A p‐GaN‐Gated Hybrid Anode Lateral Diode with a Thicker AlGaN Barrier Layer

2020 ◽  
Vol 217 (7) ◽  
pp. 1900781
Author(s):  
Shuai Su ◽  
Yaozong Zhong ◽  
Yu Zhou ◽  
Hongwei Gao ◽  
Xiaoning Zhan ◽  
...  
2015 ◽  
Vol 2015 ◽  
pp. 1-6
Author(s):  
Yanli Liu ◽  
Xifeng Yang ◽  
Dunjun Chen ◽  
Hai Lu ◽  
Rong Zhang ◽  
...  

The temperature-dependent stress state in the AlGaN barrier layer of AlGaN/GaN heterostructure grown on sapphire substrate was investigated by ultraviolet (UV) near-resonant Raman scattering. Strong scattering peak resulting from the A1(LO) phonon mode of AlGaN is observed under near-resonance condition, which allows for the accurate measurement of Raman shifts with temperature. The temperature-dependent stress in the AlGaN layer determined by the resonance Raman spectra is consistent with the theoretical calculation result, taking lattice mismatch and thermal mismatch into account together. This good agreement indicates that the UV near-resonant Raman scattering can be a direct and effective method to characterize the stress state in thin AlGaN barrier layer of AlGaN/GaN HEMT heterostructures.


2011 ◽  
Vol 20 (9) ◽  
pp. 097701 ◽  
Author(s):  
Zi-Yang Liu ◽  
Jin-Cheng Zhang ◽  
Huan-Tao Duan ◽  
Jun-Shuai Xue ◽  
Zhi-Yu Lin ◽  
...  

2006 ◽  
Vol 49 (4) ◽  
pp. 393-399 ◽  
Author(s):  
Yan Yang ◽  
Yue Hao ◽  
Jincheng Zhang ◽  
Chong Wang ◽  
Qian Feng

2002 ◽  
Vol 743 ◽  
Author(s):  
Narihiko Maeda ◽  
Kotaro Tsubaki ◽  
Tadashi Saitoh ◽  
Takehiko Tawara ◽  
Naoki Kobayashi

ABSTRACTElectron transport properties and DC device characteristics have been examined in the AlGaN/GaN heterostructure field-effect transistors (HFETs) with back-doping design that makes it possible to obtain high two-dimensional electron gas (2DEG) densities even for the devices with thin AlGaN barrier layers. In the back-doping design, an asymmetric double-heterostructure is employed, and donor atoms are doped not only in the surface-side AlGaN layer but also in the underlying AlGaN layer. In this structure, electrons are efficiently supplied also from the back-doped AlGaN barrier layer to the GaN channel and merged into a single 2DEG layer, with the help of the negative polarization charges at the heterointerface between the GaN channel and the underlying AlGaN barrier layer. By using back-doping design, very high 2DEG densities around 3×1013 cm−2 has been achieved in the Al0.3Ga0.7N/GaN HFET whose barrier layer (Al0.3Ga0.7N) is designed to be as thin as 120 Å. An HFET with the gate-length of 1.5 μm has exhibited a high current density of 1.2 A/mm and a high transconductance of 200 mS/mm, which is ascribed to high 2DEG densities and thin barrier layers in these devices. HFETs with the back-doping design are thus promising for high-power applications.


2020 ◽  
Vol 20 (7) ◽  
pp. 4404-4408
Author(s):  
June-Heang Choi ◽  
Tuan Anh Vuong ◽  
Hyungtak Kim ◽  
Ho-Young Cha

We have developed a Pd-functionalized hydrogen gas sensor based on a recessed AlGaN/GaN heterostructure field-effect transistor. The AlGaN barrier layer under the Pd catalyst was partially etched to enhance its sensitivity. Both low-power consumption and high sensitivity were achieved by employing a recessed structure. Sensor characterization was carried out at the temperature range from room temperature to 250 °C, among which the best sensing characteristics were observed at 200 °C. A sensitivity of 380% with a response time of 0.25 s was achieved at a bias voltage of 0.3 V at 200 °C under a hydrogen exposure concentration of 4%. The standby power consumption was only 2 μW for the sensing area of 100×28 μm2 due to the low standby current, which was caused by the recessed AlGaN barrier layer.


2007 ◽  
Vol 24 (6) ◽  
pp. 1705-1708 ◽  
Author(s):  
Ma Zhi-Yong ◽  
Wang Xiao-Liang ◽  
Hu Guo-Xin ◽  
Ran Jun-Xue ◽  
Xiao Hong-Ling ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document