scholarly journals Engine performance and emission reduction characteristics of biodiesel blended diesel fuel in a passenger car diesel engine

2014 ◽  
Vol 23 (3) ◽  
pp. 181-185
Author(s):  
Shi Gie Jho
Author(s):  
Ahmed I. EL-Seesy ◽  
Ali K. Abdel-Rahman ◽  
Hamdy Hassan ◽  
Shinichi Ookawara ◽  
Meshack Hawi

The current work presents the results of an experimental study that is conducted to investigate the effect of nanoparticles added to biodiesel-diesel fuel mixture. Nano-biodiesel-diesel mixture fuels were prepared by adding of multi-walled carbon nanotubes (MWCNTs). These nanoparticles were blended with biodiesel-diesel fuel in varying mass fractions using an ultrasonic stabilization. A diesel engine test rig was used to examine the effect of nanoparticles on engine performance and emission characteristics with a constant speed of 2500 rpm and different engine loads. The engine test results indicated that the biodiesel-diesel fuel blend slightly decreased the engine performance and increased its emission characteristics at all tested engine operating conditions. The use of nanoparticles was found to improve all engine performance parameters. Specifically, the maximum emission reduction was obtained at a dose level of 20 mg/l, where considerable emission reduction was observed; NOx by 14 %, CO by 30 %, and UHC by 34 %. Also, the best of both engine combustion characteristics and performance were reached at a dose level of 40–50 mg/l. Where the reduction in the brake specific fuel consumption was by 16 %, the increase in both the cylinder peak pressure Pmax, and maximum gross heat release rate dQg/dθmax. were 4 % and 1%, respectively. Finally, the recommended dose level to achieve a significant enhancement in all engine performance is 40 mg/l.


Transport ◽  
2014 ◽  
Vol 29 (4) ◽  
pp. 440-448 ◽  
Author(s):  
Tomas Mickevičius ◽  
Stasys Slavinskas ◽  
Slawomir Wierzbicki ◽  
Kamil Duda

This paper presents a comparative analysis of the diesel engine performance and emission characteristics, when operating on diesel fuel and various diesel-biodiesel (B10, B20, B40, B60) blends, at various loads and engine speeds. The experimental tests were performed on a four-stroke, four-cylinder, direct injection, naturally aspirated, 60 kW diesel engine D-243. The in-cylinder pressure data was analysed to determine the ignition delay, the Heat Release Rate (HRR), maximum in-cylinder pressure and maximum pressure gradients. The influence of diesel-biodiesel blends on the Brake Specific Fuel Consumption (bsfc) and exhaust emissions was also investigated. The bench test results showed that when the engine running on blends B60 at full engine load and rated speed, the autoignition delay was 13.5% longer, in comparison with mineral diesel. Maximum cylinder pressure decreased about 1–2% when the amount of Rapeseed Methyl Ester (RME) expanded in the diesel fuel when operating at full load and 1400 min–1 speed. At rated mode, the minimum bsfc increased, when operating on biofuel blends compared to mineral diesel. The maximum brake thermal efficiency sustained at the levels from 0.3% to 6.5% lower in comparison with mineral diesel operating at full (100%) load. When the engine was running at maximum torque mode using diesel – RME fuel blends B10, B20, B40 and B60 the total emissions of nitrogen oxides decreased. At full and moderate load, the emission of carbon monoxide significantly raised as the amount of RME in fuel increased.


2019 ◽  
Vol 26 (26) ◽  
pp. 27362-27371 ◽  
Author(s):  
Elumalai Perumal Venkatesan ◽  
Annamalai Kandhasamy ◽  
Arularasu Sivalingam ◽  
Appuraja Senthil Kumar ◽  
KrishnaMoorthy Ramalingam ◽  
...  

2014 ◽  
Vol 18 (1) ◽  
pp. 239-247 ◽  
Author(s):  
Hasan Yamik

Biodiesel is an alternative fuel for diesel engines which doesn?t contain pollutants and sulfur; on the contrary it contains oxygen. In addition, both physical and chemical properties of sunflower oil methyl ester (SME) are identical to diesel fuel. Conversely, diesel and biodiesel fuels are widely used with some additives to reduce viscosity, increase the amount of cetane, and improve combustion efficiency. This study uses diesel fuel, SME and its mixture with aviation fuel JetA-1 which are widely used in the aviation industry. . Fuel mixtures were used in 1-cylinder, 4-stroke diesel engine under full load and variable engine speeds. In this experiment, engine performance and emission level are investigated. As a conclusion, as the JetA-1 ratio increases in the mixture, lower nitrogen oxide (NOx) emission is measured. Also, specific fuel consumption is lowered.


2014 ◽  
Vol 984-985 ◽  
pp. 839-844
Author(s):  
Natesan Kanthavelkumaran ◽  
P. Seenikannan

In present scenario researchers focusing the alternate sources of petroleum products. Based on this, current research work focused the emission study of its characteristics and potential as a substitute for Diesel fuel in CI engines. Current research biodiesel is produced by base catalyzed transesterification of rice bran oil is known as Rice Bran Oil Methyl Ester (Biofuel). In this research various proportions of Biofuel and Diesel are prepared on volume basis. It is used as fuels in a four stroke single cylinder direct injection Diesel engine to study the performance and emission characteristics of these fuels. Varieties of results obtained, that shows around 50% reduction in smoke, 33% reduction in HC and 38% reduction in CO emissions. In result discussion a different blends of the brake power and BTE are reduced nearly 2 to 3% and 3 to 4% respectively around 5% increase in the SFC. Therefore it is accomplished from the this experimental work that the blends of Biofuel and Diesel fuel can successfully be used in Diesel engines as an alternative fuel without any modification in the engine. It is also environment friendly blended fuel by the various emission standards.


