Preparatory Procedures for Electron Microscopic Analysis at the Molecular Level of Resolution

1978 ◽  
Vol 36 (3) ◽  
pp. 516-520
Author(s):  
F.J. Sjostrand
Keyword(s):  
Electron Microscope ◽  
Molecular Level ◽  
Microscopic Analysis ◽  
Resolving Power ◽  
Cellular Structures ◽  
Electron Microscopic ◽  
Systematic Analysis ◽  
Technical Developments ◽  
Thin Sectioning ◽  
Obvious Reason

In the 1940's and 1950's electron microscopy conferences were attended with everybody interested in learning about the latest technical developments for one very obvious reason. There was the electron microscope with its outstanding performance but nobody could make very much use of it because we were lacking proper techniques to prepare biological specimens. The development of the thin sectioning technique with its perfectioning in 1952 changed the situation and systematic analysis of the structure of cells could now be pursued. Since then electron microscopists have in general become satisfied with the level of resolution at which cellular structures can be analyzed when applying this technique. There has been little interest in trying to push the limit of resolution closer to that determined by the resolving power of the electron microscope.

Lead aspartate: a new en bloc stain for electron microscopy

1978 ◽  
Vol 36 (2) ◽  
pp. 34-35
Author(s):  
J.R. Walton
Keyword(s):  
Electron Microscopy ◽  
Calcium Ion ◽  
Enzyme Reaction ◽  
Lead Citrate ◽  
Reaction Products ◽  
En Bloc ◽  
Thin Sections ◽  
Lead Salts ◽  
Thin Sectioning ◽  
High Alkalinity

In electron microscopy, lead is the metal most widely used for enhancing specimen contrast. Lead citrate requires a pH of 12 to stain thin sections of epoxy-embedded material rapidly and intensively. However, this high alkalinity tends to leach out enzyme reaction products, making lead citrate unsuitable for many cytochemical studies. Substitution of the chelator aspartate for citrate allows staining to be carried out at pH 6 or 7 without apparent effect on cytochemical products. Moreover, due to the low, controlled level of free lead ions, contamination-free staining can be carried out en bloc, prior to dehydration and embedding. En bloc use of lead aspartate permits the grid-staining step to be bypassed, allowing samples to be examined immediately after thin-sectioning.Procedures. To prevent precipitation of lead salts, double- or glass-distilled H20 used in the stain and rinses should be boiled to drive off carbon dioxide and glassware should be carefully rinsed to remove any persisting traces of calcium ion.

Albumins as Embedding Media for Electron Microscopy

1969 ◽  
Vol 27 ◽  
pp. 422-423 ◽  
Author(s):  
J. L. Farrant ◽  
J. D. McLean
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
High Temperature ◽  
Biological Material ◽  
Globular Proteins ◽  
The Past ◽  
Antibody Staining ◽  
Thin Sectioning ◽  
Embedding Medium

For electron microscope techniques such as ferritin-labeled antibody staining it would be advantageous to have available a simple means of thin sectioning biological material without subjecting it to lipid solvents, impregnation with plastic monomers and their subsequent polymerization. With this aim in view we have re-examined the use of protein as an embedding medium. Gelatin which has been used in the past is not very satisfactory both because of its fibrous nature and the high temperature necessary to keep its solutions fluid. We have found that globular proteins such as the serum and egg albumins can be cross-linked so as to yield blocks which are suitable for ultrathin sectioning.

Structural modifications of intercellular junctions.

1978 ◽  
Vol 36 (2) ◽  
pp. 330-331
Author(s):  
J. Metz ◽  
M. Merlo ◽  
W. G. Forssmann
Keyword(s):  
Gap Junctions ◽  
Intercellular Junctions ◽  
Cell Isolation ◽  
Extrahepatic Cholestasis ◽  
Structural Modifications ◽  
Pancreatic Duct Ligation ◽  
Pancreatic Cells ◽  
Duct Ligation ◽  
Thin Sectioning ◽  
And Function

Structure and function of intercellular junctions were studied under the electronmicroscope using conventional thin sectioning and freeze-etch replicas. Alterations of tight and gap junctions were analyzed 1. of exocrine pancreatic cells under cell isolation conditions and pancreatic duct ligation and 2. of hepatocytes during extrahepatic cholestasis.During the different steps of cell isolation of exocrine pancreatic cells, gradual changes of tight and gap junctions were observed. Tight junctions, which formed belt-like structures around the apex of control acinar cells in situ, subsequently diminished, became interrupted and were concentrated into macular areas (Fig. 1). Aggregations of membrane associated particles, which looked similar to gap junctions, were intermixed within tight junctional areas (Fig. 1). These structures continously disappeared in the last stages of the isolation procedure. The intercellular junctions were finally separated without destroying the integrity of the cell membrane, which was confirmed with porcion yellow, lanthanum chloride and horse radish peroxidase.

