Microplastics Reduce the Negative Effects of Litter-Derived Plant Secondary Metabolites on Nematodes in Soil

Microplastics and plant litter are ubiquitous in the soil environment, and both materials can influence soil properties and biota. Plant litter releases secondary metabolites (e.g., phenolic compounds) during the decomposition process, including chemical compounds active in plant defense. Effects of microplastics and plant litter on soil biota have been studied independently but we have limited information about the combined effects of both sources of chemicals. Here, we specifically focused on the interaction between plant litter and microplastics, as well as their potential effects on soil biota (i.e., nematodes). We used soils from a previous experiment that included three different types of microplastic fibers (MFs) and four different types of plant litter, which were incubated in the soil in all combinations of materials. After soil incubation (42 days) in the previous experiment, we here tested for effects on nematodes (Caenorhabditis elegans). Plant litter treatments negatively affected the reproduction of nematodes, but these effects were reduced when the soils were incubated along with MFs. We measured the phenolic concentrations in plant litter extracts in a kinetic experiment and found that phenolic concentrations significantly decreased with some of the MF additions. Our results suggest that microplastics can affect the potential effects of natural chemicals such as plant phenolic compounds. We urge future studies to consider this possibility as a key explanatory process underpinning effects of microplastic in the soil environment.

Top-Down Synthesis of NaP Zeolite from Natural Zeolite for the Higher Removal Efficiency of Cs, Sr, and Ni

A solid phase of natural zeolite was transformed to Na-zeolite P (NaP zeolite) by a “top-down approach” hydrothermal reaction using 3 M of NaOH solution in a 96 °C oven. Time-dependent X-ray diffraction (XRD), Fourier-transform infrared (FT-IR), XRF, and scanning electron microscopy (SEM) analysis as well as kinetic, isotherm, and cation exchange capacity experiments were performed to understand the mechanism of mineral transition from natural zeolite to NaP zeolite. The XRD crystal peaks of the natural zeolite decreased (decrystallization phase) first, and then the NaP zeolite XRD crystal peaks increased gradually (recrystallization phase). From the XRF results, the dissolution rate of Si was slow in the recrystallization phase, while it was rapid in the decrystallization phase. The specific surface area measured by BET analysis was higher in NaP zeolite (95.95 m2/g) compared to that of natural zeolite (31.35 m2/g). Furthermore, pore structure analysis confirmed that NaP zeolites have more micropores than natural zeolite. In the kinetic experiment, the results showed that the natural zeolite and NaP zeolite were well matched with a pseudo-second-order kinetic model, and reached equilibrium within 24 h. The isotherm experiment results confirmed that both zeolites were well matched with the Langmuir isotherm, and the maximum removal capacity (Qmax) values of Sr and Ni were highly increased in NaP zeolite. In addition, the cation exchange capacity (CEC) experiment showed that NaP zeolite has an enhanced CEC of 310.89 cmol/kg compared to natural zeolite (CEC = 119.19 cmol/kg). In the actual batch sorption test, NaP zeolite (35.3 mg/g) still showed high Cs removal efficiency though it was slightly lower than the natural zeolite (39.0 mg/g). However, in case of Sr and Ni, NaP zeolite (27.9 and 27.8 mg/g, respectively) showed a much higher removal efficiency than natural zeolite (4.9 and 5.5 mg/g for Sr and Ni, respectively). This suggests that NaP zeolite, synthesized by a top-down desilication method, is more practical to remove mixed radionuclides from a waste solution.

Preparation and adsorption properties of Ni(ii) ion-imprinted polymers based on synthesized novel functional monomer

