scholarly journals Computing Mass Transfer at Deformable Bubbles for High Schmidt Numbers

Author(s):  
Andre Weiner ◽  
Dirk Gründing ◽  
Dieter Bothe
1981 ◽  
Vol 46 (7) ◽  
pp. 1566-1576
Author(s):  
František Vašák ◽  
Václav Kolář ◽  
Zdeněk Brož

Theoretical relation derived in the last study for calculation of the mass transfer coefficient in the region of not fully developed concentration profile at high Schmidt numbers has been verified experimentally. This experimental study has been devoted to measurements of the rate of benzoic acid dissolution into aqueous solutions of glycerol from the internal surface of the pipe of circular cross section in the range 933 ⪬ Sc ⪬ 225 000 and 5 000 ⪬ Re ⪬ 50 000. It has been possible to explain on basis of the theoretical model, the differences between the data of various authors and to obtain a unified description of the phenomena.


2012 ◽  
Vol 550-553 ◽  
pp. 2014-2018
Author(s):  
Xiao Lan Zhou ◽  
Cai Xi Liu ◽  
Yu Hong Dong

Electrochemical mass transfer in turbulent flows and binary electrolytes is investigated. The primary objective is to provide information about mass transfer in the near-wall region between a solid boundary and a turbulent fluid flow at different Schmidt numbers. Based on the computational fluid dynamics and electrochemistry theories, a model for turbulent electrodes channel flow is established. The turbulent mass transfer in electrolytic processes has been predicted by the direct numerical simulation method under limiting current and galvanostatic conditions, we investigate mean concentration and the structure of the concentration fluctuating filed for different Schmidt numbers from 0.1 to 100 .The effect of different concentration boundary conditions at the electrodes on the near-wall turbulence statistics is also discussed.


2014 ◽  
Vol 744 ◽  
pp. 217-249 ◽  
Author(s):  
H. Herlina ◽  
J. G. Wissink

AbstractTo elucidate the physical mechanisms that play a role in the interfacial transfer of atmospheric gases into water, a series of direct numerical simulations of mass transfer across the air–water interface driven by isotropic turbulence diffusing from below has been carried out for various turbulent Reynolds numbers ($R_T=84,195,507$). To allow a direct (unbiased) comparison of the instantaneous effects of scalar diffusivity, in each of the DNS up to six scalar advection–diffusion equations with different Schmidt numbers were solved simultaneously. As far as the authors are aware this is the first simulation that is capable to accurately resolve the realistic Schmidt number, $\mathit{Sc}=500$, that is typical for the transport of atmospheric gases such as oxygen in water. For the range of turbulent Reynolds numbers and Schmidt numbers considered, the normalized transfer velocity $K_L$ was found to scale with $R_T^{-{1/2}}$ and $\mathit{Sc}^{-{1/2}}$, which indicates that the largest eddies present in the isotropic turbulent flow introduced at the bottom of the computational domain tend to determine the mass transfer. The $K_L$ results were also found to be in good agreement with the surface divergence model of McCready, Vassiliadou & Hanratty (AIChE J., vol. 32, 1986, pp. 1108–1115) when using a constant of proportionality of 0.525. Although close to the surface large eddies are responsible for the bulk of the gas transfer, it was also observed that for higher $R_T$ the influence of smaller eddies becomes more important.


2010 ◽  
Vol 133 (2) ◽  
Author(s):  
I. V. Shevchuk

The convective diffusion of feeding culture and the effect of fluid shear stress on endothelial cells are frequently investigated in cone-and-plate devices. Laminar fluid flow and heat and mass transfer in a cone-and-plate device, with cone apex touching the plate/disk, were simulated. The disk-to-cone gap made 1–5 deg. Transport equations were reduced to a system of self-similar ordinary differential equations solved numerically. Cases studied were a rotating cone and a stationary plate, and vice versa. The cone was isothermal, while the disk temperature followed a power-law radial distribution; boundary concentrations were constant. Prandtl and Schmidt numbers varied from 0.1 to 800. Temperature/diffusion profiles in the gap and Nusselt and Sherwood numbers exhibit different regimes of heat/mass transfer, depending on the disk surface temperature distribution.


1950 ◽  
Vol 17 (4) ◽  
pp. 399-408 ◽  
Author(s):  
Walton Forstall ◽  
Ascher H. Shapiro

Abstract The mixing at constant pressure of a circular jet with an annular coaxial stream has been studied for conditions of nearly common density and temperature, but differing initial velocities. By using 10 per cent by volume of helium as a tracer in the inner stream, the mixing region was mapped with respect to both material and momentum transfer. It is concluded that material diffuses more rapidly than momentum; that the principal independent variable determining the shape of the mixing region is the velocity ratio of the streams; and that the integral method of Squire and Trouncer, using experimentally determined constants, is adequate for predicting approximate values of concentration and velocity in the mixing region of a jet flowing into a moving medium of the same density. Data for widely different experiments of various investigators show that the turbulent Prandtl and the Schmidt numbers are both within ±10 per cent of 0.70, independent of the nature of the experiment and the magnitudes of the laminar Prandtl and Schmidt numbers.


Sign in / Sign up

Export Citation Format

Share Document