions on the individual mixing process nor on the location and time of the event, the consideration of data subsets allows discussing the formation and interpretation of isentropic and vertical mixing lines in T-T space and to develop hypotheses on mixing at different time-scales. The presented two-dimensional lidar data is considered to be of relevance for the investigation of further synoptic situations leading to mixing across the tropopause and for future validation of chemistry and numerical weather prediction models.


2019 ◽  
Vol 11 (5) ◽  
pp. 509 ◽  
Author(s):  
Ian Paynter ◽  
Crystal Schaaf ◽  
Jennifer Bowen ◽  
Linda Deegan ◽  
Francesco Peri ◽  
...  

Airborne lidar can observe saltmarshes on a regional scale, targeting phenological and tidal states to provide the information to more effectively utilize frequent multispectral satellite observations to monitor change. Airborne lidar observations from NASA Goddard Lidar Hyperspectral and Thermal (G-LiHT) of a well-studied region of saltmarsh (Plum Island, Massachusetts, United States) were acquired in multiple years (2014, 2015 and 2016). These airborne lidar data provide characterizations of important saltmarsh components, as well as specifications for effective surveys. The invasive Phragmites australis was observed to increase in extent from 8374 m2 in 2014, to 8882 m2 in 2015 (+6.1%), and again to 13,819 m2 in 2016 (+55.6%). Validation with terrestrial lidar supported this increase, but suggested the total extent was still underestimated. Estimates of Spartina alterniflora extent from airborne lidar were within 7% of those from terrestrial lidar, but overestimation of height of Spartina alterniflora was found to occur at the edges of creeks (+83.9%). Capturing algae was found to require observations within ±15° of nadir, and capturing creek structure required observations within ±10° of nadir. In addition, 90.33% of creeks and ditches were successfully captured in the airborne lidar data (8206.3 m out of 9084.3 m found in aerial imagery).


2020 ◽  
Vol 237 ◽  
pp. 07016
Author(s):  
Y. Saito ◽  
K. Shiraishi ◽  
A. Nishimura ◽  
T. Kirinaka ◽  
Y. Sakurai ◽  
...  

A database containing spectrum and cross-section of the fluorescence of substances has been made. In test of forest environment monitoring by our Laser-Induced Fluorescence Spectrum (LIFS) lidar, the database showed that the origin substance of the aerosol observed by the lidar was cedar pollen, and the concentration was calculated using the cross-section. In the urban atmosphere monitoring, three substances stored in the database were proposed to be the origins of the aerosol. Based on these experiments, we discuss the usefulness of the fluorescence database in lidar observations.


Author(s):  
V. Mizuhira ◽  
Y. Futaesaku

Previously we reported that tannic acid is a very effective fixative for proteins including polypeptides. Especially, in the cross section of microtubules, thirteen submits in A-tubule and eleven in B-tubule could be observed very clearly. An elastic fiber could be demonstrated very clearly, as an electron opaque, homogeneous fiber. However, tannic acid did not penetrate into the deep portion of the tissue-block. So we tried Catechin. This shows almost the same chemical natures as that of proteins, as tannic acid. Moreover, we thought that catechin should have two active-reaction sites, one is phenol,and the other is catechole. Catechole site should react with osmium, to make Os- black. Phenol-site should react with peroxidase existing perhydroxide.


Author(s):  
Tamotsu Ohno

The energy distribution in an electron; beam from an electron gun provided with a biased Wehnelt cylinder was measured by a retarding potential analyser. All the measurements were carried out with a beam of small angular divergence (<3xl0-4 rad) to eliminate the apparent increase of energy width as pointed out by Ichinokawa.The cross section of the beam from a gun with a tungsten hairpin cathode varies as shown in Fig.1a with the bias voltage Vg. The central part of the beam was analysed. An example of the integral curve as well as the energy spectrum is shown in Fig.2. The integral width of the spectrum ΔEi varies with Vg as shown in Fig.1b The width ΔEi is smaller than the Maxwellian width near the cut-off. As |Vg| is decreased, ΔEi increases beyond the Maxwellian width, reaches a maximum and then decreases. Note that the cross section of the beam enlarges with decreasing |Vg|.


2009 ◽  
Author(s):  
Marci Culley ◽  
Holly Angelique ◽  
Courte Voorhees ◽  
Brian John Bishop ◽  
Peta Louise Dzidic ◽  
...  

The work of multilayer glass structures for central and eccentric compression and bending are considered. The substantiation of the chosen research topic is made. The description and features of laminated glass for the structures investigated, their characteristics are presented. The analysis of the results obtained when testing for compression, compression with bending, simple bending of models of columns, beams, samples of laminated glass was made. Overview of the types and nature of destruction of the models are presented, diagrams of material operation are constructed, average values of the resistance of the cross-sections of samples are obtained, the table of destructive loads is generated. The need for development of a set of rules and guidelines for the design of glass structures, including laminated glass, for bearing elements, as well as standards for testing, rules for assessing the strength, stiffness, crack resistance and methods for determining the strength of control samples is emphasized. It is established that the strength properties of glass depend on the type of applied load and vary widely, and significantly lower than the corresponding normative values of the strength of heat-strengthened glass. The effect of the connecting polymeric material and manufacturing technology of laminated glass on the strength of the structure is also shown. The experimental values of the elastic modulus are different in different directions of the cross section and in the direction perpendicular to the glass layers are two times less than along the glass layers.


CFA Digest ◽  
2008 ◽  
Vol 38 (3) ◽  
pp. 55-56
Author(s):  
Kathryn Dixon Jost

Sign in / Sign up

Export Citation Format

Share Document