In this study, a novel functional monomer N-(1-(2,4-difluorophenyl)-2-(1H-1,2,4-triazol-1-yl)ethyl)acrylamide (NDTEA) was designed and synthesized, and was used to prepare Ni(ii) ion-imprinted polymers (Ni(ii)-IIPs). Sixteen kinds of Ni(ii)-IIP (Ni(ii)-IIP1–16) and corresponding non-imprinted polymers (NIP1–16) were prepared by precipitation polymerization method. After optimized condition experiment, Ni(ii)-IIP5 possessed maximum adsorption capacity and better imprinting factor under optimal experimental conditions which indicated by equilibrium adsorption experiments. The morphology and structural characteristics of Ni(ii)-IIP5 were characterized by scanning electron microscopy (SEM) and Brunauer–Emmett–Teller (BET). The adsorption selectivity of Ni(ii)-IIP5 was analyzed by ICP-OES, and the results showed that Ni(ii)-IIP5 had favorable selectivity recognition ability for Ni(ii) when Cu(ii), Co(ii), and Cd(ii) are used as competitive ions. The kinetic experiment indicated that the performance of Ni(ii) adsorption on the surface of Ni(ii)-IIP5 obeyed the pseudo-first-order model, and adsorption equilibrium was attained after 15 min. Isothermal adsorption process fitted to Langmuir and Freundlich isothermal adsorption models, simultaneously. The results showed that Ni(ii)-IIP5 prepared by using a new functional monomer had better permeation selectivity and higher affinity for Ni(ii), which also verified the rationality of the functional monomer design. At the same time, it also provided a broad application prospect for removal of Ni(ii) in complex samples.

Early transcriptional response to gravistimulation in poplar without phototropic confounding factors

Background and Aims In response to gravistimulation under anisotropic light, tree stems showing an active cambium produce reaction wood that redirects the axis of the trees. Several studies have described transcriptomic or proteomic models of reaction wood relative to the opposite wood. However, the mechanisms leading to the formation of reaction wood are difficult to decipher because so many environmental factors can induce various signaling pathways leading to this developmental reprogramming. Using an innovative isotropic device where the phototropic response does not interfere with gravistimulation we characterized the early molecular responses occurring in the stem of poplar after gravistimulation in an isotropic environment, and without deformation of the stem. Methods After 30 minutes tilting at 35° under anisotropic light, we collected the upper and lower xylems from the inclined stems. Controls were collected from vertical stems. We used a microarray approach to identify differentially expressed transcripts. High throughput real-time PCR allowed a kinetic experiment at 0, 30, 120 and 180 minutes after tilting at 35°, with candidate genes. Key Results We identified 668 differentially expressed transcripts, from which we selected 153 candidates for additional fluidigm qPCR assessment. Five candidate co-expression gene clusters have been identified after the kinetic monitoring of the expression of candidate genes. Gene-ontology analyses indicate that molecular reprogramming of processes such as “wood cell expansion”, “cell wall reorganization” and “programmed cell death” occur as early as 30 minutes after gravistimulation. Of note is that the change in the expression of different genes involves a fine regulation of gibberellin and brassinosteroid pathways as well as flavonoid and phosphoinositide pathways. Conclusions Our experimental setup allowed the identification of genes regulated in early gravitropic response without the bias introduced by phototropic and stem bending responses.

Using corncob-based biochar to intercept BTEX in stormwater filtration systems

A biochar material made from corncobs was tested for its capability in BTEX adsorption/interception in stormwater filtration systems. Batch experiments were conducted to examine the adsorption kinetics, adsorption isotherms, and adsorption thermodynamics of BTEX onto this biochar. The feasibility of applying this biochar in stormwater filtration was studied by dynamic transport experiments and model simulations. The result showed that this biochar can adsorb BTEX and the adsorption is a thermodynamically spontaneous, and endothermic process. The BTEX adsorption kinetic experiment and adsorption retarded BTEX transport experiment indicated that the BTEX adsorption kinetics can be changed by the driving force between the BTEX concentrations and the active adsorption site as well as the contact time between BTEX and the biochar. In terms of applying this biochar in stormwater filtration, the Monte Carlo uncertainty analysis indicated that the BTEX interception is sensitive to the hydraulic conductivity of the biochar filter and the adsorption kinetics of the biochar material. Although this corncob-made biochar demonstrated effective pollutant adsorption capability, the biochar adsorption capability should be utilized to retain the pollutant long enough for biodegradation to take effect for ultimate pollutant attenuation.

Comparative Pathology of Domestic Pigs and Wild Boar Infected with the Moderately Virulent African Swine Fever Virus Strain “Estonia 2014”

Endemically infected European wild boar are considered a major reservoir of African swine fever virus in Europe. While high lethality was observed in the majority of field cases, strains of moderate virulence occurred in the Baltic States. One of these, “Estonia 2014”, led to a higher number of clinically healthy, antibody-positive animals in the hunting bag of North-Eastern Estonia. Experimental characterization showed high virulence in wild boar but moderate virulence in domestic pigs. Putative pathogenic differences between wild boar and domestic pigs are unresolved and comparative pathological studies are limited. We here report on a kinetic experiment in both subspecies. Three animals each were euthanized at 4, 7, and 10 days post infection (dpi). Clinical data confirmed higher virulence in wild boar although macroscopy and viral genome load in blood and tissues were comparable in both subspecies. The percentage of viral antigen positive myeloid cells tested by flow cytometry did not differ significantly in most tissues. Only immunohistochemistry revealed consistently higher viral antigen loads in wild boar tissues in particular 7 dpi, whereas domestic pigs already eliminated the virus. The moderate virulence in domestic pigs could be explained by a more effective viral clearance.

