Investigating formulation of honey beverages (honey beer and liqueur)

Beverages containing alcohol are fermented from the sugars in fruits, berries, grains, and such other ingredients as plant saps, tubers, honey, and milk and may be distilled to reduce the original watery liquid to a liquid of much greater alcoholic strength. Fermented honey drinks may have been the earliest alcoholic beverages known to man. The aim of this work was to contribute to filling the gap of low brewing technology knowledge and scientific knowledge for an innovative application of honey in the beer and liquors industry. In this study honey beverages were formulated using different amount of honey with spices, yeast, hop, fruit, alcohol with different alcohol contents, herbs like cinnamon, clove, ginger, vanilla, fruits and maize and finger millet grain ingredients. Quality assessment of the products were assessed concerning physicochemical analysis, microbiological analysis, sensory evaluation of the formulations, estimation of shelf-life and cost and yield of the products to characterize the honey beverages three different liquors and nine beer beverages produced from honey and other different ingredients. The pH, total acidity, total soluble solid and ethyl acohol contents of the formulated honey beverages were range from 3.8±0.03 to 6.1±0.010, 1.63±0.06 to 21.0±1.63, 21.30±0.56 to 36.87±0.50 and 4.81±0.17 % to 44.10±0.50 %, respectively. Liquors and beers can be formulated from honey and other ingredients to involve unemployed young as entrepreneurs to increase their income. Keywords: Honey Beverages; Honey Beer; Honey Liquor; Sensory; Physicochemical; Microbiological properties

Sorting Liquid Droplets by Surface Tension Using Devices with Quasi-Superamphiphobic Coatings

Any solid surface with homogenous or varying surface energy can spontaneously show variable wettability to liquid droplets with different or identical surface tensions. Here, we studied a glass slide sprayed with a quasi-superamphiphobic coating consisting of a hexane suspension of perfluorosilane-coated nanoparticles. Four areas on the glass slide with a total length of 7.5 cm were precisely tuned via ultraviolet (UV) irradiation, and droplets with surface tensions of 72.1–33.9 mN m−1 were categorized at a tilting angle of 3°. Then, we fabricated a U-shaped device sprayed with the same coating and used it to sort the droplets more finely by rolling them in the guide groove of the device to measure their total rolling time and distance. We found a correlation between ethanol content/surface tension and rolling time/distance, so we used the same device to estimate the alcoholic strength of Chinese liquors and to predict the surface tension of ethanol aqueous solutions.

Chemical Characterization of Craft Filuferru Spirit from Sardinia, Italy

Traditional Filuferru is an ancient spirit from Sardinia, Italy, which is usually obtained from the distillation of wine or grape marc. In this contribution, the results of the first chemical characterization of a wide number of crafts Filuferru samples has been accomplished in terms of an evaluation of the alcoholic strength, qualitative and quantitative gas-chromatography–mass spectrometry (GC-MS) analysis of the volatile composition of the distillate, and its trace element composition by means an inductively coupled plasma–mass spectrometry (ICP-MS) method. Both instrumental methods have been validated and applied on 21 craft samples of Filuferru, whereas one sample of commercial distillate has been analyzed for comparison purposes. Alcoholic strength ranged between 41.0 and 62.4% (v/v). Sixty volatile compounds were identified and ten of them have been quantified. Analogies and differences with Grappa (i.e., the Italian distilled spirit closer to Filuferru) have been highlighted in the qualitative and quantitative profile of this matrix. Often meaningful amounts of acetaldehyde, ethyl acetate, dietyl acetal, and acetic acid were measured. Elemental analysis, performed on toxic, non-toxic elements, and oligoelements, 18 in total, revealed a wide variability of concentrations in both analytes and samples. High concentrations of Cu are sometimes evidenced, which are likely caused by losses from the distillation apparatus. The principal components analysis (PCA) allowed the differentiation of the ten volatile compounds quantified in two groups: the former, as described mainly by PC1, constituted by acetic acid, ethyl acetate, dietyl acetal, and acetaldehyde, and the second, described by PC2, constituted by 1-propanol, 2-methyl-1-propanol, the two coeluiting isomers 2-methyl-1-butanol and 3-methyl-1-butanol,1-hexanol, 2-phenylethanol, and 2,3-butanediol. Data obtained may be useful in order to establish a regulation for the production of high-quality traditional Filuferru from Sardinia.

