Methods and Instruments in Fermentation Gas Analysis

Biotechnology ◽  
2008 ◽  
pp. 27-74 ◽  
Author(s):  
Elmar Heinzle ◽  
Irving J. Dunn
Keyword(s):  
1912 ◽  
Vol 74 (1914supp) ◽  
pp. 159-160
Author(s):  
Lawford H. Fry
Keyword(s):  
Flue Gas ◽  

2014 ◽  
Vol 17 (3) ◽  
pp. 154 ◽  
Author(s):  
Arıtürk Cem ◽  
Ustalar Serpil ◽  
Toraman Fevzi ◽  
Ökten Murat ◽  
Güllü Ümit ◽  
...  

<p><strong>Introduction:</strong> Clear guidelines for red cell transfusion during cardiac surgery have not yet been established. The current focus on blood conservation during cardiac surgery has increased the urgency to determine the minimum safe hematocrit for these patients. The aim of this study was to determine whether monitoring of cerebral regional oxygen saturation (rSO<sub>2</sub>) via near-infrared spectrometry (NIRS) is effective for assessing the cerebral effects of severe dilutional anemia during elective coronary arterial bypass graft surgery (CABG).</p><p><strong>Methods:</strong> The prospective observational study involved patients who underwent cerebral rSO<sub>2</sub> monitoring by NIRS during elective isolated first-time CABG: an anemic group (<em>N</em>=15) (minimum Hemoglobin (Hb) N=15) (Hb &gt;8 g/dL during CPB). Mean arterial pressure (MAP), pump blood flow, blood lactate level, pCO<sub>2</sub>, pO<sub>2</sub> at five time points and cross-clamp time, extracorporeal circulation time were recorded for each patient. Group results statistically were compared.</p><p><strong>Results:</strong> The anemic group had significantly lower mean preoperative Hb than the control group (10.3 mg/dL versus 14.2 mg/dL; <em>P</em> = .001). The lowest Hb levels were observed in the hypothermic period of CPB in the anemic group. None of the controls exhibited a &gt;20% decrease in cerebral rSO<sub>2</sub>. Eleven (73.3%) of the anemic patients required an increase in pump blood flow to raise their cerebral rSO<sub>2</sub>.</p><p><strong>Conclusions:</strong> In this study, the changes in cerebral rSO<sub>2</sub> in the patients with low Hb were within acceptable limits, and this was in concordance with the blood lactate levels and blood-gas analysis. It can be suggested that NIRS monitoring of cerebral rSO<sub>2</sub> can assist in decision making related to blood transfusion and dilutional anemia during CPB.</p>


Author(s):  
G.G. Khubulava ◽  
A.B. Naumov ◽  
S.P. Marchenko ◽  
O.Yu. Chupaeva ◽  
A.A. Seliverstova ◽  
...  

1997 ◽  
Author(s):  
Q. He ◽  
Pon Ponnappan ◽  
J. Brown ◽  
Q. He ◽  
Pon Ponnappan ◽  
...  

2020 ◽  
Author(s):  
Paul Kitz ◽  
Matthew Lacey ◽  
Petr Novák ◽  
Erik Berg

<div>The electrolyte additives vinylene carbonate (VC) and fluoroethylene carbonate (FEC) are well known for increasing the lifetime of a Li-ion battery cell by supporting the formation of an effective solid electrolyte interphase (SEI) at the anode. In this study combined simultaneous electrochemical impedance spectroscopy (EIS) and <i>operando</i> electrochemical quartz crystal microbalance with dissipation monitoring (EQCM-D) are employed together with <i>in situ</i> gas analysis (OEMS) to study the influence of VC and FEC on the passivation process and the interphase properties at carbon-based anodes. In small quantities both additives reduce the initial interphase mass loading by 30 to 50 %, but only VC also effectively prevents continuous side reactions and improves anode passivation significantly. VC and FEC are both reduced at potentials above 1 V vs. Li<sup>+</sup>/Li in the first cycle and change the SEI composition which causes an increase of the SEI shear storage modulus by over one order of magnitude in both cases. As a consequence, the ion diffusion coefficient and conductivity in the interphase is also significantly affected. While small quantities of VC in the initial electrolyte increase the SEI conductivity, FEC decomposition products hinder charge transport through the SEI and thus increase overall anode impedance significantly. </div>


Author(s):  
S. A. Sadovnikov

Introduction: Successful monitoring of environmental parameters requires the development of flexible software complexes with evolvable calculation functionality. Purpose: Developing a modular system for numerical simulation of atmospheric laser gas analysis. Results: Based on differential absorption method, a software system has been developed which provides the calculation of molecular absorption cross-sections, molecular absorption coefficients, atmospheric transmission spectra, and lidar signals. Absorption line contours are calculated using the Voigt profile. The prior information sources are HITRAN spectroscopic databases and statistical models of the distribution of temperature, pressure and gas components in the atmosphere. For modeling lidar signals, software blocks of calculating the molecular scattering coefficient and aerosol absorption/scattering coefficients were developed. For testing the applicability of various laser sources in the problems of environmental monitoring of the atmosphere, a concentration reconstruction error calculation block was developed for the atmospheric gas components, ignoring the interfering absorption of laser radiation by foreign gases. To verify the correct functioning of the software, a program block was developed for comparing the results of the modeling of atmospheric absorption and transmission spectra by using the standard SPECTRA information system. The discrepancy between the calculation of the atmospheric transmission spectra obtained using the developed system as compared to the SPECTRA results is less than 1%. Thus, a set of the presented program blocks allows you to carry out complex modeling of remote atmospheric gas analysis. Practical relevance: The software complex allows you to rapidly assess the possibilities of using a wide range of laser radiation sources for the problems of remote gas analysis.


Sign in / Sign up

Export Citation Format

Share Document