scholarly journals Central Mediterranean Sea forecast: effects of high-resolution atmospheric forcings

2006 ◽  
Vol 3 (3) ◽  
pp. 637-669 ◽  
Author(s):  
S. Natale ◽  
R. Sorgente ◽  
S. Gaberšek ◽  
A. Ribotti ◽  
A. Olita

Abstract. Ocean forecasts over the Central Mediterranean, produced by a near real time regional scale system, have been evaluated in order to assess their predictability. The ocean circulation model has been forced at the surface by a medium, high or very high resolution atmospheric forcing. The simulated ocean parameters have been compared with satellite data and they were found to be generally in good agreement. High and very high resolution atmospheric forcings have been able to form noticeable, although short-lived, surface current structures, due to their ability to detect transient atmospheric disturbances. The existence of the current structures has not been directly assessed due to lack of measurements. The ocean model in the slave mode was not able to develop dynamics different from the driving coarse resolution model which provides the boundary conditions.

2018 ◽  
Vol 48 (5) ◽  
pp. 1139-1150 ◽  
Author(s):  
Lachlan Stoney ◽  
Kevin J. E. Walsh ◽  
Steven Thomas ◽  
Paul Spence ◽  
Alexander V. Babanin

Abstract A parameterization of turbulent mixing from unbroken surface waves is included in a 16-yr simulation within a high-resolution ocean circulation model (MOM5). This “surface wave mixing” (SWM) derives from the wave orbital motion and is parameterized as an additional term in a k-epsilon model. We show that SWM leads to significant changes in sea surface temperatures but smaller changes in ocean heat content, and show the extent to which these changes can reduce pre-existing model biases with respect to observed data. Specifically, SWM leads to a widespread improvement in sea surface temperature in both hemispheres in summer and winter, while for ocean heat content the improvements are less clear. In addition, we show that introducing SWM can lead to an accumulation of wave-induced ocean heat content between years. While it has been well established that secular positive trends exist in global wave heights, we find that such trends are relatively unimportant in driving the accumulation of wave-induced ocean heat content. Rather, in response to the new source of mixing, the simulated ocean climate evolves toward a new equilibrium with greater total ocean heat content.


2021 ◽  
Author(s):  
Alfatih Ali ◽  
Malte Muller ◽  
Laurent Bertino ◽  
Arne Melson

<p>As grid resolutions of operational ocean models are becoming finer and approach closer to the coast, the importance of inclusion of tidal forcing in high resolution operational ocean forecasting systems has increasingly been recognized. In the current work,  we present a 3D general ocean circulation model of ocean tides in the pan-Arctic region at ~3km horizontal grid resolution and 50 hybrid layers in the vertical, thus representing both barotropic and internal tides. The model system is based on the Hybrid Coordinate Ocean Model (HYCOM)  coupled with the Los Alamos Sea Ice Model (CICE). The results showed good agreement when compared with observations from tide gauges and a data-assimilative global barotropic tidal model. Among other results, the evaluation includes results for tidal amplitude and phase of the most energetic constituents (M2, S2, K1 and Q1).   The model system is currently operational and its development is supported by the Copernicus Marine Environment Monitoring Service (CMEMS) where its forecasts are disseminated.</p>


2005 ◽  
Vol 12 (5) ◽  
pp. 755-765 ◽  
Author(s):  
I. Hoteit ◽  
G. Korres ◽  
G. Triantafyllou

Abstract. Kalman filters are widely used for data assimilation into ocean models. The aim of this study is to discuss the relevance of these filters with high resolution ocean models. This was investigated through the comparison of two advanced Kalman filters: the singular evolutive extended Kalman (SEEK) filter and its ensemble-based variant, called SEIK filter. The two filters were implemented with the Princeton Ocean model (POM) considering a low spatial resolution configuration (Mediterranean sea model) and a very high one (Pagasitikos Gulf coastal model). It is shown that the two filters perform reasonably well when applied with the low resolution model. However, when the high resolution model is considered, the behavior of the SEEK filter seriously degrades because of strong model nonlinearities while the SEIK filter remains remarkably more stable. Based on the assumption of prior Gaussian distributions, the linear analysis step of the latter can still be improved though.