Comparative Pathology of Domestic Pigs and Wild Boar Infected with the Moderately Virulent African Swine Fever Virus Strain “Estonia 2014”

Endemically infected European wild boar are considered a major reservoir of African swine fever virus in Europe. While high lethality was observed in the majority of field cases, strains of moderate virulence occurred in the Baltic States. One of these, “Estonia 2014”, led to a higher number of clinically healthy, antibody-positive animals in the hunting bag of North-Eastern Estonia. Experimental characterization showed high virulence in wild boar but moderate virulence in domestic pigs. Putative pathogenic differences between wild boar and domestic pigs are unresolved and comparative pathological studies are limited. We here report on a kinetic experiment in both subspecies. Three animals each were euthanized at 4, 7 and 10 days post infection (dpi). Clinical data confirmed higher virulence in wild boar although macroscopy and viral genome load in blood and tissues were comparable in both subspecies. The percentage of viral antigen positive myeloid cells tested by flow cytometry did not differ significantly in most tissues. Only immunohistochemistry revealed consistently higher viral antigen loads in wild boar tissues in particular 7 dpi, whereas domestic pigs already eliminated the virus. The moderate virulence in domestic pigs could be explained by a more effective viral clearance.

A Mild Method for Preparation of Highly Selective Magnetic Biochar Microspheres

We report the use of biochar and Fe3O4 nanoparticles as co-stabilizers for oil-in-water (o/w) Pickering emulsion. The emulsion is subsequently used to prepare magnetic tetracycline-imprinted biochar composite microspheres (MMIPMs) with good uniformity and high selectivity. The MMIPMs were characterized by scanning electron microscopy (SEM), Brunner-Emmet-Teller (BET) measurements, Fourier transform infrared spectrometry (FT-IR), X-ray diffraction (XRD), vibrating sample magnetometer (VSM) and thermogravimetry analysis (TGA). The adsorption properties of tetracycline to the MMIPMs were investigated using different adsorption experiments including adsorption kinetic experiment, equilibrium binding experiment, selectivity evaluation and competitive adsorption tests. The theoretical maximum adsorption capacity of the MMIPMs (15.45 mg g−1) was greater than that of the raw biochar (2.10 mg g−1) and non-imprinted biochar composite microspheres (3.39 mg g−1) for tetracycline. Further, the MMIPMs were used as adsorbent for magnetic solid phase extraction (SPE) for the extraction of tetracycline present in drinking water, milk, fish and chicken samples. Under optimal conditions, the results showed good recovery yield ranging from 88.41% to 106.29% with a relative standard deviation (RSD) ranging from 0.35% to 6.83%, respectively.

Coating phosphorus fertilizer with renewable natural polymers

Low phosphorus use efficiency (PUE) is one of the major reasons of poor production worldwide. Among the various approaches used to enhance PUE, polymer coated fertilizers are relatively a new concept. Its main advantages are that they dissolve slowly and release nutrients to plants gradually during the growing season. Keeping this in view, a study was performed in the laboratory to evaluate polymers coated monoammonium phosphate (MAP) to enhance PUE. Commercial MAP and MAP coated with biodegradable polymers with Krafit black liquor (BL) and cellulose acetate (CA) in the concentration (0.5, 1.0, 2.0 wt % coating). The effectiveness of these coatings was assessed by the electrical conductivity (EC) and phosphorus release (PR) in a kinetic experiment. The kinetic study was carried out in a controlled environment (± 25 °C), following the release pattern of P from 1.5 g of fertilizer in 50 mL of H2O, with and without the coatings. The objective of this work was to study different lignin-based coatings and the phosphorus release behavior of the resulting fertilizer. EC showed to be an effective method of indirect analysis of P releasing from coated MAP. The BL coating presented better results than the CA in terms of controlling the release of P, and the higher the coating ratio (1.0 and 2.0 %) the slower the release of P.