2018 ◽  
Vol 225 ◽  
pp. 04022
Author(s):  
Zainal Ambri Abdul Karim ◽  
Mohammed Yahaya Khan

Water in diesel emulsion when used as fuel in diesel engine has shown simultaneous reduction in both nitrogen oxides and particulate matters. However, when water in bio-diesel emulsion is used, the effect of simultaneous reduction of nitrogen oxides and particulate reduction is not achieved. The current study aims at investigating the diesel engine performance and exhaust emissions using water in bio-diesel fuel prepared by a homogenizer that produced micro-water particles in the emulsion. A 1.8L indirect injection diesel engine was operated using bio-diesel fuel which contains 95% diesel and 5% palm oil methyl ester, mixed with 5%, 10% and 20% by volume of water. Engine testing was conducted at full load condition with the engine speeds ranges from 1000 to 4000 rpm. Torque, engine speed and fuel consumption were measured along with emissions of NOx, CO, CO2, HC, O2. The results showed small reduction in brake power, 1.4% and 2.1% for WBDE-5 and WBDE-10 respectively, at maximum torque. While, reduction in exhaust gas temperature, CO2 and smoke opacity for all the tested emulsions were exhibited. On the other hand, NOx was found to increase with increase in water contents due to the higher oxygen content in the bio-diesel fuel. WBDE-20 showed the worst efficacy due to having water content of 20% by volume.


2014 ◽  
Vol 607 ◽  
pp. 588-593 ◽  
Author(s):  
Amir Aziz ◽  
Ahmad Fitri Yusof ◽  
Rizalman Mamat ◽  
W.N. Azeem

An emulsion of biodiesel and water is one of the possible approaches that have been used to overcome diesel engine pollution. In this work, the performance and emission characteristics of a 4-cylinder diesel engine using pure diesel, biodiesel B20 and emulsified biodiesel were investigated. Emulsified biodiesel containing 5 % and 10 % water were utilize for the engine tests. During the experimental work, the engine was set-up at 2500 rpm and 20 % to 60 % loads. The result shows the reduction in NOx formation when the water content in emulsified biodiesel increased from 5 % to 10%. For the performance, there were no significant differences between the engine break powers measured for emulsified biodiesel containing 5% water and diesel fuel.


Author(s):  
Alex Y ◽  
Roji George Roy

Biodiesel has become more attractive recently, because of its environmental benefits and the fact that it is made from renewable resources. Over the past few decades, most of the countries depending on diesel engines for transportation. Some of its valuable advantages like highest thermal efficiency made it very popular. At the same time, the cost of diesel fuel is increasing, due to the depletion of fossil fuels. In this current scenario, we need an alternative fuel instead of diesel fuel. Many of the researchers have successfully placed several works on generating energy from different types of alternative sources including solar and some kind of conversion processes including renewable agricultural products into liquid fuel. One of the biggest challenges for developing countries in relation to energy consumption is to develop and implement technologies that help to improve efficiency of automobile engines, also to reduce the emissions of harmful gases and particulate matters. In order to avoid environmental impacts, emissions are reduced or eliminated by introducing renewable energy resources. The present research chronicles the production and testing of renewable biodiesel fuel derived from virgin coconut oil on a diesel engine, to analyses the engine performance and emission characteristics. In the first phase of work, production of biodiesel fuel from virgin coconut oil using transeterification process with two types of catalysts (homogenous and heterogeneous). The preliminary results shows that, with the addition of homogenous catalyst called Potassium Hydroxide (KOH) with methanol shows much higher activity than that of heterogeneous catalysts, and it shows more similar properties with diesel fuel. The results obtained from the chemical test and physicochemical properties of transesterified biodiesel fuel clearly proves the above-mentioned statement. The chemical tests such as GCMS and FT-IR clearly shows that the biodiesel fuel has sufficient amount of volatile components and functional groups. Then, physicochemical properties include, Fire point, Flashpoint, density, and viscosity were analyzed. Finally, Engine performance and Emission characteristics were analysed to confirm, whether this biodiesel fuel is suitable for diesel engines, without any engine modifications. It was found to be, the transesterified virgin coconut oil biodiesel has similar properties to that of the diesel fuel. From the physiochemical properties and engine performance clearly shows that, coconut oil biodiesel is suitable for diesel engine on blending, at a blending percentage level of 20% with conventional diesel fuel. Since the obtained transesterified biofuel can be used as an alternative fuel for diesel engines. The several journal reports and find outs from experimental investigation clearly depicts that the efficiency of the transesterified biofuel mainly depends upon the amount of catalyst adding and type of catalysts present in the biofuel, whether it is homogenous or heterogeneous catalyst is suitable with methanol. Finally, from the analysis made from biodiesel fuel. Coconut Oil Biodiesel fuel has less emission characteristics than that of the diesel fuels.


Sign in / Sign up

Export Citation Format

Share Document