Chemical characterization of craft Filuferru spirit from Sardinia, Italy

Traditional Filuferru is an ancient spirit from Sardinia, Italy, usually obtained from the distillation of wine or grape marc. In this contribution, the results of the first chemical characterization of a wide number of craft Filuferru samples has been accomplished in terms of evaluation of the alcoholic strength, qualitative and quantitative GC-MS analysis of the volatile composition of the distillate, and its trace element composition by means a ICP-MS method. Both instrumental methods have been validated and applied on 21 craft samples of Filuferru, whereas one sample of commercial distillate has been analyzed for comparison purposes. Alcoholic strength ranged between 41.0 and 62.4% (v/v). Sixty volatile compounds were identified and ten of them have been quantified. Analogies and differences with Grappa (i.e. the Italian distilled spirit most close to Filuferru) have been highlighted in the qualitative and quantitative profile of this matrix. Often meaningful amounts of acetaldehyde, ethyl acetate, dietyl acetal and acetic acid were measured. Elemental analysis, performed on toxic, non-toxic elements and oligoelements, 18 in total, revealed a wide variability of concentrations in both analytes and samples. High concentrations of Cu are sometimes evidenced, likely caused by losses from the distillation apparatus. The principal components analysis (PCA) allowed the differentiation of the ten volatile compounds quantified in two groups: the former, described mainly by PC1, constituted by acetic acid, ethyl acetate, dietyl acetal and acetaldehyde, and the second, described by PC2, constituted by 1-propanol, 2-methyl-1-propanol, the two coeluiting isomers 2-methyl-1-butanol and 3-methyl-1-butanol,1-hexanol, 2-phenylethanol and 2,3-butanediol. Data obtained may be useful in order to establish a regulation for the production of high-quality traditional Filuferru from Sardinia.

Studies Regarding the Main Compositional Parameters and Some Volatile Compounds in Spirits from Iaşi Vineyard

The distillates obtained from wine, both raw and aged, are highly appreciated alcoholic beverages due to the refinement and fineness that characterizes them. Romania’s viticultural conditions are very favourable for these products - which in the last centuries have made regions such as Cognac and Armagnac in France famous. In Romania the aged distillate of wine is called “vinars” and in the Republic of Moldova it is named “divin”. This study analyses how the main compositional parameters and volatile compounds are influenced by the raw material wine, distillation technology, distillation steps, removal of the lower-quality fractions (heads and tails). The raw material used to make the distillates was a mixture of two wines of Fetească albă and Fetească regală, harvest of 2015, from Iasi vineyard. The proposed experimental protocol consisted of the double distillation of a volume of 1000 L of raw material. For the distillation, a simple copper distillery with a deflector was used. From each 10 L of distillate obtained, samples were taken and analysed via gas-chromatography.In the first and second distillation, the largest amounts of acetic acid are found in the head. The highest concentrations of octanoic acid are recorded in tails, as does hexanoic acid. The product obtained after the first distillation recorded an average alcoholic strength of 33.5% vol, which increased after the second distillation, so that the final distillate has an alcoholic strength of 58.5% vol. Concerning the acid profile, the following can be concluded: Acetic acid can be considerably diminished with the removal of the head fractions; Octanoic, hexanoic and decanoic acids fall into the class of short chain fatty acids, can affect the organoleptic qualities but are easily esterify the resulting compounds giving pleasing odour; aging in oak or mulberry wood barrels of crude distillates to achieve the maximum potential is recommended.

High Ethanol Contents of Spirit Drinks in Kibera Slums, Kenya: Implications for Public Health

Cheap licit and artisanal illicit spirit drinks have been associated with numerous outbreaks of alcohol poisoning especially with methanol. This study aimed to evaluate the quality of cheap spirit drinks in Kibera slums in Nairobi County, Kenya. The samples consisted of cheap licit spirits (n=11) and the artisanal spirit drink, ‘chang’aa’, (n=28). The parameters of alcoholic strength and volatile composition were used as indicators of quality and were determined using GC-FID and GC-MS respectively. The pH of chang’aa was 3.3-4.2 and 4.4-8.8 for licit spirit drinks while ranges for alcoholic strength were 42.8-85.8 % vol. and 28.3-56.7% vol. for chang’aa and licit spirit drinks respectively. The majority of volatiles were found in artisanal spirits and they included higher alcohols, ethyl esters and carbonyl compounds. The alcoholic strength of all the artisanal spirits (100%) and 91% of the licit spirits was above the 40% vol. of standard spirits such as vodka. The high ethanol content of the alcohol products was the only element of public health significance in this study.