Ferritin Labeled Antibody Staining of Thin Sections

1969 ◽  
Vol 27 ◽  
pp. 420-421
Author(s):  
J. D. McLean ◽  
S. J. Singer
Keyword(s):  
Biological Material ◽  
Water Soluble ◽  
Thin Sections ◽  
Antibody Staining ◽  
Thin Sectioning ◽  
Ultrathin Sections

The successful application of ferritin labeled antibodies (F-A) to ultrathin sections of biological material has been hampered by two main difficulties. Firstly the normally used procedures for the preparation of material for thin sectioning often result in a loss of antigenicity. Secondly the polymers employed for embedding may non-specifically absorb the F-A. Our earlier use of cross-linked polyampholytes as embedding media partially overcame these problems. However the water-soluble monomers used for this method still extract many lipids from the material.

Deposited emulsion particles in the pores of aluminum oxide film

1978 ◽  
Vol 36 (1) ◽  
pp. 450-451
Author(s):  
Michio Ashida ◽  
Yasukiyo Ueda
Keyword(s):  
Oxide Film ◽  
Acid Solution ◽  
Barrier Layer ◽  
Colloidal Particles ◽  
Oxalic Acid Solution ◽  
Anodic Oxide ◽  
Anodic Oxide Film ◽  
Carbon Replica ◽  
Sectioning Method ◽  
Thin Sectioning

An anodic oxide film is formed on aluminum in an acidic elecrolyte during anodizing. The structure of the oxide film was observed directly by carbon replica method(l) and ultra-thin sectioning method(2). The oxide film consists of barrier layer and porous layer constructed with fine hexagonal cellular structure. The diameter of micro pores and the thickness of barrier layer depend on the applying voltage and electrolyte. Because the dimension of the pore corresponds to that of colloidal particles, many metals deposit in the pores. When the oxide film is treated as anode in emulsion of polyelectrolyte, the emulsion particles migrate onto the film and deposit on it. We investigated the behavior of the emulsion particles during electrodeposition.Aluminum foils (99.3%) were anodized in either 0.25M oxalic acid solution at 30°C or 3M sulfuric acid solution at 20°C. After washing with distilled water, the oxide films used as anode were coated with emulsion particles by applying voltage of 200V and then they were cured at 190°C for 30 minutes.

Ultrastructure and Morphology of the Neurospora Crassa Cell Wall Mutants, Slime And Slime X, Using Tem and Sem

1976 ◽  
Vol 34 ◽  
pp. 54-55
Author(s):  
Karen S. Howard ◽  
H. D. Braymer ◽  
M. D. Socolofsky ◽  
S. A. Milligan
Keyword(s):  
Cell Wall ◽  
Neurospora Crassa ◽  
Wild Type ◽  
Morphological Comparison ◽  
Small Areas ◽  
Solid Media ◽  
Thin Sectioning ◽  
X Cells ◽  
Mutant Cells ◽  
Isolated Cell

The recently isolated cell wall mutant slime X of Neurospora crassa was prepared for ultrastructural and morphological comparison with the cell wall mutant slime. The purpose of this article is to discuss the methods of preparation for TEM and SEM observations, as well as to make a preliminary comparison of the two mutants.TEM: Cells of the slime mutant were prepared for thin sectioning by the method of Bigger, et al. Slime X cells were prepared in the same manner with the following two exceptions: the cells were embedded in 3% agar prior to fixation and the buffered solutions contained 5% sucrose throughout the procedure.SEM: Two methods were used to prepare mutant and wild type Neurospora for the SEM. First, single colonies of mutant cells and small areas of wild type hyphae were cut from solid media and fixed with OSO4 vapors similar to the procedure used by Harris, et al. with one alteration. The cell-containing agar blocks were dehydrated by immersion in 2,2-dimethoxypropane (DMP).

