Land Degradation as a Transformation Process in an Intertemporal Welfare Optimisation Framework

Author(s):  
Peter J. Albersen ◽  
Laixiang Sun
Author(s):  
Jenö Beyer ◽  
Lajos Tóth

The structural changes during reversible martensitic transformation of near-equiatomic NiTi alloys can best be studied in TEM at around room temperature. Ternary additions like Mn offer this possibility by suppressing the Ms temperature below RT. Besides the stable intermetallic phases (Ti2Ni, TiNi, TiNi3) several metastable phases with various crystallographic structures (rhombohedral, hexagonal, monoclinic, cubic) have also been reported to precipitate due to suitable annealing procedures.TiNi:Mn samples with 0.9 and 1.3 at% Mn were arc melted in argon atmosphere and homogenized at 948 °C for 72 hours in high vacuum in an infrared furnace. After spark cutting slices of 0.2 mm, TEM specimens were prepared by electrochemical polishing with the twin-jet technique in methanol - perchloric acid electrolyte. The TEM study was carried out in a JEOL 200 CX analytical electron microscope.In this paper a new intermetallic phase is reported which has been observed in both samples by TEM during the martensitic transformation process.


2012 ◽  
Vol 2 (1) ◽  
pp. 25-33 ◽  
Author(s):  
Michaela Heese

Members of the Civil Air Navigation Services Organisation have committed themselves to measure and improve safety culture within their organizations by 2013 ( CANSO, 2010 ). This paper attempts to offer support to air navigation service providers that have already implemented a standardized safety culture survey approach, in the process of transforming their safety culture based on existing survey results. First, an overview of the state of the art with respect to safety culture is presented. Then the application of the CANSO safety culture model from theory into practice is demonstrated based on four selected case studies. Finally, a summary of practical examples for driving safety culture change is provided, and critical success factors supporting the safety culture transformation process are discussed.


2020 ◽  
Vol 2020 (10) ◽  
pp. 19-33
Author(s):  
Nadiia NOVYTSKA ◽  
◽  
Inna KHLIEBNIKOVA ◽  

The market of tobacco products in Ukraine is one of the most dynamic and competitive. It develops under the influence of certain factors that cause structural changes, therefore, the aim of the article is to conduct a comprehensive analysis of transformation processes in the market of tobacco and their alternatives in Ukraine and identify the factors that cause them. The high level of tax burden and the proliferation of alternative products with a potentially lower risk to human health, including heating tobacco products and e-cigarettes, are key factors in the market’s transformation process. Their presence leads to an increase in illicit turnover of tobacco products, which accounts for 6.37% of the market, and the gradual replacement of cigarettes with alternative products, which account for 12.95%. The presence on the market of products that are not taxed or taxed at lower rates is one of the reasons for the reduction of excise duty revenues. According to the results of 2019, the planned indicators of revenues were not met by 23.5%. Other reasons for non-fulfillment of excise duty revenues include: declining dynamics of the tobacco products market; reduction in the number of smokers; reorientation of «cheap whites» cigarette flows from Ukraine to neighboring countries; tax avoidance. Prospects for further research are identified, namely the need to develop measures for state regulation and optimization of excise duty taxation of tobacco products and their alternatives, taking into account the risks to public health and increasing demand of illegal products.


2019 ◽  
Vol 2 (1) ◽  
pp. 071-084
Author(s):  
Silwanus M. Talakua ◽  
Rafael M. Osok

The study was conducted in Wai Sari sub-watershed, Western Seram Regency Maluku to develop an accurate land degradation assessment model for tropical small islands. The Stocking’s field land degradation measurement and RUSLE methods were applied to estimate soil loss by erosion and the results of both methods were statistically tested in order to obtain a correction factor. Field indicators and prediction data were measured on 95 slope units derived from the topographic map. The rates of soil loss were calculated according to both methods, and the results were used to classify the degree of land degradation. The results show that the degree of land degradation based on the field assessment ranges from none-slight (4.04 - 17.565 t/ha/yr) to very high (235.44 - 404.00 t/ha/yr), while the RUSLE method ranges from none-slight (0.04-4.59 t/ha/yr) to very high 203.90 - 518.13 t/ha/yr.  However, the RUSLE method shows much higher in average soil loss (133.4 t/ha/yr) than the field assessment (33.9 t/ha/yr). The best regression equation of  logD/RP = - 0.594 + 1.0 logK + 1.0 logLS + 1.0 logC or D = 0.2547xRxKxLSx CxP was found to be a more suitable land degradation assessment  model for a small-scale catchment area in the tropical small islands.


2019 ◽  
Vol 2 (1) ◽  
Author(s):  
Elsa Karino

Production is an activity to convert inputs into outputs through the transformation process. Input in the form of man, money, method, material, machine. While the output is in the form of goods or services. The purpose of production in general is to meet individual needs. There are several factors that influence production namely land and all economic potential that is processed and cannot be separated from the production process, labor is directly related to the demands of property rights through production, and capital, management and technology. In production there are various types of production, namely production which is intermittent and continuous. The production, if viewed from an Islamic perspective, it must fulfill the following principles. First, produce in a halal circle. Second, managing natural resources in production is interpreted as the process of creating wealth by utilizing natural resources must rely on the vision of the creation of this nature and along with the vision of human creation, namely as a blessing for all nature. Third, the Caliph on the earth is not only based on the activity of producing the usefulness of an item but work is done with the motive of benefiting to seek the pleasure of Allah SWT. Key Words: Production, Red Sugar, benefiting


Proceedings ◽  
2020 ◽  
Vol 1 (1) ◽  
Author(s):  
Youssra El Qasemy ◽  
Abdelfatah Achahbar ◽  
Abdellatif Khamlichi

The stochastic behavior of wind speed is a particular characteristic of wind energy production, which affects the degradation mechanism of the turbine, resulting in stochastic charging on the wind turbine. A model stochastic is used in this study to evaluate the efficiency of wind turbine power of whatever degree given fluctuating wind turbulence data. This model is based on the Langevin equations, which characterize, by two coefficients, drift and diffusion functions. These coefficients describe the behavior of the transformation process from the input wind speed to the output data that need to be determined. For this present work, the computation of drift and diffusion functions has been carried out by using the stochastic model to assess the output variables in terms of the torque and power curves as a function of time, and it is compared by the classical method. The results show that the model stochastic can define the efficiency of wind turbine generation more precisely.


Sign in / Sign up

Export Citation Format

Share Document