2017 ◽  
Vol 68 (1) ◽  
pp. 104
Author(s):  
P. Anand ◽  
P.V. Hareesh Kumar

<p class="p1"><span class="Apple-converted-space"> </span>A three dimensional ocean circulation model (Princeton Ocean Model) is utilised to study the thermohaline variability of the eastern Arabian Sea associated with changes in the three input bathymetry data sets, viz. ETOPO5 (E5), Modified ETOPO5 (ME5) and ME5 further modified based on actual fine resolution data collected using Multibeam echo-sounder (MEN5). The temperature and salinity measurements made onboard INS Sagardhwani for the period July 2000 is utilised to validate the model. Simulations of temperature using Princeton Ocean Model show good improvement in the coastal region with MEN5 bathymetry data (RMS error of 0.71 °C and correlation coefficient of 0.98). The study highlights the choice of fine resolution bathymetry data in the simulation of nearshore processes, where bathymetry is very complex.</p>


2016 ◽  
Vol 12 (5) ◽  
pp. 1181-1198 ◽  
Author(s):  
Daniel J. Lunt ◽  
Alex Farnsworth ◽  
Claire Loptson ◽  
Gavin L. Foster ◽  
Paul Markwick ◽  
...  

Abstract. During the period from approximately 150 to 35 million years ago, the Cretaceous–Paleocene–Eocene (CPE), the Earth was in a “greenhouse” state with little or no ice at either pole. It was also a period of considerable global change, from the warmest periods of the mid-Cretaceous, to the threshold of icehouse conditions at the end of the Eocene. However, the relative contribution of palaeogeographic change, solar change, and carbon cycle change to these climatic variations is unknown. Here, making use of recent advances in computing power, and a set of unique palaeogeographic maps, we carry out an ensemble of 19 General Circulation Model simulations covering this period, one simulation per stratigraphic stage. By maintaining atmospheric CO2 concentration constant across the simulations, we are able to identify the contribution from palaeogeographic and solar forcing to global change across the CPE, and explore the underlying mechanisms. We find that global mean surface temperature is remarkably constant across the simulations, resulting from a cancellation of opposing trends from solar and palaeogeographic change. However, there are significant modelled variations on a regional scale. The stratigraphic stage–stage transitions which exhibit greatest climatic change are associated with transitions in the mode of ocean circulation, themselves often associated with changes in ocean gateways, and amplified by feedbacks related to emissivity and planetary albedo. We also find some control on global mean temperature from continental area and global mean orography. Our results have important implications for the interpretation of single-site palaeo proxy records. In particular, our results allow the non-CO2 (i.e. palaeogeographic and solar constant) components of proxy records to be removed, leaving a more global component associated with carbon cycle change. This “adjustment factor” is used to adjust sea surface temperatures, as the deep ocean is not fully equilibrated in the model. The adjustment factor is illustrated for seven key sites in the CPE, and applied to proxy data from Falkland Plateau, and we provide data so that similar adjustments can be made to any site and for any time period within the CPE. Ultimately, this will enable isolation of the CO2-forced climate signal to be extracted from multiple proxy records from around the globe, allowing an evaluation of the regional signals and extent of polar amplification in response to CO2 changes during the CPE. Finally, regions where the adjustment factor is constant throughout the CPE could indicate places where future proxies could be targeted in order to reconstruct the purest CO2-induced temperature change, where the complicating contributions of other processes are minimised. Therefore, combined with other considerations, this work could provide useful information for supporting targets for drilling localities and outcrop studies.