The Application of Ultra-Thin Sectioning Techniques to Non-Biological Samples

1968 ◽  
Vol 26 ◽  
pp. 332-333
Author(s):  
C. F. Oster
Keyword(s):  
Biological Sciences ◽  
Epoxy Resin ◽  
Cross Sections ◽  
Biological Samples ◽  
Industrial Applications ◽  
Photographic Film ◽  
Silver Particles ◽  
Thin Sectioning ◽  
Embedding Medium

Although ultra-thin sectioning techniques are widely used in the biological sciences, their applications are somewhat less popular but very useful in industrial applications. This presentation will review several specific applications where ultra-thin sectioning techniques have proven invaluable.The preparation of samples for sectioning usually involves embedding in an epoxy resin. Araldite 6005 Resin and Hardener are mixed so that the hardness of the embedding medium matches that of the sample to reduce any distortion of the sample during the sectioning process. No dehydration series are needed to prepare our usual samples for embedding, but some types require hardening and staining steps. The embedded samples are sectioned with either a prototype of a Porter-Blum Microtome or an LKB Ultrotome III. Both instruments are equipped with diamond knives.In the study of photographic film, the distribution of the developed silver particles through the layer is important to the image tone and/or scattering power. Also, the morphology of the developed silver is an important factor, and cross sections will show this structure.

Rotary Beveling for In Situ Thin-Section Microscopy of Cell Cultures

1981 ◽  
Vol 39 ◽  
pp. 550-551
Author(s):  
Dean A. Handley ◽  
Jack T. Alexander ◽  
Shu Chien
Keyword(s):  
Cell Growth ◽  
Cell Cultures ◽  
Molecular Interactions ◽  
Convenient Method ◽  
Petri Dish ◽  
Simple Method ◽  
Thin Section Microscopy ◽  
Thin Sectioning ◽  
Organic Fluids

In situ preparation of cell cultures for ultrastructural investigations is a convenient method by which fixation, dehydration and embedment are carried out in the culture petri dish. The in situ method offers the advantage of preserving the native orientation of cell-cell interactions, junctional regions and overlapping configurations. In order to section after embedment, the petri dish is usually separated from the polymerized resin by either differential cryo-contraction or solvation in organic fluids. The remaining resin block must be re-embedded before sectioning. Although removal of the petri dish may not disrupt the native cellular geometry, it does sacrifice what is now recognized as an important characteristic of cell growth: cell-substratum molecular interactions. To preserve the topographic cell-substratum relationship, we developed a simple method of tapered rotary beveling to reduce the petri dish thickness to a dimension suitable for direct thin sectioning.

Effect of Iron Limitation on the Ultrastructure of Agmenellum Quadruplicatum

1981 ◽  
Vol 39 ◽  
pp. 410-411
Author(s):  
L. P. Hardie ◽  
D. L. Balkwill ◽  
S. E. Stevens
Keyword(s):  
Growth Medium ◽  
Green Alga ◽  
Natural Habitat ◽  
Iron Limitation ◽  
Natural Environments ◽  
Blue Green Alga ◽  
Marine Cyanobacterium ◽  
Natural Systems ◽  
Thin Sectioning ◽  
Agmenellum Quadruplicatum

Agmenellum quadruplicatum is a unicellular, non-nitrogen-fixing, marine cyanobacterium (blue-green alga). The ultrastructure of this organism, when grown in the laboratory with all necessary nutrients, has been characterized thoroughly. In contrast, little is known of its ultrastructure in the specific nutrient-limiting conditions typical of its natural habitat. Iron is one of the nutrients likely to limit this organism in such natural environments. It is also of great importance metabolically, being required for both photosynthesis and assimilation of nitrate. The purpose of this study was to assess the effects (if any) of iron limitation on the ultrastructure of A. quadruplicatum. It was part of a broader endeavor to elucidate the ultrastructure of cyanobacteria in natural systemsActively growing cells were placed in a growth medium containing 1% of its usual iron. The cultures were then sampled periodically for 10 days and prepared for thin sectioning TEM to assess the effects of iron limitation.

Sign in / Sign up

Export Citation Format

Share Document