Сomposition, structure and functional properties of silver-tungsten composition electrochemistry coatings formed with the help of ultrasound

Influence of electrolyte composition and deposition parameters on the composition, structure, physicalmechanical and functional properties of composite silver-tungsten coatings was studied. It was shown that addition of sodium tungstate in electrolyte and application of ultrasound at the electroplating leads to formation of silver layers that contains tungsten oxides and demonstrates lower crystalline nucleus. Application of ultrasound vibration at the electrochemical deposition increases ability for plating process control and allows to optimize electrophysical and functional properties of composite electrochemical coatings, to make dense fine crystalline thin layers. Obtained layers demonstrate increased microhardness (by 10–50 %), wear resistance (1,5–2 times), corrosion resistance and improved contact electrical resistance. It is shown that application of ultrasound effect to electrodeposition allows increased level of permissible current density and provides.

Opportunities of striation-free crystal growth with ultrasound effect

The main condition for elimination of growth striations is the formation of standing waves in the melt for damping of convection. The formation of standing waves between the crucible bottom...

Low-Intensity Pulsed Ultrasound Effect on MIO-M1 Cell Viability: Setup Validation and Standing Waves Analysis

Low-intensity pulsed ultrasound (LIPUS) has been proposed for novel therapies still under study, where similar parameters and protocols have been used for producing opposite effects that range from increasing cell viability to provoking cell death. Those divergent outcomes make the generalization of expected effects difficult for cell models not yet studied. This paper presents the effect of LIPUS on the viability of the MIO-M1 cell line for two well-established setups and different protocols; the acoustic intensities, duty factors, and treatment duration were varied. Measurements and models for acoustic and thermal analysis are included for proposing a solution to improve the reproducibility of this kind of experiments. Results indicate that MIO-M1 viability is less affected for the cells treated through a dish that is partially immersed in water; in these conditions, the cells neither show detrimental nor proliferative effects at intensities lower than 0.4 W/cm2 at 20% duty factor. However, cell viability was reduced when LIPUS was followed by cell subculturing. Treating the cells through a gel, with the culture dish placed on the transducer, increases cell mortality by the production of standing waves and mixed vibration-acoustical effects. Using the water-based setup with a 1° dish inclination reduces the effects of standing waves.

Use of ultrasound for cleaning of components of historical vehicles in Technical Museum in Brno

In the collections of Technical Museum in Brno, large number of historical vehicles is placed. During the operation, parts of their motors are being fouled. Frequently, they become even immobile (e. g. due to a fouled fuel system). In this case, the method using ultrasound with a suitable concentrate appears as the most suitable. In fact, ultrasound works also in inaccessible places with large efficiency. Not only the chosen solution influences the cleaning efficiency, but also parameters as time, bath temperature and ultrasound frequency. The cleaning process was evaluated according to the volume of removed dirt and by observing wettability change using the measuring of contact angle of a water drop. The ultrasound shock waves influence the surface to a certain extent also mechanically. That is why, the ultrasound effect on defects in the structure was observed. The aggressivity of cleaning concentrates was evaluated on the ground of determination of dissolved metals in the baths by ET AAS method.