A Novel Operational Transconductance Amplifier Based an RLC-Low-Pass Filter

Author(s):  
Karima Garradhi ◽  
Néjib Hassen ◽  
Thouraya Ettaghzouti ◽  
Kamel Besbes
Author(s):  
Noor Thamer Almalah ◽  
Faris Hasan Aldabbagh

<p>In this paper, a designed circuit used for low-frequency filters is implemented and realized the filter is based on frequency-dependent negative resistance (FDNR) as an inductor simulator to substitute the traditional inductance, which is heavy and high cost due to the coil material manufacturing and size area. The simulator is based on an active operation amplifier or operation transconductance amplifier (OTA) that is easy to build in an integrated circuit with a minimum number of components. The third and higher-order Butterworth filter is simulated at low frequency for low pass filter to use in medical instruments and low-frequency applications. The designed circuit is compared with the traditional proportional integral controller enhanced (PIE) and T section ordinary filter. The results with magnitude and phase response were compared and an acceptable result is obtained. The filter can be used for general applications such as medical and other low-frequency filters needed.</p>


2021 ◽  
Vol 11 (3) ◽  
pp. 171-190
Author(s):  
Tapas Kumar Paul ◽  
Suvajit Roy ◽  
Radha Raman Pal

In this contribution, nine new Grounded Inductance Simulators (GISs) using a single Multiple-Output Current Controlled Current Conveyor Transconductance Amplifier (MO-CCCCTA) and one grounded capacitor are proposed. Among them, two are lossless types and seven are lossy types. The use of a single grounded capacitor makes the circuits suitable for fabrication. All the proposed circuits are electronically tunable through the bias currents of MO-CCCCTA. Furthermore, no component matching conditions are needed for realizing them. The designed circuits are verified through PSPICE simulator with ± 0.9 V power supply. The simulation results show that for all the proposed circuits: maximum operating frequencies are about 12 MHz, power dissipation is less than 0.784 mW, Total Harmonic Distortions (THDs) are under 8.09%, and maximum output voltage noise at 1 MHz frequency is 14.094 nV/√Hz. To exhibit the workability of the proposed circuits, they are used to design band-pass, low-pass filter, parallel RLC resonator, and parasitic inductance cancelator.


2019 ◽  
Vol 92 ◽  
pp. 104606 ◽  
Author(s):  
Paulo M. Pinto ◽  
Luís H.C. Ferreira ◽  
Gustavo D. Colletta ◽  
Rodrigo A.S. Braga

2017 ◽  
Vol E100.C (10) ◽  
pp. 858-865 ◽  
Author(s):  
Yohei MORISHITA ◽  
Koichi MIZUNO ◽  
Junji SATO ◽  
Koji TAKINAMI ◽  
Kazuaki TAKAHASHI

2016 ◽  
Vol 15 (12) ◽  
pp. 2579-2586
Author(s):  
Adina Racasan ◽  
Calin Munteanu ◽  
Vasile Topa ◽  
Claudia Pacurar ◽  
Claudia Hebedean

Sign in / Sign up

Export Citation Format

Share Document