Optimization of the Guide Design of MIRACLES, the Neutron Time-of-Flight Backscattering Spectrometer at the European Spallation Source

To boost the science case of MIRACLES, the time-of-flight backscattering spectrometer at the European Spallation Source (ESS), an optimized neutron guide system, is proposed. This systematic study resulted in an enhancement in the transport of cold neutrons, compared with the previous conceptual design, with wavelengths ranging from λ = 2 Å to 20 Å along the 162.5-m distance from source to sample. This maintained the undisturbed main focus of the instrument, viz, to carry out quasielastic and inelastic neutron scattering (QENS and INS) experiments on a large dynamic range and for both energy-gain and energy-loss sides. To improve the collection of cold neutrons from the source and direct them to the sample position, the vertical geometry was adjusted to an adapted version of a ballistic elliptical profile. Its horizontal geometry was conceived to: (i) keep the high-resolution performance of the instrument, and (ii) minimize the background originating from fast and thermal neutrons. To comply with the first requirement, a narrow guide section at the pulse shaping chopper position has been implemented. To fulfil the second, a curved guide segment has been chosen to suppress neutrons with wavelengths λ < 2 Å. Subsequent tailoring of the phase space provided an efficient transport of cold neutrons along the beamline to reach a 3 × 3 cm2 sample. Finally, additional calculations were performed to present a potential upgrade, with the exchange of the final segment, to focus on samples of approximately 1 × 1 cm2; the proposal anticipates a flux increase of 70% in this 1 cm2 sample area.

Searches for Exotic Interactions Using Neutrons

Slow neutrons possess several advantageous properties which make them useful probes for a variety of exotic interactions, including some that can form at least some components of the dark matter of interest for this issue of Symmetry. We discuss the relevant neutron properties, describe some of the recent work that has been done along these lines using neutron experiments mainly with cold and ultra-cold neutrons, and outline some interesting and exciting opportunities which can be pursued using resonant epithermal neutron interactions in heavy nuclei.

Effect of Particle Sizes on the Efficiency of Fluorinated Nanodiamond Neutron Reflectors

Over a decade ago, it was confirmed that detonation nanodiamond (DND) powders reflect very cold neutrons (VCNs) diffusively at any incidence angle and that they reflect cold neutrons quasi-specularly at small incidence angles. In the present publication, we report the results of a study on the effect of particle sizes on the overall efficiency of neutron reflectors made of DNDs. To perform this study, we separated, by centrifugation, the fraction of finer DND nanoparticles (which are referred to as S-DNDs here) from a broad initial size distribution and experimentally and theoretically compared the performance of such a neutron reflector with that from deagglomerated fluorinated DNDs (DF-DNDs). Typical commercially available DNDs with the size of ~4.3 nm are close to the optimum for VCNs with a typical velocity of ~50 m/s, while smaller and larger DNDs are more efficient for faster and slower VCN velocities, respectively. Simulations show that, for a realistic reflector geometry, the replacement of DF-DNDs (a reflector with the best achieved performance) by S-DNDs (with smaller size DNDs) increases the neutron albedo in the velocity range above ~60 m/s. This increase in the albedo results in an increase in the density of faster VCNs in such a reflector cavity of up to ~25% as well as an increase in the upper boundary of the velocities of efficient VCN reflection.

Tailoring neutron beam properties by target-moderator-reflector optimisation

Compact accelerator-driven neutron sources allow to operate multiple optimised target-moderator-reflector (TMR) units adapted to the requirements of the respective instruments. The compact design of the TMR units allows an efficient coupling of neutron production, neutron moderation and extraction, but requires a novel way of optimisation. The neutronic performance of different TMR units based on polyethylene, heavy water and a mixture of heavy and light water moderators together with Pb and Be reflectors and a borated polyethylene absorber is discussed. Extraction channels for thermal and cold neutrons are investigated regarding the energy and time spectra.

Neutron Imaging Using a Fine-Grained Nuclear Emulsion

A neutron detector using a fine-grained nuclear emulsion has a sub-micron spatial resolution and thus has potential to be applied as high-resolution neutron imaging. In this paper, we present two approaches to applying the emulsion detectors for neutron imaging. One is using a track analysis to derive the reaction points for high resolution. From an image obtained with a 9 μm pitch Gd grating with cold neutrons, periodic peak with a standard deviation of 1.3 μm was observed. The other is an approach without a track analysis for high-density irradiation. An internal structure of a crystal oscillator chip, with a scale of approximately 30 μm, was able to be observed after an image analysis.

Using Pulsed Cold Neutrons to Measure Neutron Lifetime

Scientists measure the lifetime of a neutron with pulsed neutron beams to explore the cause of a puzzling discrepancy in their previously measured lifetime.

Neutron lifetime measurement with pulsed cold neutrons

The neutron lifetime has been measured by comparing the decay rate with the reaction rate of 3He nuclei of a pulsed neutron beam from the spallation neutron source at the Japan Proton Accelerator Research Complex (J-PARC). The decay rate and the reaction rate were determined by simultaneously detecting electrons from the neutron decay and protons from the 3He(n, p) 3H reaction using a gas chamber of which working gas contains diluted 3He. The measured neutron lifetime was 898 ± 10stat+15−18sys s.

Non-static surfaces in MCNPX: The chopper extension1

Rotating objects, such as choppers, are common components of a neutron beamline, and the motion of these components is not described in the static geometry of an MCNPX model. The special case of non-static surfaces for rotation about a stationary point in space has been developed for MCNPX. In addition, velocity dependent kinematics due to the motion of the medium have been implemented. This implementation allows for the simulation of rotating objects at speeds comparable to the velocity of cold neutrons. Applications of the chopper extension will be discussed, including the direct simulation of a bandwidth chopper system, the thermalization of neutrons inside a spinning material, and the discussion of the implementation of a spinning single crystal.

Development of high intensity neutron source at the European Spallation Source

The European Spallation Source being constructed in Lund, Sweden will provide the user community with a neutron source of unprecedented brightness. By 2025, a suite of 15 instruments will be served by a high-brightness moderator system placed above the spallation target. The ESS infrastructure, consisting of the proton linac, the target station, and the instrument halls, allows for implementation of a second source below the spallation target. We propose to develop a second neutron source with a high-intensity moderator able to (1) deliver a larger total cold neutron flux, (2) provide high intensities at longer wavelengths in the spectral regions of Cold (4–10 Å), Very Cold (10–40 Å), and Ultra Cold (several 100 Å) neutrons, as opposed to Thermal and Cold neutrons delivered by the top moderator. Offering both unprecedented brilliance, flux, and spectral range in a single facility, this upgrade will make ESS the most versatile neutron source in the world and will further strengthen the leadership of Europe in neutron science. The new source will boost several areas of condensed matter research such as imaging and spin-echo, and will provide outstanding opportunities in fundamental physics investigations of the laws of nature at a precision unattainable anywhere else. At the heart of the proposed system is a volumetric liquid deuterium moderator. Based on proven technology, its performance will be optimized in a detailed engineering study. This moderator will be complemented by secondary sources to provide intense beams of Very- and Ultra-Cold Neutrons.