2020 ◽  
Vol 13 (11) ◽  
pp. 5465-5483
Author(s):  
Clément Bricaud ◽  
Julien Le Sommer ◽  
Gurvan Madec ◽  
Christophe Calone ◽  
Julie Deshayes ◽  
...  

Abstract. Ocean biogeochemical models are key tools for both scientific and operational applications. Nevertheless the cost of these models is often expensive because of the large number of biogeochemical tracers. This has motivated the development of multi-grid approaches where ocean dynamics and tracer transport are computed on grids of different spatial resolution. However, existing multi-grid approaches to tracer transport in ocean modelling do not allow the computation of ocean dynamics and tracer transport simultaneously. This paper describes a new multi-grid approach developed for accelerating the computation of passive tracer transport in the Nucleus for European Modelling of the Ocean (NEMO) ocean circulation model. In practice, passive tracer transport is computed at runtime on a grid with coarser spatial resolution than the hydrodynamics, which reduces the CPU cost of computing the evolution of tracers. We describe the multi-grid algorithm, its practical implementation in the NEMO ocean model, and discuss its performance on the basis of a series of sensitivity experiments with global ocean model configurations. Our experiments confirm that the spatial resolution of hydrodynamical fields can be coarsened by a factor of 3 in both horizontal directions without significantly affecting the resolved passive tracer fields. Overall, the proposed algorithm yields a reduction by a factor of 7 of the overhead associated with running a full biogeochemical model like PISCES (with 24 passive tracers). Propositions for further reducing this cost without affecting the resolved solution are discussed.


2016 ◽  
Vol 33 (1) ◽  
pp. 119-126 ◽  
Author(s):  
Lucile Gaultier ◽  
Clément Ubelmann ◽  
Lee-Lueng Fu

AbstractConventional altimetry measures a one-dimensional profile of sea surface height (SSH) along the satellite track. Two-dimensional SSH can be reconstructed using mapping techniques; however, the spatial resolution is quite coarse even when data from several altimeters are analyzed. A new satellite mission based on radar interferometry is scheduled to be launched in 2020. This mission, called Surface Water and Ocean Topography (SWOT), will measure SSH at high resolution along a wide swath, thus providing two-dimensional images of the ocean surface topography. This new capability will provide a large amount of data even though they are contaminated with instrument noise and geophysical errors. This paper presents a tool that simulates synthetic observations of SSH from the future SWOT mission using SSH from any ocean general circulation model (OGCM). SWOT-like data have been generated from a high-resolution model and analyzed to investigate the sampling and accuracy characteristics of the future SWOT data. This tool will help explore new ideas and methods for optimizing the retrieval of information from future SWOT missions.


2013 ◽  
Vol 165 ◽  
pp. 2041-2046 ◽  
Author(s):  
Young-Gyu Park ◽  
Sang-Wook Yeh ◽  
Jin Hwan Hwang ◽  
Taerim Kim

2021 ◽  
pp. 50-66
Author(s):  
V. N. Stepanov ◽  
◽  
Yu. D. Resnyanskii ◽  
B. S. Strukov ◽  
A. A. Zelen’ko ◽  
...  

The quality of simulation of model fields is analyzed depending on the assimilation of various types of data using the PDAF software product assimilating synthetic data into the NEMO global ocean model. Several numerical experiments are performed to simulate the ocean–sea ice system. Initially, free model was run with different values of the coefficients of horizontal turbulent viscosity and diffusion, but with the same atmospheric forcing. The model output obtained with higher values of these coefficients was used to determine the first guess fields in subsequent experiments with data assimilation, while the model results with lower values of the coefficients were assumed to be true states, and a part of these results was used as synthetic observations. The results are analyzed that are assimilation of various types of observational data using the Kalman filter included through the PDAF to the NEMO model with real bottom topography. It is shown that a degree of improving model fields in the process of data assimilation is highly dependent on the structure of data at the input of the assimilation procedure.


Sign in / Sign up

Export Citation Format

Share Document