Square-Wave Voltammetric Sensing of Lawsone (2- Hydroxy-1,4-Naphthoquinone) Based on the Enhancement Effect of Cationic Surfactant on Anodically Pretreated Boron-Doped Diamond Electrode

In this reported work, an anodically pretreated boron-doped diamond (BDD) electrode was used for the inexpensive, simple and quick detection of a natural dye, lawsone. Lawsone had a well-defined, irreversible and diffusion-controlled oxidation peak at approximately +0.19 V in phosphate buffer solution (PBS, 0.1 M, pH 2.5) using cyclic voltammetry (CV). The oxidation peak heights of lawsone were significantly increased in PBS using the cationic surfactant cetyltrimethylammonium bromide (CTAB). Under optimized experimental conditions, the calibration curve was linear over a concentration range of 0.1–5.0 μM with detection limit of 0.029 μM in 0.1 M PBS (pH 2.5) containing 0.1 mM CTAB by using square-wave voltammetry (SWV). To evaluate the practical applicability of the BDD electrode, it was used for the quantification of lawsone in commercial henna, a natural dye made from the leaves of the henna plant.

Efficient Sub-1 Minute Analysis of Selected Biomarker Catecholamines by Core-Shell Hydrophilic Interaction Liquid Chromatography (HILIC) with Nanomolar Detection at a Boron-Doped Diamond (BDD) Electrode

A rapid, sensitive method for the separation of catecholamine biomarkers (CAs), of importance in traumatic brain injury (TBI) and in Parkinson’s disease (PD), has been successfully developed using hydrophilic interaction liquid chromatography (HILIC). Dopamine (DA), epinephrine (EPI), and norepinephrine (NE) are known to be three to fivefold elevated above normal in traumatic brain injury (TBI) patients. HILIC facilitates the rapid and efficient separation of these polar biomarkers, which can be poorly retained by reversed-phase liquid chromatography (RPLC), while electrochemical detection (ECD) at the boron-doped diamond (BDD) electrode provides enhanced nanomolar detection. Three HILIC columns were compared, namely the superficially porous (core-shell) Z-HILIC column and the Z-cHILIC and Z-HILIC fully porous columns. The core-shell Z-HILIC showed the highest efficiency with a rapid separation within 60 s. The HILIC method utilizing the core-shell Z-HILIC column was initially optimized for the simultaneous analysis of DA, EPI, and NE using UV detection. The advantages of using the BDD electrode over UV detection were explored, and the improved limits of detection (LODs, S/N = 3) measured were 40, 50, and 50 nM for DA, EPI, and NE, respectively. Method validation is reported in terms of the linearity, repeatability, reproducibility, and LODs. Furthermore, the proposed method was successfully applied to the real sample analysis of urinary CAs following phenylboronic acid (PBA) solid phase extraction (SPE) pretreatment.

Graphene Oxide Electroreduced onto Boron-Doped Diamond and Electrodecorated with Silver (Ag/GO/BDD) Electrode for Tetracycline Detection in Aqueous Solution

A new electrochemical sensor designed by modifying the commercial boron-doped diamond (BDD) electrode with graphene oxide (GO) reduced electrochemically and further electrodecorated with silver (Ag), named the Ag/GO/BDD electrode, was selected among a series of the BDD, GOelectroreduced onto BDD (GO/BDD) and silver electrodeposited onto BDD (Ag/BDD) electrodes for the detection of tetracycline (TC) in aqueous solution. The best results regarding the sensitivity of 46.6 µA·µM−1·cm−2 and the lowest limit of detection of 5 nM was achieved using square-wave voltammetry (SWV) operated at the step potential of 5 mV, modulation amplitude of 200 mV and the frequency of 10 Hz in alkaline medium. The application of the alkaline supporting electrolyte-based procedure is limited for water monitoring due to the presence of chloride that interferes with TC detection; however, it can be applied for quantitative determination of pharmaceutical formulations. 0.1 M Na2SO4 supporting electrolyte eliminated chloride interference and can be used for the application of Ag/GO/BDD in practical detection of TC in water.

Electrooxidation of the Paracetamol on Boron Doped Diamond Anode Modified by Gold Particles

The environment pollution, in particular that of the aquatic environment, by wastewater is a reality because it is discharged for the most part without treatment. The presence of pharmaceutical pollutants such as paracetamol in these waters can constitute a risk to human health. The objective of this work is to study the electrochemical oxidation of paracetamol using cyclic voltammetry on the boron doped diamond (BDD) anode and boron doped diamond modified by gold particles (Au-BDD) anode. The Au-BDD electrode was obtained by modifying the surface of BDD with gold particles. This was done by electrodeposition (chronoamperometry) in 0.5 M HAuCl4 and 0.1 M H2SO4 using a three pulse nucleation and growth process. Physical characterization with Scanning Electron Microscopy coupled with Dispersive Energy spectroscopy has shown that the Au-BDD surface presents asperities with the presence of microparticles and nanoparticles. The electrochemical characterization made in three electrolytic solutions (H2SO4, NaOH and KClO4) showed that Au-BDD has a high electroactivity domain than that of BDD. The study of the Benzoquinone-hydroquinone redox couple has shown a quasi-reversible character of these two anodes. It also revealed that Au-BDD has a more accentuated metallic character than BDD. The voltammetric measurements made it possible to show that the paracetamol oxidation is limited by the transport of material on each anode. This oxidation is characterized by the presence of an anodic peak in the support electrolytes stability domain. The paracetamol oxidation is rapid on Au-BDD than on BDD in the various medium explored, thus showing that Au-BDD is more efficient than BDD for the paracetamol oxidation by electrochemical means.